双壳类壳体时间序列的建立方法及存在的问题

利用双壳类壳体提取古气候古环境信息是生物碳酸盐研究的热点,而壳体定年一直是研究中的难点。相关研究主要观点是先找到一些时间控制点,再按照线性内插法来确定壳体的时间序列。本文综述了国内外目前双壳类壳体定年的常用方法,根据时间控制点的获得将这些方法归为以下几类:壳体日生长层法、壳体氧同位素法、数字图像技术法和微量元素法,介绍并讨论了每种方法的应用和存在的不足。研究者应该根据具体研究的生物和环境选择适合的方法。     

氧化沟中微孔曝气器的技术特性分析

曝气设备是氧化沟污水处理系统中最主要的设备,本文分析了微孔曝气的技术性能,及其在氧化沟中的特性分析和工程应用。     

络合-超滤耦合工艺去除水中镍离子的研究

以聚丙烯酸钠(PAANa)和聚乙烯亚胺(PEI)作为络合剂,将其与镍离子络合后的溶液转移至超滤杯中,在0.1 MPa压力下通过聚醚砜超滤膜进行分离,研究pH值和络合剂/Ni2+装载质量比(L)对Ni2+去除率的影响,并根据朗缪尔等温模型拟合络合反应平衡常数.同时研究超滤时间对膜通量和Ni2+去除率的影响.结果表明,选用PAANa为络合剂,在pH值为8、L=5时,Ni2+的去除率达到最大值99.5%.PEI为络合剂时,Ni2+去除率在pH值为7、L为5时达到最大值93.0%.不同pH值条件下拟合得到的络合平衡常数表明,pH为7时最有利于络合反应.另外,单个络合剂单体所能结合的Ni2+个数随着pH值的升高而增大.研究结果还表明,在长达12 h的超滤时间内,PAANa为络合剂时,膜通量的衰减<10%;PEI为络合剂时,膜通量基本保持不变;Ni2+的去除率都基本保持恒定.因此,在合适条件下,络合-超滤耦合工艺能有效去除水中的镍离子.     

西安市再生水利用存在问题及预测分析研究

污水作为一种稳定可靠、再生利用的水资源,经深度处理后可用作工业冷却水、城市杂用水、河流景观补充水及农业灌溉等方面。合理开发和利用再生水是解决水资源缺乏的有效途径。本文通过深入调查、分析西安市再生水利用现状,找出再生水利用率低的原因,提出针对性措施,并对防治对策进行定量分析,预测2015年西安市“污水再生利用率”为30．6％,可达到20％的国家考核要求。     

降膜法脱氨氮的技术可行性及影响因素浅析

对煤气化废水的特性和处理现状进行了阐述和分析,总结了降膜技术在煤气化高氨氮废水中的脱氮效果和液泛气速、膜厚、pH值、温度的关系。研究表明,降膜技术可将氨氮去除率提高到95%以上,同时降低调整pH值的药剂成本,并有效缓解结垢现象,在类似工业废水处理项目中具有较好的推广应用价值。     

奥克托今在丙酮中的热安全性研究

奥克托今(HMX)作为爆速高和耐热性好的炸药被广泛应用,其制备提纯工艺均在丙酮中进行。为研究HMX在丙酮中的热安全性,用差示扫描量热-热重(DSC-TG)同步热分析仪研究HMX的热分解过程。测得升温速率为5,10,15,20℃/min的DSC和热重-微商热重法(TG-DTG)曲线,并得出分解峰温分别为279.8,282.5,284.5和288.8℃。用自行设计的临界爆温测试装置,通过小容量法测定HMX、丙酮以及HMX的丙酮溶液的临界爆炸温度。结果表明,在试验条件下,HMX的丙酮溶液的临界爆炸温度高于纯HMX的临界爆炸温度,说明丙酮抑制了HMX的热分解反应,当HMX溶液质量分数为10%时,临界爆炸温度最高,热安全性最好。     

4种硝酸酯热安定性的绝热试验研究

利用绝热加速量热仪(ARC)对硝酸正丙酯(NPN)、硝酸异丙酯(IPN)、太根(TEGDN)、敌根(DEGDN)4种硝酸酯的热稳定性进行了绝热试验研究,得到绝热放热曲线和热分解特征参数。分析了4种物质分解过程的特点,对测试结果进行了修正。计算得到动力学参数和自加速分解温度SADT,以此作为评估热安定性的判据。结果表明,4种硝酸酯在外界热作用下容易发生分解,反应速度较快,伴随明显的热效应和压力效应。4种硝酸酯的热安定性由好到差排序为:IPN、NPN、TEGDN、DEGDN。     

The relationship between oxygen consumption rate and temperature during coal spontaneous combustion

Spontaneous combustion is a major natural disaster in coal production. In the process of exploring coal self-ignition, a series of hypotheses have been put forward, most scholars agree that the current coal-oxygen compound theory. Oxygen consumption rate reflects the status of coal spontaneous combustion, and it is also one of the parameters necessary for numerical simulation of coal spontaneous combustion. In this paper, a coal heating and oxidation experiment was designed, Experimental device consists of heating and oxidation furnace, gas chromatograph, temperature control and data acquisition systems and other equipment components. Three coal samples whose weight each is 5 g were selected for the study. By experiment, oxygen concentration at the inlet and outlet of temperature oxidation furnace was measured. Oxygen consumption rate is calculated in the heating process of coal according to air flow. In the Cartesian coordinate system, the temperature as abscissa and the oxygen consumption rate for the longitudinal coordinates, drawing the relationship between oxygen consumption rate and temperature plot. And then regression analysis was used to analyze the relationship between oxygen consumption rate and coal temperature during the heating and oxidation process of coal. The results show that the oxygen consumption rate and temperature of coal were linear relationships both before and after the critical temperature when the coal temperature is less than 180 °C. Before the critical temperature oxygen consumption rate is low, however it increases rapidly when coal temperature reaches a critical temperature. The result is important for the prevention and treatment of spontaneous combustion of coal.     

相对速率法测氯原子与一系列低碳醇的反应速率常数

在 2 92± 1K温度和 1 0 1× 10 5Pa压力下 ,以丙烷为参照物 ,采用相对速率方法测定了一系列醇与氯原子在气相中的反应速率常数 ,这些醇与氯的反应速率常数分别为 (单位 :10 7m3·mol-1·s-1) :甲醇k1=3 2 9,乙醇k2 =6 14,正丙醇k3=8 97,异丙醇k4 =4 0 0 ,正丁醇k5=11 7,异丁醇k6=12 5 ,叔丁醇k7=2 0 5 ,正戊醇k8=15 8,异戊醇k9=12 3     

Oxidation inhibition of sulfite in dual alkali FGD system

A laboratory-scale well-mixed thermostatic reactor with continuously blasting air was used to investigate the oxidation inhibition of sulfite in dual alkali flue gas desulfurization （FGD） system. The effects of operating parameters such as pH value and catalyst concentration on the oxidation were studied. Sodium thiosulfate was used in the system, and was found that it significantly inhabited the sulfite oxidation. In the absence of catalyst, sodium thiosulfate at 12.67 mmol/L had an inhibition efficiency of approximately 98%. While in the presence of catalyst, sodium thiosulfate at 26.72 mmol/L had an inhibition efficiency less than 85.0%. The oxidation reaction order of sulfite in the sodium thiosulfate was determined to be -1.90 and 4）.55 in the absence and presence of the catalyst, respectively. Apparent activation energy of oxidation inhibition was calculated to be 53.9 kJ/mol. Pilot tests showed that the consumption rate of thiosulfate agreed well with the laboratory-scale experimental results.