X射线底片缺陷特征提取与分析

1 现有X射线成像的处理手段 射线成像检测有两种方式：一种是以胶片形式存贮的离线检测．例如：在锅炉压力容器检测中大量使用的X光照片。拍摄好的底片图像放在扫描仪中．通过图像扫描仪把底片图像扫描数字化成为数字图像，送入到计算机内，由计算机对数字图像进行调整、滤波、增强、压缩和识别等处理．改善图像的清晰度，通过人机对话对底片图像缺陷进行评估．     

起重机吊钩的检查与报废

吊钩是超重机的重要承载构件。由于经常吊挂重物，很容易磨损，所以它也是一个易损构件。因此，使用单位必须经常检查吊钩的使用状况。吊钩的全面检查周期一般不应超过1年。如有条件可进行磁粉探伤，检查吊钩是否出现裂纹。     

UV/Fenton反应对直接黑38的脱色与矿化

为了研究过程参数对photo-Fenton法降解偶氮染料直接黑38人工废水的影响,进行了实验室规模的UV/Fenton反应光催化降解染料直接黑38的研究。在一定的时间段内检测水溶液直接黑38的UV吸光度、总有机碳(TOC)浓度的变化,确定了直接黑38废水的降解速度。以单因素实验方法确定了pH值、[Fe2+]、[H2O2]比例及其初始浓度对降解速度的影响。实验结果表明,在pH为3,染料浓度为30mg/L,[Fe2+]/[H2O2]比例1:100,[Fe2+]=0.12mmol/L,[H2O2]=12mmol/L条件下,UV/Fenton方法能在50min内使染料脱色率达90%,使TOC的去除率达到57%。实验证明了photo-Fenton法对于含有偶氮染料废水的脱色与矿化具有很好的应用前景。     

煅烧结合光辐照提高纳米AgI/TiO2的可见光响应

为提高AgI/TiO₂的可见光响应能力,采用煅烧结合光辐照的工艺对其进行改性.紫外-可见光吸收分析表明,改性AgI/TiO₂的敏感光谱范围覆盖了整个可见区,吸收边带从465 nm红移至800 nm,在500 nm处的吸光度提高了近3倍.X-射线衍射分析结果指出,煅烧提高了金红石型TiO₂的相对含量,导致禁带宽度从2.89 eV降到2.81 eV,氙灯辐照进一步增加了锐钛型TiO₂、金红石型TiO₂和AgI的相对含量,并生成了新的晶体AgCl,使其禁带宽度又降至1.55 eV左右.AgCl的产生、AgI和金红石型TiO₂相对含量的增加是降低改性材料禁带宽度和增强可见光响应能力的主要原因.研究还表明,只有煅烧后的AgI/TiO₂才能通过光辐照来拓宽可见光敏感范围,而且,光辐照中起作用的主要是紫外光,可见光的作用甚小.研究最后提出将2种或2种以上的卤化银负载在纳米TiO₂上,更能有效地增强TiO₂的可见光响应能力.     

Seasonal features of aerosol particles recorded in snow from Mt. Qomolangma （Everest） and their environmental implications

To assess the seasonality of aerosol deposition and anthropogenic effects on central Himalayas, a 1.85-m deep snow pit was dug on the northern slope of Mr. Qomolangma (Everest). Based on the morphology and energy dispersive X-ray (EDX) signal, totally 1500 particles were classed into 7 groups: soot; aluminosilicates; fly ash; calcium sulfates; Ca/Mg carbonates; metal oxides; and biological particles and carbon fragments. The size distribution and number fractions of different particle groups exhibited distinct seasonal variations between non-monsoon and monsoon periods, which are clearly related to the differences in air mass pathways. Specifically, the relative abundance of soot in non-monsoon period (25%) was much higher than that in monsoon period (14%), indicating Mr. Qomolangma region received more anthropogenic influence in non-monsoon than monsoon period.     

基于光漫反射的真空皮带脱水机滤布纠偏原理

介绍了湿法脱硫系统中真空皮带脱水机滤布的一种光漫反射纠偏装置,包括其主要部件如光漫反射传感器、电动推杆驱动装置、滤布控制滚轮等,重点阐述了光漫反射纠偏装置的工作原理及纠偏过程。光漫反射纠偏装置的主要原理是通过光漫反射传感器的输出信号来判断滤布的跑偏,根据光漫反射传感器的输出信号,DCS控制系统发送指令启动可伸缩的电动推杆装置来伸长和收缩推杆,从而控制滤布滚轮围绕着旋转点进行相应的倾斜调整,使滤布回到其中心位置。     

基于光环境指数综合评价法的综掘工作面照明环境评价

人通过视觉从外界获得信息的效率和质量与照明环境条件有直接关系,而且人维持基本的视觉功能也依赖于照明,因此照明条件是作业环境中的一个重要方面。为了分析光环境中影响人的工作效率与心理舒适度的因素的各种可能状态与光环境质量的关系,参照建筑行业的光环境指数综合评价法对煤矿井下综掘工作面照明环境进行了评价,从而确立了两个工作面照明环境的质量等级,并据此提出了改善井下照明环境的措施。该研究可对煤矿井下其他作业地点的光照环境评价与分析提供借鉴。     

干发酵对稻草结构及产沼气的影响

为了防止稻草焚烧产生的环境污染,采用厌氧干发酵方式对稻草进行资源化处理.通过稻草元素的分析、X射线衍射(XRD)及红外光谱(FT-IR)的分析,考察了干发酵及预处理对稻草结构的改变.结果表明,稻草干发酵60d单位挥发固体累积产气量278.1mL/g (0℃),前30d产气占总产气量的90.3%;XRD显示稻草纤维晶体为纤维素Ⅰ型,堆沤预处理和厌氧发酵未改变纤维素的晶型,但略微增加纤维素的结晶度;FT-IR表明:堆沤预处理使聚糖脱聚、纤维素分子键氢键增强和木质素结构部分改变;发酵主要使聚糖脱聚与降解.     

Complete catalytic oxidation of o-xylene over CeO2 nanocubes

The activities of CeO2 nanocubes calcined at di erent temperatures were tested for catalytic oxidation of o-xylene. Using CeO2 nanocubes as catalysts, complete catalytic oxidation of o-xylene was achieved below 210°C. The CeO2 nanomaterials were characterized by means of BET, X-ray di raction (XRD), transmission electron microscopy (TEM), and high-resolution transmission electron microscopy (HRTEM). From the TEM images, all CeO2 nanocubes displayed cubic morphology irrespective of calcination temperature. The HRTEM images revealed that these nanocubes were enclosed by reactive f001g planes, which may contribute to the intrinsically catalytic property of o-xylene oxidation. The higher activity of CeO2 nanocubes calcined at 550°C than those calcined at above 550°C was attributed to their smaller crystallite size and larger surface area. The influences of reaction conditions were also studied, which found that a higher reaction temperature was necessary for complete catalytic oxidation of o-xylene at higher weight hourly space velocity (WHSV) and o-xylene concentration.