Promotion of hexadecyltrimethyleamine bromide to the damage of Alexandrium sp. LC3 by cupric glutamate

The effect of hexadecyltrimethyleamine bromide （HDTMAB） on the removal of A lexandrium sp. LC3 under cupric glutamate stress was investigated. Toxic effect of cupric glutamate on A lexandrium sp. LC3 was significantly promoted in the presence of HDTMAB, especially at 3.0 cmc of HDTMAB. It was found that the sulfhydryl group content of the cell decreased, while the malonaldehyde content and membrane permeability increased when A lexandrium sp. LC3 was treated with HDTMAB and cupric glutamate complex, compared with cupric glutamate alone. The data suggest that HDTMAB might stimulate the damage of A lexandrium sp. LC3 by enhancing the membrane permeability.     

电解浮选用于活性污泥固液分离的研究

在装有Ti/RuO₂-IrO₂-TiO₂阳极、Ti阴极的电解浮选槽中进行了活性污泥固液分离的研究.考察了影响电解浮选性能的操作参数,这些参数包括水力停留时间、电流密度、进水SS浓度和进水pH值.研究表明,电解浮选是高效的固液分离单元,水力停留时间和电流密度是主要的影响因素.SS的去除率随着水力停留时间和电流密度的增加而增大;污泥负荷增加,SS的去除率下降;pH值影响电解产生微气泡的尺寸和污泥性质,但对SS的去除影响不大,实际应用中可以不调节pH值.进水SS约1 000mg/L时,当水力停留时间为20min,接触室电流密度为5 mA/cm²,分离区电流密度为2.5 mA/cm²,SS的去除率可达97%以上,此时的能耗为0.4～0.5(kW.h)/m³废水.电解浮选产生的浮渣含水率为95.9%,低于溶气气浮和二沉池的污泥含水率,对污泥减量化及其最终处置有较大的意义.     

Occurrences of pharmaceutical and personal care products as micropollutants in rivers from Romania

The occurrence of pharmaceutical and personal care products (PPCPs) was investigated in the Somes River. The aim of this study was to obtain a first overview about the contamination of Somes River (Transylvania) with PPCPs. The samples were preconcentrated by Solid Phase Extraction (SPE) procedures and analysed by GC/MS. A number of 15 compounds including pharmaceutics, metabolites, intermediates and musk fragrances were detected in concentration ranging from 30 ng/l to 10 μg/l. The detected pharmaceuticals are included in following therapeutic groups: analgesics, antiepileptics, psychiatric, stimulants, anticoagulants, antineoplastic and disinfectants.     

Vapour pressures, aqueous solubility, Henry's law constants and air/water partition coefficients of 1,8-dichlorooctane and 1,8-dibromooctane

New data on the vapour pressures and aqueous solubility of 1,8-dichlorooctane and 1,8-dibromooctane are reported as a function of temperature between 20 °C and 80 °C and 1 °C and 40 °C, respectively. For the vapour pressures, a static method was used during the measurements which have an estimated uncertainty between 3% and 5%. The aqueous solubilities were determined using a dynamic saturation column method and the values are accurate to within ±10%. 1,8-Dichlorooctane is more volatile than 1,8-dibromooctane in the temperature range covered (p_sat varies from 3 to 250 Pa and from 0.53 to 62 Pa, respectively) and is also approximately three times more soluble in water (mole fraction solubilities at 25 °C of 5.95 × 10⁻⁷ and 1.92 × 10⁻⁷, respectively). A combination of the two sets of data allowed the calculation of the Henry’s law constants and the air water partition coefficients. A simple group contribution concept was used to rationalize the data obtained.     

Formation of dioxins from combustion of polyvinylidene chloride in a well-controlled incinerator

Polyvinylidene chloride (PVDC; polymer of 1,1-dichloroethylene) was combusted with paper in a well-controlled, small-scale incinerator at an average grate temperature of 700 °C, and then dioxins (PCDDs, PCDFs, and coplanar-PCBs) formed in the exhaust gases were analyzed by gas chromatography/mass spectrometry. PVDC lowered the combustion temperature due to its less flammable character. The amount of total dioxins (PCDDs + PCDFs + coplanar-PCBs) formed in the exhaust gas was 58.0 ng/g of a combustion sample and its toxicity equivalency quantity (TEQ) value was 0.64 ng-TEQ/g. The amount of PCDDs formed in the sample ranged from 2.33 ng/g (Cl₈-isomer) to 0.048 ng/g (Cl₁-isomer). The lower the number of chloride, the less production of PCDDs. On the other hand, there was no relation between the number of chloride and PCDF formation. The amount of PCDFs formed in the sample ranged from 8.02 ng/g (Cl₂-isomer) to 4.46 ng/g (Cl₈-isomer). A polyvinylchloride (PVC) sample produced 207 ng/g of total dioxins and a PVDC sample produced 57.4 ng/g of total dioxins when they were combusted under the same conditions. An approximately equal composition of dioxin isomers was formed from PVDC and PVC samples. Paper was found to contribute to PCDF formation when it was combusted with plastics.     

