碳纤维混凝土的耐火性能试验测试与分析*

为研究不同碳纤维体积掺量（0,0.2%,0.6%,1%,1.5%,2%）对混凝土耐火性能的影响,考察不同温度环境下（20,60,100,300,500,800 ℃）的混凝土质量损失率与抗压强度损失率的变化情况;分析高温环境下混凝土的静置时间（0,1,3,7,12 h）对混凝土抗压强度损失率的影响。结果表明:随着碳纤维掺量的增加,混凝土质量损失率与抗压强度损失率呈现先下降后增加的趋势,其纤维掺量的拐点为1%;随着环境温度的上升,纤维混凝土的质量损失率与抗压强度损失率逐渐增加,并呈非线性增长趋势。随着静置时间的增加,混凝土抗压强度损失率逐渐增加,且呈非线性增长趋势。     

空气扰动对净化器去除香烟源颗粒物性能的影响

空气净化器可有效改善雾霾天气下室内空气质量,颗粒物去除效果与洁净空气量(CADR)是衡量其性能的主要参数。在典型室内环境下,以香烟源颗粒物为目标,开展空气扰动对净化器去除颗粒物效果和CADR的影响实验与评价分析。结果显示,在室内空气扰动下,净化器对粒径≥5μm的颗粒物去除率为75.6%,在无空气扰动情况下的去除率为46.6%。空气净化器对粒径0.3μm^5μm的颗粒物有较好的去除效果,而对于粒径10μm的较大颗粒物,空气扰动造成CADR增加。空气扰动在一定程度上提升了空气净化器的净化能力,同时在性能方面也存在影响。     

Thermal hazard analysis of 1-((cyano-1-methylethyl) azo) formamide and effect of incompatible substances on its thermal decomposition

1-((cyano-1-methylethyl) azo) formamide (CABN) is an azo compound that exhibits high thermal sensitivity and self-reactivity. Because of incorrect operation, incompatible substances and other dangerous conditions, thermal explosion accidents may occur during the manufacturing, storage, and transportation of CABN. The pyrolysis characteristics of CABN and its mixture for various heating rates were assessed using differential scanning calorimetry. The results showed that incompatible substances increased the risk of CABN. Moreover, the thermal runaway of CABN under an adiabatic condition was studied using an adiabatic rate calorimeter to obtain the parameters under adiabatic condition. Based on the experimental data, the kinetic parameters of CABN and its mixtures were obtained. In addition, a thermal decomposition kinetic model of CABN was created using Thermal Safety Series. All experiments have shown that the conditions and parameters of CABN must be strictly controlled.     

多传感器耦合区域火灾报警技术研究

早期预警与低误报率一直是建筑火灾探测面临的挑战与难题。已有研究多针对特殊场所特定燃烧产物或多种传感器耦合,普适性不强,探测设备成本高,无法大规模应用。通过将火灾烟气蔓延规律与探测器信号时空分布融合,在不增加探测器数量和分布的情况下,提出了一种基于建筑结构微元的多传感器耦合区域火灾报警模型。对典型火灾场景的烟气蔓延情况进行了模拟分析,狭长结构中探测器信号强度变化具有一定的规律性。应用区域火灾报警模型后,报警时间较传统模式提前了14.7%,基本杜绝了单个探测器误报引发建筑物火灾报警的问题。结果表明:多传感器耦合探测模式显著缩短了火灾报警时间,降低了火灾探测误报率,实现了火灾的早期准确识别与预警。     

风电机舱内典型混合液态油品热诱导燃烧特性

为探究不同尺寸方形油盘对双馈异步风力发电机组机舱中典型混合油品燃烧特性的影响,自主设计和搭建了热平板诱导油品加热燃烧测定实验系统。将液压油(CALTEXRANDO HDZ32)和齿轮箱油(CALTEXMEROPA320)按1∶1质量(各40.0g)比例均匀混合后,盛装于横截面尺寸分别为6.5cm×6.5cm、10.0cm×10.0cm、13.5cm×13.5cm 的钢制油盘中,利用热平板加热和诱导盘内同样质量混合油品燃烧,利用摄像机记录其燃烧行为和阶段节点时间,利用热电偶树、温度采集模块对油品燃烧对应阶段节点液内和上方火焰中心轴温度分布进行测定。观察发现,液/齿混合油品在加热后出现液内流动、蒸发、冒泡、气化、燃烧、发烟、火焰蹿高等典型传热传质和液相燃烧现象。实验结果表明,随油盘横截面尺寸递增,混合油品着火时间依次缩短(最高1048.0s),燃烧持续时间依次递减(最高1980.0s),燃烧液内最高温度依次升高(最高564.3 ℃),中心轴第一层火焰熄灭温度依次升高(最高489.2 ℃)。小尺寸油盘内油品交流换热过程缓慢,质量损失速率较低,着火前阶段出现最大质量损失速率(0.041g/s);中大尺寸油盘内对流、传质和传热过程明显增强,质量损失速率较高,火焰蹿高节点时出现最大质量损失速率(0.25g/s和0.29g/s)     

