佛山地区干季边界层垂直风温结构对空气质量的影响

利用佛山地区2013年12月大气边界层观测试验得到的垂直风温资料和相应逐日AQI资料、逐时PM_(2.5)浓度资料,研究了佛山地区大气边界层垂直风温结构对空气质量的影响.结果表明:佛山地区干季持续存在的逆温结构是导致PM_(2.5)污染较重的重要原因.干季污染日近60%的最低逆温层高度低于1000 m,而非污染日低于1000 m的最低逆温层仅占36%,污染日佛山贴地逆温频率高达31.2%.逆温层出现高度较低,将污染物压缩积累在贴地层大气中导致污染较重.在大陆冷高压控制下,佛山地区的边界层结构演化非常典型,最大边界层高度和最大边界层通风量表现出了显著相关,污染日日平均边界层高度始终维持在较低的水平,多数时候不足500 m,最大边界层高度则大部分小于1000 m,日平均边界层通风量主要分布在500~1500 m~2·s~(-1)之间,在极端情况下甚至不足300 m~2·s~(-1),最大边界层通风量大部分处于1500~5000 m~2·s~(-1)之间,导致污染物始终聚集在较低的大气边界层内,使得PM_(2.5)浓度长时间维持在较高的污染水平.佛山地区风场存在显著的3层结构,较小的底层风速意味着大气的输送和扩散能力较弱,高度较低的中层使得污染物进一步被压缩累积在大气底层,垂直风场的不稳定性使得污染日佛山地区局地回流活跃,回流(RF)指数极小值多分布在0.2~0.4之间,污染日RF指数普遍小于非污染日,垂直风场的有效输送能力被显著削弱.     

乌鲁木齐市一次冷空气过境天气对空气污染的影响分析

根据对2006年11月20～28日乌鲁木齐市出现冷空气过境天气过程的天气形式和主要气象要素及空气污染变化情况进行的分析,结果表明:冷空气过境天气前后,诸多气象要素发生了变化,冷空气导致逆温层的破坏和降水过程使各项污染物均得到有效的清除.通过此分析可为类似天气的空气质量预报提供思路.     

混凝-气浮-加压曝气工艺处理屠宰废水

高浓度生猪屠宰废水属难治理工业废水.采用混凝-气浮-加压曝气工艺处理屠宰废水,经生产实践证明,出水水质可达到<肉类加工工业水污染物排放标准>(GB13457-92)中的一级标准.     

Assessment of population exposure to particulate matter pollution in Chongqing, China

To determine the population exposure to PM(10) in Chongqing, China, we developed an indirect model by combining information on the time activity patterns of various demographic subgroups with estimates of the PM(10) concentrations in different microenvironments (MEs). The spatial and temporal variations of the exposure to PM(10) were illustrated in a geographical information system (GIS). The population weighted exposure (PWE) for the entire population was 229, 155 and 211 microg/m(3), respectively, in winter, summer and as the annual average. Indoor PM(10) level at home was the largest contributor to the PWE, especially for the rural areas where high pollution levels were found due to solid fuels burning. Elder people had higher PM(10) exposure than adults and youth, due to more time spent in indoor MEs. The highest health risk due to particulate was found in the city zone and northeast regions, suggesting that pollution abatement should be prioritized in these areas.     

Field monitoring of volatile organic compounds using passive air samplers in an industrial city in Japan

Highly portable, sensitive, and selective passive air samplers were used to investigate ambient volatile organic compound (VOC) levels at multiple sampling sites in an industrial city, Fuji, Japan. We determined the spatial distributions of 27 species of VOCs in three campaigns: Mar (cold season), May (warm season), and Nov (mild season) of 2004. In all campaigns, toluene (geometric mean concentration, 14.0microg/m3) was the most abundant VOC, followed by acetaldehyde (4.76microg/m3), and formaldehyde (2.58microg/m3). The spatial distributions for certain VOCs showed characteristic patterns: high concentrations of benzene and formaldehyde were typically found along major roads, whereas high concentrations of toluene and tetrachloroethylene (PCE) were usually found near factories. The spatial distribution of PCE observed was extremely consistent with the diffusion pattern calculated from Pollutant Release and Transfer Register data and meteorological data, indicated that passive air samplers are useful for determining the sources and distributions of ambient VOCs.     

Seasonal and spatial occurrence and distribution of atmospheric polycyclic aromatic hydrocarbons (PAHs) in rural and urban areas of the North Chinese Plain

Passive air sampling (PAS) was employed to study the occurrence of gaseous and particle-bound PAHs in the North Chinese Plain. The averaged concentrations of gaseous and particle-bound PAHs were 485 ± 209 ng/m³ and 267 ± 161 ng/m³, respectively. The PAHs concentrations at urban sites were generally higher than those at rural ones with ratios <1.5 in spring, summer and fall, but differences between them were not significant for the wintertime and annually averaged concentrations. This urban-rural distribution pattern was related to the PAHs emission sources. PAHs spatial variation can be partially (49%) explained by emission with a simple linear regression method. Both the gaseous and particle-bound PAHs were highest in winter and lowest in summer, with winter/summer ratios of 1.8 and 8, respectively. Emission strength was the most important factor for the seasonality.     

