利用废弃物衍生燃料的热化学处理法制富含氢气合成气

为了探讨利用热化学方式从城市垃圾中制取富含氢气合成气过程的要素影响,解析氢气发生特性及其与主要影响要素之间的关系。在分析了城市生活垃圾组分特性的基础上,将其加工成组分均一的废弃物衍生燃料(refuse de-rived fuel,RDF),并在700、800和900℃等3个温度条件下,分别开展了RDF的热解、气化及水蒸汽气化等实验。研究表明,RDF的加工不但可有效降低垃圾含水率,还可将垃圾热值提高近1倍。温度和添加水蒸汽是从RDF中制取富含氢气合成气过程中的关键影响要素。其中,温度对氢气生成起到至关重要的决定作用,温度的提高对促进H2浓度的提高有利,同时,在气化过程中添加水蒸汽,可有效促进CO和H2等有价气体组分生成。在900℃的高温水蒸汽气化处理过程中,可获得H2浓度最高为34.13%的合成气。另外,800℃热解过程所产生的合成气热值最高,达到14 509 kJ/Nm3。     

MFC-MBR耦合系统运行效果

膜生物反应器(MBR)是一种高效的污水处理工艺,而微生物燃料电池(MFC)能有效降解污泥中的胞外生物有机质(EBOM)并回收电能.将MFC与MBR联用,建立了一套能够有效抑制膜污染同时回收电能的新系统——MFC-MBR耦合系统,MBR的剩余污泥经MFC处理后回流.以传统MBR为对照,对耦合系统中污水处理效果、膜污染情况和污泥混合液的性质进行研究.研究表明,耦合系统的污水处理效果没有明显恶化,COD去除率为94％,NH4+-N的去除率为92％.耦合系统能够有效减缓膜污染的发生,清洗周期延长了28％.污泥混合液的MLVSS/MLSS稳定在80％ ～ 88％,系统内几乎没有无机颗粒积累.松散结合态胞外聚合物(LB-EPS)降低了48％,使污泥混合液性质得到改善.较低的污泥比阻(2.69×1012m/kg)和标准化毛细吸水时间(1.67 s·L/g MLSS),证明耦合系统污泥混合液脱水性能提高了.     

混合酶强化剩余污泥微生物燃料电池性能

为了提高剩余污泥为燃料的微生物燃料电池(SMFC)产电性能以及污泥减量化效果,在不同的温度(40、45和50℃)研究单室无膜微生物燃料电池中酶对SMFC产电特性的强化效果.加入单一酶(蛋白酶或α-淀粉酶)的结果表明,随着温度的上升,SMFC功率密度均上升,但40℃时强化效果最明显,与加入失活酶的对照组相比分别增加198％和130％.在40℃下,混合酶比(蛋白酶浓度:淀粉酶浓度)为2∶3时,SMFC最大功率密度为776 mW/m2.随着混合酶中淀粉酶的比例提高,SMFC库伦效率逐渐增加,当混合酶比为4∶1时,CE(库伦效率)可达18.3％,同时TCOD、TSS和VSS去除率分别为70.3％、66.7％和80.4％.因此,温度相对较低时,外加酶强化效果更明显;与单种酶相比,混合酶对SMFC产电性能和污泥减量化的强化效果更显著.     

Development of a hybrid microbial fuel cell (MFC) and fuel cell (FC) system for improved cathodic efficiency and sustainability: the M2FC reactor

In an effort to improve the efficiency and sustainability of microbial fuel cell (MFC) technology, a novel MFC reactor, the M2FC, was constructed by combining a ferric-based MFC with a ferrous-based fuel cell (FC). In this M2FC reactor, ferric ion, the catholyte in the MFC component, is regenerated by the FC system with the generation of additional electricity. When the MFC component was operated separately, the electricity generation was maintained for only 98 h due to the depletion of ferric ion in the catholyte. In combination with the fuel cell, however, the production of power was sustained because ferric ion was continually replenished from ferrous ion in the FC component. Moreover, the regeneration process of ferric ion by the FC produced additional energy. The M2FC reactor yielded a power density of up to 2 W m⁻² (or time-averaged value of approximately 650 mW m⁻²), density up to 20 times (or approximately six times based on time-averaged value) higher than the corresponding MFC system.     

