A hybrid decision-making approach based on FCM and MOORA for occupational health and safety risk analysis

IntroductionWith the development of industries and increased diversity of their associated hazards, the importance of identifying these hazards and controlling the Occupational Health and Safety (OHS) risks has also dramatically augmented. Currently, there is a serious need for a risk management system to identify and prioritize risks with the aim of providing corrective/preventive measures to minimize the negative consequences of OHS risks. In fact, this system can help the protection of employees’ health and reduction of organizational costs. Method: The present study proposes a hybrid decision-making approach based on the Failure Mode and Effect Analysis (FMEA), Fuzzy Cognitive Map (FCM), and Multi-Objective Optimization on the basis of Ratio Analysis (MOORA) for assessing and prioritizing OHS risks. After identifying the risks and determining the values of the risk assessment criteria via the FMEA technique, the attempt is made to determine the weights of criteria based on their causal relationships through FCM and the hybrid learning algorithm. Then, the risk prioritization is carried out using the MOORA method based on the decision matrix (the output of the FMEA) and the weights of the criteria (the output of the FCM). Results: The results from the implementation of the proposed approach in a manufacturing company reveal that the score at issue can overcome some of the drawbacks of the traditional Risk Priority Number (RPN) in the conventional FMEA, including lack of assignment the different relative importance to the assessment criteria, inability to take into account other important management criteria, lack of consideration of causal relationships among criteria, and high dependence of the prioritization on the experts’ opinions, which finally provides a full and distinct risk prioritization.     

Nitrogen evolution during the co-combustion of hydrothermally treated municipal solid waste and coal in a bubbling fluidized bed

Nitrogen evolution was studied during the co-combustion of hydrothermally treated municipal solid wastes (HT MSW) and coal in a bubbling fluidized bed (BFB). HT MSW blending ratios as 10%, 20% and 30% (wt.%) were selected and tested at 700, 800, 900 °C. Emissions of NO and N₂O from blends were measured and compared with the results of mono-combustion trials. Moreover, concentrations of precursors like NH₃ and HCN were also quantified. The results are summarized as follows: NO emissions were predominant in all the cases, which rose with increasing temperature. The blending of HT MSW contributed to the NO reduction. N₂O emissions decreased with temperature rising and the blending of HT MSW also presented positive effects. At 30% HT MSW addition, both NO and N₂O emissions showed the lowest values (391.85 ppm and 55.33 ppm, respectively at 900 °C). For the precursors, more HCN was detected than NH₃ and both played important roles on the gas side nitrogen evolution.     

不同运行模式下改良型CAST工艺处理生活污水的除磷性能

实验采用改良型CAST工艺,以生活污水为研究对象,考察了C/P、回流比及温度等不同运行模式对系统除磷性能的影响.结果表明,常温条件下进水C/P由50升至100,系统除磷率均值从15%迅速升至95.6%,除磷性能显著提高;继而降低C/P至75,除磷性能因进水碳源不足再度下降,除磷率均值为51.4%,且长期投加易降解碳源引发系统污泥膨胀并导致污泥大量流失.C/P较低情况下,回流比由25%降低至12.5%,除磷性能提高2.3倍,继续降低回流比至0,除磷性能反而下降;温度实验研究则表明,低温系统(14℃±1℃),除磷率稳定维持在90%以上,而高温短程硝化系统(27℃±1℃)除磷率仅为14.1%,可见低温更有利于系统磷的去除.吸磷小试发现,常温系统污泥以O_2、NO_3~-和NO_2~-为电子受体均能进行吸磷,而低温系统污泥能以O_2、NO_3~-为电子受体进行吸磷,高温系统污泥则仅能以O_2为电子受体进行少量吸磷.此外,实验还发现,系统短期闲置导致的污泥"饥饿"有利于系统除磷率的提高.     

磷酸盐对亚硝化系统的抑制及恢复

通过接种城镇污水处理厂的污泥,采用连续流反应器启动亚硝化系统并改变进水磷酸盐的浓度,研究了不同磷酸盐浓度对亚硝化系统的影响.结果表明经过14 d的运行,亚硝化系统启动成功,氨氮转化率达到92.2%,亚硝酸盐累积率为73.66%,亚硝酸盐产生速率达到14.42 g·(m~3·d)~(-1).磷酸盐浓度在10~30 mg·L~(-1)时对亚硝化系统的影响并不大;随着磷酸盐浓度持续提高,氨氮转化率在不断降低.当磷酸盐的浓度为80 mg·L~(-1)时,系统的氨氮转化率为13.6%,亚硝酸盐累积率仅18.19%,亚硝酸盐产生速率仅0.54 g·(m~3·d)~(-1),亚硝化反应受到严重抑制.将进水磷酸盐浓度降低到0,经过14 d运行,亚硝化系统获得恢复,且氨氮转化率可以达到80%以上,亚硝酸盐累积率达到86.96%,亚硝酸盐产生速率为15.63g·(m~3·d)~(-1).     

