CAST工艺高温短程硝化的实现及其除磷性能

以模拟废水为研究对象,考察了22、25、28℃这3个温度下CAST反应器内短程硝化的实现及其除磷性能.结果表明,不同温度下系统的TN去除均稳定在80%以上,且NH_4~+-N去除良好.当温度为22℃和25℃时系统内未观察到亚硝积累,除磷率为94. 3%和86. 9%,升高温度至28℃,反应器内亚硝积累率为87. 2%,实现稳定的短程硝化.此外,高温短程硝化阶段(28℃),系统释、吸磷能力较22℃和25℃均有所下降,且厌氧段释磷量/COD消耗量(P/C)比明显低于前两个阶段.然而,该温度条件下反应器除磷性能并未恶化,除磷率为68. 9%,说明进水碳源充足不仅能保证CAST工艺对TN的去除,同时可用于解毒NO_2~-以减弱其对聚磷菌的抑制.不同温度条件下的污泥吸磷小试发现,O_2、NO_3~-、NO_2~-均可作为电子受体进行吸磷,其中好氧吸磷速率高于以NO_3~-和NO_2~-为电子受体的反硝化吸磷速率,且以O_2和NO_3~-为电子受体的吸磷速率与温度呈负相关.     

C9-AA水溶性石油树脂的制备及其阻垢性能

以乙烯生产过程中的副产物C9馏分和丙烯酸为原料,采用自由基溶液聚合,合成具有阻垢性能的C9-AA水溶性石油树脂。考察了引发剂AIBN和溶剂的加入量、C9-AA加入量、Ca^2＋浓度、循环冷却水pH和养护时间对C9-AA水溶性石油树脂阻垢性能的影响,并对其阻垢效果进行了评价。在Ca^2＋质量浓度小于或等于600mg／L、循环冷却水pH小于或等于9．3、C9-AA水溶性石油树脂加入量大于或等于15mg／L的条件下,C9—AA水溶性石油树脂对循环冷却水的阻垢率达到90％以上,其有效作用时间为60h。     

Concentrations of cadmium and lead heavy metals in Dardanelles seawater

Cadmium and lead were determined simultaneously in seawater by differential pulse stripping voltammetry (DPSV) preceded by adsoptive collection of complexes with 8-hydroxyquinoline (oxine) on to a hanging mercury drop electrode (HMDE). In preliminary experiments the optimal analytical condition for oxine concentration was found to be 2.10⁻⁵ M, at pH 7.7, the accumulation potential was −1.1 V, and the initial scannig potential was −0.8 V. The peak potentials were found −0.652 V for Cd and −0.463 V for Pb At the 60 s accumalation time. The limit of detection (LOD) and limit of quantitatification (LOQ) were found to be by voltammetry as 0.588 and 1.959 μg l⁻¹ (RSD, 5.50%) for Cd and 0.931 and 3.104 μg l⁻¹ (RSD, 4.10%) for Pb at 60 s stirred accumulation time respectively. In these conditions the most of the seawater samples are amenable for direct voltammetric determination of cadmium and lead using a HMDE. An adsorptive stripping mechanism of the electrode reaction was proposed. For the comparison, seawater samples were also analysed by ICP-atomic emission spectrometry method (ICP-AES). The applied voltammetric technique was validated and good recoveries were obtained.     

Determination of Nitrobenzene in Wastewater Using a Hanging Mercury Drop Electrode

The determination of trace amount nitrobenzene in wastewater on a hanging mercury drop electrode was studied. The determination conditions of pH, supporting electrolyte, accumulation potential, accumulation time, and voltammetric response were optimized. The sharp peak of the nitrobenzene was appeared at 0.05 V. The peak electric current was proportional to the concentration of nitrobenzene in the range of 1.47 × 10⁻⁵ ∼ 1.0 × 10⁻³ mol/l with relative standard deviations of 3.99 ∼ 8.94%. The detection limit of the nitrobenzene in water was 5 × 10⁻⁶ mol/l. The proposed method offered low limit of determination, easy operation, the use of simple instrumentation, high sensitivity and good reproducibility. It was applied to the determination of nitrobenzene in wastewater with an average recovery of 94.0% ∼ 105%. The proposed method provided fast, sensitive and sometimes real time detection of nitrobenzene.     

