Effects of ozone on growth, yield and leaf gas exchange rates of two Bangladeshi cultivars of wheat (Triticum aestivum L.)

To clarify the effects of O₃ on crop plants cultivated in Bangladesh, two Bangladeshi wheat cultivars (Sufi and Bijoy) were grown in plastic boxes filled with Andisol and exposed daily to charcoal-filtered air or O₃ at 60 and 100 nl l⁻¹ (10:00-17:00) from 13 March to 4 June 2008. The whole-plant dry mass and grain yield per plant of the two cultivars at the final harvest were significantly reduced by the exposure to O₃. Although there was no significant effect of O₃ on stomatal diffusive conductance to H₂O of flag leaf, net photosynthetic rate of the leaf was significantly reduced by the exposure to O_3. The sensitivity of growth, yield, yield components and leaf gas exchange rates to O₃ was not significantly different between the two cultivars. The results obtained in the present study suggest that ambient levels of O₃ may detrimentally affect wheat production in Bangladesh.     

Biomass fuel burning and its implications: Deforestation and greenhouse gases emissions in Pakistan

Pakistan is facing problem of deforestation. Pakistan lost 14.7% of its forest habitat between 1990 and 2005 interval. This paper assesses the present forest wood consumption rate by 6000 brick kilns established in the country and its implications in terms of deforestation and emission of greenhouse gases. Information regarding consumption of forest wood by the brick kilns was collected during a manual survey of 180 brick kiln units conducted in eighteen provincial divisions of country. Considering annual emission contributions of three primary GHGs i.e., CO₂, CH₄ and N₂O, due to burning of forest wood in brick kiln units in Pakistan and using IPCC recommended GWP indices, the combined CO₂-equivalent has been estimated to be 533019 t y⁻¹.     

医疗废物焚烧处理核心技术的开发及应用

国内已建成的医疗废物焚烧设施目前普遍存在进料系统不稳定、玻璃结渣和高浓度HCl气体的排放的问题。这些技术难点已成为医疗废物焚烧处置行业发展的瓶颈。本文介绍了可解决上述问题的"可调节医疗废物恒流量进料技术"、"医废焚烧防玻璃结渣技术"和"含高浓度氯化氢医废尾气处理技术"三项医疗废物焚烧处理核心技术的主要特点及技术指标与应用实例。     

我国机动车污染防治行业2009年发展综述

综述了2009年我国机动车污染防治行业的发展环境及市场特点、主要(骨干)企业发展情况,分析了2009年行业发展中存在的主要问题,提出了解决对策和建议,并对行业的发展进行了展望。     

基于因子分析法优选河流水体中氮浓度预测方法的研究

定量的河流水体中氮浓度预测方法有很多种,如何优选出预测精度较高的方法一直是学术界多年来致力于研究的重点。本研究采用因子分析法对预测方法的精度评价指标进行分析,并建立了预测方法精度的评价模型,对回归分析法、神经网络法、灰色系统法和增长率统计法4种水体氮浓度预测方法进行综合评估,优选出精度较高的河流水体氮浓度预测模型——BP神经网络预测模型。结果表明,此评估模型对类似研究具有一定的参考价值,能为选择出合适的河流水体氮浓度预测方法提供依据。     

二氧化碳水合物储气特性的实验研究

利用二氧化碳水合物小型实验装置分别在恒容和恒压条件下,研究了机械搅拌对二氧化碳气体溶解的影响以及温度与水-气比对二氧化碳水合物形成和储气密度的影响。通过实验结果发现,机械搅拌对二氧化碳的溶解有非常明显的促进作用,可以在3 min内完成溶解过程,促进溶解作用好于添加剂SDS。研究还发现,反应温度越低,二氧化碳水合物的生成速率越快,总的储气量越大,而水-气比越大,储气密度越小。在实验压力3 MPa、反应温度273.55 K的条件下,1体积的水生成水合物后可储存157体积的二氧化碳。     

ASBBR-二级SBBR-化学除磷组合工艺处理榨菜腌制废水

针对榨菜腌制废水高盐高氮磷高有机物浓度的特征,提出"厌氧序批式生物膜反应器(ASBBR)-二级序批式生物膜反应器(SBBR)-化学除磷"组合处理工艺,在前期对组合工艺中单元工艺的关键工况参数研究的基础上,考察组合工艺的处理效能。实验结果表明,采用该组合工艺,可使进水COD、NH4+-N、TN及PO43--P分别为10 000、345、550和38.5mg/L的榨菜腌制废水,处理出水COD、NH4+-N、TN及PO43--P分别达到93.6、12.3、18和0.1 mg/L,去除率分别为99.1%、96.4%、96.7%和99.9%,出水达到污水综合排放一级标准。     

石膏浆液旋流器的分离性能实验研究

通过理论分析及工程经验对石灰石/石膏法烟气脱硫工艺中石膏浆液脱水系统的旋流器进行优化设计,在与工业实际相近的操作条件下,优选出了一根综合性能较好的旋流器。考察了该旋流器的压力、流量与分离效率之间相互关系,与常规石膏浆液旋流器的分级效率进行了比较,确定了最佳操作条件。结果表明,旋流器的进口流量随着进出口压力差的增大而增大,分离效率随着流量增加先上升后下降。在进口硫石膏颗粒平均粒径为24μm,流量为11.8~14.8 m3/h时,分离效率在85%以上,底流出口10μm、15μm以下的颗粒分别占底流出口颗粒总体积的1%、10%左右,起到了很明显的分级浓缩作用,分离性能也优于常规使用的石膏浆液旋流器。     

氧化镁烟气脱硫反应特性研究

利用实验室规模的鼓泡式反应装置,对比了碳酸钙、氧化镁和氧化镁/硫酸镁脱硫剂的反应活性,证实脱硫液中高浓度硫酸镁的存在是保证镁法脱硫效率高于钙法的重要因素,并考察了硫酸镁浓度、脱硫剂(氧化镁)浓度、烟气量、SO2浓度和吸收液温度等因素对脱硫效率的影响。结果表明,脱硫反应可以根据pH分为2个不同阶段;反应过程中脱硫效率随着硫酸镁浓度的增加而显著升高;烟气量增加将会导致脱硫效率有所下降;入口SO2浓度升高,脱硫效率下降;氧化镁浓度、温度对脱硫效率影响不显著。结合实验现象进行推断,氧化镁脱硫的反应过程受SO2在气液两相界面的传质扩散和其水解产物在液相的扩散控制。     

A Monte Carlo study of radon detection in cylindrical diffusion chambers

The functioning of radon diffusion chambers was studied using the Monte Carlo code RAMMX developed here. The alpha particles from radon are assumed randomly produced in the volume of the cylinder, and those from the progeny are assumed to originate randomly at the cylindrical surface. The energy spectrum, the distribution of incident angles, and the distribution of path lengths of the alpha particles on the detector were obtained. These quantities vary depending on input parameters such as initial alpha particle energy, radius and depth of the diffusion chamber, detector size and atmospheric pressure. The calculated energy spectrum for both ²²²Rn and ²²⁰Rn was compared with experiment, permitting the identification of each peak and its origin, and a better understanding of radon monitoring. Three aspects not considered in previous calculations are progeny alphas coming from surfaces of the monitor, taking into account the atmospheric pressure, and including the isotope ²²⁰Rn.