Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

飞机用铝合金腐蚀行为和腐蚀预测研究现状及问题分析

针对不同的航空铝合金结构及部位,从腐蚀机理、腐蚀行为和腐蚀预测技术三方面较为系统地分析了研究现状及进展。在此基础上,明确了航空铝合金腐蚀预测技术需要进一步研究的问题,分别为飞机结构表面腐蚀环境的确定问题,材料在海洋大气环境下腐蚀电化学性能的准确测量问题,腐蚀预测模型的选取问题。     

基于SOM-SVM组合分类器的涂层防护性能研究

目的为避免EIS,EN技术可能出现的问题,建立一个准确、高效的评价模型,以探究现役军用有机涂层防护性能。方法利用电化学阻抗谱(EIS)、电化学噪声(EN)技术分析了两种军车有机涂层在循环暴露试验中的腐蚀行为,提取低频阻抗模值|Z|_(0.1 Hz)与涂层噪声电阻R_n两种电化学评价参数作为自组织神经网络(SOM)的输入训练样本,同时结合支持向量机(SVM)方法建立涂层防护性能组合分类器。结果将涂层失效过程自适应地分为涂层防护性能良好、防护性能下降、基本失效三个阶段。结论所建立的SOM-SVM组合分类器对于辅助分析涂层防护性能具有可行性。     

可靠性强化试验技术在某型伺服作动器研制中的适用性探索

目的探索可靠性强化试验技术在典型机电液一体化产品伺服作动器研制过程中的适用性。方法以某型伺服作动器为研究对象,从故障激发的角度对可靠性强化试验技术的应用进行可行性分析,在响应调查和应力分析的基础上,结合产品的工作特点设计适用于该类伺服作动器的可靠性强化试验方案,包含低温步进应力试验、高温步进应力试验、快速温度循环试验10个循环、振动步进应力试验(包含气锤式三轴向六自由度超高斯随机振动方式及电磁振动台随机振动方式)及综合环境应力试验5个循环,并依此进行试验。结果在快速温度循环试验及综合环境应力试验过程中,均有效地激发出了产品的漏油故障,与相似产品外场暴露的漏油故障模式相吻合。结论可靠性强化试验技术可有效地应用于典型机电液一体化产品伺服作动器的研制过程,设计的可靠性强化试验方案可有效地激发外场出现频率较高的故障,可作为该类产品研制的试验手段之一。     

“天舟一号”货运飞船在轨污染探测数据分析

目的分析"天舟一号"(TZ-1)货运飞船的空间污染探测器的在轨探测数据。方法 TZ-1货运飞船上的污染探测器采用石英晶体微量天平(QCM),利用污染物沉积在QCM探测器传感晶片表面引起的振荡频率变化情况来分析航天器在轨空间污染环境。根据其探测原理,通过分析下传的原始数据,得到航天器在轨的污染累积量结果。结果航天器在轨飞行过程中,污染累积已达到会导致污染敏感器件光学性能明显退化的程度,并且污染源温度是影响航天器污染累积量的一个重要因素,可以将其作为航天器在轨污染控制的重要措施。结论该研究结果可以为航天器污染设计、控制提供参考,为提高航天器可靠性设计提供数据支持。     

高强预腐蚀铝合金单轴拉-拉疲劳断口定量分析

目的通过断口定量分析获得7A09铝合金的疲劳裂纹扩展规律,为7A09铝合金结构的寿命评估提供依据。方法使用EXCO溶液对试验件进行预腐蚀,利用疲劳拉伸机进行疲劳加载直至断裂,使用扫描电镜对疲劳断口进行定量化分析。结果疲劳裂纹在试件的腐蚀坑处萌生,从自由界面附近向纵深发展导致试件的断裂。通过断口分析和Paris公式确定了裂纹的萌生寿命和扩展寿命。结论腐蚀之后的试件裂纹萌生寿命占总寿命的比例下降,当裂纹扩展程度较大之后,受腐蚀影响减轻,得出裂纹扩展速率和应力强度因子的关系。     

Monitoring Air Quality in Mountains: Designing an Effective Network

A quantitatively robust yet parsimonious air-quality monitoring network in mountainous regions requires special attention to relevant spatial and temporal scales of measurement and inference. The design of monitoring networks should focus on the objectives required by public agencies, namely: 1) determine if some threshold has been exceeded (e.g., for regulatory purposes), and 2) identify spatial patterns and temporal trends (e.g., to protect natural resources). A short-term, multi-scale assessment to quantify spatial variability in air quality is a valuable asset in designing a network, in conjunction with an evaluation of existing data and simulation-model output. A recent assessment in Washington state (USA) quantified spatial variability in tropospheric ozone distribution ranging from a single watershed to the western third of the state. Spatial and temporal coherence in ozone exposure modified by predictable elevational relationships ( 1.3 ppbv ozone per 100 m elevation gain) extends from urban areas to the crest of the Cascade Range. This suggests that a sparse network of permanent analyzers is sufficient at all spatial scales, with the option of periodic intensive measurements to validate network design. It is imperative that agencies cooperate in the design of monitoring networks in mountainous regions to optimize data collection and financial efficiencies.     

Analysis of pollutant levels in central Hong Kong applying neural network method with particle swarm optimization

Air pollution has emerged as an imminent issue in modernsociety. Prediction of pollutant levels is an importantresearch topic in atmospheric environment today. For fulfillingsuch prediction, the use of neural network (NN), and inparticular the multi-layer perceptrons, has presented to be acost-effective technique superior to traditional statisticalmethods. But their training, usually with back-propagation (BP)algorithm or other gradient algorithms, is often with certaindrawbacks, such as: 1) very slow convergence, and 2) easilygetting stuck in a local minimum. In this paper, a newlydeveloped method, particle swarm optimization (PSO) model, isadopted to train perceptrons, to predict pollutant levels, andas a result, a PSO-based neural network approach is presented. The approach is demonstrated to be feasible and effective bypredicting some real air-quality problems.     

有关有限边界岸边排放稳态二维混合模式的几个问题的探讨

针对目前我国环境影响评价领域普遍采用的有限边界岸边排放稳态二维混合模式的局限性和不精确性，本文对由河流二维稳态水质模型的基本方程推求出的有限边界岸边排放的二维稳态混合模式的解析解的各项进行分析比较。同时针对费休的混合长度公式进行了计算比较。     

济南市创建国家环保模范城市的调查与思考

从济南市环境保护现状调查入手,对照国家环境保护模范城市考核指标,分析济南市创建国家环境保护模范城市存在的问题,借鉴其他城市创建国家环境保护模范城市的成功经验,结合济南市实际,提出了有针对性的对策与建议。