膜电解技术处理含氯及重金属的废酸

采用离子交换膜电解技术处理铜冶炼过程产生的含氯及重金属的废酸。考察了废酸处理工艺、电解温度、电解时间、电流密度和催化剂的添加等条件对处理效果的影响。实验结果表明：采用先沉淀重金属后脱氯的废酸处理工艺,氯离子和铜离子的去除效果均较好;当以钛盐为催化剂时,在电解温度为40 ℃、电解时间为2.0 h、电流密度为825 A/m²的最佳工艺条件下,处理后废酸中的氯离子质量浓度为0.22 g/L,氯离子去除率为98.59%,铜离子质量浓度为0.45 g/L,铜离子去除率为95.08%,其他重金属大部分也得到有效去除。净化后的废酸可回用至铜冶炼的生产过程中。     

表面活性剂改性4A分子筛对Cr(VI)的吸附行为

采用浸渍法对4A分子筛进行表面改性,通过引入阳离子表面活性剂,使4A分子筛表面附着季铵型阳离子,并与反离子Br-形成"阴离子交换膜",从而促使更多的Cr(VI)阴离子通过离子交换吸附到改性4A分子筛上,通过X-射线衍射(XRD)和傅里叶变换红外光谱(FTIR)对样品的物相结构和组成进行表征分析。研究表明,表面活性剂的类型和疏水碳氢链结构会影响4A分子筛的吸附能力,十八烷基三甲基溴化铵(OTAB)碳氢链长,在分子筛表面形成的双分子层密,对Cr(VI)的吸附量最大。采用准一级、准二级、Elovich和Bangham动力学模型对六价铬的吸附数据进行拟合,其中准一级动力学方程最符合十八烷基三甲基溴化铵改性分子筛的吸附行为。同时,分别从Langmuir和Redlich-Peterson等温吸附模型获得六价铬的最大吸附量为13.98 mg/g,且改性分子筛以均一表面吸附为主。     

Development of a hybrid microbial fuel cell (MFC) and fuel cell (FC) system for improved cathodic efficiency and sustainability: the M2FC reactor

In an effort to improve the efficiency and sustainability of microbial fuel cell (MFC) technology, a novel MFC reactor, the M2FC, was constructed by combining a ferric-based MFC with a ferrous-based fuel cell (FC). In this M2FC reactor, ferric ion, the catholyte in the MFC component, is regenerated by the FC system with the generation of additional electricity. When the MFC component was operated separately, the electricity generation was maintained for only 98 h due to the depletion of ferric ion in the catholyte. In combination with the fuel cell, however, the production of power was sustained because ferric ion was continually replenished from ferrous ion in the FC component. Moreover, the regeneration process of ferric ion by the FC produced additional energy. The M2FC reactor yielded a power density of up to 2 W m⁻² (or time-averaged value of approximately 650 mW m⁻²), density up to 20 times (or approximately six times based on time-averaged value) higher than the corresponding MFC system.     

Novel mesoporous microspheres of Al and Ni doped LMO spinels and their performance as cathodes in secondary lithium ion batteries

A facile, scalable, and solution-based technique is used to fabricate Al and Ni-doped (LiAl_0.1Mn_1.9O₄ and LiAl_0.1Ni_0.1Mn_1.8O₄) microspheres of lithium manganese oxide (LMO) spinels for use as reversible cathode materials for lithium ion batteries (LIBs). The spheres of the two samples exhibit different porosities. Cells with these LMO-based cathodes are then cycled between 4.5 V and 2 V to study their stabilities while simultaneously being subjected to the undesirable Jahn-Teller distortion that occurs around the ~3 V regime. The LiAl_0.1Mn_1.9O₄ (LAMO) and the LiAl_0.1Ni_0.1Mn_1.8O₄ (LANMO) cells exhibit comparable open circuit voltages (OCV) of 2.94 V and 2.97 V, respectively. During cell cycling, the LAMO cell exhibits a maximum specific capacity of 122.51 mAh g^?1 with a capacity fade of 65.35% after 75 cycles. The LiAl_0.1Ni_0.1Mn_1.8O₄ (LAMO) sample fares better and exhibits a maximum of 140.49 mAh g^?1 and a capacity drop of 52.59%. Detailed structural studies indicate that Ni doping and the greater degree of porosity of the LANMO sample to be a stabilizing factor. This is further confirmed by cyclic voltammetry (CV) and AC impedance spectra analysis.     

