厌氧氨氧化菌富集培养过程微生物群落结构及多样性

为深入理解厌氧氨氧化菌富集培养过程微生物群落变化特征,采用ASBR反应器进行厌氧氨氧化菌富集培养,考察了不同培养时间微生物群落组成、多样性及物种网络关系.结果表明,通过逐步提高基质浓度,实现了厌氧氨氧化菌富集,NH₄⁺-N和NO₂^--N去除率分别为97.6%和95.4%,总氮去除率为84.9%.高通量测序发现,整个培养过程优势菌门（相对丰度>5%）为变形菌门（Proteobacteria）、拟杆菌门（Bacteroidetes）、绿弯菌门（Chloroflexi）、浮霉菌门（Planctomycetes）、装甲菌门（Armatimonadetes）和放线菌门（Actinobacteria）;富集培养获得的主要厌氧氨氧化菌为Candidatus Brocadia,相对丰度从1.42%增长到24.66%;培养过程,微生物群落优势菌群组成未发生变化,但相对丰度呈现显著差异（P<0.05）.富集培养过程不同时间,微生物群落α多样性呈现先升高后降低的趋势,且存在显著差异（P<0.05）;微生物群落β多样性在富集培养过程发生明显空间分异特征,且存在显著差异（R=0.5672,P<0.01）.培养过程不同时间,物种网络密度分别为0.188、0.068、0.059、0.18和0.0735;虽然富集培养过程导致微生物间的关联作用变弱,但浮霉菌门相关类群的物种成为网络中的主要节点.     

3种染料化合物在UV-TiO2/H2O2和UV-TiO2体系中的光催化降解研究

采用自制的TiO2膜和平板式固定床型光催化氧化反应装置,对甲基橙、茜素红和罗丹明B 3种含有不同生色基团的染料化合物进行了TiO2光催化氧化降解研究,通过对照测定降解过程中吸光度、电导率、pH的变化,分析了在加入和不加入H2O22种情况下降解过程的异同,比较了3种染料化合物脱色的难易程度,揭示了降解产物中无机离子的变化规律及某些可能的产物类型.     

Winsor I微乳液+臭氧氧化联合处理油基岩屑的研究

采用“含有配制油基钻井液用主乳和油相的Winsor I微乳液+臭氧氧化”联合工艺对油基岩屑进行处理,Winsor I微乳液处理油基岩屑后的所得基础油和部分主乳进入平衡油相,可以用来配制油基钻井液,臭氧氧化对岩屑进行深度处理,进一步降低岩屑表面含油量。论文以处理后岩屑含油量为指标,系统优化了微乳液组成、微乳液清洗油基岩屑工艺和臭氧氧化工艺。实验结果建议微乳液组成为“脂肪醇聚氧乙烯醚硫酸钠+配制油基钻井液用主乳(2:1)”混合乳化剂浓度为6wt%,正戊醇浓度5 wt%,柴油浓度36 wt%,其他为盐水。推荐微乳液清洗条件为固液比1:5,室温下搅拌清洗60 min。此条件下岩屑含油量可以降低至1.41 wt%,微乳液重复使用4次后,岩屑含油量仍可以保持在2.0 wt%以下。臭氧氧化深度处理时,建议工艺条件为臭氧氧化时间40 min,清水pH=7,固液比1:5,臭氧流量5 mg/min,处理后岩屑含油量可降低至0.36wt%。     

Potential energy production from organic waste and its environmental and economic impacts at a tertiary institution in Palestine

Municipal solid waste (MSW) is one of the most well-known biomass resources that can be utilized to produce renewable energy. Numerous countries are plagued by the proliferation of waste, particularly organic waste that can be utilized for energy recovery. Palestine suffers from inefficient solid waste management, and only recently have a few projects focused on bioenergy production been implemented. Throughout the years, the city of Tulkarm experiences power outages which cause a challenge to the Palestine Technical University-Kadoorie campus in Tulkarm. Thus, the possibility of energy recovery from the organic portion in Palestine Technical University-Kadoorie was evaluated. The analysis of an economic impact included discussions of a number of economic aspects, including Levelized cost of energy, internal rate of return, present worth, annual worth, and payback period. On the other hand, a carbon dioxide savings analysis and gas emission were evaluated. The outcomes of the energy optimization demonstrated that the suggested system could supply the institution with an average of roughly 7 MWh of electrical energy. According to the economic study, this project offers 0.25 million dollars in present value, 0.144 million dollars in annual value, a 13 percent internal rate of return, a payback period of 6 years, and a levelized cost of energy of 0.11 dollars for each kWh generated. Additionally, the environmental assessment revealed that this system might reduce CO₂ emissions by around 8,343,778 tons. For effective waste management, energy recovery, and emission reduction, it is advised to implement anaerobic digestion technology.     

