Influences of Magnesium <Emphasis Type="Italic">tri-</Emphasis>Silicate on the Physical,Mechanical, and Degradable Properties of Ultraviolet (UV) Radiation Cured Plain Board Surface

A series of formulations were prepared with different percentages of oligomer, epoxy diacrylate (EA-1020 ), monomer, 1,6 Hexane diol diacrylate,(HDDA) and different percentages of filler (Magnesium tri-silicate, Mg₂Si₃O₈). Irgacure 369 [2-Benzyl-2-dimethyl-amine-1 (4-morpholinophenyl) butanone-1] was used in the formulations as photoinitiator. Ultraviolet (UV) cured thin polymer films were prepared from these formulating solutions on clean glass plates. Pendulum hardness (PH), gel content and macro scratch hardness (MSH) of the UV cured films were studied. One percent Mg₂Si₃O₈ containing formulation showed the premium properties. The substrates (plain board) were coated by these formulating solutions and cured under the same UV lamp at different intensities of radiation. Various properties of the coated surface such as PH, gloss, adhesion, abrasion and MSH were investigated. The base coat containing 1% Mg₂Si₃O₈ and top coat containing 48% HDDA produced the best performance among all the formulations inspected. The degradable properties in different weathering conditions on PH, gloss, adhesion, abrasion and MSH were measured. The surface cured with the optimized formulation (E) again yielded the minimum loss of the properties.     

THE USE OF MAGNESIUM CARBONATE IN CHLOROPHYLL DETERMINATIONS1

Abstract: Chlorophyll analyses of both laboratory cultures and natural aquatic samples were unaffected by the use of magnesium carbonate. Equal volumes of the samples (at various pH values) were pipetted onto 0.45 micrometer filters with and without magnesium carbonate. Chlorophyll concentrations were determined for each filtered sample and those frozen for specified times. In all samples tested there was no difference either in the retention of algae or in the stability of chlorophyll over the time period and pH range tested.     

用碳化法从制碱废渣一次盐泥中制取轻质氧化镁的研究

本研究是用制碱废渣一次盐泥作原料，采用二氧化碳碳化法制取轻质氧化镁。同时分析了提取轻质氧化镁后的残渣用于制造水泥或其它胶凝材料的原料的可行性。     

pH-dependent leaching behaviour and other performance properties of cement-treated mixed contaminated soil

Portland cement has been widely used for stabilisation/solidification (S/S) treatment of contaminated soils. However, there is a dearth of literature on pH-dependent leaching of contaminants from cement-treated soils. This study investigates the leachability of Cu, Pb, Ni, Zn and total petroleum hydrocarbons (TPH) from a mixed contaminated soil. A sandy soil was spiked with 3000 mg/kg each of Cd, Cu, Pb, Ni and Zn, and 10,000 mg/kg of diesel, and treated with ordinary Portland cement (CEM I). Four different binder dosages, 5%, 10%, 15% and 20% (m/m) and different water contents ranging from 13%-19% dry weight were used in order to find a safe operating envelope for the treatment process. The pH-dependent leaching behaviour of the treated soil was monitored over an 84-day period using a 3-point acid neutralisation capacity (ANC) test. The monolithic leaching test was also conducted. Geotechnical properties such as unconfined compressive strength (UCS), hydraulic conductivity and porosity were assessed over time. The treated soils recorded lower leachate concentrations of Ni and Zn compared to the untreated soil at the same pH depending on binder dosage. The binder had problems with Pb stabilisation and TPH leachability was independent of pH and binder dosage. The hydraulic conductivity of the mixes was generally of the order, 10^-8 m/sec, while the porosity ranged from 26%-44%. The results of selected performance properties are compared with regulatory limits and the range of operating variables that lead to acceptable performance described.     

