Comprehensive temperature monitoring in an in-vessel forced-aeration static-bed composting process

Comprehensive temperature monitoring was done in an in-vessel forced-aeration static-bed composting process using sewage sludge. The three layers that divided the compost pile horizontally showed different temperature distributions. The temperature of the top layer appeared not to be influenced by the ambient temperature. The temperature of the center area of the top layer was taken to be the representative temperature for evaluating composting start-up performance. The temperature of the bottom layer was strongly influenced by the ambient temperature, and the temperature of the center area of the bottom layer was taken to be the representative temperature for pathogen control as it was the minimum temperature in the reactor. Composting start-up performance was influenced by several factors when the ambient temperature was either below or above 20°C. When the ambient temperature was below 20°C, the time taken to reach 65°C (T ₆₅) was influenced by the temperature of inflowing air, but when the temperature was higher than 20°C, it was influenced by the ratio of sewage sludge to seed compost (F/S). T ₆₅ was least when F/S was 1–2. Received: January 9, 2001 / Accepted: October 10, 2001     

An optimal level of dust explosion risk management: Framework and application

The current research provides guidance on the prevention and mitigation of dust explosion using a Quantitative Risk Management Framework (QRMF). Using concepts drawn from previous studies, the framework consists of three main steps: (i) a new combined safety management protocol, (ii) the use of DESC (Dust Explosion Simulation Code) and FTA (Fault Tree Analysis) to assess explosion consequences and likelihood, respectively, and (iii) application of the hierarchy of controls (inherent, engineered and procedural safety). QRMF assessment of an industrial case study showed that the original process was at high risk. DESC simulations and Probit equations determined the destructive percentages. FTAs revealed high probabilities of explosion occurrence; in addition, detailed individual and societal risks calculations were made, before and after the framework was applied. Based on the hierarchy of controls technique, the framework showed significant risk reduction to the point where the residual risk was acceptable for the process.     

Strength and tightness evaluation method for pipe flange connections considering thermal effects

The pipe flange connection is widely applied in chemical, power plants, petrochemical, offshore oil and gas industries, and its strength and tightness are significant for the safe operation. However, there are still no practical and applicable strength and tightness evaluation methods for pipe flange connections working in dramatically varying temperatures. This paper proposed an approach to evaluate the pipeline's strength and sealing performance considering thermal effects in actual operating conditions by combining the experimental measurement and thermostructural analysis. The critical thermodynamic parameters are identified through measured temperature data in operating conditions, and then these parameters are used in the thermostructural analysis to obtain the actual temperature and stress fields. Then, the strength and tightness in complex temperature cases can be evaluated accurately. The pipe flange connection of a liquefied natural gas (LNG) fueling station is analyzed to verify the presented method's effectiveness. This method applies to evaluating the pipeline's strength and tightness and can predict the pipeline's performances under extreme temperatures using the tested data within the measurement range and the corresponding thermostructural analysis. Furthermore, the work in this paper also provides a reference for the design and analysis of pipe flange connections working in complex temperature conditions.     

围垦后南汇东滩海三棱藨草的空间分布及其影响因子研究

2015年9月~10月期间对2012年底围垦后南汇嘴区域的海三棱藨草(Scirpus mariqueter)湿地系统进行了调研,运用主成分分析、典范对应分析(canonical correspondence analysis,CCA)方法,基于101个样地土壤的有机碳、总磷、总氮、硝酸盐氮、亚硝酸盐氮、氨氮、正磷酸盐、pH、含水率、粒径、盐度、滩涂高程等12个环境因子数据,探讨了围垦后海三棱藨草空间分布的关键影响因子。结果表明:海三棱藨草的分布与滩涂高程具有显著正相关(P0.05),海三棱藨草群落主要分布在南汇滩涂2.5~3.4 m高程范围内;海三棱藨草的密度、盖度与盐度呈显著正相关(P0.05)。结论认为滩涂高程和土壤盐度是影响海三棱藨草分布的主要环境因子。未来需要结合围垦后的水动力变化过程数值模拟,对海三棱藨草生态系统高时空分辨率的响应过程及机制进行研究,以进一步确立海三棱藨草对围垦工程响应的关键阈值。研究对围垦工程后的滨海湿地植被恢复及滩涂生态修复具有参考意义。     

Influence of environmental factors on the response of a natural population of Daphnia magna (Crustacea: Cladocera) to spinosad and Bacillus thuringiensis israelensis in Mediterranean coastal wetlands

The present study was undertaken to assess the impact of a candidate mosquito larvicide, spinosad (8, 17 and 33 μg L⁻¹) on a field population of Daphnia magna under natural variations of water temperature and salinity, using Bti (0.16 and 0.50 μL L⁻¹) as the reference larvicide. Microcosms (125 L) were placed in a shallow temporary marsh where D. magna was naturally present. The peak of salinity observed during the 21-day observation period may have been partly responsible for the decrease of daphnid population density in all the microcosms. It is also probably responsible for the absence of recovery in the microcosms treated with spinosad which caused a sharp decrease of D. magna abundance within the first two days following treatment whereas Bti had no effect. These results suggest that it may be difficult for a field population of daphnids to cope simultaneously with natural (water salinity and temperature) and anthropogenic (larvicides) stressors.     

