最优安全文明施工措施费费率计取模型的构建与应用

建筑工程建设周期长、施工环境复杂、可变因素多,是一项安全系数低的系统工程,其安全文明施工措施费计取费率的合理性直接影响到建筑安全生产水平。首先建立万人死亡率与安全文明施工措施费基本费率的函数关系,并结合建筑施工安全的社会总成本函数,构建最优安全文明施工措施费费率的非线性计取模型;然后以江苏省安全文明施工措施费为例应用该模型,经过优化后的江苏省措施费的基本费费率为2．33％,现场考评费率为1．28％,奖励费率为0．47％-0．82％;最后得出目前江苏省安全文明施工措施费费率较低,同时也证明该模型是有效可行的。     

温拌阻燃沥青混合料阻燃效果评价

通过氧指数、质量损失率及路用性能试验,研究EC130温拌剂、FRMAX型阻燃剂对沥青混合料阻燃效果的影响。试验结果显示,相比普通沥青混合料,阻燃沥青混合料、温拌阻燃沥青混合料氧指数分别增加23.3%、25.6%,质量损失率减小28.0%、32.0%,残留动稳定度增加14.0%、16.1%,残留最大弯拉应变增加14.1%、17.1%,冻融劈裂强度比增加5.3%、9.0%。相比普通沥青路面,阻燃沥青路面、温拌阻燃沥青路面发生火灾时能够减少34.0%、41.1%的毒害气体生成,并减少路面修补所需的混合料质量。其次得出普通沥青路面、阻燃沥青路面及温拌阻燃沥青路面的质量损失率、残留动稳定度、残留最大弯拉应变、残留冻融劈裂强度比与燃烧时间的关系模型。结果表明:阻燃剂对沥青混合料的阻燃效果显著;温拌剂有助于阻燃剂更好地发挥阻燃作用,降低火灾对道路的破坏,降低隧道火灾发生时有害气体的生成,提升隧道安全性。     

莠去津降解菌HB-5的最佳产酶培养基及发酵条件

从农药厂废水中分离到一株降解莠去滓的节杆菌(Arthrobacter sp.)HB-5,以从该菌中提取到的降解酶对莠去津的降解率为指标,进行最佳产酶培养基及发酵条件的优化研究,对其产酶量进行了评价.通过正交试验和均匀试验,对细菌HB-5的发酵培养基进行了优化研究.运用SAS软件进行结果分析,所获优化培养基配方为:蔗糖3.0g·L-1,莠去津0.38g·L-1,K2HPO40.5g·L-1,KH2PO41.2 g·L-1,MgSO4·7H2O 1.2g·L-1,NaCl 0.1g·L-1,微量元素溶液3.8mL·L-1.得到菌株培养的最佳优化条件为:菌株发酵液培养时间为48h.接种量为2%,发酵液初始pH值为9,250mL三角瓶中装液量为80mL经优化后,降解酶对莠去津的降解率(91.64%)比原培养基(40.67%)提高了125%.     

沼泽湿地植物光合特性及固“碳”潜势对外源氮输入的响应

以沼泽湿地典型草甸植被小叶章(Calamagrostis angustifolia)为研究对象,在三江平原进行了野外培养实验,探讨了4个不同氮素输入水平(0(NO)、6(N6),12(N12)、24(N24)g·m-2· a-1)下沼泽湿地植物生长与光合特性的响应特征,并从光合固"碳"的角度分析了小叶章沼泽湿地的固"碳"潜势.结果表明,外源氮输入明显促进了小叶章的株高、叶面积及植株数,显著增加了碳的生物量积累,到植物生长季结束,N6、N12和N24三个施氮水平下,小叶章地上部分生物量分别比对照增加了58.79%、133.11%和190.55%.同时,小叶章叶片全氮含量、叶绿素、可溶性蛋白和游离氨基酸含量也显著增加,净光合速率明显提高,分别比对照增加了20.70%、26.69%和53.54%.从光合固"碳"的角度来看,外源氮输入能够促使沼泽湿地植物通过光合作用固定更多CO2.     

