仪化热电厂提高循环水浓缩倍率的措施

针对仪化热电厂将循环水用作冲灰水，导致浓缩倍率只有1.6，以及凝汽器铜管腐蚀结垢严重等问题，提出了隔断循环水与冲灰水的直接联系，实现闲路循环，对凝汽器铜管进行酸洗，并对循环水实施加缓蚀阻垢荆、杀菌剂和旁流过滤等办法，全部实施后产生了很好的效益，值得借鉴。     

O2-Fenton试剂处理对氨基苯磺酸废水的探讨

利用由O2和Fenton试剂组成的类Fenton系统处理对氨基苯磺酸废水,取得了很好的降解效果.当FeSO4(10g/L)投加量为1.2mL、H2O2(3%)投加量为3mL时,COD去除率可达到70%.     

Mechanical and Barrier Properties of Biodegradable Films Made from Chitosan and Poly (Lactic Acid) Blends

Biodegradable film blends of chitosan with poly(lactic acid) (PLA) were prepared by solution mixing and film casting. The main goal of these blends is to improve the water vapor barrier of chitosan by blending it with a hydrophobic biodegradable polymer from renewable resources. Mechanical properties of obtained films were assessed by tensile test. Thermal properties, water barrier properties, and water sensitivity were studied by differential scanning calorimeter analysis, water vapor permeability measurements, and surface-angle contact tests, respectively. The incorporation of PLA to chitosan improved the water barrier properties and decreased the water sensitivity of chitosan film. However, the tensile strength and elastic modulus of chitosan decreased with the addition of PLA. Mechanical and thermal properties revealed that chitosan and PLA blends are incompatible, consistent with the results of Fourier transform infrared (FTIR) analysis that showed the absence of specific interaction between chitosan and PLA.     

金沙江对硫酸的缓冲性能分析

本文分析了金沙江对硫酸的缓冲特征，建立了江水的缓冲曲线方程，并且验证了此方程的有效性，证明用此方程预测硫酸进入金沙江后江水pH值的变化情况，其预测准确度在0.2个pH单位内。     

树脂相分光光度法测定水中痕量苦味酸

建立了树脂相分光光度法测定水中痕量苦味酸的新方法。该法灵敏度高,表观摩尔吸光系数为1.08×105L/(mol·cm);精密度理想(测定苦味酸质量浓度为5μg/mL的实验5次,相对标准偏差为1.0%);线性范围为0～7.0μg/mL;以3σ衡量,检出限为0.14μg/mL;加标回收率为97%～103%。采用该法直接测定水样中的苦味酸、间接测定烟草中的烟碱,结果令人满意。     

垃圾焚烧飞灰中重金属的固化/稳定化处理实验研究

研究了城市生活垃圾焚烧-电灰的特性及飞灰中重金属的特性,对利用水泥作粘结剂进行飞灰固化/稳定化处理效果开展了系统的实验研究,分析了水泥固化/稳定化飞灰的工艺特点和最佳工艺参数,并讨论了粘结剂固化飞灰机理以及重金属浸出毒性,为进一步研究城市生活垃圾焚烧飞灰的无害化处理与利用提供了有重要价值的参考依据.     

Characterisation of FOGs in grease trap waste from the processing of chickens in Thailand

Industrial firms that kill and process chickens generate wastewater that contains fat, oil, and grease (FOG). The FOGs are located in the fatty waste that is collected by floatation in grease traps. Chemical and physical characterisation of FOGs would provide useful information that would help in the development of methods designed to decrease the extent of pollution caused by disposal of the waste and to utilise commercially some of its lipid constituents. Employing these methods would enhance the profitability and competitive potential of these commercial organisations. Samples of grease trap waste from 14 firms in central Thailand have been examined. Due to the very different schemes of waste management employed by these firms, the physical appearance of their fatty wastes showed considerable variation. The chemical and physical properties of the FOGs present in these wastes showed considerable variation also. Large amounts of free fatty acids (10–70% as oleic acid) were detected in most of the 14 wastes and palmitic, cis-9-oleic, cis,cis-9,12-linoleic, stearic, and palmitoleic acids were the predominant species of free and esterified acids. Most of the FOGs were solid at temperatures below 40 °C. Many of them contained traces of heavy metals (Cu and Pb) and some contained traces of the pesticides dimethoate and cypermethrin. The content of these potentially hazardous substances would have to be considered very carefully before discarding the fatty wastes and during the development of methods designed to isolate their potentially profitable lipid constituents.     