Acid Rain in Downtown São Paulo City, Brazil

During the period from July 2002 to June 2004, the chemical characteristics of the rainwater samples collected in downtown São Paulo were investigated. The analysis of 224 wet-only precipitation samples included pH and electrical conductivity, as well as major ions (Na⁺, $ \rm NH^{ + }_{4} During the period from July 2002 to June 2004, the chemical characteristics of the rainwater samples collected in downtown S?o Paulo were investigated. The analysis of 224 wet-only precipitation samples included pH and electrical conductivity, as well as major ions (Na⁺, , K⁺, Ca²⁺, Mg²⁺, Cl⁻, , ) and carboxylic acids (acetic, formic and oxalic) using ion chromatography. The volume weighted mean, VWM, of the anions , and Cl⁻ was, respectively, 20.3, 12.1 and 10.7 μmol l⁻¹. Rainwater in S?o Paulo was acidic, with 55% of the samples exhibiting a pH below 5.6. The VWM of the free H⁺ was 6.27 μmol l⁻¹), corresponding to a pH of 5.20. Ammonia (NH₃), determined as (VWM = 32.8 μmol l⁻¹), was the main acidity neutralizing agent. Considering that the H⁺ ion is the only counter ion produced from the non-sea-salt fraction of the dissociated anions, the contribution of each anion to the free acidity potential has the following profile: (31.1%), (26.0%), CH₃COO⁻ (22.0%), Cl⁻ (13.7%), HCOO⁻ (5.4%) and (1.8%). The precipitation chemistry showed seasonal differences, with higher concentrations of ammonium and calcium during autumn and winter (dry period). The marine contribution was not significant, while the direct vehicular emission showed to be relevant in the ionic composition of precipitation.     

Suspended Particulate Matter Distribution in Rural-Industrial Satna and in Urban-Industrial South Delhi

An air quality sampling program was designed and implemented to collect the baseline concentrations of respirable suspended particulates (RSP = PM₁₀), non-respirable suspended particulates (NRSP) and fine suspended particulates (FSP = PM_2.5). Over a three-week period, a 24-h average concentrations were calculated from the samples collected at an industrial site in Southern Delhi and compared to datasets collected in Satna by Envirotech Limited, Okhla, Delhi in order to establish the characteristic difference in emission patterns. PM_2.5, PM₁₀, and total suspended particulates (TSP) concentrations at Satna were 20.5 ± 6.0, 102.1 ± 41.1, and 387.6 ± 222.4 μg m⁻³ and at Delhi were 126.7 ± 28.6, 268.6 ± 39.1, and 687.7 ± 117.4 μg m⁻³. Values at Delhi were well above the standard limit for 24-h PM_2.5 United States National Ambient Air Quality Standards (USNAAQS; 65 μg m⁻³), while values at Satna were under the standard limit. Results were compared with various worldwide studies. These comparisons suggest an immediate need for the promulgation of new PM_2.5 standards. The position of PM₁₀ in Delhi is drastic and needs an immediate attention. PM₁₀ levels at Delhi were also well above the standard limit for 24-h PM₁₀ National Ambient Air Quality Standards (NAAQS; 150 μg m⁻³), while levels at Satna remained under the standard limit. PM_2.5/PM₁₀ values were also calculated to determine PM_2.5 contribution. At Satna, PM_2.5 contribution to PM₁₀ was only 20% compared to 47% in Delhi. TSP values at Delhi were well above, while TSP values at Satna were under, the standard limit for 24-h TSP NAAQS (500 μg m⁻³). At Satna, the PM₁₀ contribution to TSP was only 26% compared to 39% in Delhi. The correlation between PM₁₀, PM_2.5, and TSP were also calculated in order to gain an insight to their sources. Both in Satna and in Delhi, none of the sources was dominant a varied pattern of emissions was obtained, showing the presence of heterogeneous emission density and that nonrespirable suspended particulate (NRSP) formed the greatest part of the particulate load.     

Results of An Indoor Size Fractionated PM School Sampling Program in Libby, Montana

Libby, Montana is the only PM_2.5 nonattainment area in the western United States with the exceptions of parts of southern California. During January through March 2005, a particulate matter (PM) sampling program was conducted within Libby’s elementary and middle schools to establish baseline indoor PM concentrations before a wood stove change-out program is implemented over the next several years. As part of this program, indoor concentrations of PM mass, organic carbon (OC), and elemental carbon (EC) in five different size fractions (>2.5, 1.0–2.5, 0.5–1.0, 0.25–0.5, and <0.25 μm) were measured. Total measured PM mass concentrations were much higher inside the elementary school, with particle size fraction (>2.5, 0.5–1.0, 0.25–0.5, and <0.25 μm) concentrations between 2 and 5 times higher when compared to the middle school. The 1.0–2.5 μm fraction had the largest difference between the two sites, with elementary school concentrations nearly 10 times higher than the middle school values. The carbon component for the schools’ indoor PM was found to be predominantly composed of OC. Measured total OC and EC concentrations, as well as concentrations within individual size fractions, were an average of two to five times higher at the elementary school when compared to the middle school. For the ultrafine fraction (<0.25), EC concentrations were similar between each of the schools. Despite the differences in concentrations between the schools at the various fraction levels, the OC/EC ratio was determined to be similar.