Ammonium-dependent regulation of aerobic methane-consuming bacteria in landfill cover soil by leachate irrigation

The impacts of landfill leachate irrigation on methane oxidation activities and methane-consuming bacteria populations were studied by incubation of landfill cover soils with leachate and (NH₄)₂SO₄ solution at different ammonium concentrations. The community structures and abundances of methane-oxidizing bacteria (MOB) and ammonia-oxidizing bacteria (AOB) were examined by PCRDGGE and real-time PCR. Compared with the pure (NH₄)₂SO₄ solution, leachate addition was found to have a positive effect on methane oxidation activity. In terms of the irrigation amount, ammonium in leachate was responsible for the actual inhibition of leachate. The extent of inhibitory effect mainly depended on its ammonium concentration. The suppression of the predominant methaneconsuming bacteria, type I MOB, was responsible for the decreased methane oxidation activity by ammonium inhibition. Methaneconsuming bacteria responded diversely in abundance to ammonium. The abundance of type I MOB decreased by fivefold; type II MOB showed stimulation response of fivefold magnification upon the first addition but lessened to be lower than the original level after the second addition; the amount of AOB was stimulated to increase for 20-30 times gradually. Accumulated nitrate from nitrification strengthened the ammonium inhibition on type I and type II MOB, as a result, repetitive irrigation was unfavorable for methane oxidation.     

Operating condition influences on PCDD/Fs emissions from sinter pot tests with hot flue gas recycling

This study was designed to clarify the influence of operating conditions on the formation and emissions of polychlorinated-pdibenzodioxins and dibenzofurans (PCDD/Fs) from a sintering process with hot flue gas recycling. A pilot scale sinter pot with simulated flue gas recycling was developed, and four key operational parameters, including temperature, oxygen content of the simulated waste flue gas, the coke rate of the sintering mixture, and the quicklime quality, were selected for exploring PCDD/Fs formation. The results showed that the temperature of the recycled flue gas had a major affect on PCDD/Fs formation, and a high temperature could significantly increase their formation during sintering. A clear linear correlation between the temperature of recycling flue gas and PCDD/Fs emission (r = 0.93) was found. PCDD/Fs could be reduced to a certain extent by decreasing the level of oxygen in the recycled flue gas, while sintering quality was unchanged. The coke rate had no significant influence on the formation of PCDD/Fs, but the quality of quicklime used in the sintering mixture could affect not only the amount of PCDD/Fs emissions but also the sintering productivity. Compared with a benchmark sinter pot test, PCDD/Fs emissions markedly decreased with improvements to quicklime quality. However, the reduction in PCDD/Fs emissions realized by using high-quality quicklime was limited by the temperature of the inlet gas. The highest reduction achieved was 51% compared with conventional quicklime when the temperature of the inlet gas was 150°C.     

再生条件对钾基CO_2吸附剂吸附性能的影响

通过固定床实验研究了再生条件对钾基CO2吸附剂吸附性能的影响。深入分析了再生温度和气氛对吸附穿透时间和饱和吸附量的影响。研究发现,当再生温度为200℃,N2气氛下再生时效果最佳,在此条件下再生后钾基CO2吸附剂循环性能良好,10次循环后仍然能有很好的吸附效果;再生气氛中有H2O或CO2时会影响再生反应的进行,不利于吸附剂的再生。     

改进测定水中氨氮分子吸收光谱法的试验研究

水中氨氮含量是反应水质状况的重要指标。文章对测定水中氨氮气相分子吸收光谱法(标准号HJ/T195-2005)进行了改进试验研究。第一,对氧化剂的配比进行了改进,使氨氮的测定范围扩展至100μg。第二,对标准HJ/T195-2005中直接使用亚硝酸钠标准溶液做标准曲线的处理方式也做了探讨。通过一系列对比实验认为,应用硫酸铵标准溶液做工作曲线更加准确合理。最后应用改进后的气相分子吸收光谱法和纳氏比色法或滴定法对多种实际废水样品进行同时测定。结果表明,改进后的气相分子吸收光谱法测定氨氮的范围更宽,灵敏度更高和准确度更好。     

