气相色谱-离子选择电极检测器测定有机氯

用氯离子选择电极作为气相色谱检测器,测定了γ-BHC、三氯甲烷和四氯化碳,其检测下限分别为2.6×10~(-?),1.8×10~(-10)和1.0×10~(-10)mol.以γ-BHC为测定物的相对标准偏差为3.4％,线性范围为2.6×10~(-10)-9.8×10~(-7)mol.     

苯酚在预活化聚酰胺膜酪氨酸酶生物传感器上的响应特性

研究苯酚在预活化聚酰胺膜酪氨酸酶生物传感器上的响应特性,适量儿茶酚的存在可加快传感器到达恒态的速度。被固定酶的量、活性及传感器的有效面积等是影响检测灵敏度的主要因素。首次采用预活化聚酰胺膜固定酪氨酸酶,并与浸蜡石墨电极组合成酪氨酸酶生物传感器,在温度２５℃电位－０．２００ＶｖｓＳＣＥ,儿茶酚浓度５×１０（－７）ｍｏｌ／Ｌ,底液０．１ｍｏｌ／Ｌ磷酸盐缓冲溶液ｐＨ６．５０下,采用电流法测定苯酚及水样中的酚。酶膜的制备、替换和贮存极为方便,酶膜贮存５个月未见活性下降,有良好的重现性和线性范围２×１０（－７）－１．２５×１０（－５）ｍｏｌ／Ｌ。     

丰沛铜地氟病区大气环境中氟的分布

利用石灰滤纸法和滤膜电极法测试了徐州丰沛铜地区大气环境中的氟含量,结果表明：由城区至城效到农村,大气环境中的氟含量趋向下降,采煤、煤的燃烧和铝厂等企业是大气中氟的主要污染源,该区地氟病与大气环境中的氟含量未见明显联系,不属燃煤污染型     

城市生活垃圾集运设备研究

对城市生活垃圾的集运方式进行了研究与分析。介绍了所研究开发的链条型地平式垃圾中转站和采用楔型压头结构的压缩式垃圾中转站的关键技术     

街谷地区CO污染现状分析

本文分析了典型街谷地区ＣＯ污染的现状及其浓度的垂直分布和水平分布的变化情景。由监测结果可知,街谷地区ＣＯ浓度是较高的,而且峰值出现在采暖期。     

改性Ti/SnO2-Sb电极催化降解1,4-二氯苯废水试验研究

采用聚合物前驱体法制备了未掺杂、掺杂Cu、掺杂Bi、掺杂Ni的4种Ti/Sn O2-Sb电极,运用SEM和XRD分析电极表面形貌及结构,通过线性极化扫描、循环伏安等测试考察其电化学性能,同时进行1,4二氯苯(p-DCB)降解实验进一步探究电极的电催化氧化特性.SEM和XRD结果表明,掺杂金属可改善电极表面形貌,增大其比表面积;电化学测试表明,Ti/Sn O2-Sb电极的析氧电位并未因金属掺杂而有明显改变,掺杂金属后,Ti/Sn O2-Sb电极具有更优的电催化活性和稳定性.p-DCB降解实验表明,改性Ti/Sn O2-Sb电极对p-DCB的降解效率明显提高,其中Ti/Sn O2-Sb-Cu电极的电催化处理效果最优,电解2 h后p-DCB的去除率即达到87.6%,且p-DCB的降解反应遵循一级反应动力学规律.     

电气设备触电危险因素分析

我国现阶段生产、生活中触电事故增加,采用故障树的分析方法,对用电设备触电事故进行危险因素分析,得出保护接地在供配电系统中的重要作用。简要介绍保护接地,并指出目前我国用电设备保护接地中存在的问题及接地故障的防范措施。     

An integrated method for the rapid dewatering and solidification/stabilization of dredged contaminated sediment with a high water content

