管式电除尘器"伞形罩"结构特性研究

在高温、高湿窑炉烟气条件下,采用立式管式电除尘器“伞形罩”结构,能够解决其清灰不力、二次扬尘、除尘效率不稳定等问题。本研究了“伞形罩”结构的除尘机理及效率及清灰力度影响因素、抑制二次扬尘机制。研究结果表明,“伞形罩”结构除尘效率因集尘表面积的增加而提高;应用支铁框架式振打方式,振打强度明显加强;其分流机制能有效地抑制二次扬尘：从而为“伞形罩”结构的优化设计提供了依据。     

Characterization of Dust Storms to Hong Kong in April 1998

In April 1998, two intense dust storms were generated in CentralAsia and transported eastward across East Asia (15 and 19 April). This article presents the chemical characterization ofHong Kong (HK) aerosols during the dust storms. During the 15 Aprildust storm, hourly respiratory suspended particles (RSP)(particle diameter smaller than 10 m) concentrationsmonitored at 7 sites in Hong Kong reached the peak valuessynchronously between 9 and 11 a.m. on 17 April, in which thehighest concentration was 267 g m^-3. Analysis ofthe RSP samples showed that concentrations of crustalelements (Ba, Ca, Cd, Cr, Fe, Mg, K⁺) and anthropogenicspecies (As, Ni, Pb, Zn, NH₄ ⁺, NO₃ ^-,SO₄ ^2- and total carbon) were substantiallyenhanced. Enhancement of these species was more than afactor of 2 to 14 relative to the non dust period. The totalcarbon content was high, at 59 g m^-3 (notincluding carbonate), and the enrichment factors of Asand Pb on 17 April were 122 and 117, respectively. Thisimplied that anthropogenic materials together with mineraldust were transported to HK from Mainland China. Based onmaterial balance calculations, mineral dust contributed41% to the observed RSP mass on 17 April, which was 2 times thatof the nondust sample (22%). From the 5-day backwardtrajectory analysis, this storm was transported directlyfrom Northwest China to HK. However, there was nocorresponding observation for the 19 April dust stormaerosol. Consequently, 15 April storm had stronger impact onHK's atmosphere than 19 April storm. Compared to the HK AirQuality Objective, 15 April dust storm did not cause seriousair pollution in HK.     

全密闭电石炉尾气治理及综合利用

由于全密闭电石炉的尾气性质特殊，治理和综合利用存在一定的难度。本文总结了国内电石生产厂家的多种治理和利用方法，并根据国家产业政策的要求，提出了适合我国国情的电石炉烟气治理及综合利用方法。     

CONTROL OF LAKE PHOSPHORUS WITH ALUMINUM SULFATE: DOSE DETERMINATION AND APPLICATION TECHNIQUES1

ABSTRACT: Nutrient diversion does not always bring about prompt and sufficient reduction in lake phosphorus concentration due to recycling from nutrient rich sediments. Certain lakes and reservoirs may continue to experience nuisance algal blooms and require additional restorative steps. The phosphorus precipitation/inactivation technique is a procedure to remove phosphorus from the water column and to control its release from sediments in order to achieve P-limiting conditions to algal growth. Aluminum salts have been used in advanced waste water treatment to remove phosphorus and this technology was extended to lake rehabilitation. Guidelines for dose calculation and application are generally lacking, and are provided in this report. The dose determination suggested here allows maximum application of aluminum to bottom sediments and thus emphasizes long term control of phosphorus recycling. Dose can be calculated directly from the alkalinity of the water to be treated. Titration of lake water samples of Varying alkalinity allows the establishment of the relationship between residual dissolved aluminum, alkalinity, and dose which can then be employed for lake scale applications of alum to lakes and reservoirs. Application equipment and procedures are described. These depend on site characteristics and treatment objectives and include lakeside stores, a distribution pipe, and an application barge and manifold. Alum may also be used to meet other restoration objectives including the treatment of problem flows and the reduction of particulate concentrations.     

辽宁省典型城市道路尘PM2.5成分谱研究

为构建辽宁省典型城市道路尘源成分谱，分别采集了鞍山市和盘锦市道路尘样品，分析了其化学组分特征，用富集因子法和比值法分析了其主要来源，用分歧系数法分析了两个城市成分谱的相似度.结果表明：盘锦市和鞍山市道路尘PM_2.5中的化学组成以有机碳组分（OC）和地壳类元素（Al、Ca、Mg、Fe和K）为主.除Cu和V元素外，其余元素均表现为鞍山市的富集因子大于盘锦市.由比值法可得，盘锦市和鞍山市OC/EC分别为（13.20±6.26）和（3.94±0.63），均存在二次污染现象；NO₃^-/SO₄^2-的均值分别为（0.52±0.55）和（0.46±0.13），说明其道路尘PM_2.5受固定源影响更大.盘锦市与鞍山市道路尘成分谱分歧系数为0.354，说明两个源成分谱可能相似.     