废弃混凝土对C_3S形成动力学的影响

废弃混凝土中石灰石的含量比较稳定,适合取代天然石灰石作为钙质原料配制水泥生料,并含有少量的SiO2,可以起部分硅质原料的作用。硬化的水泥浆体在高温下脱水形成氧化钙、氧化铝和氧化铁等氧化物,都是制造水泥所必须的氧化物。实验室利用20%和40%的废弃混凝土代替部分石灰石制备水泥熟料。研究了废弃混凝土对硅酸盐水泥熟料形成动力学的影响。用快速滴定法测定了不同熟料中f-CaO含量,根据文章提出CaO反应生成C3S的转化率,并用Amhenius公式计算了熟料中C3S形成反应的表观活化能。研究表明:废弃混凝土能改善生料的易烧性,并能降低熟料的烧成温度。     

水泥炉窑SNCR及SCR烟气脱硝技术比较

通过分析水泥炉窑氮氧化物(NOx)生成机理、脱除技术以及国内外水泥炉窑脱硝现状并结合我国具体情况,探讨适合我国的水泥炉窑切实可行脱硝技术,为"十二五"期间我国水泥炉窑开展烟气脱硝整治工作提供技术性方向。     

工业废渣在新型干法水泥生产中应用

依据废渣特性的理论分析,通过对废渣成分以及采用废渣配料前后生料、熟料的成分分析及性能测试,调整生料配比和改变水泥窑操作工艺,通过生产实践数据分析,说明了利用钢渣和粉煤灰作为铁质和铝质校正材料生产普通硅酸盐水泥熟料,不仅可以提高水泥熟料产量和质量,而且可以有效地降低熟料生产成本和产品综合能耗。促进了企业节能减排和资源综合利用的可持续发展。     

超疏水表面在提高镁合金耐蚀性能上的研究进展

总结和讨论了超疏水表面提高镁合金耐蚀性能的制备方法。采用电化学测试方法研究了超疏水表面的抗腐蚀行为。总结了在镁合金上制备抗腐蚀性超疏水表面的最新进展,提出了超疏水表面提高镁合金耐蚀性能的机理。镁合金上制备超疏水表面的方法较多,但是能进行大规模生产的较少,且制备的超疏水表面耐久性、机械稳定性较差。     

水泥-电力行业的产业共生网络构建及区域案例研究

水泥工业作为工业生态系统的汇,能够多样化地利用其他行业的副产物,这种典型的产业共生模式可以通过减少资源和能源的消耗带来显著的CO₂减排效果.由于产业共生在水泥行业具有一定的普遍性及巨大的CO₂减排潜力,所以对水泥工业产业共生现状的了解与分析就显得尤为重要;而通过对产业共生现状的全面了解,才能对现有水泥行业产业共生的程度进行分析,并以此为参照,对未来不同政策与情景下的CO₂减排潜力进行量化与评估.为实现对产业共生实际情况的模拟,以水泥-电力行业的产业共生为例,采用最优化的方法,提出了一套基于一般统计数据来模拟产业共生实际情况的系统方法,将技术、经济与政策3类不同的决策变量影响纳入模型,以模拟出最接近真实情景的产业共生情况.为验证模型的有效性,对新乡市水泥-电力行业实际的产业共生情况进行分析.结果表明:新乡市水泥-电力行业间存在普遍的产业共生现象,实地调查中有77.8%（21家）的水泥制造企业利用粉煤灰作为水泥制造的原材料.将一般统计数据与实地调查数据对比发现,一般统计数据能较好地反映企业实际物质投入产出情况;利用一般统计数据,模型对新乡市产业共生网络结构模拟的准确率高达92.6%,显示该模型能较为有效地对产业共生的实际情况进行模拟.      

温度对镁合金牺牲阳极材料电化学行为的影响研究

目的研究温度对常用镁合金阳极材料MIC、AZ31、AZ63电化学行为的影响。方法根据GB/T 17848—1999,采用四天加速试验法,在25～70℃的人造海水介质中进行阳极电化学性能评价,并观察腐蚀后阳极的宏观腐蚀形貌。采用极化曲线测试技术,研究温度对加速试验前后阳极的极化行为影响。结果随着温度的升高,三种镁阳极的局部腐蚀明显加剧,溶解状态逐渐变得不均匀。随着温度的上升,三种镁阳极的实际电容量和电流效率呈小幅增加趋势,温度的影响不显著。极化曲线显示,镁阳极表现出活化溶解特征,温度升高明显促进了镁阳极的阴极过程,自腐蚀速率逐渐增加。结论在腐蚀初期,温度升高明显促进了镁合金阳极的腐蚀过程,但对镁阳极的电化学性能影响不显著,这可能与后期腐蚀产物生成以及表面状态的变化有关。