3种运行模式下CAST工艺脱氮性能

以模拟城市污水为处理对象,采用循环式活性污泥法（CAST）反应器,对3种运行模式（M1：常规模式,M2：缺氧好氧模式、M3：缺氧好氧交替模式）下系统的脱氮性能进行了研究,比较了各模式下CAST反应器的氨氮和总氮的去除效率,并对各模式下典型周期内氮基质浓度变化进行了考察,以确定系统的脱氮模式。结果表明,在氨氮去除不成为限制条件（去除率〉90％）的条件下,3种运行模式下系统总氮的平均去除率分别为67．3％、70．6％和82．4％,以缺氧好氧交替模式下的最高;M1、M2和M3均可实现亚硝酸型硝化,但随着温度的升高,亚硝酸型硝化逐渐消失。静态实验分析表明,3种模式下系统的氨氧化速率大小次序为：vN：M1〉vN：M2〉vN：M3,反硝化速率大小次序为：vDN,M2〉vDN,M3〉vDN,M1。     

基于方波溶出伏安法的电化学传感器检测水体中痕量铅

基于方波溶出伏安法运用丝网印刷电极探索了一种利用电化学传感器检测水样中痕量铅的方法.得到了该检测方法的最佳参数:方波频率30 Hz,振幅80 mV,电位增量5 mV;0.5 mol/L的支持电解质(KCl);沉积电位-1.1 V,沉积时间400 s.在该优化条件下,在浓度为25 ～ 500μg/L范围内溶出峰电流与铅离子浓度呈良好的线性关系(R2=0.9945).对于几种其他金属离子的干扰实验结果表明,Mn2的存在严重抑制铅离子的峰电流.     

Electrochemical study of the fungicide acibenzolar-s-methyl and its voltammetric determination in environmental samples

The electrochemical behavior of new generation fungicide acibenzolar-s-methyl (S-methyl 1,2,3-benzothiadiazole-7-carbothioate, ASM) on the hanging mercury drop electrode (HMDE) was investigated using square wave adsorptive stripping voltammetry. This method of determination is based on the irreversible reduction of ASM at the HMDE. The well-defined ASM peak was observed at ?0.4 V (vs. Ag/AgCl) in BR buffer at pH 2.2. The reduction peak current was proportional to concentration of ASM from 1.0 × 10^?8 to 6.0 × 10^?8 mol L^?1 with detection and quantification limit 3.0 × 10^?9 and 1.0 × 10^?8 mol L^?1, respectively. The applicability of the developed method for analysis of spiked samples of tap water, river water, and soil is illustrated. The effect of adsorption on the mercury electrode was studied in detail using the AC impedance method. Possible interferences with other common pesticides and heavy metal ions were examined. Clarification of the electrode mechanism was made using cyclic voltammetry (CV) technique.     

2A12铝合金在模拟溶液中的周浸腐蚀行为

采用干湿周浸实验、失重法和电化学阻抗谱研究了2A12铝合金在0.6mol/L NaCl和0.6mol/L NaCl 0.02mol/L NaHSO3两种溶液中的腐蚀行为与规律, 利用扫描电镜(SEM)、能谱(EDX)和红外光谱(FTIR) 观察分析腐蚀产物表面形貌、结构和组成,测试了材料的力学性能.研究表明,随腐蚀时间的延长,腐蚀产物不断增多,失重增加,力学性能下降,阻抗模值逐渐减小;腐蚀产物形貌以团状和块状为主,在0.6mol/L NaCl溶液中腐蚀产物主要为铝的氯化物和氧化铝,在0.6mol/L NaCl 0.02mol/L NaHSO3溶液中腐蚀产物主要为氧化铝、铝的硫酸盐水合物和铝的氯化物;由于NaCl和NaHSO3共同作用,2A12合金在0.6mol/L NaCl 0.02mol/L NaHSO3溶液中腐蚀电流密度高,阻抗模值相对较小,腐蚀速率较高,腐蚀后失重大,力学性能下降幅度较大,腐蚀更严重.     

