铁炭复配修复地下水中NO_3~--N的条件研究

采用了铁炭复配修复地下水中NO3--N,探讨了实验条件对修复效果的影响。结果表明,在pH值近中性条件(初始pH 6.42)下,反应时间为1 h时NO3--N修复率达到60.85%;Fe/C=1∶1时介质最佳用量分别为4~5 g;Fe/C=1/1.5时修复率为72.80%;反应速率在高振荡强度下大于低振荡强度;氧化铜的催化效果最好,可使修复率提高7.5个百分点。铁炭复配介质修复地下水中NO3--N是有效可行的,修复率随反应时间的增加而提高,在Fe/C=1∶1时修复率与介质用量呈正相关,无限减小Fe/C比并不能无限提高修复率,振荡强度对修复具有显著影响,低振荡强度下的修复过程较高强度存在滞后现象,并非所有金属氧化物催化剂对铁炭修复NO3--N均有促进作用。     

Arsenic stabilization by zero-valent iron,bauxite residue,and zeolite at a contaminated site planting Panax notoginseng

Panax notoginseng (Burk.) F.H. Chen, a rare traditional Chinese medicinal herb, is a widely used phytomedicine used all over the world. In recent years, the arsenic contamination of the herb and its relative products becomes a serious problem due to elevated soil As concentration. This study aimed to evaluate the effects of different types and dosages of amendments on As stabilization in soil and its uptake by P. notoginseng. Results showed that comparing to control treatment, the As concentrations of P. notoginseng declined by 49–63%, 43–61% and 52–66% in 0.25% zero-valent iron (Fe(0)), 0.5% bauxite residue, and 1% zeolite treatment, respectively; whereas the biomasses were elevated by 62–116%, 45–152% and 114–265%, respectively. The As(III) proportions of P. notoginseng increased by 8%, 9%, and 8%, and the transfer factors of As from root to shoot increased by 37%, 42% and 84% in the optimal treatments of Fe(0), bauxite residue, and zeolite. For soil As, all the three amendments could transform the non-specifically adsorbed As fraction to hydrous oxides Fe/Al fractions (by Fe(0) and red mud) or specifically adsorbed As fraction (by zeolite), therefore reduced the bioavailability of soil As. With a comprehensive consideration of stabilization efficiency, plant growth, environmental influence, and cost, Fe(0) appeared to be the best amendment, and zeolite could also be a good choice. In conclusion, this study was of significance in developing As contamination control in P. notoginseng planting areas, and even other areas for medicinal herb growing.     

Impact of carbon,oxygen and sulfur content of microscale zerovalent iron particles on its reactivity towards chlorinated aliphatic hydrocarbons

Zerovalent iron (ZVI) abiotically degrades several chlorinated aliphatic hydrocarbons (CAHs) via reductive dechlorination, which offers perspectives for in situ groundwater remediation applications. The difference in reactivity between ZVI particles is often linked with their specific surface area. However, other parameters may influence the reactivity as well. Earlier, we reported for a set of microscale zerovalent iron (mZVI) particles the disappearance kinetic of different CAHs which were collected under consistent experimental conditions. In the present study, these kinetic data were correlated with the carbon, oxygen and sulfur content of mZVI particles. It was confirmed that not only the specific surface area affects the disappearance kinetic of CAHs, but also the chemical composition of the mZVI particles. The chemical composition, in addition, influences CAHs removal mechanism inducing sorption onto mZVI particles instead of dechlorination. Generally, high disappearance kinetic of CAHs was observed for particles containing less oxygen. A high carbon content, on the other hand, induced nonreactive sorption of the contaminants on the mZVI particles. To obtain efficient remediation of CAHs by mZVI particles, this study suggested that the carbon and oxygen content should not exceed 0.5% and 1% respectively. Finally, the efficiency of the mZVI particles may be improved to some extent by enriching them with sulfur. However, the impact of sulfur content on the reactivity of mZVI particles is less pronounced than that of the carbon and oxygen content.     

Impact of long‐term pesticide applications on some soil biological parameters

Abstract

The soil oxidative and anaerobic processes, as well as, the microbial biomass were followed during three years in a cotton farm (Tatuí) where the recommended pesticides have been used for several years, and in an experimental field (São Paulo) treated first time with the same pesticides. The oxidative process was monitored by the dehydrogenase (DHA)‐activity using triphenyltetrazolium chloride (TTC) as substrate. The anaerobic process was followed by the iron‐oxide reduction, and the microbial biomass was estimated by the substrate (glucose)‐indiced respiration. Increases in DHA‐activity and in the microbial biomass occurred only in the farm soil, with concomitant decreases in iron‐reduction. In the experimental field soil, the increases in DHA‐activity were followed only by decreases in iron‐reduction. Soil characteristics were the determining factor for different biological parameters after pesticide inputs. All the pesticides produced at least one clear but transient effect.     

