旋转切向流聚丙烯管式膜微滤能耗分析

设计了一种新型旋转切向流聚丙烯管式膜器,实验研究了聚丙烯PA管式膜器的能耗通过建立的旋转切向流强化微滤实验装置系统,测定了聚丙烯PA管式膜器在旋转切向流和轴向流下的膜通量与能量有效利用率.实验结果表明,旋转切向流管式膜微滤比一般轴向流膜微滤的有效利用率要高得多,是一种非常有效的强化膜分离技术在实验条件下,直线切向流膜微滤和圆弧切向流膜微滤的稳态能量有效利用率比轴向流稳态能量有效利用率分别高11.185倍和14.591倍.     

洪水泥石流等自然灾害对旅游景区的破坏作用研究

通过泥石流灾害模拟模型与灾害损失率计算方法了解旅游景区的损失状况,研究自然灾害对旅游景区的破坏作用。旅游景区洪灾模拟模型由分流模型与汇流模型构成,根据泥石流多相流成分中固液两相分离原则构建泥石流分流模型;引用DEM数据得到泥石流流域栅格的汇流方向,根据经验模型计算汇流用时,采用八方向方法获取河道信息,基于这些数据构建泥石流模拟的汇流模型,采用ArcGis软件实时呈现该模型的泥石流灾害模拟效果;结合ArcGis软件显示的灾情数据,采用洪灾损失率计算方法获取旅游景区自然灾害损失率。实验结果表明,该模型计算旅游景区建筑损失率误差均小于5%,在有效模拟泥石流灾害的同时,可准确描述自然灾害对旅游景区的破坏作用。     

The deflectors influence on flow complexity,bed morphology,sediment transport and water quality of urban lotic waters - A laboratory study

In this laboratory study different combinations of bed (sand, pebble gravel [gravel], and a mix of sand and gravel) and flow (typical and overtopping) were experimented with to investigate the impact of porous deflectors in flow diversity, water quality, and fish performance in prismatic open channels. Deflectors changed the gradually varied flow to a rapidly varied flow, as a sudden change in the water depth was observed at the deflectors, and this change was large for smooth beds. With the presence of gravel, the scouring near the downstream deflector was almost twice that of the sand bed, and with the scouring at its own upstream deflector, irrespective of whether the flow was typical or overtopping. This behavior was a result of sand mobilization due to shear stress and sand mobilization aided gravel transport. The mixed bed showed less gravel movement compared to the gravel-only bed. The percentage of sediment washed out was minor for all bed scenarios, indicating that sediment transport was local. Relative to the sand bed without deflectors (representing a typical urban canal), deflectors resulted in reduced and improved water quality (in terms of sediment load) for sand, and mixed bed, respectively. The fishes found refuge and were comfortable in the pool areas created by deflectors unlike in channels without deflectors where they showed exhaustion.     

综合拉底、扩漏和出矿全过程的底部结构安全性颗粒流模拟技术研究

为探明自然崩落法从拉底崩落至出矿全过程中底部结构节理连续扩展过程与破坏过程规律，采用PFC2D软件，结合RocLab软件反演节理岩体参数，建立229 m×129 m的岩体扩大模型，对拉底崩落至出矿过程进行连续综合计算。研究结果表明:模拟结果及破坏现象与现场监测结果相近，建模与细观参数反演方法适用于该类岩体工程研究；裂纹扩展贯通导致岩体失稳破坏，破坏过程与裂纹扩展具有相对应的阶段特征，裂纹扩展分为崩落前稳定扩展期，崩落与聚矿槽开挖过程加速扩展期和后续持续扩展期；结构破坏分为蕴育过程，扰动失稳过程和宏观破坏过程；较大范围的宏观破坏主要在出矿阶段。该模拟方法与结果可为底部结构维护以及节理岩体长期稳定性研究提供参考。     

Dynamic pressure induced by a methane–air explosion in a coal mine

The hazardous effect of dynamic pressure and strong gas flows induced by a methane–air mixture explosion in underground coal mines is studied. The dynamic pressure effect of a methane–air explosion was analyzed by numerical simulation, in a duct and tunnel. Compared to the overpressure generated by an explosion that can act on a body, the dynamic pressure caused by the high-speed flow of the gaseous combustion products can cause serious damage as well. At the structural opening of a coal mine, the destruction caused by the dynamic pressure induced by a methane–air explosion is more serious than the overpressure. For a tube or tunnel partially filled by a methane–air mixture, the dynamic pressure is lower than the overpressure in the region occupied by the flammable mixture. Beyond the premixed region, the dynamic pressure is of the same order of magnitude as the overpressure.     

