Validation of a booted finite element model of the WIAMan ATD lower limb in component and whole-body vertical loading impacts with an assessment of the boot influence model on response

Objective: A novel anthropomorphic test device (ATD) representative of the 50th percentile male soldier is being developed to predict injuries to a vehicle occupant during an underbody blast (UBB). The main objective of this study was to develop and validate a finite element (FE) model of the ATD lower limb outfitted with a military combat boot and to insert the validated lower limb into a model of the full ATD and simulate vertical loading experiments.

Methods: A Belleville desert combat boot model was assigned contacts and material properties based on previous experiments. The boot model was fit to a previously developed model of the barefoot ATD. Validation was performed through 6 matched pair component tests conducted on the Vertically Accelerated Loads Transfer System (VALTS). The load transfer capabilities of the FE model were assessed along with the force-mitigating properties of the boot. The booted lower limb subassembly was then incorporated into a whole-body model of the ATD. Two whole-body VALTS experiments were simulated to evaluate lower limb performance in the whole body.

Results: The lower limb model accurately predicted axial loads measured at heel, tibia, and knee load cells during matched pair component tests. Forces in booted simulations were compared to unbooted simulations and an amount of mitigation similar to that of experiments was observed. In a whole-body loading environment, the model kinematics match those recorded in experiments. The shape and magnitude of experimental force–time curves were accurately predicted by the model. Correlation between the experiments and simulations was backed up by high objective rating scores for all experiments.

Conclusion: The booted lower limb model is accurate in its ability to articulate and transfer loads similar to the physical dummy in simulated underbody loading experiments. The performance of the model leads to the recommendation to use it appropriately as an alternative to costly ATD experiments.     

强化垂直流可渗透反应墙处理渗滤液污染物

针对垃圾渗滤液污染物组分多、处理难度大、可生化性差的特点,基于可渗透反应墙(PRB)被动修复技术,通过多种填料的组合构建三重垂直流PRB强化的砂箱模型,对垃圾渗滤液进行连续动态处理研究。实验结果表明,填料的组合顺序对强化PRB系统净化能力有较大的影响,由无烟煤、沸石、钢渣依次组成的强化垂直流PRB系统(2#砂箱)对NH+4-N、NO-3-N、NO-2-N、COD、PO3-4-P的平均去除率分别为96.12%、30.36%、75.24%、39.03%和30.47%,处理效果明显好于相同条件下依次由无烟煤、钢渣、沸石组成的强化垂直流PRB系统(1#砂箱)。与常规PRB处理系统相比,强化垂直流可渗透反应墙系统可实现垃圾渗滤液中多种污染物同步有效去除,是极具发展潜力的新型技术。     

旅游相关企业松散型纵向一体化战略联盟研究

我国旅游产业发展水平不高,其深层次的原因是旅游产业链中存在着严重的纵向外部性问题。在借助演化博弈思想对旅游产业链中经济主体的决策行为进行深入分析后,认为纵向一体化战略联盟能有效提升旅游产业链和相关主体利益,在传统的纵向一体化联盟基础上提出了一种界于市场和企业,但又不同于完全一体化的"混合"组织形式——松散型纵向一体化战略联盟,并初步描绘了这一联盟模式的构建过程。     

生物强化处理石油污染土壤理化性质和微生物学特性的纵向分布特征

采用原位强化生物修复技术对某区块石油污染土壤进行为期16个月的生物修复,考察了处置后污染土壤理化性质、微生物学特性以及石油烃组成的纵向分布特征。实验结果表明,经过修复后各土层的石油烃去除率是表层土IN-3(50.42%)中层土IN-2(23.54%)底层土IN-1(10.51%);IN-1处于缺氧环境,存在硫酸盐还原和反硝化作用,使得土壤pH值从7.86±0.03降低至7.27±0.03,土壤总氮从2.53±0.13 g/kg降低至0.77±0.04 g/kg;厌氧菌的种群数量是IN-1(10.43±0.71×104CFU/g)IN-3(6.74±0.39×104CFU/g)IN-2(5.15±0.42×104CFU/g),放线菌数量与石油烃含量显著负相关(r=-0.989,p=0.0110.05);IN-3对饱和份和芳香份的降解率最高,分别达到了70.27%和54.52%,远高于IN-2和IN-1;模拟蒸馏结果表明,IN-3正构烷烃得到了很大程度的去除,缺氧的IN-1对正构烷烃去除得较少;厌氧菌数量与胶质和沥青质去除率之间成正相关关系,对于污染源较为分散的污染区域,采用原位生物强化修复时可以考虑引入厌氧修复。     

