环境约束下长江经济带全要素能源效率的时空分异研究——基于超效率DEA模型和ML指数法

基于超效率DEA模型和ML指数法,考察长江经济带1999~2013年全要素能源效率。实证研究结果显示:研究期内,环境约束下的长江经济带全要素能源效率年均下降2.9%,而不考虑环境因素的全要素能源效率年均下降幅度仅为0.4%,污染是导致能源效率损失的重要因素;长江经济带整体层面全要素能源效率的发展演变基本呈"双峰一谷"的"M"形分布,表现为两个"上升—下降"周期,而省际和上中下游全要素能源效率的演变特征迥异;从空间差异看,省际全要素能源效率差异远远大于上中下游差异,但近年来这种差异均有不同程度的缩小。未来长江经济带发展必须践行生态文明发展战略,保证发展的可持续性,同时加强能源、环保等领域的合作,促进长江经济带全要素能源效率发展的协同进步。     

钠化改性河南南部膨润土吸附亚甲基蓝性能分析

以河南南部天然钙基膨润土为原料,通过钠化改性得到了钠基膨润土.通过调控吸附剂用量、亚甲基蓝（MB）浓度、吸附时间、溶液pH值和温度,分析对比了天然钙基膨润土（PRT-1）、钙基提纯膨润土（PRT-1T）和钠基膨润土（PRT-1Na）对MB的去除效率.同时,对PRT-1T和PRT-1Na对MB的吸附动力学和吸附机制进行了研究.结果表明,由于PRT-1Na有更大的比表面积、更高的阳离子交换容量和更丰富的羟基结构,表现出对MB更好的吸附效果.在同等吸附条件下,PRT-1Na的吸附效果是PRT-1的4倍,PRT-1T是PRT-1的2倍.在20℃,pH为6,PRT-1Na用量为1.0 g,吸附时间为2 h,MB为500 mL,且初始浓度为500 mg·L^-1时,MB去除率高达99.89%.另外,PRT-1Na对MB染料废水的吸附既存在物理吸附也有化学吸附,Elovich模型对PRT-1T和PRT-1Na吸附MB染料废水的过程拟合度均高,但伪一级动力学模型对PRT-1Na拟合效果最好.     

气相色谱法测定室内空气中挥发性卤代烃

建立了活性炭吸附-溶剂解吸-气相色谱测定室内空气中7种挥发性卤代烃的分析方法。样品经活性炭采样管富集后,用二硫化碳解吸,Agilent HP-1色谱柱分离,使用带有电子捕获检测器的气相色谱仪测定,以保留时间定性,外标法定量。当采样体积为10 L时,方法检出限范围是0.03~0.18 g/m3,加标回收率在72%~114%之间,相对标准偏差小于15%。结果表明,该方法可以应用于室内空气中痕量挥发性卤代烃样品的检测分析。     

Life-cycle phosphorus use efficiency of the farming system in Anhui Province,Central China

The rapid increase of phosphorus (P) use in farming has raised concerns regarding its conservation and environmental impact. Increasing the P use efficiency (PUE) is an approach to mitigating these adverse impacts. In this study, we applied substance flow analysis (SFA) to establish a life-cycle P use efficiency model to determine the life-cycle PUE of the farming system used in Anhui Province in 2011, which is typical of the agriculture practiced in central China. Based on this model, the P flows and PUEs of five subsystems were identified and quantified: crop farming, crop processing, livestock breeding, rural living, and urban living. The three largest P flows were found in the crop farming and livestock breeding subsystems; it can therefore be concluded that these subsystems have substantial impacts on the entire farming system. In contrast, the PUEs of crop farming, rural consumption, and livestock breeding subsystems presented the three lowest PUEs (58.79%, 71.75%, and 76.65%, respectively). These results were also consistent with the finding that the greatest P losses occurred in crop farming and livestock breeding. Consequently, the study proposes that great potential exists for increasing PUEs in the farming system of Anhui, and several of the most promising measures could be combined for improving PUEs. Finally, the study assesses data quality and presents a sensitivity analysis for use in interpreting the results. The study also shows that improving PUE and decreasing P losses in farming systems through improved nutrient management must be considered an important issue, and this study represents valuable experience in resource conservation and agricultural development in China.     

