论水处理工程中的节能

人们在污水处理厂的建设中对污水处理工艺的先进性、可靠性以及工程投资大小考虑较多,而对污水处理厂建成后的运营管理考虑较少,因而造成许多污水处理厂建成后由于运营成本过高而不能正常运行。从能耗角度出发,分析造成运行成本高的主要原因以及相应采取的措施。     

高压储氢系统泄漏爆炸事故的动力学演化

为研究燃料氢气泄漏、爆炸的特性和规律,预防高压储氢系统中氢气泄漏爆炸事故发生,以加氢站为背景,数值仿真45 MPa高压储罐氢气泄漏并引发爆炸事故,分析泄漏爆炸动力学性质以及爆炸波在非均匀氢气浓度中的传播机制。同时,基于泄漏爆炸事故演化的力学机理,开展氢气泄漏爆炸动态风险分析,针对氢气不同泄漏量,建立泄漏扩散形成的气云体积、气云爆炸产生的冲击波与空间x,z方向上危害距离之间关系。研究结果表明：氢气泄漏过程中,气云氢气浓度变化与流场雷诺数具有较好一致性;氢气扩散受到高压储氢罐周围装置影响,流场中氢气浓度分布不均匀;当发生燃烧爆炸事故时,冲击波参数和湍动能变化梯度大;得到复杂布局区域冲击波超压峰值与比例距离之间关系式,其相比于理论方法更精细、计算结果更准确。研究结果可为降低高压储氢系统泄漏爆炸事故后果、采取有效防护措施提供一定依据。     

肥煤自燃全过程热动力学特征参数研究

实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。     

Effect of pyrolysis and oxidation characteristics on lauric acid and stearic acid dust explosion hazards

The effect of pyrolysis and oxidation characteristics on the explosion sensitivity and severity parameters, including the minimum ignition energy MIE, minimum ignition temperature MIT, minimum explosion concentration MEC, maximum explosion pressure P_max, maximum rate of pressure rise (dP/dt)_max and deflagration index K_st, of lauric acid and stearic acid dust clouds was experimentally investigated. A synchronous thermal analyser was used to test the particle thermal characteristics. The functional test apparatuses including the 1.2 L Hartmann-tube apparatus, modified Godbert-Greenwald furnace, and 20 L explosion apparatus were used to test the explosion parameters. The results indicated that the rapid and slow weight loss processes of lauric acid dust followed a one-dimensional diffusion model (D1 model) and a 1.5 order chemical reaction model (F1.5 model), respectively. In addition, the rapid and slow weight loss processes of stearic acid followed a 1.5 order chemical reaction model (F1.5 model) and a three-dimensional diffusion model (D3 model), respectively, and the corresponding average apparent activation energy E and pre-exponential factor A were larger than those of lauric acid. The stearic acid dust explosion had higher values of MIE and MIT, which were mainly dependent on the higher pyrolysis and oxidation temperatures and the larger apparent activation energy E determining the slower rate of chemical bond breakage during pyrolysis and oxidation. In contrast, the lauric acid dust explosion had a higher MEC related to a smaller pre-exponential factor A with a lower amount of released reaction heat and a lower heat release rate during pyrolysis and oxidation. Additionally, due to the competition regime of the higher oxidation reaction heat release and greater consumption of oxygen during explosion, the explosion pressure P_m of the stearic acid dust was larger in low concentration ranges and decayed to an even smaller pressure than with lauric acid when the concentration exceeded 500 g/m³. The rate of explosion pressure rise (dP/dt)_m of the stearic acid dust was always larger in the experimental concentration range. The stearic acid dust explosion possessed a higher P_max, (dP/dt)_max and K_st mainly because of a larger pre-exponential factor A related to more active sites participating in the pyrolysis and oxidation reaction. Consequently, the active chemical reaction occurred more violently, and the temperature and overpressure rose faster, indicating a higher explosion hazard class for stearic acid dust.     

Environmental pollution,hydropower and nuclear energy generation before and after catastrophe: Bathtub-Weibull curve and MS-VECM methods

In this paper, the life span of hydro and nuclear energy generations and the relationship between hydro and nuclear energy generations, environmental pollution, and economic growth were investigated for Japan covering the period of 1960–2018 by employing the Bathtub-Weibull curve and Markov switching-vector error correcting (MSVEC) method, respectively. According to the Bathtub-Weibull curve analysis, a rising failure rate for nuclear energy was found, indicating that the life of nuclear energy has expired, but a decreasing failure rate for hydroelectric energy has been detected. Then two different MSVEC models were used. The MSVEC method, unlike traditional approaches, determines the relationship between variables under different regimes. The results of MSVEC methods indicate three important points. First, regime-dependent asymmetry and regime changes are crucial for policy recommendations. Second, the shocks to hydropower and nuclear energy generations cause temporary deviations from the long-run growth path in both regimes. Lastly, the increase in hydropower generation leads to a decrease in environmental pollution and an increase in GDP, and an increase in nuclear power generation increases pollution and growth in both regimes.     

