新疆奎屯原生高砷地下水的分布、类型及成因分析

原生高砷地下水在全球分布广、危害大,严重威胁着全世界数亿人口的身体健康.为科学指导高砷地区地下水资源的合理开发利用,以中国大陆第一个砷中毒病区新疆奎屯为研究区域,分析了奎屯地区高砷地下水的分布规律、类型及成因.结果表明,奎屯地区有88.7%的地下水中砷浓度超出10μg·L~(-1),多为高砷地下水.高砷地下水多分布在深层承压含水层,砷浓度从南向北逐渐升高,与采样点海拔高度呈显著负相关.奎屯地区地下水整体呈弱碱性、碱性环境,氧化还原电位(Eh)均为负值,具有较强的还原性,属于还原性-弱碱性高砷地下水(I-2型).奎屯南面的天山与北面的河流沉积平原环境相结合,为该区地下水形成高砷提供了有利的地质环境.奎屯地区沉积层深厚,地下径流更替缓慢,相对封闭的水文地质条件使地下水中的砷富集而不易流失,强烈的蒸发可以使地下水中的砷进一步浓缩.同时,地下水的还原条件有利于含水层中砷的释放,砷浓度不仅受铁锰氧化物矿物还原的影响,而且受SO2-4还原和硫化物矿物沉淀的控制,吸附态砷的解吸附也是该地区地下水的富砷过程.     

秸秆压块与燃煤供热系统生命周期环境排放对比研究

为证明采用秸秆压块燃料替代煤炭进行供热的可持续性,对秸秆压块和燃煤供热系统的生命周期环境排放进行了对比分析.基于我国2012年投入产出表,构建了投入产出生命周期评价(IO-LCA)和过程生命周期评价(PLCA)相结合的混合生命周期评价(Hybrid-LCA)模型,核算了玉米秸秆压块和燃煤供热系统供应1 GJ热的生命周期CO2、SO2、NOx和PM2.5排放.结果显示,秸秆压块供热系统的生命周期CO2排放量为7 kg·GJ-1热,比燃煤供热排放减少121 kg.此外,秸秆压块供热系统比燃煤供热系统可以分别减少SO2排放98%、NOx排放76%和PM2.5排放58%.控制原料水分,通过减少原料收集和能源转化过程中的耗损,减少能源转化过程的电力消耗以及控制原料收集半径等可以有效改进秸秆压块供热系统环境表现.     

城市热岛效应下浅层土中混凝土的酸腐蚀试验研究

针对城市热岛效应引起城区浅层土地温场升高这一观测结果,采用室内快速模拟试验方法,对城区酸性土壤腐蚀混凝土材料的温度效应开展了试验研究.试验研究了在温度为5℃、20℃和40℃条件下,混凝土试样在酸浓度分别为0%、5%和10%的沙土介质中放置30 d、90 d后的抗压强度变化规律,并对混凝土试样在腐蚀过程中的腐蚀系数变化规...     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.     

Characteristics of stable biodiesel emulsion fuel with the aid of lipophilic surfactant,polyglycerol polyricinoleate (PGPR)

ABSTRACT

Biodiesel emulsion fuel is reported as one of the most feasible options capable of generating lower NOx emission than that from fossil fuels. However, oil and water in the emulsion fuel are easily separated and unstable. The aim of the present study is to consider the production and stability of biodiesel emulsion fuel by using tetraglycerin ester (CR-310), i.e., one of lipophilic surfactant, polyglycerol polyricinoleate (PGPR) and biodiesel, i.e., Waste cooking Oil Methyl Ester (WOME) produced based on waste cooking oil. The corresponding heat rate, water content, and viscosity are measured. Emphasis is placed on the effects of water content and surfactant on biodiesel emulsions. It is found that: (i) stable emulsion fuel is obtained by adding at least 2.0% of CR-310 and is maintained over 1 month, (ii) there is no effect of water content on stable emulsion fuel if CR-310 is used over 2.0%, and (iii) the viscosity of emulsion fuels is higher than that of the biodiesel fuel and is gradually increased with an increase in the water content.     

