Tracing the sources of refractory dissolved organic matter in a large artificial lake using multiple analytical tools

Structural and chemical characteristics of refractory dissolved organic matter (RDOM) from seven different sources (algae, leaf litter, reed, compost, field soil, paddy water, treated sewage) were examined using multiple analytical tools, and they were compared with those of RDOM in a large artificial lake (Lake Paldang, Korea). Treated sewage, paddy water, and field soil were distinguished from the other sources investigated by their relatively low specific UV absorbance (SUVA) values and more pronounced fulvic-like versus humic-like fluorescence of the RDOM samples. Microbial derived RDOM from algae and treated sewage showed relatively low apparent molecular weight and a higher fraction of hydrophilic bases relative to the total hydrophilic fraction. For the biopolymer types, the presence of polyhydroxy aromatics with the high abundance of proteins was observed only for vascular plant-based RDOM (i.e., leaf litter and reed). Molecular weight values exhibited positive correlations with the SUVA and the hydrophobic content among the different RDOM, suggesting that hydrophobic and condensed aromatic structures may be the main components of high molecular weight RDOM. Principal component analysis revealed that approximately 77% of the variance in the RDOM characteristics might be explained by the source difference (i.e., terrestrial and microbial derived) and a tendency of further microbial transformation. Combined results demonstrated that the properties of the lake RDOM were largely affected by the upstream sources of field soil, paddy water, and treated sewage, which are characterized by low molecular weight UV-absorbing and non-aromatic structures with relatively high resistance to further degradation.     

Plant communities in relation to flooding and soil contamination in a lowland Rhine River floodplain

Using canonical correspondence analysis (CCA), relationships were investigated between plant species composition and flooding characteristics, heavy metal contamination and soil properties in a lowland floodplain of the Rhine River. Floodplain elevation and yearly average flooding duration turned out to be more important for explaining variation in plant species composition than soil heavy metal contamination. Nevertheless, plant species richness and diversity showed a significant decrease with the level of contamination. As single heavy metal concentrations seemed mostly too low for causing phytotoxic effects in plants, this trend is possibly explained by additive effects of multiple contaminants or by the concomitant influences of contamination and non-chemical stressors like flooding. These results suggest that impacts of soil contamination on plants in floodplains could be larger than expected from mere soil concentrations. In general, these findings emphasize the relevance of analyzing effects of toxic substances in concert with the effects of other relevant stressors.     

The relationships between air pollutants, meteorological parameters and concentration of airborne fungal spores

Fungal spores are an important component of bioaerosol and also considered to act as indicator of the level of atmospheric bio-pollution. Therefore, better understanding of these phenomena demands a detailed survey of airborne particles.The objective of this study was to examine the dependence of two the most important allergenic taxa of airborne fungi - Alternaria and Cladosporium - on meteorological parameters and air pollutant concentrations during three consecutive years (2006-2008). This study is also an attempt to create artificial neural network (ANN) forecasting models useful in the prediction of aeroallergen abundance.There were statistically significant relationships between spore concentration and environmental parameters as well as pollutants, confirmed by the Spearman’s correlation rank analysis and high performance of the ANN models obtained. The concentrations of Cladosporium and Alternaria spores can be predicted with quite good accuracy from meteorological conditions and air pollution recorded three days earlier.     

新型结构ABR的设计与水力特性研究

针对ABR自身的缺点,设计出一种新型结构的ABR.该反应器为双层结构,共有5部分组成,各部分容积各不相同.该反应器的设计思想是将ABR与生物滤池以及活性炭吸附等工艺相联合.这种设计能够最大程度地发挥各工艺的优势,进而达到更好的处理效果.通过脉冲响应实验对该反应器的水力特性进行研究,得出不同水力停留时间(HRT)下的停留...     

