XZKP型高效空塔喷淋烟气脱硫装置技术特点

介绍了XZKP型高效空塔喷淋烟气脱硫装置的技术原理、技术特点、中试及工业化试验的情况。该技术通过改进工艺和结构,在提高脱硫效率和脱硫剂循环利用率两项技术上成效显著,用户可在不增加装置投资的前提下,获得更高的效率和更低的运行成本。     

高气速间歇式生物过滤去除高负荷H2S

采用生物过滤法,以鸡粪堆肥和PE混合物为填料,在高气速条件下间歇式处理高负荷H2S废气。空床停留时间为20、15、10、6.7和5 s时,入口浓度3 000 mg/m3下的平均去除率分别为100%、100%、96.5%、89.2%和90.5%。高气速EBRT为5 s时,高入口负荷2 147 g/(m3.h)时的去除负荷为2 023 g/(m3.h),去除率达94%。采用Michaelis-Ment-en模型进行生物降解宏观动力学研究,其中Ks为550 mg/m3,Vm为6.8×104g/(m3.d)。结果表明,在实验温度17～24℃,湿度30%～50%下,生物过滤法间歇式处理高气速高负荷H2S的去除性能好。     

曝气浸没固定生物膜反应器处理化粪池出水

研究了以丝瓜络作为生物膜载体的曝气浸没固定生物膜反应器在处理化粪池出水时的可行性以及运行性能。结果表明,丝瓜络生物膜反应器可以在2周内成功启动;水力停留时间(HRT)对COD和氨氮的去除效果有显著影响,在水力停留时间为4 h的条件下,系统对COD和氨氮的去除率分别达到了78.5%和96.4%。另外,系统有较强抗有机污染物冲击负荷的能力,当COD和氨氮的进水浓度分别为59.3 mg/L和15.9 mg/L时,系统对有机污染物的去除效果较佳,去除率分别达到了80.0%和98.9%。     

诱导结晶工艺中诱品载体的选择与改性

以含铜废水为处理对象,重点考察了诱晶载体的表面性质及表面负荷对诱导结晶过程的影响。结果表明,在工艺启动初期,白云石以及碱式碳酸铜为诱晶载体时,铜的去除率在90％以上,石英砂对铜的去除率较低,但石英砂经表面改性后对铜的去除效率亦可达90％以上。在运行稳定后,几类诱导载体对铜的去除率皆能稳定在95％,说明诱晶载体的表面性质对诱导结晶工艺的影响主要在于反应启动初期,选择与目标结晶产物结构、成分相同或相似的诱晶载体有利于诱导结晶过程的进行。此外,研究结果还表明,诱晶载体表面负荷对结晶过程影响较大,诱导结晶除铜工艺中载体表面负荷不宜高于0．054gCu／（m2·d）。     

生物填料地下渗滤系统对生活污水的脱氮

将草甸棕壤、炉渣和活性污泥等基质按体积比13∶6∶1配制生物填料,研究了生物填料地下渗滤系统（subsurface wastewater infiltration system,SWIS）在不同的水力负荷和污染负荷条件下对校园生活污水的脱氮效果。场地实验结果表明,当BOD5负荷为12.0 g BOD5/（m2·d）,表面水力负荷为0.04-0.10 m3/（m2·d）时,SWIS对NH＋4-N和TN的平均去除率分别为92.4%和82.0%。当水力负荷为0.08 m3/（m2·d）,BOD5负荷9.3-16.8 g BOD5/（m2·d）时,SWIS对NH＋4-N和TN的平均去除率为92.7%和81.2%。SWIS中氧化还原电位（oxygen reduction potential,ORP）随进水水力负荷和BOD5负荷的增加而降低,脱氮效率下降。综合出水水质和处理效率,适宜的水力负荷和污染负荷分别为0.065 m3/（m2·d）和12.0 g BOD5/（m2·d）。在此条件下,SWIS的启动周期为25-30 d。出水水质均优于《城市污水再生利用-景观环境用水水质》（GB/T18921-2002）标准,且处理效果稳定,抗负荷冲击能力强。     

The Contribution of Marsh Zones to Water Quality in Dutch Shallow Lakes: A Modeling Study