Simultaneous determination of three herbicides by differential pulse voltammetry and chemometrics

A novel differential pulse voltammetry method (DPV) was researched and developed for the simultaneous determination of Pendimethalin, Dinoseb and sodium 5-nitroguaiacolate (5NG) with the aid of chemometrics. The voltammograms of these three compounds overlapped significantly, and to facilitate the simultaneous determination of the three analytes, chemometrics methods were applied. These included classical least squares (CLS), principal component regression (PCR), partial least squares (PLS) and radial basis function-artificial neural networks (RBF-ANN). A separately prepared verification data set was used to confirm the calibrations, which were built from the original and first derivative data matrices of the voltammograms. On the basis relative prediction errors and recoveries of the analytes, the RBF-ANN and the DPLS (D – first derivative spectra) models performed best and are particularly recommended for application. The DPLS calibration model was applied satisfactorily for the prediction of the three analytes from market vegetables and lake water samples.     

Ring-Opening Polymerization of Cyclic Esters onto Liquefied Biomass

Ring-opening polymerization of cyclic esters (-caprolactone, -valerolactone, and l-lactide) onto liquefied biomass (LB) was conducted to obtain the polyester-type polyol and to regulate the characteristics of LB. IR and ¹H-NMR spectra of the obtained polyol showed that the polymerization was successfully conducted in the presence of acid catalyst, which is used in liquefaction. The molecular weight (M_w), hydroxyl value, and viscosity were controllable by changing the reaction conditions. Polyester-type polyurethane foams with a wide range of properties were prepared from the obtained polyol with the appropriate combinations of foaming agents.     

MANAGEMENT ASPECTS OF CYCLIC STORAGE OF WATER IN AQUIFER SYSTEMS1

ABSTRACT: Most of California's precipitation falls at the wrong place in the wrong season in relation to the water needs. Redistribution and regulation are essential. Aquifer systems – groundwater basins – can provide a share of the future cyclic storage regulation. There are some differences in management concepts in using a full basin in comparison with a partially dewatered basin. Legal, water quality, and physical impacts on aquifer systems, including subsidence, are concerns. Storage may be for the benefit of overlying water users or for distant areas. Extraction during dry periods or recharge methods will require careful planning. Existing rights and uses and equitable treatment of all parties must be assured. Financial compensation may be involved. Changes in methods of operation or degree of self-determination by affected water agencies will require committed watermanship to resolve. Legislation or amendments to organic acts may be needed but much can be accomplished within existing statutes. Environmental impacts which can be avoided by not using large surface storage sites are important. Energy for pumping will be a key consideration. About 40 percent of California is underlain by aquifer systems. This resource offers major potential in overcoming the maldistribution of natural water resources.     

活性炭纤维对于离子的电吸附选择性能研究

通过循环伏安测试、交流阻抗测试、电吸附实验等方法研究了单组分和多组分溶液中不同离子在活性炭纤维电极表面的选择性电吸附性能。结果表明,电吸附选择性能与离子的水合半径、离子价态、离子浓度有关;增大初始浓度可以提高电吸附容量;并且,由于强烈的选择吸附作用,Ca2+离子可以吸附取代其它已经被吸附的离子。     

四川省农业循环经济发展状况评估

通过构建以经济社会发展、资源物资投入、资源循环利用以及资源环境安全四大类指标构成的农业循环经济综合评价指标体系,运用层次分析法,采用综合评价指数及障碍度对四川省2006年~2011年的农业循环经济发展状态进行了评价。结果表明:四川省农业循环经济发展总体状况逐年趋好,对农业循环经济发展的影响程度从大到小的因素是资源物资投入、经济社会发展、资源环境安全及物质循环利用。     

大吨位预应力锚具组装件锚固性能足尺试验

广州西塔节点层系采用大直径体外预应力拉索直接对钢管柱施加楼层平面内方向的体外预应力.选取3根φ7×199的预应力锚具组装件进行了50次周期荷载试验及静载锚同性能足尺试验.采用两台YC-1350型液压千斤顶同步顶推箱梁对预应力试验索进行张拉,测定拉索的周期载荷性能、静载锚同性能、拉伸弹性模量以及极限拉力时的总应变和锚杯与锚板间相对位移,考核锚具拉伸时锚固情况、拉伸过程及卸载后锚具的变形情况.结果表明,经过50次循环加载后试验索均无断丝,破断荷载超过12151kN,其他各项指标也均符合要求,因而能保证广州西塔体外预应力设计的安全性.