RP-1400a大气颗粒物(PM10)监测仪的日常维护经验

RP-1400a大气颗粒物(PM10)监测仪的日常维护和常见故障排除方法的一些经验.     

Effects of combinations of malathion and cypermethrin on survivability and time of metamorphosis of tadpoles of Indian cricket frog (Fejervarya limnocharis)

This study was undertaken to determine the effect of environmentally realistic concentrations of two commonly used pesticides viz., malathion and cypermethrin, using a fully 3 × 3 factorial experiments on the survivability and time of metamorphosis in a common rice paddy field frog (cricket frog) Fejervarya limnocharis under laboratory conditions. The results suggest that cypermethrin is more toxic than malathion and combinations of higher concentrations of cypermethrin (50 μg/L) with malathion (250 and 500 μg/L) are more deleterious to the survivability of tadpoles. With increasing cypermethrin concentration, the survivability of tadpole decreased (r = ?0.986, P = 0.108). But cypermethrin alone induced early metamorphosis among the surviving tadpoles. However, there was a delay in the time required for metamorphosis induced by malathion and its combination with cypermethrin. The delay in metamorphosis may indicate the altered physiological fitness of the individual. The emergent froglets will be subjected to environmental stressors like high temperature and less humidity of post-monsoon tropical climate that could enhance negative influence triggered by pesticides.     

Prediction of near-field shear dispersion in an emergent canopy with heterogeneous morphology

The evaluation of longitudinal dispersion in aquatic canopies is necessary to predict the behavior of dissolved species and suspended particles in marsh and wetland systems. Here we consider the influence of canopy morphology on longitudinal dispersion, focusing on transport before constituents have mixed over depth. Velocity and longitudinal dispersion were measured in a model canopy with vertically varying canopy density. The vertical variation in canopy morphology generates vertical variation in the mean velocity profile, which in turn creates mean-shear dispersion. We develop and verify a model that predicts the mean-shear dispersion in the near field from morphological characteristics of the canopy, such as stem diameter and frontal area. Close to the source, longitudinal dispersion is dominated by velocity heterogeneity at the scale of individual stems. However, within a distance of approximately 1 m, the shear dispersion associated with velocity heterogeneity over depth increases and eclipses this smaller-scale process.     

岛津TNP-4110在线分析仪的日常维护

从数据比对、硬件维护两个方面探讨岛津TNP-4110在线仪的日常维护问题。通过分析各种干扰因素来查找造成数据比对差异的原因并提出相应解决措施。在仪器日常维护上设立不同周期保养计划、共享设备维护经验,结合实践制定了合适的检修流程图。     

有害物质环境测试组合舱的研制及性能评价

研制了一种新型有害物质环境测试组合舱,该测试舱由舱体系（内舱和外舱）、恒温恒湿空气处理系统、空气循环装置和信号控制与处理软件组成。该测试舱具有可分别使用内舱和外舱对样品进行测试的特点,并采用美国FLUNT公司开发的air pack软件包对内舱和外舱的气流进行模拟与计算,并划分出内舱的层流区域,同时也对舱体系的性能进行了测试与评价。结果表明,有害物质环境测试组合舱的温湿度的相对标准偏差分别为0.04℃和0.7%,混合性达到90.7%。因此,该有害物质环境测试组合舱对温湿度控制精准,气流稳定,混合性能良好,能为室内空气污染研究提供条件稳定的室内仿真环境。     

潜流人工湿地水力学特性及工程设计

以净化低污染水体的潜流人工湿地水力学特性工程设计为重点,系统开展了室内外实验研究,并利用Peelet数分析了水平潜流人工湿地碎石床渗流返混程度。结果表明,潜流人工湿地集水花管孔口出流计算、基质填料内渗流计算、碎石床平均水力停留时间计算可分别借鉴薄壁孔口恒定淹没出流、线性或非线性渗流、活塞流理论;但受工程实际条件及运行淤堵等影响,工程实测结果均小于理论计算值。基于室内外实验成果,提出一套包括集配水系统水力计算、填料内渗流计算、平均水力停留时间计算在内的潜流人工湿地水力学特性计算方法和参数选择,可为人工湿地技术的工程设计提供借鉴。     

PRB强化垂直流人工湿地系统处理煤矿废水

针对常规人工湿地系统处理高浊含氮磷的有机煤矿废水不佳的问题,采用PRB与人工湿地耦合的方法,进行砂箱模拟实验研究。实验结果表明,由无烟煤、钢渣及沸石构建的PRB强化垂直流人工湿地系统对NH4+-N、PO34--P、Mn2+、COD、SS的去除率分别达到88.84%、96.08%、98.98%、85.78%和94.00%,与常规人工湿地相比,具有处理效率高、水力负荷大、占地面积小等特点,更便于运行管理。     

不同流量分配比对多级A/O工艺去除有机物及脱氮的影响

采用三级A/O工艺分段进水工艺处理低碳源生活污水,考察了进水流量分配比对系统去除有机物、硝化反硝化能力以及去除TN的影响。通过对水质指标沿程监测结果表明,不同流量分配比(4∶3∶3,5∶3∶2,6∶3∶1)对系统去除有机物及硝化效率影响不大,出水COD、氨氮分别均在30 mg/L、1 mg/L以下。但反硝化效果受流量分配比的影响较大,在流量比为5∶3∶2时,有效利用原水中碳源进行反硝化,反硝化效果最好。在流量比为5∶3∶2的情况下,TN出水为5.7 mg/L去除率为82.9%,优于流量分配比为6∶3∶1和4∶3∶3时的脱氮效果。总体而言,分段进水工艺在对碳源的有效利用及能耗节省方面优于单点进水。     

IC反应器处理MTO废水的中试研究

中试研究了内循环(IC)反应器处理甲醇制烯烃(MTO)废水的启动和运行过程,同时考察了颗粒污泥的性状及沼气产量的变化情况。试验过程运行稳定,系统抗冲击性强。以絮状污泥为接种污泥,经过131 d的启动和运行,IC反应器的COD去除负荷可达10 kg/(m~3·d)以上,COD去除率可达90%以上。IC反应器中的成熟颗粒污泥形状规则、密实、粒径大、沉降速率快。IC反应器的沼气产量符合理论预期。     

Physical Modeling of Emissions from Naturally Ventilated Underground Parking Garages

The dispersion of pollutants from naturally ventilated underground parking garages has been studied in a boundary layer wind tunnel. Two idealized model setups have been analysed, one was simulating pollutant dispersion around an isolated rectangular building and one was representing dispersion in a finite array of idealized building blocks. Flow and dispersion close to modelled ground level emission sources was measured. The results illustrate the complexity of the flow around buildings and provide insight in pollutant transport from ground level sources located directly on building surfaces. As a result, areas critical with respect to high pollutant concentrations could be visualized. Particularly, the results show high concentration gradients on the surface of the buildings equipped with modelled emission sources. Inside the boundary layers on the building walls, a significant amount of pollutants is transported to upwind locations on the surface of the building. The paper documents the potential of physical modelling to be used for the simulation and measurement of dispersion close to emission sources and within complex building arrangements.