SBR法短程深度脱氮过程分析与控制模式的确立

为了实现稳定的SBR法短程深度脱氮技术,考察了实际生活污水处理过程中pH值的变化规律及其影响因素.通过对生物脱氮过程机制和碳酸平衡过程的分析可知,pH值在氨氧化结束和反硝化结束时都会出现明显的变化点,对于采用SBR工艺处理有机物浓度较低、碱度适中的生活污水或城市污水的过程来说,采用pH值作为控制参数一方面可以保证出水水质达到TN＜1 mg/L的深度脱氮效果;另一方面防止了过度曝气引起短程硝化率降低,对于短程深度脱氮的稳定起到了重要作用.在理论分析和试验研究的基础上建立了SBR法短程深度脱氮过程的实时控制策略,在控制策略中设置了18个可调节的变量,以适应不同的水质并保持控制策略的准确性.该控制策略的建立为开发短程深度脱氮的控制软件和控制系统奠定了基础.     

两级SBR工艺去除磷、氮及有机物效能分析

以模拟生活污水为处理对象,在常温条件下,采用对比试验与机制分析方法,研究了两级SBR工艺分级除磷、去除有机物及脱氮的特性,分析了工艺的效能优势.结果表明,通过控制泥龄(除磷级5~7 d,脱氮级约50 d),可以将异养的PAOs与硝化菌分别控制在2个反应器中优势生长,在出水水质更优的情况下,系统的处理效率可比单级SBR提高1倍以上;两级SBR系统可以有效地缓解有机负荷对硝化过程的冲击影响,在进水COD浓度较高的情况下,能够保持其脱氮级(SBS2)具有稳定的硝化速率,且系统的最终出水可以容易并稳定地达到TP≤0.5 mg.L-1的国家标准;另外,两级SBR的脱氮级(SBS2)除具有优势的硝化菌种外,还能培养出适合降解难降解有机物的异养菌,使其好氧硝化结束时COD浓度较单级SBR系统更低.     

SBR中除磷颗粒污泥的培养和A/O及A/A/O颗粒污泥工艺除磷特性研究

以絮状活性污泥为接种污泥,乙酸钠为碳源,在SBR反应器内采用水力筛选的方法进行生物除磷颗粒污泥培养,然后诱导为反硝化聚磷颗粒污泥,探讨2种颗粒污泥除磷特性.结果表明,在厌氧/好氧(A/O)交替运行条件下,82d后培养出生物除磷颗粒污泥,污泥颜色呈淡黄色,粒径为0.5~1.5 mm,沉速为20~30 m/h,含水率为94%,密度为1.043 9,SVI在50 mL/g以下;437d时污泥最大比释磷速率(SRPR)为67.7 mg/(g.h),最大比吸磷速率(SUPR)为43.2 mg/(g.h),污泥中总磷的含量(TP/SS)为6.5%;448 d时改变运行条件为厌氧/缺氧/好氧(A/A/O)进行反硝化聚磷试验,653 d时反硝化聚磷颗粒污泥最大SRPR为30mg/(g.h),最大缺氧SUPR为27.9 mg/(g.h),TP/SS为6.3%.生物除磷颗粒污泥和反硝化聚磷颗粒污泥具有较强的除磷能力.     

An experimental study on the influence of zeolite on changes of pH and alkalinity in anaerobic treatment of compost leachate

With the increase of urbanization, municipal solid waste has also increased. Therefore, the need for solid waste management is also increasing compared with earlier decades. Composting is a good option for the recycling of solid waste; however, it produces leachate, which requires proper treatment systems to prevent environmental degradation. Due to high chemical oxygen demand (COD) concentrations in compost leachate, anaerobic treatment is the best option for handling the effluent, and an anaerobic baffled reactor (ABR) is one such anaerobic reactor that can be used for its treatment. Because of high ammonia and heavy metal concentrations, as well as the possibility of sludge washout in ABRs, it is important to use proper media, such as zeolite, which can reduce inhibition effects and sludge washout from the reactor. Anaerobic treatment, especially during the methanogenesis phase, is sensitive, and pH and alkalinity are parameters that influence the treatment. Therefore, adjusting these parameters within a normal range is very important to the proper functioning of anaerobic systems. In this study, a pilot‐scale ABR was used, and the last 4 of the 8 ABR compartments were filled with zeolite. The bioreactor was operated at hydraulic retention times (HRT) of 3, 4, and 5 days, with zeolite filling ratios of 10%, 20%, and 30%, and influent COD concentrations of 10,000, 20,000, and 30,000 milligrams per liter (mg/L). In this study, pH value was 6.43 ± 0.1, 6.96 ± 0.3, and 6.96 ± 0.25 at filling ratios of 10%, 20%, and 30%, respectively. According to the results, in all filling ratios, no significant changes were observed in the pH value when the organic loading rate increased and its amount was within a constant range. Influent alkalinity was equal to 2015 ± 510, 2884 ± 505, and 4154 ± 233 milligrams of calcium carbonate per liter (mg CaCO₃/L) at influent COD concentrations of 10,000, 20,000, and 30,000 mg/L, respectively, and in effluent, they were 2536 ± 336, 3379 ± 639, and 4377 ± 325 mg CaCO₃/L, respectively. The amount of alkalinity in the effluent increased compared with the alkalinity in the influent. The results show that the amount of alkalinity in the influent and effluent was similar, and the alkalinity enhancement was lower when the filling ratio was increased from 10% to 20%, and 20% to 30%. Comparisons of the results from zeolite with and without biofilm showed that, in cases of zeolite with biofilm, the amounts of silica and oxygen decreased and the amount of carbon increased, and it showed the formation of biofilm on the surface of zeolite. In addition, the absence of sodium in the zeolite with the biofilm indicated that sodium was exchanged with ammonium ions. According to the results, zeolite can be used in anaerobic reactors as a medium, and it also reduces fluctuations in pH and alkalinity at different organic loading rates, providing a normal range for anaerobic treatment.     