Alternative method to prevent thermal runaway in case of error on operating conditions continuous reactor

Thermal runaway was studied in a continuous tubular pilot reactor under steady-state regime. Different accident scenarii were conducted by making some errors on reactant concentrations and/or temperature feed. To prevent thermal runaway, control by direct contact by solvent injection was used at different reactor locations. This injection allowed controlling the maximum reaction temperature. A simplified analytical method to estimate the maximum reaction temperature along the reactor was used.Benefit of this control method was the diminution of computational time. Furthermore, by injecting solvent to control maximum reaction temperature, there is no need to shut down the unit. The control method was validated experimentally.     

基于层次分析法的热塑性聚氨酯及其纳米复合材料火灾危险性综合评价

聚合物的火灾危险性与热、烟、毒的释放密切相关,但采用不同指标对材料的评价结果不一致。以纳米级蒙脱土(MMT)、氢氧化铝(ATH)和聚磷酸铵(APP)为添加剂的热塑性聚氨酯(TPU)纳米复合材料为研究对象,选取其在静态管式炉、稳态管式炉和锥形量热仪中的相关实验数据,以HCN总浓度作为特殊毒性危害指标,CO和CO_2浓度为一般毒性危害指标,以热释放速率峰值、平均热释放速率、总热释放量为热危害指标,以产烟速率峰值、生烟总量为烟危害指标。进一步细分了火灾烟气中不同毒性气体对于火灾风险的影响,并运用层次分析法计算指标权重,综合评价了热塑性聚氨酯及其复合材料的火灾危险性。结果表明,当添加量为6 wt%聚磷酸铵、3 wt%氢氧化铝与3 wt%蒙脱土时,此时复合材料的火灾危险最低,证明了综合热、烟、毒三个层次来降低聚合物材料火灾危险性是可行的。     

双风机并联机站局阻特性研究

为探究双风机并联机站局部阻力特性、完善机站局部阻力及其系数的计算公式,以实际矿井通风机站为工程背景,在分析机站流场能量损失机理的基础上,采用物理模型实验和数值计算相结合的方法,分析了机站入口分流、出口汇流的断面速度不均匀程度与机站阻力损失的关系,同时对不同宽高比的矩形断面进行多工况模拟。结果表明:断面速度不均匀性越大,速度分布重组造成的阻力损失越大;确定了机站局阻计算所需参数的合理测定位置,得出机站局阻系数计算时的综合影响系数Kc随风机工况增大而增大、随断面宽高比A增大而减小,并呈现较好的线性关系。研究结果可为多级机站通风系统通风阻力特性分析以及工程优化设计提供参考。     

基于CFD-DEM的旋风除尘器内气固流动特性研究

为了研究旋风除尘器内气固流动特性,采用CFD-DEM耦合算法研究不同入口气体速度下旋风除尘器内颗粒流态、静压、径向速度及轴向速度分布特征。结果表明:煤屑颗粒在离心力和径向曳力的作用下以螺旋颗粒条带靠近除尘器的壁面稳定向下移动,随着入口风速的增加煤屑颗粒条带变宽,条带与除尘器的第1次接触的拐点上移,螺距减小;除尘器内部压力轴向变化较小,径向变化较大,随着入口气体速度增加,除尘器壁面附近高压区范围和压力也随之增加,除尘器上方和下方的负压区变宽并朝轴向方向延伸;随入口气体速度增加,除尘器内径向速度和轴向速度逐渐增加,煤屑颗粒在除尘器中部聚集较多,煤屑停留时间变长,入口气体速度为15 m/s时,煤屑颗粒在除尘器内停留时间最长。     

气固两相流90°弯管抗冲蚀结构优化

为了提高天然气输送管道90°弯管的耐磨性能,提出了1种三段弯曲式弯管,通过对弯管弯曲段进行三段式改进来减小弯管中二次流的大小,优化弯管内的流场,改善弯管的冲蚀磨损状况。利用COMSOL仿真软件建立三段式弯管模型,并以弯管弯曲段和出口段二次流平均值之和最小为优化目标,在约束条件下凭借COMSOL中的COBYLA优化算法得到了最优管形;用Fluent对优化后的三段式弯管进行冲蚀数值模拟并与一段式弯管的模拟结果进行对比分析。研究结果表明:与一段式90°弯管相比,优化后的三段式弯管流场更加平稳,其弯曲段的二次流强度大幅降低,弯管壁面的冲蚀磨损程度得到较大的改善。