钢渣预处理含铬废水及其废渣与铬渣的固化

用钢渣对含铬废水进行预处理,探讨了钢渣粒度、用量、废水pH值和添加硫酸亚铁还原剂的影响.结果表明,经硫酸亚铁还原处理后再用钢渣处理比单纯用钢渣处理的效果明显提高,采用钢渣/总铬质量比为40的100目钢渣处理经硫酸亚铁还原后的含铬废水,总铬和Cr6 去除率分别达79%和84%,采用钢渣柱进行的两级淋滤实验进一步表明该方法可作为工业上含铬废水处理的预处理段.处理后的废钢渣同工业铬渣一起进行水泥固化,标准养护20 d后固化体表面Cr6 浸出率、破碎至5 mm粒径以下和酸雨淋溶下的浸出液Cr6 浓度均符合安全标准,可作为普通建材或进行填埋处置.     

Integrated Risk Framework for Onsite Wastewater Treatment Systems

Onsite wastewater treatment systems (OWTS) are becoming increasingly important for the treatment and dispersal of effluent in new urbanised developments that are not serviced by centralised wastewater collection and treatment systems. However, the current standards and guidelines adopted by many local authorities for assessing suitable site and soil conditions for OWTS are increasingly coming under scrutiny due to the public health and environmental impacts caused by poorly performing systems, in particular septic tank-soil adsorption systems. In order to achieve sustainable onsite wastewater treatment with minimal impacts on the environment and public health, more appropriate means of assessment are required. This paper highlights an integrated risk based approach for assessing the inherent hazards associated with OWTS in order to manage and mitigate the environmental and public health risks inherent with onsite wastewater treatment. In developing a sound and cohesive integrated risk framework for OWTS, several key issues must be recognised. These include the inclusion of relevant stakeholders throughout framework development, the integration of scientific knowledge, data and analysis with risk assessment and management ideals, and identification of the appropriate performance goals for successful management and mitigation of associated risks. These issues were addressed in the development of the risk framework to provide a generic approach to assessing risk from OWTS. The utilisation of the developed risk framework for achieving more appropriate assessment and management techniques for OWTS is presented in a case study for the Gold Coast region, Queensland State, Australia.     

玻璃纸生产废气中CS2和H2S的治理

阐述了玻璃纸生产中CS2和H2S废气产生的原理,介绍了该废气处理的现状,总结了目前普遍采用的冷凝法、活性炭吸附法、活性碳纤维吸附法、改性活性炭吸附法、螯合铁氧化法、吸收-吸附法等处理方法的特点和效果。介绍了一种先采用螯合铁氧化法、再采用冷凝法、最后采用活性炭吸附法的综合处理工艺,可使废气达标排放。     

Effect of fipronil on biogas production performance during anaerobic digestion of chicken manure and corn straw

Fipronil is a broad-spectrum insecticide that has a good control effect on pests of commercial poultry. Although many studies have reported the environmental fate of fipronil, the influence of residual fipronil in poultry waste on biogas production has not been further explored yet. In this article, an experimental comparative study on anaerobic digestion (AD) of chicken manure (CM) and corn straw (CS) with different fipronil concentrations (FCs) was carried at 8% of total solid (TS) and mid-temperature (35?±?1)°C. The results showed that fipronil had a significant effect on biogas production during AD of CM and CS. When the FC is at a low level (≤10?mg·kg^?1), the biogas production rate is increased and the digestion period was shortened, while higher FC (≥ 20?mg·kg^?1) showed an inhibitory effect. During the monitoring of enzyme activity, low FC showed no significant effect on cellulase and saccharase, but the urease activity increased in the early stage. High FC showed inhibition of activity of cellulase and urease, but the saccharase activity was significantly inhibited until FC reached 40?mg·kg^?1. This study also confirms that the environment in anaerobic digester is favorable for the degradation of fipronil, and its half-life is about 15.83?days.     

经济型阳离子淀粉絮凝剂的制备及其对印染废水的处理效果

采用玉米淀粉为原料、氯化缩水甘油三甲基铵（GTA）作阳离子化试剂、水-乙醇混合液作分散剂、NaOH作碱催化剂,制备了经济型阳离子淀粉絮凝剂（简称经济型阳离子淀粉）。实验结果表明：在淀粉加入量110g、GTA加入量30g、NaOH加入量1．6g、分散剂中m（水）：m（乙醇）=1：1、m（分散剂）：m（淀粉）=0．50：1、反应温度80℃、反应时间2．5h的条件下,可制得取代度（DS）为0．31的经济型阳离子淀粉;用该经济型阳离子淀粉与聚丙烯酰胺（PAM）联用处理印染废水,当经济型阳离子淀粉加入量为140mg／L、PAM加入量为4mg/L、废水pH为8时,印染废水的色度去除率和COD去除率分别达92％和82％。该方法絮凝效果好,药剂费用低,产生的污泥少。     