水力条件对复合人工湿地处理城市受污染河水效果的影响

通过对水力负荷、水力停留时间等水力条件的控制,观察其对复合垂直上行流人工湿地处理城市受污染河水效果的影响.一年多来的运行结果表明:水力条件对复合垂直上行流人工湿地去除其他污染物的影响显著,但对总氮去除的影响不大.水力停留时间的延长可提高总磷、氨氮、COD的去除效果;随着水力负荷的增加,总磷、氨氮、COD去除率都有所增加...     

垂直流人工湿地水力学特性研究

通过示踪剂实验从停留时间分布（RTD）曲线及其统计特征值等方面对垂直流人工湿地的水力学特性进行了定性和定量的分析。研究表明水流在垂直流人工湿地中的流动是一种非理想的不均匀流动,存在一定的死区和水流的扩散;垂直流人工湿地较大的死区率与其表面布水的不均匀性有关,这也可能是其死区率大于表流人工湿地的最主要的原因。实验还表明,进水流量对垂直流人工湿地停留时间分布影响较大,随着进水流量的增加,平均停留时间减小,但标准平均停留时间增大,死区率减小;当进水流量为15L／h（水力负荷为620mm／d）时,水流在湿地中的散度最大,水流更接近全混流,不利于污染物的降解。     

西安f7地裂缝发展变化的预测研究

论文首先分析和总结了影响西安地裂缝发展变化的主要人为因素。随后,利用三维非稳定渗流分析方法研究了人类活动对地下水位的影响;根据西安市新增固定资产投资的变化,预测了地面荷载的变化;以时间、地下水位和地面荷载为基本变量,建立了预测f 7地裂缝活动趋势的BP神经网络模型;最后,借助MATLAB语言进行编程,利用训练稳定的网络模型,预测了f 7地裂缝的活动趋势以及年平均的垂直位移沉降量,为进一步研究西安地铁2号线安全运行和防护提供参考依据。     

Inventory and vertical migration of 90Sr fallout and 137Cs/90Sr ratio in Spanish mainland soils

In this paper the inventory of ⁹⁰Sr in 34 points distributed along the Spanish peninsular territory is presented. Obtained values range between 173 Bq/m² and 2047 Bq/m². From these data set and those ¹³⁷Cs data obtained in a previous work the ¹³⁷Cs/⁹⁰Sr activity ratio has been established, laying this value between 0.9 and 3.6. Also the migration depth of both radionuclides has been analysed obtaining for ¹³⁷Cs an average value 57% lower than that obtained for ⁹⁰Sr.Additionally, this paper presents the results obtained in 11 sampling points in which the activity vertical profile has been measured. These profiles have been analysed to state the behaviour of strontium in soils and after, by using a convective-diffusive model, the parameters of the model which governs the vertical migration of ⁹⁰Sr in the soil, v (apparent convection velocity) and D (apparent diffusion coefficient) have been evaluated. Mean values obtained are 0.20 cm/year and 3.67 cm²/year, respectively.     

改性纤维球处理炼油废水的应用研究

通过用改性纤维球处理炼油废水的试验,对纤维球过滤技术的处理效果和反冲洗特性进行了详细的研究,试验结果表明,炼油废水经处理后,出水中油的含量小于4 mg/L、悬浮物含量小于6 mg/L,出水可达标排放,并且经过改性后的纤维球在含油废水处理中可以通过反冲洗再生并重复使用.     

立式加热炉节能减排可行性研究

大庆油田原稳装置采用立式加热炉,烟气中存在大量的废热。在现有装置运行中,烟气直接排放,浪费了大量的热量。通过在实验装置中可回收废热资源及废热回收技术研究,采用热管技术回收烟气废热,用于预热空气,不仅会节能降耗,给企业创造可观的经济效益,还会减少大气污染,创造良好的社会效益。