TMBR+NF/RO组合工艺处理垃圾渗滤液的工程应用

采用TMBR+NF/RO组合工艺对湖北省宜昌市某垃圾卫生填埋场渗滤液进行处理,介绍了组合工艺的流程、特点、设备规格、技术参数。TMBR系统对可生化降解COD处理后,COD平均质量浓度为822 mg/L,平均去除率为95.8%,对NH_3-N平均去除率为94.9%;经过NF/RO出水的COD平均值为45 mg/L,NH_3-N均小于25mg/L,达到《生活垃圾填埋场污染控制标准》(GB 16889—2008)的排放标准。组合工艺处理成本为29.5元/m3。     

外置浸没式超滤膜处理垃圾焚烧发电厂渗滤液

结合外置浸没式超滤膜处理垃圾渗滤液的中试试验,对垃圾焚烧厂渗滤液SBR出水进行处理,主要研究结果如下:外置浸没式超滤膜(膜孔径0.1μm)对COD_(Cr)去除率为36.86%,出水SDI为1.87~3.69,可以作为纳滤预处理工艺使用,选取10 L/(m~2·h)的运行通量较为合理。     

驯化活性污泥SBR工艺处理乳制品废水研究

乳制品废水直接采用生物法处理在现有研究中较少,为验证处理效果,将4阶段驯化后的活性污泥投加到SBR中,进行了低浓度乳制品废水的直接生物降解试验,主要考察了对COD、NH4-N的去除效果,结果显示:活性污泥驯化期间,COD、NH4-N平均去除率分别为93%、90%;驯化后的活性污泥处理效果稳定,当进水COD为1654 mg/L、NH4-N为115 mg/L时,出水COD、NH4-N分别为66 mg/L、2 mg/L,达到《污水综合排放标准》(GB 8978-1996)一级排放标准,证明了用驯化活性污泥直接处理低浓度乳制品废水是可行的.     

微波协同氧化预处理垃圾渗滤液NF膜滤浓缩液研究

针对城市生活垃圾填埋场垃圾渗滤液NF膜处理后产生的浓缩液处理难问题,采用微波协同氧化技术对其进行预处理,探讨了pH值、预反应时间、药剂用量、微波反应时间等因素对浓缩液CODcr及色度去除率的影响.结果表明:当pH=4,预反应时间60 min,药剂用量1g/l、微波反应时间3 min时,CODcr、色度的去除率分别为71.2%,80%.预处理后的出水CODcr及色度指标达到垃圾渗滤液现有生化处理系统的进水要求.     

陈腐生活垃圾处理处置工程设计实例

介绍了河北省秦皇岛市某生活垃圾填埋场陈腐生活垃圾处置工程设计实例。工程建设规模为500 t/d,采用分选+建筑垃圾破碎制砖+塑料清洗制颗粒+可燃垃圾气化制备+可燃气体发电的循环经济工艺。该工程的实施可解决非正规垃圾填埋场占地及由陈腐垃圾带来的一系列环境问题,使占用的土地资源得到释放,同时使垃圾各组分得到综合利用,为非正规垃圾填埋场的处理处置和垃圾的减量化、无害化、资源化提供参考和借鉴。     

基于MCDA模型的危险废物填埋场地下水污染风险分级

基于对风险全过程控制的思想,利用层次分析法,构建了综合考虑危险废物填埋场自身属性、污染场地水文地质条件以及污染受体等因素的危险废物填埋场地下水污染风险分级指标体系,该体系共包括14项指标;并采用MCDA(multi-criteria decision analysis,多准则决策分析)模型,对我国37个危险废物填埋场(不包括港澳台数据,下同)地下水污染风险进行了分级研究. 结果表明:14项风险分级指标之间具有很好的独立性,指标体系能够较为完整、准确地反映危险废物填埋场对地下水的污染风险程度;37个危险废物填埋场地下水污染风险可分为高、中、低3个级别,其中81%处于中、低级风险级别;地下水中特征污染物ρ(Cr)监测值与风险分级分值的距平指数为0.802 9,验证了风险分级结果的可靠性;同时采用MDCA模型对风险分级指标权重的敏感性进行分析,验证了风险分级过程中指标权重赋值的准确性,并降低了指标权重赋值过程中的不确定性,进一步提高了分级结果的可靠性.风险分级结果在一定程度上可为危险废物填埋场地下水污染风险管理提供依据.