A study on emission of phthalate esters from plastic materials using a passive flux sampler

Phthalate esters are used as plasticizer in many plastics, and several studies have shown their toxicity. Phthalate esters are gradually emitted over time, and so it is conceivable that they pose a significant health risk. This study aims to investigate the temperature dependence of the emissions of various phthalate esters and to estimate the health risks of these emissions at various temperatures. A passive-type sampler was developed to measure the flux of phthalate esters from the surface of plastic materials. With this sampler, we examined three widely used plastic materials: synthetic leather, wallpaper and vinyl flooring. The observed maximum emissions of diethyl phthalate, dibutyl phthalate, and diethylhexyl phthalate (DEHP) from these materials at 20°C were 0.89, 0.77, and 14 μg m⁻² h⁻¹, respectively. Emissions at 80°C were 2.8, 4.5×10², and 1.5×10³ μg m⁻² h⁻¹, respectively. The results showed this temperature dependence is determined primarily by the type of phthalate ester and less so by the type of material. The estimation from the results of temperature dependence indicated the concentration of DEHP in a vehicle left out in the sunshine during the day can exceed the recommended levels of Japan Ministry of Health, Labour and Welfare.     

夏季海淀公园内PM2.5浓度水平梯度分布规律

于2014年夏季,通过观测海淀公园不同区域沿道路不同宽度处PM2.5浓度,研究PM2.5浓度日变化规律、水平梯度分布规律、净化效益及其影响因素。结果表明,海淀公园内PM2.5浓度日变化规律呈白天低晚上高的趋势,09：00-15：00时PM2.5浓度达到国家标准Ⅱ类功能区浓度质量要求,05：00时PM2.5浓度最高。不同观测区域一定宽度范围内出现PM2.5浓度积聚,之后开始下降。总体上,海淀公园在13：00时对PM2.5浓度净化效益最显著,09：00时净化效益最差。环城高速路区域与城市主干道区域165 m以上宽度处、城市次干道区域60 m以上宽度处为正净化效益,并维持正净化效益。海淀公园内PM2.5浓度与气象因子之间相关关系表明,PM2.5浓度与平均温度、相对湿度呈显著相关,与其他气象因素没有显著相关性。     

高效液相色谱法测定水中的六种邻苯二甲酸酯研究

建立了高效液相色谱法测定水中六种邻苯二甲酸酯(邻苯二甲酸二甲酯、邻笨二甲酸二乙酯、邻苯二甲酸二丁酯、邻苯二甲酸二(2-乙基己基)酯、邻苯二甲酸二辛酯、邻苯二甲酸丁基苄酯)的检测方法.对水样中邻苯二甲酸酯的萃取条件和高效液相色谱分析条件进行优化,采用正己烷二次萃取,浓缩定容后分析,以乙腈-水为流动相梯度洗脱,紫外检测波长226 nm,16 min可将六种邻苯二甲酸酯分离出.方法的检出限为0.13μg/L ～0.37 μg/L,加标回收率为78.6％～118.5％,相对标准偏差为0.82％～2.17％,是一种理想的测定水中六种邻苯二甲酸酯的方法.     

Characterization of the toxic effects of cadmium and 3.5-dichlorophenol on nitrifying activity and mortality in biologically activated sludge systems—effect of low temperature

Background, aims, and scope  Sometimes, urban wastewaters convey a more or less significant part of toxic products from industries or the craft industry. Nitrifying activity can be affected by these substances, implying higher ammonia concentrations in the outlet effluent and contributing to toxicity for the aquatic environment. Moreover, the more stringently treated wastewater standards now require a reliable treatment for nitrogen. One of the key issues is the identification of the inhibition behavior of nitrifying bacteria facing a toxic substance. This new understanding could then finally be integrated into models in order to represent and to optimize wastewater treatment plants (WWTP) operation in cases involving ‘toxic scenarios’. Materials and methods  The toxic substances studied in this work, cadmium and 3.5-dichlorophenol (3.5-DCP), are representative of chemical substances commonly found in municipal sewage and industrial effluents and symbolize two different contaminant groups. The effects of Cd and 3.5-DCP on nitrification kinetics have been investigated using respirometry techniques. Results  IC50 values determination gives concentrations of 3.1 mg/L for 3.5-DCP and 45.8 mg/L for Cd at 21 ± 1°C. The variation to low temperature seems to have no real effect on IC50 for DCP, but induces a decrease of cadmium IC50 to 27.5 mg/L at 14°C. Finally, specific respirometric tests have been carried out in order to determine the potential effect of these toxic substances on the nitrifying decay rate b _a . No significant effect has been noticed for Cd, whereas the presence of 3.5-DCP (at IC50 concentration) induced a dramatic increase of b _a at 20°C. The same behavior has been confirmed by experiments performed in winter periods with a sludge temperature around 12°C. Discussion  The target substances have different modes of action on activity and mortality, notably due to the abilities of the contaminant to be precipitated, accumulated, or even to be progressively degraded. Studies realized at low temperature confirmed this assumption, and put in evidence the effect of temperature on toxic substances capable of being biosorbed. However, the change in the sludge sample characteristics can be pointed out as a problem in the investigation of the temperature effect on nitrification inhibition, as biosorption, bioaccumulation, and predation are directly linked to the sludge characteristics (VSS concentration, temperature) and the plant operating conditions (loading rates, sludge age, etc.). Conclusions  This work brings new understandings concerning the action mode of these specific contaminants on nitrifying bacteria and, in particular, on the role of temperature. The experiments lead to the determination of the IC50 values for both toxic substances on biological nitrification. The inhibition mechanisms of Cd and 3.5-DCP on nitrifying activity have been simply represented by a non-competitive inhibition model. Recommendations and perspectives  Other experiments carried out in a continuous lab-scale pilot plant should be done with a proper control of the operating conditions and of the sludge characteristics in order to better understand the mechanisms of nitrification inhibition for each contaminant. Finally, these first results show that toxic substances can have an effect on the growth rate but also on the decay rate, depending on the characteristics of the toxic substance and the sludge. This eventual double effect would imply different strategies of WWTP operation according to the behavior of the contaminant on the bacteria.