• An integrated method, called PHDVPSS, was proposed for treating DCS. • The PHDVPSS method showed superior performance compared to conventional method. • Using the method, water content (%) of DCS decreased from 300 to<150 in 3 days. • The 56-day UCS from this method is 12‒17 times higher than conventional method. • Relative to PC, GGBS-MgO binder yielded greater reduction in the leachability. To more efficiently treat the dredged contaminated sediment (DCS) with a high water content, this study proposes an integrated method (called PHDVPSS) that uses the solidifying/stabilizing (S/S) agents and prefabricated horizontal drain (PHD) assisted by vacuum pressure (VP). Using this method, dewatering and solidification/stabilization can be carried out simultaneously such that the treatment time can be significantly shortened and the treatment efficacy can be significantly improved. A series of model tests was conducted to investigate the effectiveness of the proposed method. Experimental results indicated that the proposed PHDVPSS method showed superior performance compared to the conventional S/S method that uses Portland cement (PC) directly without prior dewatering. The 56-day unconfined compressive strength of DCS treated by the proposed method with GGBS-MgO as the binder is 12‒17 times higher than that by the conventional S/S method. DCS treated by the PHDVPSS method exhibited continuous decrease in leaching concentration of Zn with increasing curing age. The reduction of Zn leachability is more obvious when using GGBS-MgO as the binder than when using PC, because GGBS-MgO increased the residual fraction and decreased the acid soluble fraction of Zn. The microstructure analysis reveals the formation of hydrotalcite in GGBS-MgO binder, which resulted in higher mechanical strength and higher Zn stabilization efficiency.     

Evaluation of the technoeconomic feasibility of electrochemical hydrogen peroxide production for decentralized water treatment

• Gas diffusion electrode (GDE) is a suitable setup for practical water treatment. • Electrochemical H₂O₂ production is an economically competitive technology. • High current efficiency of H₂O₂ production was obtained with GDE at 5–400 mA/cm². • GDE maintained high stability for H₂O₂ production for ~1000 h. • Electro-generation of H₂O₂ enhances ibuprofen removal in an E-peroxone process. This study evaluated the feasibility of electrochemical hydrogen peroxide (H₂O₂) production with gas diffusion electrode (GDE) for decentralized water treatment. Carbon black-polytetrafluoroethylene GDEs were prepared and tested in a continuous flow electrochemical cell for H₂O₂ production from oxygen reduction. Results showed that because of the effective oxygen transfer in GDEs, the electrode maintained high apparent current efficiencies (ACEs,>80%) for H₂O₂ production over a wide current density range of 5–400 mA/cm², and H₂O₂ production rates as high as ~202 mg/h/cm² could be obtained. Long-term stability test showed that the GDE maintained high ACEs (>85%) and low energy consumption (<10 kWh/kg H₂O₂) for H₂O₂ production for 42 d (~1000 h). However, the ACEs then decreased to ~70% in the following 4 days because water flooding of GDE pores considerably impeded oxygen transport at the late stage of the trial. Based on an electrode lifetime of 46 days, the overall cost for H₂O₂ production was estimated to be ~0.88 $/kg H₂O₂, including an electricity cost of 0.61 $/kg and an electrode capital cost of 0.27 $/kg. With a 9 cm² GDE and 40 mA/cm² current density, ~2–4 mg/L of H₂O₂ could be produced on site for the electro-peroxone treatment of a 1.2 m³/d groundwater flow, which considerably enhanced ibuprofen abatement compared with ozonation alone (~43%–59% vs. 7%). These findings suggest that electrochemical H₂O₂ production with GDEs holds great promise for the development of compact treatment technologies for decentralized water treatment at a household and community level.     

水平井油基钻井液气侵溶解气膨胀运移规律研究

天然气进入井筒并溶解于油基钻井液会对钻井安全产生潜在威胁,溶解气随钻井液运移到井口附近突然发生析出 并膨胀,使气侵早期监测及预警的难度显著增加。为了降低井喷发生概率和钻井作业风险,针对水平井油基钻井液溶解 气运移规律进行了研究。采用气液两相流模型,模拟了不同初始气侵速率情况下甲烷溶解气和游离气随钻井液在水平段 和垂直段的运移过程,得到环空中钻井液的流速变化、甲烷析出过程、井筒环空气液两相流流型变化、泥浆池增量随时 间变化和截面含气率沿程分布等规律。模拟结果表明,油基钻井液发生气侵时的初始进气率存在临界值;在小气侵速率 情况下,侵入环空的甲烷将以溶解气的形式运移到井口,在井口分离释放,对钻井安全构成的威胁较小;而当气侵量超 过临界值时,在环空上部发生气体分离,分离点迅速下移,如不及时控制,在极短时间内便可演化为井喷,危险性极大 。