人工神经网络用于铅的化学形态模拟计算

用前馈线性网络法求解水体系中Ｐｂ（２＋）与ＯＨ－之间的反应常数，不同训练算法对求解结果的精度、收敛速度及权值均有影响．结果表明，批处理算法的精度最好，权值不出现负值，但运算时间最长；在线算法的精度虽不如批处理算法，而比数据变换－在线算法好，权值有时会出现负值．运算时间较长；数据变换－在线算法的优点是运算时间短，但相对误差较大，权值出现负值的机会多。采用反馈网络模拟计算铅的各种化学形态的浓度．用物料核算的方法对反馈网络模型进行检验表明，此种模型用于平衡计算是可行的，详细分析了理论模拟和实验曲线的差异的原因，温度的影响最小，在４＜ｐＨ＜９时，ＣＯ有重要的影响．在国代检验时，ｎ值取整所引入的误差的影响亦不可忽视。从本文的结果可以看到，采用前馈网络和反馈网络相结合的方法考察水体中的化学形态是可行的．从而为解决这一类问题提供了一种可能的途径．     

二氧化铅电极的制备、表征及其电催化性能研究

以电沉积法制备了Ti/PbO2和Ti/MnO2/PbO22种电极.采用SEM、XRD和XPS等分析方法表征了电极的形貌、元素组成及元素化学态,并以罗丹明B为目标有机物,考察了所制备电极的析氧极化曲线和电催化活性以及Ti/MnO2/PbO2电极的循环伏安曲线.研究结果表明,Ti/MnO2/PbO2电极的稳定性、使用寿命、析氧电位和电催化活性较Ti/PbO2电极都有所提高,并且罗丹明B在Ti/MnO2/PbO2电极上的反应主要发生在析氧反应区,且反应不可逆.     

砂土与EPS颗粒混合的轻质土(LSES)临界循环应力比的试验研究

循环荷载下,砂土与EPS颗粒混合的轻质土(LSES)存在临界循环应力比Sth,将割线弹性模量衰减系数δ与循环次数的关系曲线能保持平缓的最大循环应力比定义为Sth,它是结构稳定与破坏两种状态的界限指标,根据动三轴试验结果,认为影响Sth的主要因素有围压、水泥掺量和EPS颗粒含量。一般来说,水泥掺量的增加、围压和EPS颗粒含量的减小均会提高Sth,但由于高围压下的结构重塑,水泥掺量低且EPS颗粒含量高的试样的Sth表现出一些不同的性状。     

Electrochemical study of sulfide solution in the presence of surfactants

Voltammetric curve studies on aqueous Na2S solution in the presence of three types of surfactants are presented. Presence of anodic surfactant (HTAB) in creases anode current density and makes the corresponding anode peak potential shift to more negative. Potentials of the reduction of elemental sulfur to intermediates Sx2-shift to more negative with the increasing of HTAB concentrations. In the presence of HTAB, the anode current density at 77oC increases more than at 34oC. The electrolysis indicates that anodic product sulfur loosely adhered to the graphite electrode surface when HTAB is added to the anolyte. The total efficiency of producing sulfur is high after several times of cycle electrolysis.The results show that anode passivation is minimized in the presence of HTAB. The depassivation effect of HTAB is discussed.     

循环经济进程中甘肃省能源可持续利用思路探析

基于循环经济的3R原则,深入分析甘肃省的能源开发利用中存在的诸多能源问题:能源利用效率低,浪费严重;能源结构不合理,工业耗能比重过大;能源环境问题日益严重.提出今后能源开发建设的基本思路是调整能源结构,重点是转向可再生能源和新能源.并就如何实现能源和循环经济协调发展提出一系列战略重点和主要措施.     

CASS工艺用于小城镇污水处理的工程设计研究

CASS是SBR的一种改进型污水处理工艺,在污水处理特别是小城镇污水处理中有着广泛应用。本文介绍了CASS工艺在广东某镇污水处理厂的工程应用情况,主要包括CASS的工艺流程、设计参数及设计要点。对运行效果和经济技术指标进行了总结,并对工艺的运行和管理提出相应的建议。实际运行结果表明,该厂在处理规模为1万m^3／d条件下,出水达到《城镇污水处理厂污染物排放标准》（GB18918-2002）一级B标准,达到设计要求。该项目的成功实施,为CASS工艺在小城镇污水处理厂的应用提供了参考。