Biohythane production from pineapple peel using Methanosarcina mazei enhanced with palm oil mill effluent (POME) sludge in single-stage anaerobic digestion

Biohythane production via single-stage anaerobic digestion (AD) is an effective way for sustainable energy recovery from lignocellulosic biomass. In this paper, biohythane was produced through the AD process from pineapple peel waste substrate using purely cultured Methanosarcina mazei with the enhancement of palm oil mill effluent (POME) sludge as the inoculum. This study focuses on the effects of the lignocellulosic pre-treatment method, the addition of POME sludge into M. mazei culture medium as inoculum, and various operational conditions (food to microorganisms (F/M) ratios, temperature, pH) on gas production performances. The experimental results indicate that these parameters influenced the efficiency of biohythane production by producing the peak maximum biohythane production rate values (HPR_max) and (MPR_max), H₂:CH₄ = 1.93:0.67 L/L-d, and biohythane yield (HY) and (MY), H₂:CH₄ = 1.18:0.55 mL/L-substrate. This study demonstrates that biohythane gas (H₂ + CH₄ + CO₂) production from pineapple waste can be accelerated by M. mazei only with the enhancement of POME sludge through single-stage AD system under mesophilic batch process conditions.     

热-碱处理污泥与木耳菌糠共发酵产酸性能的研究

为克服单一剩余活性污泥(WAS)发酵产酸效率低的问题和资源化利用废弃木耳菌糠(SMS),本文对热-碱预处理污泥(PWS)和菌糠进行共发酵,研究预处理和菌糠添加对共发酵体系的产酸性能影响.试验基于原料的总固体含量(TS)共设置6个处理,分别为污泥(WAS∶SMS=1∶0)、预处理污泥(PWS∶SMS=1∶0)、菌糠(PW...     

Fenton氧化与生化组合技术处理油田采油废水的研究

采用Fenton氧化与生化组合技术处理生物难降解的采油废水的研究结果表明 ,Fenton氧化技术不但对采油废水中有机质有较好的去除率 ,而且大大地改善了废水的可生化性 ,在H2 O2 的投加浓度和Fe2 + 与H2 O2 的摩尔比分别为10mmol/L和 0 .1的条件下 ,经过 30min氧化后可使废水BOD值由原来的 5mg/L上升至 4 0mg/L ;同时随着氧化时间的延长 ,废水中残余的有机物分子量逐渐降低。 30min氧化后的废水经过生物处理 ,其出水COD值为 10 2mg/L ,可以满足国家综合污水外排标准 ,经济分析结果表明 ,该技术处理采油废水的运行成本为 1 4 7元 /t。这一技术在解决石油行业采油废水的外排达标方面具有很好的应用前景。     

H2O2处理酸性大红GR染料废水的研究

通过对废水pH值、H2O2用量、催化剂用量、反应时间、反应温度等工艺条件的考察,确定了H2O2催化氧化处理酸性大红染料废水的最佳工艺条件pH 4、H2O2用量6 mL/L、催化剂用量3 g/L、反应时间100 min、反应温度70℃.在该条件下,COD和色度的去除率分别为76.7%和99.4%;通过反应前后的紫外-可见光光谱分析表明,H2O2催化氧化处理酸性大红GR染料废水有比较好的效果,为该工艺处理酸性大红GR染料废水提供了科学依据.     

厌氧工艺对含铬(Ⅵ)废水处理效果初探

以砂石和活性炭作为填料,自制厌氧生物滤床系统,并对系统进行驯化,发现完成驯化后的稳定系统具有良好的去铬(Ⅵ)能力.废水在系统中经过2 h运行,加入碳源的试验组与不加碳源的对照组的铬(Ⅵ)去除率分别为87.33%和66.31%.恒流泵最佳流量为47 mL/min,外加碳源后,铬(Ⅵ)的浓度由60 mg/L左右降到0.5 mg/L以下,需要4 h,而对照组需要14 h,铬(Ⅵ)浓度由64.66 mg/L提高到 75.53 mg/L时,对本系统负面影响甚微,提高到95.47 mg/L时,系统出水达标所需时间延长到7.5 h.本系统具有耐受一定程度的浓度冲击以及进一步驯化、提高处理负荷的潜力.     

甘氨酸厂氨氮废水治理的工艺及实验研究

运用多效真空蒸发兼热泵技术回收甘氨酸厂高氨氮废水中的氯化铵,通过实验找到了治理此废水的最佳真空度,克服了采用常规蒸发方法的能耗大、料液对设备腐蚀性强的缺点。最后运用吹脱法对蒸发冷凝水进行了治理,通过实验得到了吹脱的最佳工艺参数吹脱时间6h、pH125、吹脱温度60℃,为运用生化法彻底解决甘氨酸厂高氨氮工业废水的污染难题奠定了基础。