高炉出铁场除尘方案研究

某钢铁企业高炉炼铁车间的出铁场在生产过程中产生大量高浓度的烟尘,对厂区的大气环境及周边的环境造成严重污染,同时直接危害了职工的身体健康。通过对整个出铁场除尘工艺系统及通风状况的分析及实际应用情况,总结出了适合该场合的系统除尘方案。     

Environmental resource footprinting of drug manufacturing: Effects of scale-up and tablet dosage

The formulation and scale-up of batch processes is one of the major challenges in the development of pharmaceutical dosage forms and at the same time a significant resource demanding process which is generally overlooked in environmental sustainability assessments. First, this paper proposes general trends in the experience curve of cumulative resource consumption of pharmaceutical tablet manufacturing of PREZISTA^® 800 mg through wet granulation (WG) at four consecutive scales in both R&D and manufacturing environments (resp. WG1 = 1 kg/h, WG5 = 5 kg/h, WG30 = 30 kg/h and WG240 = 240 kg/h). Second, the authors aim at evaluating the environmental impact from a life cycle perspective of a daily consumption of PREZISTA^® 2× 400 mg tablets versus the bioequivalent PREZISTA^® 800 mg tablet which was launched to enhance patient compliance. Environmental sustainability assessment was conducted at three different system boundaries, which enables identification, localization and eventually reduction of burdens, in this case natural resource extraction. Exergy Analysis (EA) was used at process level (α) and plant level (β) while a cradle-to-gate Exergetic Life Cycle Assessment (ELCA) was conducted at the overall industrial level (γ) by means of the CEENE method (Cumulative Exergy Extraction from the Natural Environment). Life cycle stages taken into account are Active Pharmaceutical Ingredient (API) production, Drug Product (DP) production and Packaging. At process level (α), the total resource extraction for the manufacturing of one daily dose of PREZISTA^® (800 mg tablet) amounted up to 0.44 MJ_ex at the smallest scale (WG1) while this amount proved to be reduced by 58%, 79% and 83% at WG5, WG30 and WG240 respectively. Expanding the boundaries to the overall industrial level (γ) reveals that the main resource demand is at the production of the Active Pharmaceutical Ingredient (API), excipients, packaging materials and cleaning media used in DP production. At the largest scale (WG240) the use of cleaning media during DP production contributes considerably less to the total resource extraction. Overall, the effect of scale-up and learning on resource consumption during DP production showed to possess a power-law experience curve y = 2.40 * x^−0.57 when shifting from WG1 (smallest lab scale) to WG240 (industrial manufacturing). Tablet dosage (2× 400 mg versus 1× 800 mg) did not significantly affect the absolute environmental burden. However, the relative contribution of resource categories did change due to the different production technology. It could be concluded that in meeting social and economic demands by launching the PREZISTA^® 800 mg tablet, no trade-off in environmental burden occurred. On the long term, future research should strive to take into account R&D processes and all services related to pipeline activities taking place prior to market launch and eventually to allocate impacts to the final product.     

System dynamics model for analyzing effects of eco-design policy on packaging waste management system

EU's long-term objective is to become a recycling and resource effective society, where waste is utilized as a resource and waste generation is prevented. A system dynamics model was developed to analyze the policy mechanisms that promote packaging material efficiency in products through increased recycling rates. The model includes economic incentives such as packaging and landfill taxes combined with market mechanisms, behavioral aspects and ecological considerations in terms of material efficiency (the packaging material per product unit, recycled fraction in products). The paper presents the results of application of various policy instruments for increasing packaging material efficiency and recovery rate and reducing landfilled fraction. The results show that a packaging tax is an effective policy instrument for increasing the material efficiency. It ensures the decrease of the total consumption of materials and subsequent waste generation. The tax helps to counteract a rebound effect, which, as identified by the analysis, can be caused by reduced material costs due to eco-design. The model is applied to the case of Latvia. Yet, the elements and structure of the model developed are similar to waste management systems in many countries. By changing numeric values of certain parameters, the model can be applied to analyze policy mechanisms in other countries.     