Hazard analysis on LPG fireball of road tanker BLEVE based on CFD simulation

In order to research the hydrocarbon fireball characteristic of LPG tanker Boiled Liquid Evaporate Vapor Explosion (BLEVE) under different conditions, computational fluid dynamics (CFD) simulations of the hydrocarbon fireballs from the LPG tanker BLEVE accidents were carried out. Several new different factors, such as the mass of fuel, inlet velocity and airflow velocity, were considered to analyze the influence on the evolution of the characteristics of the fireball and the development of the LPG tanker BLEVE accidents. Results indicate that the fireball with a greater mass of fuel radiates more heat but slower. The large longitudinal diameter of the fireball and high radiation heat flux are observed in case of a faster inlet velocity used for the same mass. The airflow was found to shorten the initial phase of the fireball effectively. Some suggestions were proposed to prevent the LPG BLEVE accidents. Analysis performed show that various parameters like fireball diameter, radiative heat flux and lifting speed of fireball can be predicted well using FDS code.     

中草药复合诱食剂对锦鲤的生长影响

选用80尾初始体长4.7cm左右、体色均一健康的锦鲤,随机分为4个组。其中,Ⅰ为对照组,饲喂基础饲料;Ⅱ、Ⅲ、Ⅳ为实验组,分别在基础饲料中添加100mL/kg、150mL/kg、200mL/kg的中草药复方。研究一副中草药复方对锦鲤诱食活性的影响,记录试验数据,并用Excel和SPSS软件进行分析。饲喂15d的结果表明,本实验所用该副中草药复方对锦鲤具有诱食反应。其中,Ⅱ组P=0.0010〈0.05、Ⅲ组P=0.0042〈0.05、Ⅳ组P=0.016〈0.05,说明其诱食效果有显著意义。不同浓度的中草药复方对锦鲤生长效果的影响差异很大,其中Ⅲ对锦鲤有显著的促生长作用。与对照组相比,增重率提高了23.090%,饵料系数降低了0.459。     

高效聚磷菌的选育及其特性研究

从鱼塘底部污泥中分离驯化得到一株高效聚磷菌株P5,采用厌氧/好氧(A/O)方式培养,在厌氧阶段3 h的最大释磷量为17 mg/L;在好氧条件下培养16 h后,P5对总磷(PO43--P)浓度为10~30 mg/L的模拟废水的除磷率均可保持在90%,COD的去除率达到82.1%。染色实验表明,P5是革兰氏阴性球杆菌,菌体内含有异染颗粒。     

催化臭氧氧化染料溶液的研究

采用催化臭氧化技术降解染料废水,以甲基紫溶液为目标污染物,研究了过渡型金属离子的类型,Fe2+的浓度,溶液初始pH值,染料浓度和正丁醇等因素对其降解率的影响。实验结果表明:臭氧氧化甲基紫溶液的过程中,加入一定浓度的过渡型金属离子对甲基紫的去除具有促进作用;当臭氧浓度为16 mg/L,一定浓度范围内,Fe2+催化臭氧化的效果随着浓度的增加而增加,但Fe2+浓度为13 mg/L时,甲基紫的降解率下降;在酸性范围时,pH值增大其降解率会减小;染料浓度增加,甲基紫的降解率减小,但是其绝对降解值会增加;正丁醇的加入抑制氧化反应的进行,甲基紫的降解率下降,说明催化臭氧化过程中有羟基自由基产生。染料降解过程符合一级反应动力学规律。     

Toward maximizing the recycling rate in a Sapporo waste plastics liquefaction plant

Sapporo Plastics Recycling Co., Ltd., (SPR) started its commercial operation of waste plastics liquefaction in 2000. At first only hydrocarbon oil was reclaimed, this being derived from the waste plastics liquefaction process under the Japanese Containers and Packaging Recycling Law. Presently, thermal degradation residue and hydrochloric acid are being produced as by-products in addition to the hydrocarbon oil. As a result, the SPR plastics liquefaction plant has achieved a high reclamation rate of 96%, and 93% of the recycled products have been reused in Hokkaido, where SPR is located. The technical problems caused by corrosion and clogging have been solved. Chemical Feedstock Recycling & Other Innovative Recycling Techniques 6