从粉煤灰中提取多种微细氧化物的研究

将粉煤灰与Na2CO3按一定的比例混合后焙烧,采用酸碱联合法提取粉煤灰中氧化硅、氧化铝和氧化铁,分析了工艺条件对粉煤灰中氧化物提取率的影响。实验结果表明,从粉煤灰中提取氧化物的最佳条件是:碳酸钠与粉煤灰的比例0.6∶1.0,焙烧温度850℃、盐酸浓度4 mol/L,氢氧化钠浓度2.6 mol/L,浸取时间约6 h。在此条件下得出微细氧化硅、氧化铝、氧化铁的晶体,其平均粒度分别为氧化硅1.107μm,氧化铝1.334μm,氧化铁0.783μm。     

AB工艺污水厂A段不同溶解氧运行效果

对AB工艺城市污水处理厂A段不同溶解氧工况下的实际运行效果进行了监测分析。结果表明:A段按设计参数兼氧运行对BOD5、COD、SS的去除率最高,平均分别达到59.4%、77.2%、73.2%;总氮的去除率随A段溶解氧含量影响不大,平均为46.8%;总磷的去除率随溶解氧含量的增大而升高,最高可达80.2%。     

燃煤电厂烟气脱硫设施脱硫效率计算方法的探讨

为准确评估燃煤电厂脱硫设施在实际运用中的脱硫效率,根据目前脱硫效率的三种计算方法在实际运用中的问题,并应用燃煤电厂的实测数据,对比了三种方法计算得出脱硫效率的相对误差。结果表明：根据折算浓度评估脱硫效率,综合考虑了烟气泄漏对计算脱硫效率的影响,并且不受烟气旁路排放等因素影响,理论上和实践中都可以得到准确的脱硫效率。     

芳香有机物电化学氧化降解的研究

为了考察物质结构对难生物降解芳香化合物电催化氧化的影响,实验研究了典型的酚类和胺类芳香污染物的电化学氧化降解。结果表明:电催化氧化技术可有效处理水中的芳香化合物,苯环上取代基对有机物的电催化降解活性有很大影响,带有供电子取代基团的芳香化合物的电催化降解速率比带有吸电子取代基团的芳香化合物的电催化降解速率快。处理2 h,苯酚、苯胺和甲苯胺接近完全去除,对氯苯酚和对氯苯胺的去除率超过90%,对硝基苯酚和2,4-二氯酚的去除率也达到70%左右。     

Organically bound tritium (OBT) for various plants in the vicinity of a continuous atmospheric tritium release

In order to quantify tritium impact on the environmental, we studied vegetation continuously exposed to a tritiated atmosphere. We chose lichens as bio-indicators, trees for determination of past tritium releases of the Valduc Centre, and lettuce as edible vegetables for dose calculation regarding neighbourhood. The Pasquill and Doury models from the literature were tested to estimate tritium concentration in the air around vegetable for distance from the release point less than 500m. The results in tree rings show that organically bound tritium (OBT) concentration was strongly correlated with tritium releases. Using the GASCON model, the modelled variation of OBT concentration with distance was correlated with the measurements. Although lichens are recognized as bio-indicators, our experiments show that they were not convenient for environmental surveys because their age is not definitive. Thus, tritium integration time cannot be precisely determined. Furthermore, their biological metabolism is not well known and tritium concentration appears to be largely dependent on species. An average conversion rate of HTO to OBT was determined for lettuce of about 0.20-0.24%h(-1). Nevertheless, even if it is equivalent to values already published in the literature for other vegetation, we have shown that this conversion rate, established by weekly samples, varies by a factor of 10 during the different stages of lettuce development, and that its variation is linked to the biomass derivative.     

Effect of bioethanol and thermal barrier coating on the performance of dual fuel engine operating on Honge oil methyl ester (HOME) and producer gas induction

Alternative fuels have numerous advantages compared to fossil fuels as they are renewable, biodegradable; provide energy security and foreign exchange saving besides addressing environmental concerns and socio-economic issues as well. Renewable fuels can be used predominantly as fuel for both transportation and power generation applications. Improved engine performance with reduced engine exhaust emissions is a major research objective in engine development. Today, the use of biomass derived producer gas is more relevant for addressing rural power generation and is a promising technique for controlling both nitric oxide (NO_x) and soot emission levels. In view of this, exhaustive experiments on the use of Honge oil methyl ester (HOME)–Producer gas in a dual fuel engine have been carried out with an intension of improving its fuel efficiency. This paper mainly presents results on a single cylinder four stroke direct injection diesel engine operated in dual fuel mode using HOME–Producer gas combination with and without bio-ethanol addition and thermal barrier coating (TBC). Further, the results were compared with diesel–producer gas mode of operation. Experimental investigation on dual fuel operation using HOME+5% bioethanol (BE5)–Producer gas operation with TBC showed 12.35% increased brake thermal efficiency with decreased hydrocarbon and carbon monoxide emissions and increased NO_x emission levels compared to HOME–Producer gas mode of operation.