秸秆还田下氮肥用量对玉米产量及土壤无机氮的影响

研究连续2年秸秆还田下氮肥用量对玉米产量、氮肥利用率及土壤硝态氮的影响,结果表明,玉米产量随着施氮量的增加逐渐增加,施氮量达到216 kg·hm^-2时,产量最高,施氮量超过216 kg·hm^-2时产量有降低的趋势。相同施氮处理玉米产量年际变化明显,2010年较2009年产量提高0.69％~4.75％。氮肥利用率、氮肥农学利用率和氮收获指数随着秸秆还田年限的增加,均有不同程度的增加。2年0~100 cm土层土壤硝态氮含量均以施氮240 kg·hm^-2最高,且有向土壤深层迁移的趋势,对浅层地下水构成潜在的威胁。与施氮240 kg·hm^-2相比,施氮168、192 kg·hm^-2和216 kg·hm^-2处理0~100 cm土壤无机氮残留量2年平均减少39.87％、35.84％和29.38％。相同施氮处理,0~100 cm土壤无机氮累积量2010年较2009年略有降低。综合考虑玉米产量、氮肥利用率与生态环境效益,该地区最适施氮量200 kg·hm^-2左右。     

Erosional Consequence of Saltcedar Control

Removal of nonnative riparian trees is accelerating to conserve water and improve habitat for native species. Widespread control of dominant species, however, can lead to unintended erosion. Helicopter herbicide application in 2003 along a 12-km reach of the Rio Puerco, New Mexico, eliminated the target invasive species saltcedar (Tamarix spp.), which dominated the floodplain, as well as the native species sandbar willow (Salix exigua Nuttall), which occurred as a fringe along the channel. Herbicide application initiated a natural experiment testing the importance of riparian vegetation for bank stability along this data-rich river. A flood three years later eroded about 680,000 m³ of sediment, increasing mean channel width of the sprayed reach by 84%. Erosion upstream and downstream from the sprayed reach during this flood was inconsequential. Sand eroded from channel banks was transported an average of 5 km downstream and deposited on the floodplain and channel bed. Although vegetation was killed across the floodplain in the sprayed reach, erosion was almost entirely confined to the channel banks. The absence of dense, flexible woody stems on the banks reduced drag on the flow, leading to high shear stress at the toe of the banks, fluvial erosion, bank undercutting, and mass failure. The potential for increased erosion must be included in consideration of phreatophyte control projects.     

Comparison of a two-stage sampling design and its composite sample alternative: An application to soil studies

The objective of a long-term soil survey is to determine the mean concentrations of several chemical parameters for the pre-defined soil layers and to compare them with the corresponding values in the past. A two-stage random sampling procedure is used to achieve this goal. In the first step, n subplots are selected from N subplots by simple random sampling without replacement; in the second step, m sampling sites are chosen within each of the n selected subplots. Thus n · m soil samples are collected for each soil layer. The idea of the composite sample design comes from the challenge of reducing very expensive laboratory analyses: m laboratory samples from one subplot and one soil layer are physically mixed to form a composite sample. From each of the n selected subplots, one composite sample per soil layer is analyzed in the laboratory, thus n per soil layer in total. In this paper we show that the cost is reduced by the factor m — 1 when instead of the two-stage sampling its composite sample alternative is used; however, the variance of the composite sample mean is increased. In the case of positive intraclass correlation the increase is less than 12.5%; in the case of negative intraclass correlation the increase depends on the properties of the variable as well. For the univariate case we derive the optimal number of subplots and sampling sites. A case study is discussed at the end.