A2O工艺好氧末段溶解氧变化对脱氮除磷影响

采用连续流A2O工艺处理实际的生活污水,研究好氧末段在不同溶解氧(DO)浓度条件下对污泥沉降性能、系统脱氮除磷的影响,同时考察了DO对污泥硝化活性、厌氧释磷速率和反硝化脱氮速率的影响.结果表明,随着末段溶解氧的提高,污泥容积指数SVI从140降至100左右,后又升高到120～170;系统的硝化效果提高,氨氮的去除率从6...     

pH、盐度对微生物还原硫酸盐的影响研究

采用厌氧生物处理工艺,研究了在不同盐度下pH连续降低对硫酸盐还原和有机物去除率的影响。实验结果表明,硫酸盐还原菌有很强的适应pH变化的能力,在pH值达到4以下仍有60％的硫酸盐去除率。NaCl浓度由4g／L增加到50g／L抑制了各厌氧菌的活性,导致硫酸盐和有机物去除率的下降,但硫酸盐还原菌耐受性高于产甲烷菌等其他厌氧菌,在NaCl浓度为50g／L下,硫酸盐去除率能达到50％,而有机物去除率则低于30％。qRT—PCR表明了系统菌落中SRB随着环境的变化情况与化学指标结果相一致,该反应器体系中SRB在整个厌氧菌群落中只占了很小部分。     

Polychlorinated naphthalenes (PCNs) in riverine and marine sediments of the Laizhou Bay area, North China

PCN congeners were analyzed in marine and riverine sediments of the Laizhou Bay area, North China. Concentrations of PCNs ranged from 0.12 to 5.1 ng g⁻¹ dry weight (dw) with a mean value of 1.1 ng g⁻¹ dw. The levels of PCNs varied largely, with industrial group approximately ten folds higher than those of the rural in riverine sediment. A strong impact by direct discharge from local factories was suggested. Similar compositional profiles were found within groups. High resemblance of compositional profiles between industrial samples and Halowax 1014 was observed. It was indicated that PCNs in riverine sediments were mainly from release of industrial usage, with additional contributions from industrial thermal process at certain sites. In marine sediments, it was suggested that PCNs along the coast of Laizhou Bay were mainly controlled by riverine input. While in the central bay, PCN distributions were possibly impacted by combined multiple factors.     

Engineered nanomaterials in rivers--exposure scenarios for Switzerland at high spatial and temporal resolution

Probabilistic material flow analysis and graph theory were combined to calculate predicted environmental concentrations (PECs) of engineered nanomaterials (ENMs) in Swiss rivers: 543 river sections were used to assess the geographical variability of nano-TiO₂, nano-ZnO and nano-Ag, and flow measurements over a 20-year period at 21 locations served to evaluate temporal variation. A conservative scenario assuming no ENM removal and an optimistic scenario covering complete ENM transformation/deposition were considered. ENM concentrations varied by a factor 5 due to uncertain ENM emissions (15%-85% quantiles of ENM emissions) and up to a factor of 10 due to temporal river flow variations (15%-85% quantiles of flow). The results indicate highly variable local PECs and a location- and time-dependent risk evaluation. Nano-TiO₂ median PECs ranged from 11 to 1′623 ng L⁻¹ (conservative scenario) and from 2 to 1′618 ng L⁻¹ (optimistic scenario). The equivalent values for nano-ZnO and nano-Ag were by factors of 14 and 240 smaller.     

Regulation (EC) No. 1107/2009 and upcoming challenges for exposure assessment of plant protection products--Harmonisation or national modelling approaches?

In the new European Pesticide Regulation (EC) No. 1107/2009, the harmonisation of approaches for estimation of the environmental exposure of pesticides is considered a major goal. Several member states currently require their own models for the calculation of predicted environmental concentrations (PEC) in surface water. The variety of methods makes risk evaluations rather time-consuming for both notifiers and evaluating authorities. In the present study we compare surface water concentrations of 19 compounds using EU and country-specific models and risk assessment approaches to evaluate to which extent the resulting estimated exposure concentrations differ. Our results show that EU and country specific approaches and the resulting surface water concentrations differ considerably regarding basic model assumptions and assessment methods. The results indicate that the aimed harmonisation of risk assessment approaches within the EU will be difficult based on current models. New scenarios may help to achieve a harmonisation taking country-specific features into account.