非烟气工况下常规烟塔与改造烟塔内部结构的比较

根据流体力学理论,基于Fluent6.3.26计算平台,对常规冷却塔和改造后的排烟冷却塔进行了三维内部流场的模拟。分析非烟气工况下,两塔内部烟道布置对气流的影响,为进一步研究在工况条件下烟气、水蒸气塔内扰流与湿热蒸汽抬升作用提供理论基础。验证了改造烟塔内部烟道布置的优越性,对排烟冷却塔结构优化有一定的指导意义。     

火电湿法烟气脱硫流程优化的实现方案研究

在给定脱硫流程模拟优化参数的情况下,尝试了基于DCS系统和基于OA局域网的两种优化控制改进方案,后一种方案解决了优化控制系统的安全性、稳定性、扩展性、易管理等问题。同时采用该控制系统的3号脱硫系统的控制效果最佳,且脱硫效率循环浆液泵功率比随着操作方式相近度的提高而呈递增趋势。     

复合吸收技术净化复杂工业有机废气

以低浓度、大风量、含无机物、尘粒和油分等成分的复杂工业有机废气为对象,进行复合吸收净化技术的研究,从吸收机制初步探索,对净化设备、工艺流程及工程应用分别进行了探讨.分别以3种不同的表面活性剂溶液为复合吸收剂,考察其处理含甲苯和醋酸丁酯废气的净化效果,结果表明降低复合吸收剂的表面张力,有利于甲苯和醋酸丁酯的去除率.针对复杂工业有机废气,开发高效吸收设备,集合了水膜、旋流板和填料3种吸收净化装置的优点于一体,具有结构简单、体积小、防堵塞及多级高效吸收传质的优势.工艺流程以吸收技术为主,整合了加热吹脱、燃烧和厌氧等工艺,最终使废气和吸收尾液达标排放.该技术已在制造、喷涂等多家企业的工程上应用.     

智能化有害有毒气体污染源监测仪的研究

为了快速寻找有害有毒气体污染源,利用8个红外激光气体传感器,分别安装步进电机驱动旋转的圆盘圆周上在不同的方向上对污染气体进行数据采集。同时与二维热差式风速风向传感器采集到的风速风向数据,一并送入MSC1210单片机进行数据处理和运用智能人工神经网络进行模式训练与模式识别,从而识别出污染源的位置、浓度和种类。通过GPS全球卫星定位系统和GPRS无线传输网络,把监测到的信息发送给相关部门早做处理,并报警,避免污染进一步扩散。实验表明,该智能化追索气体污染源监测仪具有良好的可靠性、安全性和实用性。     

厌氧生物滴滤法脱除冷煤气中硫化氢的研究

水煤气中硫化氢在燃烧时会转变成二氧化硫,对环境产生污染。文章采用厌氧生物滴滤塔法对冷煤气进行脱硫处理。因煤气对氧的严格限制,通过设计生物滴滤塔,经挂膜驯化后在厌氧条件下对浓度在1~5 g/m3左右的硫化氢进行脱除处理,考察滴滤塔运行条件对脱除效果的影响。结果表明,生物挂膜25 d后,生物滴滤塔达到稳定,喷淋液pH值为2.23,ORP值为283 mV,溶解氧为0.4 mg/L,对溶液中硫离子氧化效率达到94%。滴滤塔在液气比0.15,空塔气速0.088 m/s,pH值5.0~7.0,填料高度为82 cm,塔温为25~30℃左右时,达到较优的运行条件,此时该滴滤塔对以CO、CO2、H2和1 940 mg/m3H2S组成的模拟水煤气的脱硫效率达91.2%。     

氨法烟气脱硫循环液沉降试验研究

通过湿法烟气脱硫副产硫酸铵生产工艺中的循环母液混凝试验,讨论母液的沉降性能,初步探讨母液被循环浓缩的程度对混凝处理效果的影响。