碱激发胶凝材料及其固化Pb^2＋的试验研究

对碱激胶凝材料（碱-偏高岭土、碱-矿渣和碱-粉煤灰）与水-水泥体系固化Ph^2＋进行了试验研究,其中水-水泥体系为对比样。结果表明：对于相同稠度的碱激发胶凝材料,即使Pb^2＋含量达到2．4％,除了碱-粉煤灰的抗压强度略低外,其他都达到30MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子（Ph^2＋）浸出浓度,其规律性与其NH4交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性。     

Changes in negative air ions concentration under different light intensities and development of a model to relate light intensity to directional change

The purpose of this research was to determine changes in negative air ion (NAI) concentrations produced by plants grown under different light intensities. NAI concentrations were observed and analyzed in an outdoor green space with five plant species (Aloe arborescens, Clivia miniata, Chlorophytum comosum, Opuntia brunnescens, Crassula portulacea) and A. arborescens was then grown under controlled-light conditions in an enclosed space for the subsequent light intensity experiment.     

稠油污水回用锅炉处理工艺的应用

新疆油田公司稠油污水处理普遍采用成熟的离子调整旋流反应水处理技术,污水处理后达到回用锅炉水质标准SY/T 0097-2000《稠油油田采出水用于蒸汽发生器给水处理设计规范》,供给油田专用高压注汽锅炉用水。采用相同技术建成的采油一厂稠油处理站污水回用锅炉处理工艺投用后,处理后污水回用锅炉,减少了含油污水的外排,充分利用了稠油污水的热能,取得了良好的经济和社会效益。     

单标多点校正组合英蓝超滤测定地表水中多种阴离子

建立了利用组合单标多点校正和英蓝超滤单元的离子色谱法测定地表水中F-、C1-、NO3-、S0424—4-种离子的方法,方法操作简便,灵敏度高,线性范围广,抗干扰能力强,可同时快速测定不同数量级浓度的离子,降低了配置标准品和样品前处理的复杂性,减少了因前处理带来的干扰。     

Structural and optical characterization of dissolved organic matter from the lower Athabasca River, Canada

Dissolved organic matter (DOM) is a ubiquitous constituent of natural waters and is comprised of a variety of chemically heterogeneous molecular structures and functional groups. DOM is often considered to be a major ligand for metals in most natural waters and its reactivity is thought to be strongly dependent on its chemical composition and structure. In this study, a combination of UV/visible, emission excitation matrix fluorescence (EEM) and ¹H NMR spectroscopies were used to characterize DOM from the Athabasca River (Alberta, Canada). The chemical characterization of river DOM showed that the most upstream samples located in agricultural areas were blue-shifted and less aromatic and contained more hydrogens connected with oxygen functional groups than those in the wetland dominated area in the Athabasca oil sand deposit region. The presence of paramagnetic ions (Fe and Al) was not found to significantly affect the structural composition of DOM as revealed by ¹H NMR. Such change in the quality of DOM may have a profound impact on metal binding in the Athabasca River watershed.     

一株抗Cd~（2＋）菌株的筛选及其吸附性能

Cd2＋为一种毒性金属元素,为了实际解决污水中低浓度重金属污染,实现污水达标排放,通过12C6＋重离子束辐照诱变技术筛选到一株耐受Cd2＋的菌株C2,研究其对Cd2＋的抗性和低浓度Cd2＋的吸附性能表明,Cd2＋浓度≤100 mg/L时,C2菌株可以生长繁殖,但随Cd2＋浓度升高受到抑制;SEM分析表明,受到Cd2＋胁迫时,C2产生大量胞外产物与Cd2＋形成络合物;吸附过程中菌粉表面空隙得到填充,形成凸起;红外光谱分析表明,吸附过程中的主要作用基团为醇羟基O—H键、氨基和酰胺基团;C2菌粉和固定化菌球都对Cd2＋有较好的吸附能力,菌粉吸附效果比固定化菌球稍好;菌粉和固定化吸附剂的最佳吸附初始pH值为5~6.0,最佳投加量分别为1.0 g/L和10 g/L（实际含菌量为1.0 g/L）;Cd2＋浓度在2~20mg/L时,在最佳吸附条件下,菌粉和固定化吸附剂对Cd2＋的吸附率均在90%左右;2种吸附剂吸附过程与Langmuir等温模型和拟二级动力学模型拟合最佳;热力学研究表明吸附反应均能自发进行。以上研究结果表明,C2菌粉和固定化吸附剂均可用于污水中低浓度Cd2＋的去除。