Effects of compression ratio,swirl augmentation techniques and ethanol addition on the combustion of CNG–biodiesel in a dual-fuel engine

The diminishing resources and continuously increasing cost of petroleum in association with their alarming pollution levels from diesel engines has led to an interest in finding alternative fuels to diesel. Emission control and engine efficiency are two of the most important parameters in current engine design. The impending introduction of emission standards such as Euro IV and Euro V has forced research towards developing new technologies for combating engine emissions. This paper examines the effects of compression ratio, swirl augmentation techniques and ethanol addition on the combustion of compressed natural gas (CNG) blended with Honge oil methyl esters (HOME) in a dual fuel engine. The present results show that the combustion of HOME and 15% ethanol blend with CNG induction in a dual-fuel engine operated in optimized parameters at an injection timing of 27° Before Top Dead Centre and a compression ratio of 17.5 resulted in acceptable combustion emissions and improved brake thermal efficiencies. The implementation of swirl augmentation techniques increased brake thermal efficiencies (BTEs) and considerably reduced combustion emissions such as smoke, HC, CO and NO_x. The addition of ethanol also increased BTEs. However, at more than 15% of ethanol in HOME, NO_x emissions increased dramatically.     

MFC强化同步短程硝化反硝化工艺的启动

微生物燃料电池(MFC)可在阴极实现反硝化、短程反硝化和同步硝化反硝化并产生电能,但在MFC阴极实现同步短程硝化反硝化的研究尚未见到报道。为了探讨MFC阴极同步短程硝化反硝化工艺的性能,将双室曝气阴极MFC与A/O脱氮工艺结合处理人工模拟低碳氮比废水。通过静置运行15 d使得MFC阴极室亚硝态氮得以积累,氨氧化菌得以富集。随即改为连续运行后第21天成功启动同步短程硝化反硝化MFC;阴极出水氨氮浓度为0.3 mg/L,亚硝态氮浓度为15.9 mg/L,硝态氮浓度为0.6 mg/L,亚硝化率达到95%以上,阴极电极自养反硝化去除率达到50%以上,COD去除率达到85%以上。结果表明,将MFC与同步短程硝化反硝化工艺结合,通过阴极室中氧气得电子获得高p H,可以强化同步短程硝化反硝化工艺,完成生物脱氮的同时回收电能,并具有减少外加碱度的优势。     

火电燃料消费过程对资源环境的影响评估

我国以化石能源为主要燃料的火电生产导致了严重的资源枯竭和环境污染问题,定量评估火电燃料消费对资源环境的影响是区域可持续发展研究的重要内容。在估算火电燃料燃烧及运输、生产过程中排放的主要大气污染物的基础上,利用成分法计算相应的生态足迹,定量评估火电燃料消费过程对资源环境的影响。结果表明：我国1 kW〖DK〗·h火电的燃料消费过程中排放的CO2、CH4、NOx、SO2、烟尘分别为107 kg、993×10-3 kg、646×10-3 kg、260×10-3 kg、202×10-2 kg;全国火电燃料消费占用的生态足迹由2000年的50 67444万hm2,增加到2007年的123 84208万hm2,年均增长1362％;CO2和NOx的生态足迹平均比重高达836％,是影响资源环境的主要因子,SO2、烟尘与CH4三者合计仅164%,对资源环境的冲击相对较小     

植物油燃料研究概述

本文介绍了植物油作燃料的研究历史以及试验研究状况，表明植物油作为柴油的替代品是最易实现的方案。但植物油燃料还需进一步试验研究才能使其实用化，其技术储备具有深远的现实意义。本文还通过对燃料油植物栽培问题的探讨，认为“农林复合经营”是生产植物燃料油的重要途径。     

Determining residential firewood consumption

Household firewood use has become increasingly popular in the United States over the past few years. Significant problems remain in estimating firewood consumption. Methods of determining the amount of wood consumed vary from state to state. Units used for measuring firewood vary, but the cord remains the researcher's favorite. Factors used for converting other units, such as pickup truck loads to cords also vary. People who do not use firewood are less likely to respond to mailed surveys, resulting in potential overestimates of statewide consumption. This paper identifies some problems associated with estimating household firewood consumption and recommends methods of dealing with them.     

地下油料储存库火灾初期模式与安全性研究

使用模拟的地下油料储存库装置,对地下油料储存库火灾初期模式进行了实验研究.结合油料地下储存库火灾防治和安全性要求对实验结果进行了分析.结果表明,模拟油料地下储存库起火后,火灾初期模式与实验初始条件、边界条件和装置结构直接相关.在一定条件下,模拟油料地下储存库内出现爆燃向爆轰的转变;不同的环境条件下,火灾的模式不同;油料地下储存库内火灾的发展,油料的持续燃烧及发生燃烧的部位受通气条件和洞内复杂的烟气流向等条件控制.