Fine-resolution mapping of wildfire fuel types for Canada: Fuzzy logic modeling for an Alberta pilot area

The Canadian Forest Fire Danger Rating System (CFFDRS) is used daily across Canada for evaluating forest fire danger. Fuel-type information is one of the inputs required by the models used in the CFFDRS. In this project, three fuel-type maps with a 25 m resolution were produced for a pilot study area located in Alberta using land cover only; land cover and biomass; and, land cover, biomass and leaf area index data derived from satellite imagery. The relationships between inputs and fuel types were determined mainly by the opinions of forest fire scientists and incorporated into a computer program using fuzzy set methodology. Not all the CFFDRS fuel types could be distinguished using these inputs; three of the coniferous types had to be grouped into one common fuel type. Overall accuracy was between 74 and 83% based on ground-truth comparisons. The most accurate map resulted from land cover and biomass data. Detailed accuracy assessment indicated that the overall accuracy increased up to 86% if ambiguous fuel type identification was considered. No combination of inputs was able to define a fuel type with absolute certainty, which is a reflection of differing expert opinions and the small number of inputs used to produce the maps.     

太阳热反射涂料的研制

根据涂料反射太阳热的原理,以丙烯酸树脂为基料,以金红石型钛白粉、云母粉及空心玻璃微珠为原料,制备了隔热性能和耐候性能均良好的太阳热反射隔热涂料,并研究了颜料、填料种类、粒径、涂层厚度对涂料隔热性能的影响。     

Indigenous Systems of Forest Classification: Understanding Land Use Patterns and the Role of NTFPs in Shifting Cultivators’ Subsistence Economies

This article discusses the system of classification of forest types used by the Pwo Karen in Thung Yai Naresuan Wildlife Sanctuary in western Thailand and the role of nontimber forest products (NTFPs), focusing on wild food plants, in Karen livelihoods. The article argues that the Pwo Karen have two methods of forest classification, closely related to their swidden farming practices. The first is used for forest land that has been, or can be, swiddened, and classifies forest types according to growth conditions. The second system is used for land that is not suitable for cultivation and looks at soil properties and slope. The article estimates the relative importance of each forest type in what concerns the collection of wild food plants. A total of 134 wild food plant species were recorded in December 2004. They account for some 80–90% of the amount of edible plants consumed by the Pwo Karen, and have a base value of Baht 11,505 per year, comparable to the cash incomes of many households. The article argues that the Pwo Karen reliance on NTFPs has influenced their land-use and forest management practices. However, by restricting the length of the fallow period, the Thai government has caused ecological changes that are challenging the ability of the Karen to remain subsistence oriented. By ignoring shifting cultivators’ dependence on such products, the involvement of governments in forest management, especially through restrictions imposed on swidden farming practices, is likely to have a considerable impact on the livelihood strategies of these communities.     

河流型饮用水水源保护区划分比较

比较分析了国内外河流型水源保护区划分的原则、方法和标准,例证了我国不同省份的划分实践。指出,我国各省多采用经验值划分水源保护区范围,部分省份划分方案久未更新,没有充分发挥保护区的作用。提出,应进一步细化水源保护区划分规范指导要求,及时修订省级水源保护区划分方案,并借鉴国外水源保护区划分经验,通过调整水质标准、重视公众参与、利用地理信息系统等方式划分水源保护区,从源头上预防水源污染,降低饮用水公共风险,保障饮用水安全。     

多热源分散程度的数学模拟及对置换通风影响

通过建立多污染热源置换通风的三维数学模型,根据数值解分析三热源位置变化对多污染源置换通风效果的影响,结果表明:热源的位置变化对多污染热源置换通风效果的影响是很大的,房间内热源应紧凑布置以利于提高通风效果和节能。