瓦斯抽采PC-CAS基封孔材料优化及其膨胀作用分析*

为了研制以硅酸盐/铝酸盐水泥、生石灰、生石膏为主的PC-CAS基封孔材料,采用正交试验优化材料配比、开展膨胀力研究,并用扫描电镜观测料-煤胶结形貌。研究结果表明:材料的最优配比为A2B2C4,其具备优良的流动性、强度及致密性,造浆量达2 100 mL/kg;PC-CAS基材料具有显著的膨胀性,其膨胀力随时间先增大而后趋于稳定,并且该膨胀力随着径向约束的提高而增大;相比于FP材料,PC-CAS基材料产生的膨胀力能够显著降低材料-煤岩界面的空隙并在一定程度上压密煤体内部的裂隙;该材料产生的膨胀力可压密封孔段围岩、提高封孔质量,并为后期“二次注浆”提供保压条件。工业试验结果表明,采用PC-CAS基材料进行封孔可显著改善抽采效果,将原有平均浓度10.11%提升至20.08%。     

某处理厂CASS池改造工艺选择及运行效果

随着污水处理厂排到受纳水体标准的不断提高及区域污染物排放限值的要求,已建的污水处理厂需要提标改造提高排放标准。本文所提工程对现有的CASS池进行改造,通过投加悬浮填料形成CASS+MBBR工艺,其中TN污染物的去除率可提高到8%~15%间,其它污染物也能达到预期的设计标准。     

硫酸雾测试方法若干问题思考

简述了我国硫酸雾测试方法的发展历史,分析和总结了《固定污染源废气硫酸雾的测定离子色谱法》(HJ 544—2016)存在的一些争议和问题,包括硫酸雾的定义、测试方法的干扰控制等。分析认为,相比《硫酸工业污染物排放标准》(GB 26132—2010),HJ 544—2016对硫酸雾的定义更加合理。实验结果表明:硫酸盐是测试方法条件下的目标物,滤筒可以显著地捕捉硫酸盐。9组样品滤筒中,被测目标物所占比例为7.9%~69.1%;滤筒和前吸收液中,被测目标物所占比例为93.7%~97.8%。HJ 544—2016新增加的两级串联碱液吸收瓶可以较完全地捕集穿透滤筒后的硫酸雾,同时也会捕集SO2。SO2会对硫酸雾测试产生正干扰,约42.9%的SO2在被吸收后转化为硫酸雾。     

非金属管道微小泄漏动力学数值模拟和试验对比

为了探索非金属输送管道泄漏规律,从数值模拟和试验两个角度,对液体PE管道发生泄漏前后管道内流体与泄漏口的流动状态进行了对比分析,为判定管道泄漏提供了依据。运用FLUENT软件针对PE液体管道泄漏,在不同孔径、不同压力下,构建管道泄漏模型分别进行仿真,分析不同泄漏情景下压力梯度的分布规律。同时在近似相同条件下进行PE管道两点泄漏模拟试验。结果显示:数值模拟与试验结果基本一致,泄漏孔处压力、流速均与管内初始压力成正相关;初始压力和孔径的增大,会导致管内压力下降速度上升,但最终会趋于稳定值。     

Validation of a booted finite element model of the WIAMan ATD lower limb in component and whole-body vertical loading impacts with an assessment of the boot influence model on response

Objective: A novel anthropomorphic test device (ATD) representative of the 50th percentile male soldier is being developed to predict injuries to a vehicle occupant during an underbody blast (UBB). The main objective of this study was to develop and validate a finite element (FE) model of the ATD lower limb outfitted with a military combat boot and to insert the validated lower limb into a model of the full ATD and simulate vertical loading experiments.

Methods: A Belleville desert combat boot model was assigned contacts and material properties based on previous experiments. The boot model was fit to a previously developed model of the barefoot ATD. Validation was performed through 6 matched pair component tests conducted on the Vertically Accelerated Loads Transfer System (VALTS). The load transfer capabilities of the FE model were assessed along with the force-mitigating properties of the boot. The booted lower limb subassembly was then incorporated into a whole-body model of the ATD. Two whole-body VALTS experiments were simulated to evaluate lower limb performance in the whole body.

Results: The lower limb model accurately predicted axial loads measured at heel, tibia, and knee load cells during matched pair component tests. Forces in booted simulations were compared to unbooted simulations and an amount of mitigation similar to that of experiments was observed. In a whole-body loading environment, the model kinematics match those recorded in experiments. The shape and magnitude of experimental force–time curves were accurately predicted by the model. Correlation between the experiments and simulations was backed up by high objective rating scores for all experiments.

Conclusion: The booted lower limb model is accurate in its ability to articulate and transfer loads similar to the physical dummy in simulated underbody loading experiments. The performance of the model leads to the recommendation to use it appropriately as an alternative to costly ATD experiments.     

电磁阀贮存寿命加速试验技术研究

首先陈述了贮存寿命加速试验的基本原理,介绍电磁阀的结构组成,分析了失效模式和失效机理后,采取恒定应力加速试验方法,然后运用极大似然估计和最小二乘法对数据进行处理,最后得出其贮存寿命等结论。     

多输入多输出(MIMO)振动试验技术

多输入多输出(MIMO)振动试验由于可以更好的模拟产品的真实工作环境,是振动试验的一个发展方向。本文分析了其产生需求的根本原因,同时介绍了国内外的发展现状及其应用情况,之后对MIMO试验系统进行了分类,介绍了试验控制器和控制方法,并探讨了其工程实施所存在困难。最后针对我国MIMO试验技术的发展提出了建议,并对前景进行了展望。     

可靠性试验评价技术发展及其应用

本文介绍了可靠性试验评价的概况和技术发展,论述了可靠性仿真试验、可靠性强化试验、可靠性加速试验、系统可靠性试验、加速退化试验和可靠性综合评价的概念、方法、基本流程及其主要应用。     

混合集成电路HALT和HASS技术应用研究

介绍了HALT和HASS技术的概念和内涵,探讨了混合集成电路HALT和HASS技术应用的基本原理以及具体的应用方法和流程。     

大型蚤标志酶用于城市二级出水毒性的评价

大型蚤是一种国际公认的标准实验生物,广泛应用于污水、地表水等水质毒性检测。毒性水平较低的城市二级出水,对大型蚤往往无急性毒性效应,而具有慢性毒性效应,但慢性毒性检测周期过长,因此探索一种更灵敏的指标,实现快速检测,对于控制二级出水的水质风险具有重要意义。本研究考察了大型蚤在短期暴露于城市二级出水条件下,其体内乙酰胆碱酯酶、超氧化物歧化酶、过氧化氢酶、ATP酶、羧酸酯酶和碱性磷酸酯酶的酶活变化特征,从中筛选出对二级出水毒性响应灵敏的标志酶指标。实验结果表明,碱性磷酸酯酶、过氧化氢酶对二级出水毒性响应相对较灵敏,具有成为标志酶的潜力,研究结果为城市二级出水生物毒性评价方法优化提供新的思路。