Optimization of micro-aeration intensity in acidogenic reactor of a two-phase anaerobic digester treating food waste

Micro-aeration is known to promote the activities of hydrolytic exo-enzymes and used as a strategy to improve the hydrolysis of particulate substrate. The effect of different micro-aeration rates, 0, 129, 258, and 387 L-air/kg TS/d (denoted as LBR-AN, LBR-6h, LBR-3h and LBR-2h, respectively) on the solubilization of food waste was evaluated at 35 °C in four leach bed reactors (LBR) coupled with methanogenic upflow anaerobic sludge blanket (UASB) reactor. Results indicate that the intensity of micro-aeration influenced the hydrolysis and methane yield. Adequate micro-aeration intensity in LBR-3h and LBR-2h significantly enhanced the carbohydrate and protein hydrolysis by 21–27% and 38–64% respectively. Due to the accelerated acidogenesis, more than 3-fold of acetic acid and butyric acid were produced in LBR-3h as compared to the anaerobic treatment LBR-AN resulting in the maximum methane yield of 0.27 L CH₄/g VS_added in the UASB. The performance of LBR-6h with inadequate aeration was similar to that of LBR-AN with a comparable hydrolysis degree. Nevertheless, higher aeration intensity in LBR-2h was also unfavorable for methane yield due to significant biomass generation and CO₂ respiration of up to 18.5% and 32.8% of the total soluble hydrolysate, respectively. To conclude, appropriate micro-aeration rate can promote the hydrolysis of solid organic waste and methane yield without undesirable carbon loss and an aeration intensity of 258 L-air/kg TS/d is recommended for acidogenic LBR treating food waste.     

常规施肥条件下农田不同途径氮素损失的原位研究:以长江中下游地区夏玉米季为例

为了解农田常规施肥条件下的不同途径氮素损失特征,本文通过田间原位试验同步研究了长江中下游地区夏玉米生长季氮肥施用后的农田N2O排放、NH3挥发、氮渗漏和地表径流的变化.结果表明,在复合肥为基肥,尿素为追肥,基追肥氮素水平均为150 kg·hm-2的条件下,整个玉米生长季N2O排放系数为3.3%,NH3挥发损失率为10.2%,氮渗漏和地表径流损失率分别为11.2%和5.1%.此外,基肥施用以氮素渗漏损失为主,而追肥氮素损失以氨挥发和渗漏为主,表明不同途径化肥氮素损失主要受氮肥品种影响,玉米季追肥可改用低氨挥发氮肥品种以减少氮素损失.     

城市分散式粪便颗粒化有机肥用作叶菜肥的肥力及环境影响

城市分散式粪便的处理已经成为现代化城市管理的一个难题.本研究在将城市分散式粪便经收集、除渣、絮凝脱水后制成颗粒肥;通过盆栽小青菜试验,评价了不同施肥量对小青菜的增产效果以及对土壤、淋溶水性质的影响,探讨了颗粒肥用于叶菜施肥的可行性.结果表明,施用颗粒肥可显著提高小青菜产量,试验条件下未对小青菜叶片造成大肠杆菌、大肠菌群等病原菌污染;在适当比例的施肥水平下,颗粒肥施用后淋溶水中的病原菌浓度低于对照组.施用颗粒肥能显著提高土壤氮、磷、钾、有机质等营养物质含量,提高土壤孔隙度水平,降低土壤容重,改善土壤理化性质;同时颗粒肥施用不会对土壤和淋溶水造成重金属离子污染,且能有效降低土壤氮、钾的淋溶.