Evaluation of the emission characteristics of PCDD/Fs from electric arc furnaces

Distribution of PCDD/F (polychlorinated dibenzo-p-dioxin and polychlorinated dibenzofuran) congeners at two electric arc furnaces (EAFs) in Taiwan is evaluated via intensive stack sampling and analysis. Two kinds of exhaust system in EAFs including stack system and shutter system are selected for measuring dioxin emissions. In addition, dioxin emissions during oxidation and reduction stages at EAF-A were characterized. Results indicate that the PCDD/F concentration of stack gas in EAF-A was 4.39 ng/N m³ while total Toxic Equivalent Quantity (TEQ) concentration was 0.35 ng I-TEQ/N m³. The PCDD/F concentration of stack gas in EAF-B was 2.20 ng/N m³ and the TEQ concentration was 0.14 ng I-TEQ/N m³. 1,2,3,4,6,7,8-H_pCDF, OCDD and OCDF are the major contributors of the dioxin concentrations for two EAFs investigated and the percentage of PCDD/F in particulate phase increases as the chlorination level of the PCDD/F congener increases. The results obtained on gas/particulate partitioning of PCDD/Fs in flue gases prior to the APCD in EAFs indicate that more than 90% exists in particulate phase. In EAF-A, the PCDD/F concentration during oxidation stage is slightly higher than that measured during reduction stage, including the sampling points of CO converter outlet, prior to bag filter and stack. Majority of PCDD/Fs emitted from steel-making processes exists in particulate-phase (about 60–70%) at both EAFs investigated.     

Broad range analysis of endocrine disruptors and pharmaceuticals using gas chromatography and liquid chromatography tandem mass spectrometry

Endocrine disrupting compounds (EDCs) and pharmaceuticals and personal care products (PPCPs) have been globally detected in impacted natural waters. The detection of trace quantities of EDCs and PPCPs in the environment is of great concern since some of these compounds have known physiological responses at low concentrations. EDCs can have a wide range of polarities, acidic and basic moieties, and exist in trace quantities, which often requires numerous complex extractions, large sample collection volumes, and multiple instrumental analyses. A comprehensive method has been developed allowing for the analysis of 58 potential EDCs in various water matrices using a single solid-phase extraction (SPE) of a 1 L sample with subsequent analyses using both gas chromatography and liquid chromatography, each coupled with tandem mass spectrometry (GC–MS/MS and LC–MS/MS). Instrument detection limits ranged between 0.12–7.5 pg with corresponding method reporting limits of 1–10 ng l⁻¹ in water. Recoveries for most compounds were between 50% and 112% with good reproducibility (RSD 6–22%).     

耕作制度对川中丘陵区冬灌田CH4和N2O排放的影响

采用静态暗箱/气相色谱法连续2 a田间原位测定,研究川中丘陵区冬灌田CH₄和N₂O的排放特征和不同耕作制度对冬灌田CH₄和N₂O排放的影响.结果表明,1a只种1季中稻冬季灌水休闲的冬灌田(PF),在水稻生长期,CH₄平均排放通量为(21.44±1.77)mg·(m²·h)^-1,非水稻生长期为(3.77±0.99)mg·(m²·h)^-1,分别大大低于以前文献报道的在西南其它地方观测值;全年CH₄排放量以水稻生长期CH₄排放量为主,非水稻生长期CH₄排放量仅占全年总排放量的23.2%.冬灌田N₂O排放通量年均值为(0.051±0.008)mg·(m²·h)^-1,且主要集中在水稻生长季,非水稻生长期N₂O排放量仅占全年总排放量的8.1%.在采用水旱轮作制后,冬灌田CH₄排放量大大降低,稻-麦轮作(RW)和稻-油菜轮作(RR)全年CH₄排放量分别为PF的43.8%和40.6%.但冬灌田改为水旱轮作制后,N₂O排放量显著增大,RW和RR的N₂O年排放量分别是PF的3.7倍和4.5倍.综合考虑冬灌田在采用不同耕作制度后排放CH₄和N₂O的全球增温潜势(GWP),无论是短时间尺度还是长时间尺度,采用3种耕作制度全年所排放的CH₄和N₂O所产生的综合GWP都为:PF RW≈RR.在20a、100a和500a时间尺度上,PF分别约是RW和RR的2.6、2.1和1.7倍.冬灌田改为水旱轮作制度后能大大减少CH₄和N₂O所产生的综合GWP.     

CSM/EVA复合材料的阻燃与伸缩性能研究

采用机械共混法制备了EVA/CSM复合材料.系统地研究了EVA与CSM的混合比率、CSM交联及不同阻燃体系对复合材料阻燃性质的影响.结果表明,掺杂阻燃剂之后,复合材料都具有很好的阻燃性能,其中使用Sb2O3/氯乙醇混合阻燃体系,阻燃效果最好,且复合材料交联后,阻燃性能会进一步增强.同时研究了各种因素,如交联、混合比率和处理温度对复合材料收缩率的影响.当CSM含量较高或拉伸温度处于室温,收缩率都较好;而交联前,加入阻燃剂会使复合材料收缩性能降低;反之,交联后使之增加.     

A/DAT-IAT生物膜法处理高含盐废水

以含盐量为60 000mg/L(以NaCl计)的模拟工业废水为研究对象,利用A/DAT-IAT生物膜反应器,研究A/DAT-IAT工艺对投加悬浮填料后高含盐废水的处理,并以CODCr、NH4 -N、PO43--P等作为指标评价处理效果.试验结果表明,在总水力停留时间(HRT)为13 h、pH=7,5、25℃条件下,进水ρ(CODCr)、ρ(NH4 -N)和ρ(PO43--P)分别为907.4～1 210.0 mg/L、86.2～99.7 mg/L和3.6～5.1 mg/L.CODCr、NH4 -N和PO43--P的平均去除率分别为73.9%、38.6%和93.5%,平均出水SS为198 mg/L,其中CODCr和PO43--P的去除效果较好.研究表明,A/DAT-IAT生物膜法较其他活性污泥法有了较大的提高.