Dimethyl phthalate biodegradation by Dunaliella tertiolecta

Dunaliella tertiolecta has an ability to biodegrade dimethyl phthalate(DMP) was found in this study, and the average of the biodegradation rates were 11.3 mg/(L·d) and 30.5 mg/(L·d), and the average of the phthalic acid (PA) production rates were 1.5 mg/(L·d) and 3.6 mg/(L·d), for initial 100 mg/L and 300 mg/L DMP, respectively. The larger amount of accumulation by D. tertiolecta under higher DMP concentration may be responsible for the increase of biodegradation rate, and one of products of DMP biodegradation by D. tertiolecta may be PA. By fitting the process of DMP biodegradation by D. tertiolecta with a kinetic equation newly suggested, the standard deviations between calculated and observed values were 2.5 mg/L and 5.7 mg/L, respectively.     

Petroleum waste biodegradation with porous biomass support system (PBSS) on rotating biological contactor

A laboratory scale study was conducted to assess the feasibility of the new coupling of rotating biological contactor (RBC) plus porous biomass support system (PBSS) using polyurethane foam as porous support media to biodegrade petroleum refinery wastewater. Polyurethane foam was attached on disks of two four-stage laboratory scale cascade connected RBC units.The two RBC units were operated simultaneously at different but constant, flowrates giving hydraulic loading rates of 0.01, 0.02, 0.03, 0.04 m3/m2/d in two runs keeping the same rotational speed 10 r/min throughout. Organic loading was a less controllable factor in this study.For all of the hydraulic loadings, it was found that the removal efficiency of total chemical oxygen demand (TCOD) and oil were above 80 percent. Ammonia nitrogen and phenol removal were above 90 and 80 percent respectively. The maximum biomass concentration within polyurethane foam was about 30 g/m2 in the first stage for 0.03 m3/m2/d hydraulic loading.The results show that t     

Evidence for biodegradation and volatilisation of dissolved petroleum hydrocarbons during in situ air sparging in large laboratory columns

Laboratory column experiments run for up to 13 days compared air sparging of groundwater contaminated by dissolved petroleum hydrocarbons in sterile and non-sterile aquifer sediments as well as uncontaminated sediments and groundwater. Loss of dissolved BTEX compounds in the contaminated columns was very rapid, occurring through volatilisation. The majority of the dissolved total organic carbon (TOC) persisted for much longer periods however. A direct comparison between losses from sterile and non-sterile columns suggested a negligible contribution of biodegradation to the removal of TOC. This was difficult to confirm through examination of O₂ utilisation because oxidation of a small amount of reduced sulphur in the aquifer materials was the dominant sink for O₂. Despite this, it was possible to conclude that less than 22% of the removal of TOC was through biodegradation during the first three days of air sparging.     

The influence of degree of substitution on blend miscibility and biodegradation of cellulose acetate blends

In this account, we report our findings on blends of cellulose acetate having a degree of substitution (DS) of 2.49 (CA2.5) with a cellulose acetate having a DS of 2.06 (CA2.0). This blend system was examined over the composition range of 0–100% CA2.0 employing both solvent casting of films (no plasticizer) and thermal processing (melt-compressed films and injection molding) using poly(ethylene glycol) as a common plasticizer. All thermally processed blends were optically clear and showed no loss in optical quality after storage for several months. Thermal analysis and measurement of physical properties indicate that blends in the middle composition range are partially miscible, while those at the ends of the composition range are miscible. We suggest that the miscibility of these cellulose acetate blends is influenced primarily by the monomer composition of the copolymers. Bench-scale simulated municipal composting confirmed the biodestructability of these blends and indicated that incorporation of a plasticizer accelerated the composting rates of the blends.In vitro aerobic biodegradation testing involving radiochemical labeling conclusively demonstrated that both the lower DS CA2.0 and the plasticizer significantly enhanced the biodegradation of the more highly substituted CA2.5.While this work was in progress, Robert Gardner was struck with cancer and died on June 6, 1995. This paper is dedicated to his memory and to his contributions as a friend and colleague.     

钻井液化学剂可生物降解性研究

实验测定了16种钻井液化学剂的BOD_5和COD_cr，并计算其BOD_5／COD_cr比值。提出了以BOD_5／COD_cr的比值划分钻井液化学剂可生物降解性的分级标准，并对16种钻井液化学剂的可生物降解性进行分级，为其应用提供依据。     

Starch- polyvinyl alcohol crosslinked film— performance and biodegradation

Starch-PVOH cast films were prepared with and without crosslinking agent (hexamethoxymethylmelamine) in the absence of plasticizer. Moisture absorption in films without crosslinking agent at a low relative humidity was similar to that of PVOH and increased as the relative humidity increased. Films with crosslinking agent showed moisture absorption linearly proportional to the relative humidity. Significant improvement in resistance to water disintegration for crosslinked starch-PVOH films was observed. While the tensile strength decreased with increased relative humidity, crosslinking significantly improved the tensile strength. Increased PVOH content improved elongation of films even when the relative humidity was 80% or higher. Biodegradation studies revealed that the degradation rate was negatively correlated with the PVOH content in films and crosslinking generated more converged degradation curves. Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by USDA implies no approval of the product to the exclusion of others that may also be suitable.     