Many lakes have experienced a transition from a clear into a turbid state without macrophyte growth due to eutrophication. There are several measures by which nitrogen (N) and phosphorus (P) concentrations in the surface water can be reduced. We used the shallow lake model PCLake to evaluate the effects of three measures (reducing external nutrient loading, increasing relative marsh area, and increasing exchange rate between open water and marsh) on water quality improvement. Furthermore, the contribution of different retention processes was calculated. Settling and burial contributed more to nutrient retention than denitrification. The model runs for a typical shallow lake in The Netherlands showed that after increasing relative marsh area to 50%, total phosphorous (TP) concentration in the surface water was lower than the Maximum Admissible Risk (MAR, a Dutch government water quality standard) level, in contrast to total nitrogen (TN) concentration. The MAR levels could also be achieved by reducing N and P load. However, reduction of nutrient concentrations to MAR levels did not result in a clear lake state with submerged vegetation. Only a combination of a more drastic reduction of the present nutrient loading, in combination with a relatively large marsh cover (approximately 50%) would lead to such a clear state. We therefore concluded that littoral marsh areas can make a small but significant contribution to lake recovery.     

爆炸荷载作用下钢筋混凝土防爆墙动力响应研究

为了研究钢筋混凝土防爆墙的抗爆能力,采用有限元分析方法对不同纵向配筋率、不同高跨比、不同厚度的墙体在爆炸动态荷载作用下的动力响应进行研究,对各种不同设置的钢筋混凝土防爆墙的抗爆性能进行评估。结果表明:减小高跨比对提高钢筋混凝土防爆墙的抗爆能力最为重要,提高纵向配筋率,增加厚度都能增加防爆墙的抗爆能力。     

接地保护与接零保护安全性比较

我国现存标准或规范仍在推荐使用接零保护(TN系统),这是一种人为增大故障电流、以过流保护装置(过流保护断路器或熔断器)对漏电进行防护的方法.在漏电保护器RCD广泛应用的今天,完成漏电防护的首要装置是RCD,而不再是过流保护装置.通过基于RCD的漏电防护水平评价和对本质安全性的综合比较, 得出的结论是接地保护(TT系统)比接零保护(TN系统)更安全.     

密闭爆炸容器实验研究及数值模拟

实验研究了三种结构的爆炸容器在爆炸载荷下的响应情况；并通过二维多流体欧拉程序对二维爆炸场进行了数值模拟．在这个基础上用ＮＩＫＥ－２Ｄ对壳体的动态响应进行数值模拟。     

UNCERTAINTY ANALYSIS OF BMP EFFECTWENESS FOR CONTROLLING NITROGEN FROM URBAN NONPOINT SOURCES1

ABSTRACT: The effectiveness of urban Best Management Practices (BMPs) in achieving the No-Net-Increase Policy (NNTP), a policy designed to limit nonpoint nitrogen loading to Long Island Sound (US), is analyzed. A unit loading model is used to simulate annual nitrogen exported from the Norwalk River watershed (Connecticut) under current and future conditions. A probabilistic uncertainty analysis is used to incorporate uncertainty in nitrogen export coefficients and BMP nitrogen removal effectiveness. The inclusion of uncertainty in BMP effectiveness and nitrogen export coefficients implies that additional BMPs, or BMPs with a greater effectiveness in nitrogen removal, will be required to achieve the NNIP. Even though including uncertainty leads to an increase in BMP implementation rates or BMP effectiveness, this type of analysis provides the decision maker with a more realistic assessment of the likelihood that implementing BMPs as a management strategy will be successful. Monte Carlo simulation results indicate that applying BMPs to new urban developments alone will not be sufficient to achieve the NNIP since BMPs are not 100 percent effective in removing the increase in nitrogen caused by urbanization. BMPs must also be applied to selected existing urban areas. BMPs with a nitrogen removal effectiveness of 40–60 percent, probably the highest level of removal that can be expected over an entire watershed, must be applied to at least 75 percent of the existing urban area to achieve the NNIP This high rate of application is not likely to be achieved in urbanized watersheds in the LIS watershed; therefore, additional point source control will be necessary to achieve the NNIP