以膨润土为辅助添加剂固化/稳定化污泥的试验研究

针对传统以水泥固化污泥,带来的水泥用量大与固化体的浸出液pH过高等问题,提出了以膨润土为添加剂辅助水泥固化/稳定化污泥的思路.通过开展无侧限抗压强度试验、毒性浸出试验,测量掺入膨润土后污泥固化体的强度、重金属浸出率、浸出液COD及pH值,研究该固化/稳定化方法的效果.结果表明,膨润土的掺入极大地提高了固化体的抗压强度,将掺入量为0.4(相对污泥的质量比)的水泥一半用膨润土替代时,固化体的强度提高了6左右.体积安定性也能够满足要求.随膨润土掺入量增加,固化体中锌、铅的浸出率与浸出液的pH值呈现不断减小的趋势,锌与铅的浸出率分别由6.9%下降至0.25%,9.6%下降至5%,pH值由12.3下降至12.1.在强碱条件下及烘干或风干条件下,铜会随着有机物的分解而析出,从而增加铜的浸出率,而膨润土的加入能弥补水泥造成的强碱环境及风干或烘干过程对固化污泥中铜的稳定产生的不利影响.     

HPLC-三重四级杆质谱法测定医疗废水中抗生素残留

采用固相萃取/高效液相色谱-三重四级杆质谱法同时测定医疗废水中的20种超痕量抗生素残留,通过优化试验条件,使方法在100μg/L～100μg/L范围内线性良好,方法检出限为024ng/L～122ng/L。空白水样和实际水样3个质量浓度水平的加标回收率分别为80.2%～108%和75.8%～114%,6次测定结果的RSD分别为2.4%～8.4%和1.7%～8.1%。将该方法用于测定重庆市2家三甲医院医疗废水中的超痕量抗生素残留,结果有11种抗生素检出,其余均为未检出。     

产朊假丝酵母处理马铃薯淀粉废水

研究了pH、接种量、无机盐(通过加入磷酸二氢钾进行无机盐补充)及DO等对产朊假丝酵母处理马铃薯淀粉废水的影响.结果表明.在pH为5.0、产朊假丝酵母接种量为10%(体积分数)、磷酸二氢钾(质量分散为0.1%)加入量为0.5 g/L、废水不灭菌的条件下,废水处理效果和产朊假丝酵母生长最佳.且当废水COD为5 074 mg/L时,COD去除率达到74.86%,同时可获得2.23g/L的单细胞蛋白.产朊假丝酵母处理马铃薯淀粉废水的最佳条件的实验研究对实现马铃薯淀粉废水资源化利用提供了理论参考.     

2种反应器中好氧颗粒污泥培养的比较研究

以絮状活性污泥为接种污泥,采用人工配制的模拟生活污水,分别在气提式序批反应器(SBAR)和序批式活性污泥反应器(SBR)中成功地培养出了成熟的好氧颗粒污泥.SBAR和SBR中的好氧颗粒污泥都具有稳定的基本形态结构,其微生物主要由杆菌和球菌组成,对COD的去除率可达到93%左右.对NH+4-N的去除率可达到98%以上.SBAR中好氧颗粒污泥的粒径主要分布、污泥体积指数(SVI)、比耗氧速率(SOUR)、TN去除率和TP去除率分别为0.45～2.00 mm、19.97 mL/g、47.68 g/(kg·h)、82%和65%;而SBR中好氧颗粒污泥的粒径主要分布、SVI、SOUR、TN去除率和TP去除率分别为0.18～1.00 mm、29.12 mL/g、43.21 g/(kg·h)、58%和50%.相对而言,SBAR更有利于好氧颗粒污泥的培养和运行.     

颗粒化序列间歇式活性污泥反应器工艺处理化粪池污水

在序列间歇式活性污泥反应器(SBR)中成功培养出适应化粪池污水水质的好氧颗粒污泥.并将其应用于化粪池污水的处理.在好氧颗粒污泥培养的第15天左右,SBR中开始出现细小的颗粒,然后微生物在其上繁殖生长使颗粒逐渐增大而成熟;在第24天时,SBR中絮状活性污泥已基本实现了颗粒化.培养出的好氧颗粒污泥对化粪池污水有稳定的处理效果,在进水完全为化粪池污水时,COD、NH_4~+-N、TN的平均去除率分别为77%、61%、47%.但是,由于化粪池污水COD较低,因此无法维持较高的生物量,在后期的稳定运行过程中MLSS始终维持在2 500 mg/L左右.好氧颗粒污泥的同步硝化反硝化作用是其稳定脱氮的保证.