锈蚀钢筋混凝土圆柱抗震性能的试验研究

对不同锈蚀程度的钢筋混凝土圆柱进行低周反复试验,研究了不同轴压比下的钢筋锈蚀率对钢筋混凝土圆柱滞回曲线、骨架曲线、刚度、延性及耗能能力的影响;给出了试件累积耗能、屈服荷栽、极限荷栽、荷栽最大值和位移延性系数与钢筋锈蚀率和轴压比的关系.研究表明,随着钢筋锈蚀率和轴压比的增大,试件的滞回曲线趋于干瘪,骨架曲线下降段变陡,试...     

砂土与EPS颗粒混合的轻质土(LSES)临界循环应力比的试验研究

循环荷载下,砂土与EPS颗粒混合的轻质土(LSES)存在临界循环应力比Sth,将割线弹性模量衰减系数δ与循环次数的关系曲线能保持平缓的最大循环应力比定义为Sth,它是结构稳定与破坏两种状态的界限指标,根据动三轴试验结果,认为影响Sth的主要因素有围压、水泥掺量和EPS颗粒含量。一般来说,水泥掺量的增加、围压和EPS颗粒含量的减小均会提高Sth,但由于高围压下的结构重塑,水泥掺量低且EPS颗粒含量高的试样的Sth表现出一些不同的性状。     

二氧化铅电极的制备、表征及其电催化性能研究

以电沉积法制备了Ti/PbO2和Ti/MnO2/PbO22种电极.采用SEM、XRD和XPS等分析方法表征了电极的形貌、元素组成及元素化学态,并以罗丹明B为目标有机物,考察了所制备电极的析氧极化曲线和电催化活性以及Ti/MnO2/PbO2电极的循环伏安曲线.研究结果表明,Ti/MnO2/PbO2电极的稳定性、使用寿命、析氧电位和电催化活性较Ti/PbO2电极都有所提高,并且罗丹明B在Ti/MnO2/PbO2电极上的反应主要发生在析氧反应区,且反应不可逆.     

Concentrations of cadmium and lead heavy metals in Dardanelles seawater

Cadmium and lead were determined simultaneously in seawater by differential pulse stripping voltammetry (DPSV) preceded by adsoptive collection of complexes with 8-hydroxyquinoline (oxine) on to a hanging mercury drop electrode (HMDE). In preliminary experiments the optimal analytical condition for oxine concentration was found to be 2.10⁻⁵ M, at pH 7.7, the accumulation potential was −1.1 V, and the initial scannig potential was −0.8 V. The peak potentials were found −0.652 V for Cd and −0.463 V for Pb At the 60 s accumalation time. The limit of detection (LOD) and limit of quantitatification (LOQ) were found to be by voltammetry as 0.588 and 1.959 μg l⁻¹ (RSD, 5.50%) for Cd and 0.931 and 3.104 μg l⁻¹ (RSD, 4.10%) for Pb at 60 s stirred accumulation time respectively. In these conditions the most of the seawater samples are amenable for direct voltammetric determination of cadmium and lead using a HMDE. An adsorptive stripping mechanism of the electrode reaction was proposed. For the comparison, seawater samples were also analysed by ICP-atomic emission spectrometry method (ICP-AES). The applied voltammetric technique was validated and good recoveries were obtained.     

Determination of Nitrobenzene in Wastewater Using a Hanging Mercury Drop Electrode

The determination of trace amount nitrobenzene in wastewater on a hanging mercury drop electrode was studied. The determination conditions of pH, supporting electrolyte, accumulation potential, accumulation time, and voltammetric response were optimized. The sharp peak of the nitrobenzene was appeared at 0.05 V. The peak electric current was proportional to the concentration of nitrobenzene in the range of 1.47 × 10⁻⁵ ∼ 1.0 × 10⁻³ mol/l with relative standard deviations of 3.99 ∼ 8.94%. The detection limit of the nitrobenzene in water was 5 × 10⁻⁶ mol/l. The proposed method offered low limit of determination, easy operation, the use of simple instrumentation, high sensitivity and good reproducibility. It was applied to the determination of nitrobenzene in wastewater with an average recovery of 94.0% ∼ 105%. The proposed method provided fast, sensitive and sometimes real time detection of nitrobenzene.     