安钢第二炼轧厂转炉炼钢粉尘处理

介绍了安钢第二炼轧厂转炉炼钢采用脉冲布袋除尘回收与利用、工作原理、和减少对环境污染排放。     

基于综采面产尘分布与扩散分析的粉尘防治研究

在对W3709综采工作面产尘特点分析的基础上,将工作面产尘源分为落煤扬尘、落煤冲击产尘及割煤产尘3类。对采煤机顺风割煤与逆风割煤时粉尘运动规律进行了详细的分析,根据工作面产尘特点与粉尘运动规律,提出了包括煤层注水、采煤机割煤产尘治理与控制以及支架处粉尘治理一套完整的综合防尘系统。通过现场应用,工作面粉尘在原有设施降尘基础上降低86%以上,降尘效果良好,有效地解决了该工作面粉尘污染严重的难题。     

石英砂加工企业职业病危害防护措施与管理对策研究

通过对安徽省石英砂加工企业生产工艺流程和现场进行调查分析,得出矽尘和噪声是两种最主要的职业病危害因素,发现石英砂生产企业矽尘和噪声危害十分严重,生产作业现场未配备任何防护装备和个人防护用品,作业人员接触职业病危害的比率非常高。分析了石英砂加工企业在职业病危害防护与管理方面的欠缺与不足,提出了针对矽尘和噪声危害因素的具体工程防护措施与管理对策,从源头控制和消除职业病危害,保护劳动者的生命安全与健康。     

喷嘴直径对降尘效果影响的试验研究

为提高喷雾降尘效率,以改善作业环境,有必要研究喷嘴直径与降尘效果间的关系。基于自行设计的喷雾降尘试验系统,采用马尔文实时高速喷雾粒度分析仪、高速摄像仪及粉尘浓度测定仪对不同直径喷嘴的雾化特性参数和降尘效率进行测定。结果表明,在相同喷雾压力下,随着喷嘴直径的增大,全尘降尘效率持续增加,而呼吸性粉尘降尘效率先增加后减小,并在喷嘴直径为1.5 mm时达到最大值;在耗水量相同的情况下,随着喷嘴直径的增大,全尘和呼吸性粉尘降尘效率均下降。在井下喷雾降尘中,当耗水量不受限制时,为同时确保全尘和呼吸性粉尘降尘效率,宜选择直径为1.5 mm的喷嘴;当耗水量受限制时,宜选择直径为1.2 mm的喷嘴。     

基于两种样品前处理方法对比研究小冬克玛底冰川雪坑中痕量元素

通过对唐古拉山小冬克玛底冰川雪坑中非季风季节沉积的雪样分别进行酸化处理和消解处理后,利用高分辨扇形磁场等离子体质谱仪(ICP-SFMS)测试了样品中19种痕量元素(Ba、U、Sr、Rb、Tl、Mo、Cs、Pb、Sb、V、Cr、Mn、Fe、Co、Al、Cu、Ti、Li、As)的酸化浓度和总浓度.研究结果表明,痕量元素浓度的变化范围较大,元素Al的最大/最小浓度比为326(酸化浓度)和465(总浓度),元素Pb相应比值为27和48.雪冰中痕量元素的总浓度一般大于该元素的酸化浓度,其中,元素Pb、Fe、Sb、Ba、Al、Ti的酸化浓度占总浓度的平均比值分别为91%、76%、60%、52%、33%和21%.一般地,样品中不溶微粒含量越大,酸化浓度占总浓度的比值越小;不溶微粒含量越小,则相反.对痕量元素的富集系数(EF)分析表明,各元素总浓度EF均值小于酸化浓度EF均值,揭示了用酸化浓度计算EF存在对痕量元素人为来源影响的高估.人类排放是小冬克玛底冰川中痕量元素的来源之一,对于元素Mo和Sb,人类排放估计是主要来源.利用后向轨迹模型模拟出小冬克玛底冰川雪冰中痕量元素在非季风季节主要来源于青藏高原西部及中亚中东地区.