环境地表γ计量率、工频电磁场和射频电场监测实验结果对比分析研究

本文通过两实验室针对环境地表γ计量率、工频电磁场和射频电场仪器对比实验,并对结果进行了统计检验。分析结果表明,两者监测数据无显著差异。     

建筑陶瓷碳计量与优化模型研究

采用投入产出分析方法和目标规划方法,以某建陶企业为代表,建立了建筑陶瓷产业投入产出模型及低碳优化模型,利用投入产出模型计量和预估了建筑陶瓷产业关键环节碳排放和产品碳足迹;应用低碳优化模型对建筑陶瓷企业的产品计划进行了低碳优化.结果表明,建筑陶瓷企业年二氧化碳排放量达182 543.9 t,单位产品碳排放量多于国外先进水平10%以上;影响建筑陶瓷产业二氧化碳排放的关键环节为烧成和喷雾干燥过程,烧成和喷雾干燥过程排放的二氧化碳占总排放的80%以上;3种建筑陶瓷产品中,坯砖、抛光砖、釉面砖的万平米产量碳足迹依次为150.2、168.0、159.6 t.建筑陶瓷企业经低碳模型优化后可以在保证同样利润的同时降低5.4%的碳排放,也可以在保证碳排放相同的条件下使利润提高5.6%.     

Warm forming die design,Part II: Parting surface temperature response characterization of a novel thermal finite element modeling code

The majority of the research activities in the area of warm forming are concentrated on demonstrating or simulating the improved formability associated with forming lightweight materials such as aluminum alloys at elevated temperatures. However, the ability to design the proper thermal management system within the forming tool is a critical aspect to delivering this technology as a viable, stable production alternative to traditional stamping. This work begins to address the thermal stability issues of this process by examining the impact of process cycle time on the parting surface temperature response. Cycle times of 10, 15, 30, and 300 s were evaluated using a reciprocating surface and a self-heated experimental block of 1020 steel fitted with resistance cartridge heaters. The presented results indicate that cycle time does not significantly impact the steady-state temperature response at the parting surface for a well-insulated die that has proper thermal management. Parting surface experimental results were compared to values obtained numerically and through the use of the novel thermal finite element analysis software PASSAGE/Forming^®.     

Low cost measurements of nitrogen and sulphur dry deposition velocities at a semi-alpine site: gradient measurements and a comparison with deposition model estimates

The conditional time averaged gradient method was used to measure air-surface exchange of nitrogen and sulphur compounds at a semi-alpine site in Southern Norway. Dry deposition velocities were then obtained from the bi-weekly concentration gradient measurements. Annual deposition velocities were found to be 1.4, 11.8 and 4.0 mm s(-1) for NH3, HNO3 and SO2, respectively, if all data were included, and to be 10.8, 11.8 and 13.0 mm s(-1), respectively, if only positive values were included. Measured deposition velocities were compared to two sets of values estimated from a big-leaf dry deposition module applying to two different land types (short grass and forbs, and tundra), driven by measured micrometeorological parameters. The deposition module gives reasonable values for this site throughout the year, but does not reproduce the large variability as shown in the measured data. No apparent seasonal variations were found from either measurements or module estimates due to the very low productivity of the studied area.     

水质总氮测定中的有关问题探讨

对总氮测定中的一系列影响因素,诸如实验用水,器皿的洗涤,实验室环境试剂的提纯、配制和保存,消解温度、压力和时间的控制,以及高氨氮水样中的总氮测定、总氮、总磷的同时测定和其他有关的问题,作了较为详细的探讨,并提出了相应的解决办法。     

智能家电的低待机功耗研究

从智能家电待机工作状态入手,分析电器产品中参与待机工作的各部分电路原理,提出降低潜在功耗设计思路和计算方法,从家电设计研发阶段对待机功耗进行控制,同时对待机功耗精确测量方法关键点进行解读以控制低功耗测试不确定度,有助于低待机功耗设计和测量的标准化和规范化。     

Distribution and transport characteristics of fine particulate matter in beijing with mobile lidar measurements from 2015 to 2018

Accurately quantifying the concentration and transport flux of atmospheric fine particulate matter(PM_2.5) is vital when attempting to thoroughly identify the pollution formation mechanism.In this study,the mobile lidar measurements in Beijing on heavily polluted days in December from 2015 to 2018 are presented.The lidar was mounted on a vehicle,which could perform measurements along designated routes.On the basis of mobile lidar measurements along closed circuits of the 6 th Ring Road...     

街道峡谷内汽车排放污染物浓度分布的观测与数值模拟

在上海某典型街道峡谷内按一定的空间布点,在一定时段内同时对各布点进行采样并做一氧化碳浓度分析,同时记录车辆种类、车流量、气象条件等,分析街道峡谷内污染物浓度的分布.运用风向频率加权(WDFW)方法,结合大气流动和污染物扩散的CFD模型进行数值模拟计算.结果表明,数值模拟结果和现场观测结果较吻合,建筑物低的一侧污染物浓度远高于建筑物高的一侧污染物浓度,两侧的污染物浓度随着高度的增加而降低.     

微波、毫米波电磁材料特性及参数宽频带测试方法

讨论一种微波、毫米波电磁材料特性和参数宽频带测量方法——自由空间法。给出了该测量方法的测试原理和基于国产AV3630幅相接收机为基础的测试系统构成及系统扩频方法,论述了自由空间测试法需注意的关键技术问题。     

卫星光学反射膜光谱反射率空间综合环境退化研究

对玻璃基底和金属基底的铝反射膜在紫外、低能电子、低能质子的综合环境作用下的光谱反射率退化进行了实验研究。试验结果表明两种铝反射膜的光谱反射率均发生了退化,且光谱反射率的退化主要集中在可见光波段,在近红外波段退化很小;玻璃基底铝反射膜退化在420 nm左右出现峰值点,2种金属基底铝反射膜的退化的峰值点在450 nm左右。由于电荷沉积在玻璃中后会抑制带电粒子入射,因此玻璃基底铝反射膜的退化要小于金属基底铝反射膜。