我国工业危险废物的来源、处理及监管对策与建议

通过大量环境统计数据的分析,对我国工业危险废物的产生、综合利用、处置和贮存,从行业来源、区域分布进行了分析和总结。结合我国工业危险废物企业自建设施和政府集中处理设施处理情况,对我国工业危险废物的处理和环保监管对策提出了若干建议。     

生活垃圾焚烧飞灰固化体力学及重金属浸出特性

以苏州七子山生活垃圾焚烧厂产生的飞灰为研究对象,采用水泥作为固化剂,研究水泥飞灰固化体的应力应变特征及重金属浸出特性,并探讨了水泥飞灰配合比、养护时间等关键性因素对这些特性的影响。实验结果表明:较养护3 d的样品,其余养护时间的样品强度平均增长了约96.2%,而其破坏应变平均减小了56%。随着水泥含量和养护时间的增加,飞灰固化体的强度上升,而其破坏应变减小,该趋势主要归因于钙矾石(AFt)的形成促进了飞灰固化体强度的发展。较飞灰原样,飞灰固化体的重金属浸出浓度随着水泥含量、养护时间的增加而降低了38%~99%,重金属的迁移被限制,主要归因于水化硅酸钙(C—S—H)和钙矾石(AFt)的形成,以及飞灰和水泥水化反应创造的强碱性环境。     

厌氧发酵处理庆大霉素菌渣的可行性及条件优化

采用厌氧发酵处理庆大霉素菌渣,考察了含固率、接种比、接种污泥、发酵底物等因素对庆大霉素菌渣厌氧发酵的影响,并用累积净甲烷产量衡量庆大霉素菌渣进行厌氧发酵的可行性及发酵程度。试验结果证实了庆大霉素菌渣进行厌氧发酵的可行性,其中含固率和接种比对发酵的影响较大,最佳条件为含固率5%,接种比1/3;对比试验所用3种接种污泥,发现接种某造纸厂污水处理IC反应器的厌氧颗粒污泥效果最优,在最优含固率和接种比的条件下,累积净产甲烷量为28.21 m3/t;此外,试验还证实,采用不同菌渣的联合发酵表现出了明显的协同作用,在最优条件下,庆大霉素菌渣与林可霉素菌渣按1∶2的比例联合发酵的产甲烷量可达到37.5 m3/t。     

Effects of free ammonia on volatile fatty acid accumulation and process performance in the anaerobic digestion of two typical bio-wastes

The effect of free ammonia on volatile fatty acid(VFA)accumulation and process instability was studied using a lab-scale anaerobic digester fed by two typical bio-wastes:fruit and vegetable waste(FVW)and food waste(FW)at 35°C with an organic loading rate(OLR)of 3.0 kg VS/(m~3·day). The inhibitory effects of free ammonia on methanogenesis were observed due to the low C/N ratio of each substrate(15.6 and 17.2,respectively). A high concentration of free ammonia inhibited methanogenesis resulting in the accumulation of VFAs and a low methane yield. In the inhibited state,acetate accumulated more quickly than propionate and was the main type of accumulated VFA. The co-accumulation of ammonia and VFAs led to an "inhibited steady state" and the ammonia was the main inhibitory substance that triggered the process perturbation. By statistical significance test and VFA fluctuation ratio analysis,the free ammonia inhibition threshold was identified as 45 mg/L. Moreover,propionate,iso-butyrate and valerate were determined to be the three most sensitive VFA parameters that were subject to ammonia inhibition.     

湖北省PM2.5与PM10比值分析及PM2.5时空分布特征研究

基于2012年-2014年湖北省大气污染物监测数据,通过数据反演方法,得到湖北省17个城市的PM2.5年均浓度.利用ArcGIS绘制出各城市不同年份的颗粒物浓度空间分布图,并对其进行分析.结果表明,2012年-2014年间,湖北省17个城市PM2.5与PM10年均浓度比值为0.66,PM2.5年均浓度超出国家二级标准,整体呈现上升趋势.城市方面,在多数城市PM2.5与PM10浓度上升的同时,仅武汉、黄冈和天门3个城市颗粒物浓度2014年较2013年有所下降,且武汉市PM2.5浓度下降率达12.8%,表明武汉市近两年来采取的政策措施具有较好的可行性和有效性.     

金属铜原子氧效应研究

目的获取金属铜空间原子氧环境适应性数据,提升材料空间环境适应性设计水平。方法将金属铜样品置于射频源原子氧辐照面积内开展原子氧辐照试验,束流密度为2.5×1016/(cm2·s),最长辐照时间为300 min。研究随辐照时间增加样品表面成分、形貌以及性能的变化。结果原子氧辐照后,金属铜表面变得粗糙,300 min辐照样品出现了氧化层脱落现象;随辐照时间增加,样品质量呈增加趋势,300 min辐照样品质量增加0.035 mg;试验后样品太阳吸收比升高最大值达0.07,光谱反射系数下降;原子氧作用导致金属铜表面疏水性能提高,摩擦磨损性能下降。结论得到了金属铜原子氧环境效应数据,可为航天器空间环境效应防护设计提供技术支撑。