Pseudomonas sp. ZXY-1, a newly isolated and highly efficient atrazine-degrading bacterium, and optimization of biodegradation using response surface methodology

Atrazine, a widely used herbicide, is increasing the agricultural production effectively, while also causing great environmental concern. Efficient atrazine-degrading bacterium is necessary to removal atrazine rapidly to keep a safe environment. In the present study, a new atrazine-degrading strain ZXY-1, identified as Pseudomonas, was isolated. This new isolated strain has a strong ability to biodegrade atrazine with a high efficiency of 9.09 mg/L/hr.Temperature, p H, inoculum size and initial atrazine concentration were examined to further optimize the degradation of atrazine, and the synthetic effect of these factors were investigated by the response surface methodology. With a high quadratic polynomial mathematical model(R~2= 0.9821) being obtained, the highest biodegradation efficiency of 19.03 mg/L/hr was reached compared to previous reports under the optimal conditions(30.71°C, pH 7.14, 4.23%(V/V) inoculum size and 157.1 mg/L initial atrazine concentration).Overall, this study provided an efficient bacterium and approach that could be potentially useful for the bioremediation of wastewater containing atrazine.     

EDTA增强Cr(VI)共存时Burkholderia cepacia降解孔雀绿的效率

重金属共存严重抑制了微生物降解染料的效率,本研究拟采用EDTA螯合Cr提高Burkholderia cepacia C09G降解复合污染中孔雀绿的效率.实验结果表明,0.1 mmol·L~(-1)孔雀绿单独存在条件下,24 h的生物降解率达到96.2%;然而,在0.5 mmol·L~(-1)Cr(VI)共存条件下,60 h的降解率仅为6.7%.当加入0.5 mmol·L~(-1)EDTA螯合剂后,60 h时孔雀绿的降解率提高到18.8%.当EDTA浓度为0.5 mmol·L~(-1)时,最佳螯合Cr(VI)的浓度为0.7 mmol·L~(-1),此时,60 h后孔雀绿的降解率达到35.3%,对Cr(VI)的吸附率为24.6%.此外,通过EDS、SEM、XPS分析证明,EDTA可以减小Cr(VI)的毒性,Burkholderia cepacia C09G可将吸附的Cr(VI)还原为Cr(III).     

砷-菲对蜈蚣草根部不同碳基团的影响

采用离体鲜根实验和固态13C核磁共振技术(13C-NMR)研究蜈蚣草根部对砷和菲的吸收特征及根部碳基团的影响作用.结果表明,蜈蚣草根部在无蒸腾作用的条件下能够有效地吸收砷和菲,添加菲能够促进离体鲜根对砷的吸收,添加砷也可提高菲的吸收,与对照相比,菲提高了15%~53%.蜈蚣草离体鲜根中以烷氧基C为主,羧基C比例最低,且主要为羧酸、酯和酰胺类羧基C,添加砷和菲会显著增加蜈蚣草离体鲜根中羧基C的比例.蜈蚣草离体鲜根为应对砷和菲的胁迫形成了分子结构更为稳定和复杂的芳香类有机质,从而提高离体鲜根的抗性和适应性.     

不同pH下纳米铁镍颗粒对生物降解苯酚的影响

研究不同pH(8.0、6.0和3.0)下金属纳米颗粒(Fe和Fe/Ni)对纺锤芽孢杆菌(BFN)降解苯酚的影响.实验结果发现pH在8.0和6.0时投加2种金属纳米颗粒(Fe和Fe/Ni)对BFN降解苯酚有促进作用,其原因主要是纳米颗粒在水中持续腐蚀产生H2,为BFN降解苯酚提供电子,促进BFN的生长.但在pH=3.0时,只有BFN-纳米Fe耦合体系才使苯酚得到部分降解,主要是因为纳米Fe颗粒与水反应产生OH-,使pH值有所升高,更适宜BFN的生长,同时提供电子供体H2促进BFN对苯酚的利用.扫描电镜(SEM)和能谱分析(EDS)数据证实金属纳米颗粒(Fe和Fe/Ni)在反应后附着在微生物表面,但微生物的表面形态并未发生显著改变.因此,纳米金属颗粒虽然通过附着影响微生物的活性,但其在腐蚀过程中产生的H2将作为电子供体而被BFN所利用,综合作用的结果是有利于BFN的生长进而提高苯酚的降解速率.