脉冲袋式除尘器过滤风速的确定

过滤风速的选择是设计布袋除尘器的关键。本文在对工程应用中的脉冲袋式除尘器相关参数测定后,采用数学拟合法,得出了过滤风速与烟粉尘粒径的对数成正比、与废气含尘浓度和废气温度成反比的数学关系,并建立了具体的数学模型。     

厌氧氨氧化菌活性恢复及富集培养研究

为了防止微生物流失,向厌氧序批式反应器(ASBR)中投加纤维膜(无纺布)作为厌氧氨氧化菌的载体,而使ASBR改为厌氧序批式生物膜反应器(ASBBR),研究了厌氧氨氧化菌活性恢复及富集培养过程中氮负荷提高对ASBBR的影响。经过23d的培养,厌氧氨氧化菌的活性恢复到原有的水平,然后提高TN容积负荷培养厌氧氨氧化菌。至132d时,反应器TN容积去除负荷达到了2.060kg/(m3·d)。整个过程中NH4+-N和NO2--N去除率一直保持在98%以上。当厌氧氨氧化菌活性恢复后,NH4+-N、NO2--N消耗量与NO3--N生成量之比最终趋于一定值(1.00∶1.30∶0.25)。在培养过程中,污泥颜色逐渐由灰色变为红棕色,最终变为浅红色。结果表明,反应器运行很稳定,NH4+-N、NO2--N出水浓度非常低,在短时间内能提高到较高的容积去除负荷。可见,ASBBR很适合厌氧氨氧化菌的富集培养。     

低温等离子体技术降解含氮硫废气的研究进展

论述了采用低温等离子体技术处理含氮硫废气以及恶臭气体的反应机理和研究现状,重点介绍了低温等离子体技术与催化、吸附、光催化等技术的联合技术,分析了低温等离子体联合技术存在的问题及发展方向。     

Phenol depletion by thermally activated peroxydisulfate at 70°C

The ability of thermal activated peroxydisulfate (PS) of mineralizing phenol at 70 °C from contaminated waters is investigated. Phenol in concentrations of 10⁻⁴ to 5 × 10⁻⁴ M is quantitatively depleted by 5 × 10⁻³ to 10⁻² M activated PS in 15 min of reaction. However, mineralization of the organic carbon is not observed. Instead, an insoluble phenol polymer-type product is formed. A reaction mechanism including the formation of phenoxyl radicals and validated by computer simulations is proposed. High molecular weight phenolic products are formed by phenoxyl radical H-abstraction reactions. This is not the case for the room temperature degradation of phenol by sulfate radicals where sulfate addition to the aromatic ring mainly leads to the generation of hydroxycyclohexadienyl radicals leading to hydroxybenzenes and oxidized open chain products. Therefore, a change in the reaction mechanism is observed with increasing temperature, and thermal activation of PS at 70 °C does not lead to the mineralization of phenol. Thus PS activation at 70 °C may be considered a potential method to reduce the load of phenol in polluted waters by polymerization.     

Structure and thermal stability of toxic chromium(VI) species doped onto TiO2 powders through heat treatment

Chromium(VI)-containing sorbents in the form of sludge or solid residue from treatment processes are often landfilled or used as fill materials, therefore the long-term stability of metal binding is important. The reduction of Cr(VI)–Cr(III) through heat treatment may be a useful detoxification method. After heating at 500, 900, 1000, and 1100 °C for 4 h, the transformation of chemical states of chromium on 105 °C-dried, 7.9% Cr(VI)-doped TiO₂ powders was studied on the basis of surface area measurements, scanning electron microscopy (SEM) images, X-ray diffraction (XRD), and extended X-ray absorption fine structure (EXAFS) spectra. It was shown that Cr(VI) was reduced to Cr(III) in the Cr(VI)-doped samples after heating within 500–900 °C. The present results also suggested that the chromium octahedral was bridged to the titanium tetrahedral and was incorporated in TiO₂ minerals formed after 1000 °C treatment.     

Acid generation upon thermal concentration of natural water: The critical water content and the effects of ionic composition

Thermal evaporation of a variety of simulated pore waters from the region of Yucca Mountain, Nevada, produced acidic liquids and gases during the final stages of evaporation. Several simulated pore waters were prepared and then thermally distilled in order to collect and analyze fractions of the evolved vapor. In some cases, distillates collected towards the end of the distillation were highly acidic; in other cases the pH of the distillate remained comparatively unchanged during the course of the distillation. The results suggest that the pH values of the later fractions are determined by the initial composition of the water. Acid production stems from the hydrolysis of magnesium ions, especially at near dryness. Near the end of the distillation, magnesium nitrate and magnesium chloride begin to lose water of hydration, greatly accelerating their thermal decomposition to form acid. Acid formation is promoted further when precipitated calcium carbonate is removed. Specifically, calcium chloride-rich pore waters containing moderate (10–20 ppm) levels of magnesium and nitrate and low levels of bicarbonate produced mixtures of nitric and hydrochloric acid, resulting in a precipitous drop in pH to values of 1 or lower after about 95% of the original volume was distilled. Waters with either low or moderate magnesium content coupled with high levels of bicarbonate produced slightly basic fractions (pH 7–9). If calcium was present in excess of bicarbonate, waters containing moderate levels of magnesium produced acid even in the presence of bicarbonate, due to the precipitation of calcium carbonate. Other salts such as halite and anhydrite promote the segregation of acidic vapors from residual basic solids. The concomitant release of wet acid gas has implications for the integrity of the alloys under consideration for containers at the Yucca Mountain nuclear waste repository. Condensed acid gases at very low pH, especially mixtures of nitric and hydrochloric acid, are capable of corroding even alloys, such as nickel-based Alloy 22, which are considered to be corrosion-resistant under milder conditions.     

电袋复合除尘器的应用研究

针对我国燃煤电厂的除尘现状,指出电袋复合除尘器的技术经济优势.电袋复合除尘器在新建及改扩建电厂的成功应用取得了良好的经济、环境效益,并有广阔的发展前景.其研究重点是静电除尘单元和布袋除尘单元之间的结合.     

废钢铁切割加工烟尘的治理

介绍了氧-乙炔火焰切割加工废钢铁产生的烟尘治理系统的设计和系统设备选型,重点介绍了烟尘捕集罩的设计和除尘器、电磁脉冲阀、风机的选型和PLC自动控制以及系统实际运行效果,为废钢铁加工企业治理污染提供一套简单、经济、实用的除尘系统作参考.     

战时火力发电厂重要目标分类防护探讨

基于重要目标防护准则和模糊聚类算法,构建火力发电厂目标评价准则指标体系和模糊聚类模型,实现了火力发电厂重要目标的分类防护,进而选用具有针对性的防护措施,解决了重要目标在战时防护措施选择不完善、不合理的问题,有效地提升了战时火力发电厂的生存能力;通过模糊聚类模型实现分类防护,不仅有利于提高重要目标防护效率,而且使得防护资源少、力量弱,供需突出的问题得以改善,同时,在应对自然灾害等重大突发事件发生时,有助于保护发电厂的生产能力。通过案例给出战时某火力发电厂的具体防护措施,合理地解决了发电厂重要目标和关键部位的防护问题。     

我国煤矿劳动防护用品使用现状调查分析及对策研究

劳动防护用品是保障从业人员安全与健康的最后一道防线.本文在对全国部分重点产煤省份煤矿劳动防护用品现场调研的基础上,分析了不同类型煤矿劳动防护用品的现状及存在的问题,提出了进一步做好煤矿劳动防护用品管理工作的对策.