DESIGN OF DESALTING PLANTS FOR CONJUNCTIVE OPERATION1

ABSTRACT The selection of an evaporator design must reflect the balancing of captial cost (primarily in heat exchanger surface and vessels) against operating cost (primarily steam cost) to achieve minimum cost. In a conjunctive plant the tendency is to select a low-capital cost, high-operating cost plant. In addition, it is advantageous to use a high-capacity plant which needs to be operated much less of the time than a plant which is sized just at the needed rate. For example, in the study of a possible system to satisfy a future increase of 450 MGD in water supply to New York Qty, a plant of 750 MGD capacity was selected as optimum. This plant, of the advanced VTE-MSF process type, would have a performance ratio of 9 lb product/1000 Btu as compared to 10-13 normally used for base-loaded plants. Steam would be supplied by a multi-unit dual-purpose nuclear power plant. The most economical type of energy supply would be “interruptible”; the steam would be used by a low pressure turbine to generate electricity during periods of peak electrical demand but would be available to the desalting plant at other times. The low pressure turbine would be available as spinning reserve during desalting plant operation. It is estimated that the desalting plant would have a load factor of 27 per cent over its life.     

高喷灌浆加固抛石填海软基

高压旋喷灌浆法是本世纪７０ 年代发展起来的地基处理新技术,在砂性土和粘性土等软弱地层加固工程中已得到广泛应用,但在含有碎石的淤泥质土及穿过它对其下淤泥的加固尚少见,笔者简要介绍了采用钻灌分开两大工序的新双管法及其成功完成加固任务的事例。     

BEL型双维振打式电除尘器的研发

文章介绍了一种顶打和侧打相结合的BEL型双维振打式电除尘器，该产品将电除尘器两种主要的振打清灰技术结合，适用于老除尘器的提效改造及新除尘器的制造等。     

CALCULATION OF CUMULATIVE PERCENTAGE AT SELECTED PARTICLE SIZES FROM BOTTOM WITHDRAWAL TUBE ANALYSIS

ABSTRACT: A new computation method is developed for the bottom withdrawal tube particle size analysis. A transformation on time scale is introduced so that the cumulative percentage of a selected particle size can be determined from a single continuous Oden cum.     

热水锅炉水冷壁管爆管事故综合分析

对在同一单位的三台热水锅炉发生多起水冷壁管爆管事故进行了综合分析,提出了相应的改进措施。     

L型钢管混凝土芯柱耐火极限研究

火灾高温对结构安全有显著影响,为研究等肢L形钢管混凝土芯柱的耐火极限及其影响因素,利用ABAQUS软件建立合理的高温反应分析模型,在验证模型可靠性基础上,分析了荷载比、截面边长、长细比、荷载偏心率、含钢率等对L形钢管混凝土芯柱耐火极限的影响。研究结果表明:在一定参数范围内,荷载比和截面边长是构件耐火极限的主要影响参数,荷载比越小,截面边长越大,构件的耐火极限越高;长细比和荷载偏心率对其影响较大,长细比和荷载偏心率越小,构件的耐火极限越高;含钢率对其影响不显著。结果可为异形钢管混凝土芯柱的抗火安全设计提供参考。     

Application of CFD on the sensitivity analyses of some parameters of the modified Hartmann tube

The aim of this work is to determine the influence of operating parameters such as the dispersion pressure, the ignition delay and height on the dust flammability. A Computational Fluid Dynamics (CFD) simulation, based on an Euler–Lagrange approach, was developed with Ansys Fluent™ and validated experimentally. Such analysis will facilitate the choice of the most conservative conditions for a flammability test. This paper is focused on a case study performed on wheat starch with the modified Hartmann tube. The dispersion process of the powder was studied with granulometric analyses performed in situ and high speed videos. Tests were performed with injections at gas pressure ranging from 3 to 6 bars and the evolution of the particle size distribution (PSD) was recorded at different ignition heights (5, 10 and 15 cm over the dispersion nozzle). The observations highlighted the presence of agglomeration/deagglomeration processes and dust segregation. Besides, a CFD simulation analysis was aimed at evaluating the impact of a set of parameters on the PSD and the local turbulence, which are closely linked to some flammability parameters. For this computational analysis, the CFD simulation was coupled with a collision treatment based on a Discrete Element Method (DEM) in order to consider the cohesive behavior of the combustible dust. Thus the results suggest performing the injection of the gases at approximately 5 bars for the flammability tests of wheat starch in order to obtain the finest PSD at a given ignition height. It is also shown that the finest PSD are obtained at 5 cm over the dispersion nozzle. However, the local instabilities and turbulence levels are so high during the first stages of the dispersion that the flame growth can be disturbed for short ignition delays. Moreover, the stabilization of the bulk of the dust cloud requires longer periods of time when the ignition sources are located at 15 cm. As a result, the recommended height to perform a flammability test is 10 cm in this case. Finally, this study proposes some tools that might improve the procedure of dust flammability testing.     

Simplified model for the evaluation of the effects of explosions on industrial target

The evaluation of vulnerability of process equipment to explosion is a central issue in the analysis of industrial risks. In this work, we have developed a simplified model, however based on fundamental equations, which includes structural and fluid–dynamic parameters for the target (the industrial equipment) and for the impacting pressure wave (shock waves) or object (fragment, debris) produced by different type of chemical explosions.The validity of methodology has been assessed by case histories. Several insights on the dynamic of structural interaction of the explosion with the target have been obtained, with specific reference to escalation effects.The model derives from the well-known Johnson's number, often adopted in impact engineering.     

土壤有机质含量测定方法的改进研究

通过研究改进了土壤有机质含量的测定方法。首先称取适量土壤置于长管消解系统中进行消解,然后采用全自动电位滴定仪进行滴定,直接获得土壤的有机质含量。使用该方法测定的土壤标准样品的有机质含量均在保证值以内,同时对实际样品进行精密度测试,得到相对标准偏差为1．03％。该方法降低了土壤有机质含量检测的实验成本,减少了环境污染,同时提高了实验数据的准确度与精密度,值得推广。     

Prenatal diagnosis in three cases of iniencephaly with unusual postmortem findings

Iniencephaly is a rare and lethal congenital malformation of the neural tube characterized by occipital bone defect, cervical dysraphism, fixed retroflexion of the fetal head and severe lordosis of the cervicothoracic spine. The etiology is unknown. Prenatally diagnosed cases of iniencephaly are rare because careful and early ultrasonographic evaluation is necessary. We present three cases of iniencephaly prenatally diagnosed by sonography at 20–22 weeks' gestation in which therapeutic abortion was induced. The sonographic findings were compatible with the postmortem findings. The present cases of iniencephaly were found to carry unusual associated malformations such as two lobes in the right lung and chorangiosis of the placenta. Only hypoplastic lungs have been reported by previous authors. We also studied the 677C→T mutation on the methylenetetrahydrofolate reductase gene in the parents in one of the present cases. The mother was found to be heterozygous for the 677CT polymorphism. Copyright © 2001 John Wiley & Sons, Ltd.