Inhibition effects of aluminum dust explosions by various kinds of ammonium polyphosphate

In this work, vinyltriethoxysilane (A151) and 3-aminopropyltriethoxysilane (KH550) were used to modify ammonium polyphosphate (APP), showing that the dispersibility of APP could be improved remarkably by A151 and KH550. The maximum explosion pressure of aluminum dust explosion decreased with the addition of APP, A151-APP (APP-A) and KH550-APP (APP-B), with the exception of the case where the inerting ratio (α) of APP-A was less than 0.4. After the addition of APP-B, there was little difference in flame propagation behavior and explosion pressure compared with that of adding APP, indicating that APP-B could retain the inhibition performance of APP compared with APP-A. When the inerting ratios of APP, APP-A and APP-B were 1.2, 1.4 and 1.4, respectively, the aluminum dust explosion could be completely inhibited. The explosion residues of aluminum dust/APP mainly consisted of Al₂O₃, P-containing and N-containing compounds. It could be analyzed that APP exerted the inhibition effect through both chemical and physical effects.     

新型钢渣水处理剂去除水体污染物的研究现状

钢渣是炼钢生产过程中产生的固体废弃物,具有较高的碱度、机械强度和比表面积。钢渣化学成份较复杂,直接排放会对环境造成严重的污染,加强钢渣的处置及综合利用具有重大意义。作为一种新型的水处理剂,钢渣用于去除水体污染物不仅减少了水体、土壤等生态环境的污染,而且达到了以废治废的目的。文章分析了钢渣水处理剂去除水体污染物的作用机理,认为钢渣水处理剂对水体中污染物的去除主要通过吸附和沉淀两种作用,而还原作用和离子交换作用相对较小。阐述了钢渣水处理剂处理重金属废水、有机废水和无机废水的研究现状,提出了在开发液态钢渣新型处理工艺的基础上,实现钢渣水处理剂的应用。     

改进测定水中氨氮分子吸收光谱法的试验研究

水中氨氮含量是反应水质状况的重要指标。文章对测定水中氨氮气相分子吸收光谱法(标准号HJ/T195-2005)进行了改进试验研究。第一,对氧化剂的配比进行了改进,使氨氮的测定范围扩展至100μg。第二,对标准HJ/T195-2005中直接使用亚硝酸钠标准溶液做标准曲线的处理方式也做了探讨。通过一系列对比实验认为,应用硫酸铵标准溶液做工作曲线更加准确合理。最后应用改进后的气相分子吸收光谱法和纳氏比色法或滴定法对多种实际废水样品进行同时测定。结果表明,改进后的气相分子吸收光谱法测定氨氮的范围更宽,灵敏度更高和准确度更好。     

金属系无机抗菌材料研究进展

主要介绍金属系无机抗菌材料。从材料的选择和合成方面,讨论了材料的特性和抗菌功能相结合的途径,归纳出抗菌材料的制备工艺的一般规律,为开发适合我国国情的无机抗菌材料提供思路。     

高分子吸水树脂作为蓄冷材料的性能研究

本文研究了不同吸水倍率的高分子吸水树脂的相变温度、相变潜热及作为蓄冷材料在35℃环境下的相变时间,并与冰做了对比。结果显示：吸收不同倍率水的高分子树脂。相变温度和相变潜热基本与水相似,随着吸水倍率的增加,相变潜热越接近于水的潜热;在相同条件下放置于隔冷袋中的高分子吸水树脂．在35℃高温环境中,可以维持20℃以下低温5h,比冰多了将近1h,克服了渗漏的缺点,在蓄冷领域表现出了明显的优势。     

Effects of release pressure on the transportation characteristics in pipeline and the diffusion behaviors in enclosure space of typical gas extinguishing agent

Reducing the release pressure of fire extinguishing systems can decrease potential safety hazards in large transport airplanes. To explore whether reducing the release pressure can achieve the release effect required by the airworthiness standards or not, the transportation characteristics in the pipeline and diffusion behaviors in the enclosure space of a typical fire extinguishing agent (Halon 1301) were investigated under five release pressures in the present study. The effects of the release pressure on the degree of superheat, injection duration, jet structure, and concentration distribution of Halon 1301 were analyzed. The results show that both of the degree of superheat and the injection duration decrease with an increase in the release pressure. The supplement of bubble expansion in the fire extinguishing agent can slow down the pressure decrease in the vessel. Both of the maximum and mean values of the pipeline differential pressure increase with an increase in release pressure. The maximum value of the jet angle decreases linearly with the increase in release pressure, and the jet deflects upward owing to the effects of buoyancy. The maximum concentration value decreases with an increase in the distance from the nozzle. The maximum concentration values in the near field from the nozzle increase with an increase in the release pressure. Under five release pressures, the concentration and holding time (duration above 6% volume concentration) of Halon 1301 on the centerline of the jet meet the requirements of airworthiness provisions.     

两种粉煤灰的烟气脱硫实验

采用粉煤灰(FA)和Ca(OH)2水合制得的高活性吸收剂作为二氧化硫的干法脱硫剂，重点研究了两种粉煤灰(电除尘灰和湿式水膜除尘灰)在同一配比、同一水合温度、同一水合时间下的脱硫效率，结果表明：电除尘灰比湿式水膜除尘灰脱硫效率高，并且电除尘的脱硫效率略微低于活性炭，同时介绍了粉煤灰的脱硫机理。     

分光光度法测定COD_(Cr)的试验条件选择

用分光光度法测定水中化学需氧量ＣＯＤＣｒ,通过正交试验选择氧化的最佳选择。试验结果表明对ＣＯＤＣｒ值为５０～１０００ｍｇ／Ｌ的水样：氧化剂Ｋ２Ｃｒ２Ｏ７用量为０．２０～０．４０ｍｏｌ／Ｌ,催化剂Ａｇ２ＳＯ４用量为１０ｇ／ＬＨ２ＳＯ４,消解时间１０ｍｉｎ,加热温度１８０℃。用ＣＯＤＣｒ为１３８ｍｇ／Ｌ的质控标样进行验证试验,其绝对误差为０．５～３．０ｍｇ／Ｌ。与标准方法相比用分光光度法测定ＣＯＤＣｒ具有分析误差小,省时、省力,节约药剂的特点。     

COD_(Cr)测定中排除氯离子干扰的进一步探讨

废水中化学需氧量的测定采用重铬酸钾法［１］,大多数情况下都存在Ｃｌ－干扰,其排除方法用ＨｇＳＯ４掩蔽,通过实验探讨不用剧毒药品ＨｇＳＯ４掩蔽Ｃｌ－的干扰,而用ＣＯＤＣｒ总量减去Ｃｌ－的量。实验结果表明：当测定化学需氧量较低而Ｃｌ－含量高的水样时,即使采用掩蔽Ｃｌ－也会产生较大的误差,而用测定值减去０．２２６［Ｃｌ－］之值更接近真值。     

复合螯合剂/活性碳分离富集和ICP—AES同时测定水样中痕量元素

本文提出将复合螯合剂（NaDDTC／8—Oxin）饱和吸附于活性碳上作为吸附材料．分离富集和ICP—AES同时测定水中痕量金属元素的方法。用ICP—AES研究了该吸附材料对某些痕量元素的吸附和解吸性能；考察了共存元素的影响。方法应用于湖水中Fe、Cu、Mn、Y和Sc的测定，检出限为ng／ml级，RSD为1．9％～4．4％，加入回收率81％～101％间，试样分析结果满意。