微米Cu／Fe对污染土壤洗脱液中有机氯农药的降解

以表面活性剂TritonX-100（TX-100）为洗脱剂,某有机氯农药（organochlorinepesticides,OCPs）污染场地土壤为对象,七氯、氯丹和灭蚁灵为目标污染物,研究微米Cu／Fe双金属对污染土壤洗脱液中OCPs的降解效果。考察了洗脱液中OCPs初始浓度、洗脱液pH值、微米零价铁加入量和cu负载量对Cu／Fe去除OCPs效果的影响。结果表明,微米Cu／Fe可以有效的去除土壤洗脱液中目标污染物。当微米零价铁加入量为1．0g（25g／L）,cu负载量为1．0％,洗脱液pH值为6．89时,Cu／Fe对2号土壤洗脱液中七氯、γ-氯丹、α-氯丹和灭蚁灵的去除效果最好,去除率分别为100．0％、99．3％、80．8％和71．1％。洗脱液中OCPs初始浓度越低,微米零价铁加入量越大,Cu／Fe对OCPs去除率越高;偏酸性条件有利于Cu／Fe对γ-氯丹和灭蚁灵的去除,而α-氯丹在中性条件下去除效果最好;1号土壤和2号土壤洗脱液的最佳铜负载量分别为2．O％和1．0％。     

水热炭化餐厨垃圾制备纳米铁/炭复合材料

以餐厨垃圾中有机组分作为碳源,通过添加铁盐水热炭化制备铁/炭纳米复合材料。考察了不同铁盐(Fe-SO4,FeCl3,Fe(NO3)3)对餐厨垃圾水热炭化物的形貌,以及氮、磷元素的迁移转化的影响;并研究了负载铁的物理、化学性质。实验结果表明,铁盐在水热炭化过程中促进了餐厨垃圾转化生成多种纳米结构。铁的价态是影响复合物形貌的主要影响因素:三价铁离子对大分子有机物的水解和炭化过程有催化作用,从而促进壳核式结构的纳米线及微米球复合物的生成;而亚铁离子则导致可溶性有机物炭化形成空心纳米球结构。负载铁的化学形态主要受阴离子的影响:硝酸铁体系中铁主要以氢氧化物形式沉积、其他阴离子体系则以磷酸盐为主要形态负载。     

铁屑粉煤灰组合处理含磷废水

实验研究了铁屑粉煤灰组合处理含磷废水的除磷效果.通过单因素实验,考查了铁屑粉煤灰质量比、反应时间、pH值和投加量对除磷效果的影响.实验结果表明,该法除磷的最优条件为铁屑和粉煤灰的质量比为2∶1,反应时间为20 min,pH值为6,投加量为20 g/L.在最优实验条件下磷的去除率达到了97.5％.对比了该法和粉煤灰吸附法与传统铁屑法的除磷效果.与单一粉煤灰吸附法和传统铁屑法除磷的结果相比较,铁屑粉煤灰组合除磷的方法具有明显优势.     

几种印染助剂对壳聚糖稳定纳米铁去除酸性品红的影响

以氯化铁为铁源,硼氢化钠为还原剂,壳聚糖为稳定剂,采用液相还原法制备壳聚糖稳定纳米铁（CS-nZⅥ）;研究了印染废水中常见助剂NaNO₃、Na₂SO₄、NaH₂PO₄、K₂Cr₂O₇、EDTA二钠盐存在下,超声波辅助CS-nZⅥ对酸性品红（AF）降解的影响。结果表明,反应15 min,0.01 g CS-nZⅥ对25 mL、100 mg/L AF的去除率高达99.9%;各种助剂的存在使得纳米铁表面不同程度失活,阻碍反应的进行,使得AF的去除率下降。NaNO₃、K₂Cr₂O₇、EDTA二钠盐与纳米铁发生反应,与AF存在明显的竞争作用。重复利用实验表明,CS-nZⅥ重复利用7次仍具有一定的反应活性。此外,CS-nZⅥ对加标（50 mg/L）实际废水中AF的去除率达到99%以上,表明CS-nZⅥ是一种潜在的环境修复材料。     

Dechlorination of PCBs in the simulative transformer oil by microwave-hydrothermal reaction with zero-valent iron involved

The conventional hydrothermal reaction with iron powder, NaOH and H₂O as reactants was reported to occur at temperature above 423 K, and iron oxides (Fe₃O₄ and NaFeO₂) and hydrogen were produced. In this study, microwave heating was adopted to take the place of conventional heating to induce the hydrothermal reaction. Under microwave irradiation, NaOH and H₂O absorbed microwave energy by space charge polarization and dipolar polarization and instantly converted it into thermal energy, which initiated the hydrothermal reaction that involved with zero-valent iron. X-ray diffraction (XRD) analysis found Fe₃O₄/NaFeO₂ and confirmed the occurrence of microwave-induced hydrothermal reaction. The developed microwave-hydrothermal reaction was employed for the dechlorination of PCBs. Hexadecane containing 100 mg L⁻¹ of Aroclor1254 was used as simulative transformer oil, and the dechlorination of PCBs was evaluated by GC/ECD, GC/MS and ion chromatography. For PCBs in 10 mL simulative transformer oil, almost complete dechlorination was achieved by 750 W microwave irradiation for 10 min, with 0.3 g iron powder, 0.3 g NaOH and 0.6 mL H₂O added. The effects of important factors including microwave power and the amounts of reactants added, on the dechlorination degree were investigated, moreover, the dechlorination mechanism was suggested. Microwave irradiation combined with the common and cheap materials, iron powder, NaOH and H₂O, might provide a fast and cost-effective method for the treatment of PCBs-containing wastes.     

Adsorption of As(III) on chitosan-Fe-crosslinked complex (Ch-Fe)

It was reported the adsorption of As(III) on the surface of the chitosan-Fe-crosslinked complex. Theoretical correlation of the experimental equilibrium adsorption data for As(III)/Ch-Fe system is best explained by the non-linearized form Langmuir-Freundlich isotherm model. At optimum conditions, pH 9.0, the maximum adsorption capacity, calculated using the Langmuir-Freundlich isotherm model was 13.4 mg g⁻¹. The adsorption kinetics of As(III) onto Ch-Fe are described by the pseudo-first-order kinetic equation. The results of the Mössbauer spectroscopy showed that there is no redox process on the surface of the adsorbent.