热力管加热桥面抗冰融冰试验研究

为了研究热力管加热桥面抗冰融冰对于公路交通安全的影响,制作了尺寸为600 mm×600 mm×380 mm的桥梁试件,在人工环境室对热力管融冰进行了模型试验。结果表明:试件上表面温升速率和融冰时间取决于热力管间距、隔热层、风速、环境温度和热力管外表面温度。在相同工况条件下,100 mm间距的热力管融冰能力要大于150 mm间距的热力管,无隔热层时,100 mm间距热力管向上传递的热量占总加热量的13.4%,融冰时间为211 min;150 mm间距热力管向上传递的热量占总加热量的18.3%,融冰时间为271 min。在热力管层下面铺设厚度为2 mm、导热系数为0.062 W/（m· K）的隔热材料后,100 mm间距热力管向上传递的热量占总加热量的46.9%,融冰时间为175 min;150 mm间距热力管向上传递的热量占总加热量的51.9%,融冰时间为161 min。热力管层铺设隔热材料可有效阻止热量向下传递,从而缩短融冰时间。     

大豆蛋白粉喷雾干燥塔尾气余热的回收与利用

针对大豆蛋白粉生产过程中喷雾干燥塔尾气温度较高,有回收利用价值的现实,也针对目前的节能需求,对现有的喷雾干燥塔的尾气排放部分进行改造,设计一个片状空气预热器,以利用高温的尾气与系统的进气做热交换,实现热量再利用,降耗和提高蛋白粉产率的目的,并对投资收益进行了分析。     

Hot Steam Transfer Through Heat Protective Clothing Layers

The aim of this study was to analyse the transfer of steam through different types of textile layers as a function of sample parameters such as thickness and permeability. In order to simulate the human body, a cylinder releasing defined amounts of moisture was also used. The influence of sweating on heat and mass transfer was assessed.

The results show that in general impermeable materials offer better protection against hot steam than semi-permeable ones. The transfer of steam depended on the water vapour permeability of the samples, but also on their thermal insulation and their thickness. Increasing the thickness of the samples with a spacer gave a larger increase in protection with the impermeable samples compared to semi-permeable materials. Measurements with pre-wetted samples showed a reduction in steam protection in any case. On the other hand, the measurements with a sweating cylinder showed a beneficial effect of sweating.     

Performance of Firefighters’ Protective Clothing After Heat Exposure

Heat and mechanical protection properties of 6 fabric combinations commonly used in firefighters’ protective clothing were assessed before and after different heat treatment. It was shown that after heat exposure, the values obtained were generally lower than in the original state. The mechanical properties of the materials were more affected by heat than by heat protective properties. In 2 cases, degradation started before a visible change in the material could be observed, which might be potentially dangerous for the end user who will not realize the alteration of the material.     

Validation of Methods for Determination of Metabolic Rate in the Edholm Scale and ISO 8996

The aim of this study was to validate the Edholm scale (Edholm, 1966) and the ISO 8996 standard (International Organization for Standardization [ISO], 1990) by comparing the metabolic rates estimated for both methods with the actual measured metabolic rate (M_Meas) in 6 manual material handling tasks simulated under laboratory conditions. The metabolic rate was calculated from oxygen consumption VO₂ (19 participants) according to Standard No. ISO 8996 (ISO, 1990). Additionally, the participants estimated perceived exertion using the Borg scale. The metabolic rates derived from the Edholm scale (M_Edh) overestimated 5 of 6 activities by 34-50% (α = .05). The metabolic rates derived from ISO 8996 (M_ISO) overestimated all activities by 7-38% (α =.05).     

Determination of Heat Loss from the Feet and Insulation of the Footwear

This study compared the methods of determining footwear insulation on human participants and a thermal foot model. Another purpose was to find the minimal number of measurement points on the human foot that is needed for insulation calculation. A bare foot was tested at 3 ambient temperatures on 6 participants. Three types of footwear were tested on 2 participants. The mean insulation for a bare foot obtained on the participant and model were similar. The insulation of warm footwear measured by the 2 methods was also similar. For thin footwear the insulation values from the participants were higher than those from the thermal model. The differences could be related to undefined physiological factors. Two points on the foot can be enough to measure the insulation of footwear on human participants (r = .98). However, due to the big individual differences of humans, and good repeatability and simplicity of thermal foot method, the latter should be preferred for testing.     

扬沸火灾发生时间预测模型的建立与应用分析

原油储罐扬沸火灾由池火灾发展而成,是一种危害性极大的事故.准确预测扬沸事故发生的时间,是扬沸机理研究中的难题之一.现有扬沸时间计算的通用模型由于没有考虑油品的粘性作用,计算结果误差较大.把扬沸火灾简化为无内热源的非稳态传热问题,在此基础上进行传热分析,进而推导出扬沸事故时间计算模型.设定了6组不同尺寸和不同充装水平的原油储罐池火灾,利用推导模型计算出了相应的扬沸事故发生时间.将计算结果与通用模型计算结果以及实验结果进行对比:该模型的准确性由于通用模型,计算结果与实验值误差较小,较为合理.研究结果对于扬沸火灾事故下消防人员的灭火救援的安全保障具有重要意义.     

Analytical Study of the Heat Loss Attenuation by Clothing on Thermal Manikins Under Radiative Heat Loads

For wearers of protective clothing in radiation environments there are no quantitative guidelines available for the effect of a radiative heat load on heat exchange. Under the European Union funded project ThermProtect an analytical effort was defined to address the issue of radiative heat load while wearing protective clothing. As within the ThermProtect project much information has become available from thermal manikin experiments in thermal radiation environments, these sets of experimental data are used to verify the analytical approach. The analytical approach provided a good prediction of the heat loss in the manikin experiments, 95% of the variance was explained by the model. The model has not yet been validated at high radiative heat loads and neglects some physical properties of the radiation emissivity. Still, the analytical approach provides a pragmatic approach and may be useful for practical implementation in protective clothing standards for moderate thermal radiation environments.     

Flicker Test as a Load Measurement During the Combined Effect of Heat and Noise

This study was a joint physiological and psychological experiment undertaken to determine changes in physiological and psychological human functions under the combined influence of heat, noise, and physical activity. Seven experimental situations were simulated in a climatic chamber with different configurations of three independent variables: heat (40 °C), noise (98 dB), and physical effort (30% of maximum volume of oxygen uptake—V0₂ max). Five psychological variables (critical flicker fusion—CFF, hand tremor, reaction time, subjective climate evaluation, and subjective evaluation of the given condition load) and two physiological variables (heart rate and rectal temperature) were monitored. Results indicate that CFF changed (increased) significantly when more than one experimental variable was applied. These changes coincided with significant changes in both subjective climate evaluation and subjective evaluation of a given condition load. There were no significant changes in psychomotor functions (hand tremor and reaction time). None of the observed physiological parameters were above the critical value. The results suggest that CFF can be treated as a psychophysical load indicator.     

余热利用低低韫电除坐技术在燃煤电厂的应用

论述并总结了余热利用低低温电除尘技术在新昌某电厂700MW机组燃煤锅炉上的应用情况,指出采用该技术是燃煤电厂进一步减排节能的有益尝试。