射流曝气周期活性污泥法脱氮除磷研究

针对零星居民点的污水处理,开发了射流曝气周期活性污泥法工艺.它是一种连续进水、周期性间歇曝气的改良型SBR工艺,也是一种时间程序和空间程序相结合的污水处理工艺,具有良好的脱氮除磷效果.试验表明,在水力负荷4 m3/d,曝气周期为每2 h曝气15 min、静置105 min的条件下,出水COD为48.8～53.5 mg/L,去除率达79.4%～80.5%;出水TN为2.81～3.98 mg/L,去除率达82.4%～89.4%;出水NH3-N为0.36～0.78 mg/L,去除率高达96.4%～98.4%;出水TP为0.63～1.18 mg/L,去除率为67.2%～78.9%,均可达到《城镇污水处理厂污染物排放标准》(GB 18918-2002)中的一级B排放标准.     

粉煤灰最大往返剪切作用面上应变破坏标准的应力条件

基于文献[1]提出的最大往返剪切作用面上的液化应力条件和粉煤灰的动三轴试验数据,运用回归分析方法拟合曲线及相关参数建立了粉煤灰的破坏应力条件,并应用F检验法对参数的回归效果进行了检验,检验结果表明参数的回归效果高度显著。得出的破坏应力条件表明初始剪应力与动剪应力的倒数间并不呈线性关系,而是二次多项式关系,这与张克绪所提出的应力条件存在着差异。因此,可初步认为张克绪的液化应力条件不能直接运用于粉煤灰。     

循环载荷下煤裂隙演化试验研究

为了研究循环载荷下的煤体裂隙演化特征,在不同应力水平和不同频率条件下分别进行煤样破坏力学及声发射试验。结果表明:应力-应变曲线呈疏-密-疏的变化特征,对应的振铃数柱状图呈U型;上限应力点的应变值、累积能量、撞击计数均随循环次数增加而上升,曲线呈倒S型;煤裂隙演化经历了原始裂隙闭合、新生裂隙稳定发育和裂纹贯穿破坏等3个不同阶段;循环载荷的应力水平和加载频率对煤体疲劳寿命的影响具有差异性,对煤体裂隙演化和破坏模式均有明显影响。     

循环荷载对饱和黄土动剪模量的影响研究

利用装有压电陶瓷弯曲元的双向振动三轴仪对饱和黄土进行了循环荷载试验,并根据静力固结条件下黄土的动剪模量发展规律建立了基于哈定方程的拟合曲线;将循环荷载作用下的动剪模量与静力固结下的动剪模量进行了对比研究,并根据轴向应变的发展规律,确定了以上2种条件下动剪模量产生差异的原因:试样结构性破坏,土颗粒重排列,土体具有很高的敏感性。对于振动过程中的暂停对试验的影响进行了研究,认为由于暂停时间很短,可以忽略这种影响。在振动结束后,对试样在原压力下重新进行固结,结果表明,固结完成后,试样的动剪模量增大,且增大幅度随着密度的增加而变小。     

不同运行模式对同步脱氮除磷CAST工艺快速启动及其稳定维持的影响

以实际生活污水为处理对象,考察了传统进水/曝气和改良型分段进水的交替缺氧-好氧(A/O)2种运行模式对CAST工艺的快速启动及脱氮除磷性能稳定维持的影响。结果表明,传统进水/曝气运行模式下,系统达到最佳营养物去除性能所需启动时间30 d,稳定运行阶段TN平均去除80.66%,磷的去除率维持在66.30%左右;采用改良型交替运行模式,反应器达到稳定运行状态仅需18 d,系统稳定运行时TN平均去除81.36%,磷去除率稳定维持在90%以上,出水磷浓度在0.3 mg/L以下,出水水质达到国家污水综合排放标准一级A(GB8978-2002)。研究还发现,传统运行模式下,由低温引起的污泥沉降性能变差导致系统污泥严重流失,反应器几乎丧失污染物去除性能;而低温对交替运行模式下的反应器除磷性能几乎没有影响,总氮去除则因氨氮不完全硝化而大大降低。