Applying Integrated Urban Water Management Concepts: A Review of Australian Experience

This article explores recent Australian experiences in the application of the concept of integrated urban water management (IUWM) to land development sites through the review of 15 case studies. It discusses lUWM’s emergence and comments on the success or otherwise of Australian experience in its application. The understanding of IUWM is maturing within the Australian water industry, an occurrence that has been facilitated by demonstration sites such as those reviewed. Successes include the translation of IUWM concepts into well-functioning operational urban developments, significant reductions in the impact of the urban developments on the total water cycle, and the increasing acceptance of the concept within the water and land development industries. However, there is still room for greater integration of the water supply, stormwater, and wastewater components of the urban water cycle, improved dissemination of knowledge, enhancement of skills in both public and private organisations, and monitoring the performance of systems and technologies.     

CDM Project Activities in China＇s Iron and Steel Industry：Current Status,Barriers and Development Strategies

China is now facing huge pressure from both the domestic concern of energy security and the global community's call for emission reduction commitment. As one of the major energy consumers and greenhouse gas emitters, China's iron and steel industry has a huge clean development mechanism (CDM) potential. This article both quantitatively and qualitatively analyzes the current status of CDM project activities in the iron and steel industry in China, including characteristics of approved project types, applicable methodologies, and potential technology fields. From the perspective of project implementation, the article summarizes development barriers such as high investment risk, difficulty in project identification, strict requirements on PPDs, long registration waiting time, and etc. Policy suggestions are also put forwarded to help better promote the development of CDM projects in the iron and steel industry.     

Urban Energy Efficiency from Cities in China and Policy Implications

Using 1995-2006 panel data for 210 cities, this article firstly measures total factor energy efficiency for Chinese cities with constant return to scale data envelopment analysis model,and then describes the features of regional differences. The results show that the changing trend displays four "reversed U" shapes. A turning point of widening gap occurred among cities in 2000 and there was a certain convergence among four regions. Urban energy efficiency level is unstable. Cities with low efficiency and high energy input will be the focus of energy-saving and reducing emissions. According to Tobit model, resource endowment, temperature, industrial structure, technology level and variety of policy factors should be treated differently in different situations.     

Suitable error evaluation criteria selection in the wind energy assessment via the K-means clustering algorithm

In this paper, wind energy potential of four locations in Xinjiang region is assessed. The Weibull distribution as well as the Logistic and the Lognormal distributions are applied to describe the distributions of the wind speed at different heights. In determining the parameters in the Weibull distribution, four intelligent parameter optimization approaches including the differential evolutionary, the particle swarm optimization, and two other approaches derived from these two algorithms and combined advantages of these two approaches are employed. Then the optimal distribution is chosen through the Chi-square error (CSE), the Kolmogorov–Smirnov test error (KSE), and the root mean square error (RMSE) criteria. However, it is found that the variation range of some criteria is quite large, thus these criteria are analyzed and evaluated both from the anomalous values and by the K-means clustering method. Anomaly observation results have shown that the CSE is the first one should be considered to be eliminated from the consequent optimal distribution function selection. This idea is further confirmed by the K-means clustering algorithm, by which the CSE is clustered into a different group with KSE and RMSE. Therefore, only the reserved two error evaluation criteria are utilized to evaluate the wind power potential.     

城镇化与工业化对能源强度影响的实证研究——基于截面相关和异质性回归系数的非平衡面板数据模型

城镇化、工业化对中国能源强度的影响如何?如何在快速推进城镇化、工业化进程的同时确保节能减排目标的实现?论文以能源强度指标代替传统的能源消费指标来反映能源综合利用效率,并应用考虑截面相关性和异质性回归系数的非平衡面板数据模型,使用共同相关效应组均值(CCEMG)估计方法对中国1978-2014年城镇化、工业化与能源强度之间的关系进行分析。研究结果表明:人均实际GDP增长1%,能源强度将会降低0.412%,工业化水平增长1%,能源强度将会上升0.630%,而由于生产消费等经济活动的增加、高度集中化以及规模经济的综合作用,使得城镇化对能源强度的影响并不确定。联系研究结论,本文提出政策建议:我国应加快产业结构升级,转变经济增长方式;构建绿色制造体系,推进"五化"协同发展;推进绿色、循环、低碳发展的新型城镇化建设,提高城镇化质量,提升我国整体的能源效率,确保节能减排目标的实现,推动经济全面、协调、可持续发展。