海绵铁预处理DSD酸废水的研究

用铁泥废渣制备水处理材料海绵铁,研究含碳球团直接还原的金属化率与还原时间,温度和铁泥粒度之间的关系,得到含碳球团制备海绵铁的反应参数。并对海绵铁预处理DSD酸废水的各种影响因素进行了试验研究,确定最佳试验条件;通过试验对海绵铁处理DSD酸废水的机理进行了探讨,确定它是电化学作用、电场作用、絮凝沉淀以及物理吸附等共同作用的结果。试验表明,海绵铁可作为高浓度DSD废水的预处理材料。     

Adsorption selectivity of salicylic acid and 5-sulfosalicylic acid onto hypercrosslinked polymeric adsorbents

Both bottle-point and column-feeding experiments involving different solutes and sorbents were carried out to investigate the adsorption selectivity and separation performance of salicylic acid and 5-sulfosalicylic acid. Their adsorption isotherms onto such hypercrosslinked polymeric adsorbents as NDA-100 and NDA-99 could be well described by the Freundlich equations whose characteristics describe extrathermic and favorable adsorption processes. The adsorption towards NDA-100 mainly depended on the π-π interaction, while that towards NDA-99 was extremely influenced by the static-electric interaction. Additionally, the adsorptive capacity of salicylic acid on NDA-99 decreased while it increased on NDA-100 with the presence of 5-sulfosalicylic acid in the adsorptive environment as the competitive component. Comparatively, the adsorption capacity of 5-sulfosalicylic acid decreased on both resins with salicylic acid as the competitive component. In fact, the difference in the interaction between adsorbent and adsorbate resulted in the straight antagonism on the effective adsorption sites on the adsorbent. In conclusion, the adsorption selectivity of salicylic acid onto NDA-100 was obviously larger than that onto NDA-99 with the existence of 5-sulfosalicylic acid in the adsorptive environment. A satisfactory separation and recovery of tested solutes in aqueous phase could be foreseeably achieved by the sequencing adsorption technique involving NDA-100 as well as NDA-99. Translated from Environmental Pollution & Control, 2005, 27(8): 570–574 [译自: 环境污染与防治]     

Effects of simulated acid rain on cation release in soils of South China

This paper deals with the release of base cations and Al3+ at the treatment with simulated acid rain (SAR) in main soil types collected from South China. Results showed that the amounts of base cations increased obviously when the pH value of simulated acid rain was lower than 3.0 or 3.5. Compared with the leaching of K+ and Na+, the leaching of Ca2+ and Mg2+ was affected by the pH value of SAR. Only when the amounts of base cations leached from soils exceeded the cation exchange capacity, the pH value of leaching solutions decreased sharply and the amounts of released Al3+ increased. The H+ buffering mechanisms, which were affected notonly by the pH values of SAR, but also by the types and solid components of soils, were proposed for the main soils studied.     

酸性矿山废水的处理研究

简要分析了酸性矿山废水的主要污染物及危害,叙述了几种主要的处理技术:中和法、硫化沉淀浮选法、微生物法和人工湿地,并介绍了它们的机理、特点及实验研究和工业应用情况,由此对我国的酸性矿山废水的治理技术进行了前景展望。     

两种奥氏体不锈钢酸性盐雾腐蚀行为研究

目的研究0Cr18Ni9(钝化)不锈钢与0Cr18Ni10Ti(钝化)不锈钢在酸性盐雾条件下的腐蚀行为,为发动机零件选材及防护措施的改进提供依据。方法按GJB150.11A—2009《军用装备环境试验方法盐雾试验》进行,调节溶液p H到3.5±0.5,以24 h喷雾润湿+24 h干燥为一个循环,分别开展2(96 h)、4(192 h)、5(240 h)个循环的酸性盐雾试验。采用目视、称量、X射线衍射(XRD)、扫描电子显微镜(SEM)及能谱仪(EDS)对盐雾腐蚀后试样进行观察及分析。结果 0Cr18Ni9(钝化)与0Cr18Ni10Ti(钝化)两种奥氏体不锈钢均发生了轻微的腐蚀,主要为局部腐蚀及均匀腐蚀。结论两种金属在酸性盐雾条件下耐蚀性良好,且可满足目前海军型发动机对材料耐酸性盐雾腐蚀的要求,0Cr18Ni9(钝化)略优于0Cr18Ni10Ti(钝化)。     

活性硅酸聚合硫酸铁的研究

以硅酸钠，硫酸和聚合硫酸铁为原料制备活性硅酸合硫酸铁，测定了ＡＳＰＦＳ红外光谱，了Ｆｅ／Ｓｉ摩尔比和水样ＰＨ值等因素对产品和除浊效果的影响当Ｆｅ／Ｓｉ摩尔比为１．５时产品稳定性和除浊效果均较好。     

杂多化合物脱硫化氢动力学研究

在双搅拌、无浓度梯度气液反应器中考察了磷钼杂多化合物吸收H2S过程的宏观动力学行为.结果表明,吸收剂浓度提高,脱硫效果增强,当磷钼酸钠浓度超过6.25×10-3mol/L后,单一与复配体系对H2S的吸收速率均趋恒定.从工业操作角度来看,6.25×10-3mol/L是适宜的操作浓度温度提高,吸收效果略有降低,但变化幅度不大,实际操作温度可选择常温;进气H2S浓度提高,吸收效果增强.两种脱硫体系中,以复配体系脱硫性能为优.实验测得25℃下反应器中H2S的气、液相传质系数分别为:kGH-2S =8.201×10-10kmol/(m2.s.Pa),kLH-2S=3.440×10-4m/s.吸收反应对磷钼酸钠及硫化氢的反应级数分别为0.339与1.055.     

合成盐酸中酸性废水的综合治理

对合成盐酸中的酸性废水循环利用,并用此酸性水作为生产普通盐酸的吸收水.实践证明,该方法是一种行之有效的治理途径,有较好的环境和经济效益.     

硫精砂尾矿还原硫酸烧渣的研究

利用硫精砂尾矿还原硫酸烧渣，从而提高烧渣中的铁的浸出率，达到综合利用尾矿及烧渣，减轻污染的目的。结果表明，把烧渣和尾矿按４－６比１的比例混合，在７００－８００℃处理３０ｍｉｎ，铁的浸出率比处理前增加３倍。文中还讨论了还原机理。     

环烷酸脱油工艺的实验研究

以锦州化工二厂生产的２＃环烷酸为原料，采用减压蒸馏──初馏分皂化萃取脱油工艺，可制得中性油含量分别低于１０％和５％的一级品环烷酸．该工艺具有流程简单、物料消耗少、产品收率高等优点．通过实验，初步探讨了蒸馏真空度、氢氧化钠浓度及用量、乙醇用量、萃取剂用量等工艺条件对脱油效果及产品质量的影响。