危险品运输网络优化设计研究综述

为分析当今反恐新形势下的危险品运输网络优化设计问题的研究现状,系统总结国内外关于一般场景和恐怖袭击威胁2种情况下危险品运输网络优化设计研究的主要模型和方法,梳理两者现有的研究内容,并讨论其共性及恐怖袭击威胁情景下的研究的新特点。结果发现:目前关于解决危险品运输网络优化设计问题模型的鲁棒性研究较为缺乏,尤其是模型在更为复杂和不确定性更强的恐怖袭击情景中适用性不强;危险品运输的鲁棒优化模型即使在突发事件条件下,也可以使决策者能够作出相对满意的决策;鲁棒性危险品运输网络能够规避风险扰动,可用来防止在恐怖袭击中因危险品车辆爆炸等造成更大的危害。     

Deflagration to detonation transition in a vapour cloud explosion in open but congested space: Large scale test

The paper reviews large scale experiments with various fuels in air where successful deflagration to detonation transition (DDT) took place. This includes a recent experiment disclosed in the Buncefield R&D program, where DDT developed in the propane/air mixture. The DDT occurred in branches of deciduous trees in a premixed stagnant mixture. An internal R&D investigation programme was initiated to better understand the phenomena. A large scale experiment in an open space with ethane air mixture is presented in the paper. The premixed mixture was ignited at the edge of the congested three-dimensional rigs which consisted of vertical and horizontal pipes. After ignition, the flame accelerated in the congestion and transitioned to detonation at the end of congestion. Stable detonation propagated through the remaining open and uncongested space.The flame acceleration process leading to DDT is scale dependent. It also depends on many parameters leading to a large investigation array and, significant cost. However, such R&D efforts aimed toward a safer plant design, i.e. the prevention of occurrence of a major accident, are a small fraction of a real accident cost.     

Preparation of steel slag porous sound-absorbing material using coal powder as pore former

The aim of the study was to prepare a porous sound-absorbing material using steel slag and fly ash as the main raw material, with coal powder and sodium silicate used as a pore former and binder respectively. The influence of the experimental conditions such as the ratio of fly ash, sintering temperature, sintering time, and porosity regulation on the performance of the porous sound-absorbing material was investigated. The results showed that the specimens prepared by this method had high sound absorption performance and good mechanical properties, and the noise reduction coefficient and compressive strength could reach 0.50 and 6.5 MPa, respectively. The compressive strength increased when the dosage of fly ash and sintering temperature were raised. The noise reduction coefficient decreased with increasing ratio of fly ash and reducing pore former, and first increased and then decreased with the increase of sintering temperature and time. The optimum preparation conditions for the porous sound-absorbing material were a proportion of fly ash of 50% (wt.%), percentage of coal powder of 30% (wt.%), sintering temperature of 1130°C, and sintering time of 6.0 hr, which were determined by analyzing the properties of the sound-absorbing material.     

Impact of leakage location and downwind storage tank on the gas dispersion in a typical chemical tank storage area

Toxic gas leakage in a tank area can have catastrophic consequences. Storage tank leakage location (particularly for high leakage) and downwind storage tanks potentially influence gas diffusion in tank areas. In this study, we developed a numerical and experimental method to investigate the impact of a high leakage location and downwind storage tank on gas diffusion based on three (1.05H, 0.90H, and 0.77H, H was the tank height, 22m) leakage field experiments on the leeward side of storage tank, which have been not conducted before. The experiments revealed an unexpected phenomenon: the maximum ground concentration first decreased and then increased with increasing leakage height. The simulations illustrated that the differences in micrometeorological conditions caused the maximum ground concentration of gas emitted from the roof to be higher than that emitted from the tank wall near the storage tank height. The downwind storage tank 1) had little influence on the entire diffusion direction but altered the local diffusion pattern; 2) reduced the maximum ground concentration (∼18.7%) and the distance from the emission source (approximately a storage tank diameter); and 3) had strong influences on the concentration, velocity, turbulence, and pressure on the leeward side. The concentration negatively correlated with the velocity, pressure, and turbulence in the middle of the two storage tanks on wind centerline. Our results can improve understanding of gas dispersion in tank areas and provide references for mitigating loss and protecting lives during emergency response processes.     

关于焦化行业CO2排放核算方法的探讨

本文分析了适用于焦化行业通用CO₂排放核算方法,在此基础上结合我国焦化行业工艺和原料的特征,采用排放因子法和物料衡算法等两种方法对10家典型焦化企业CO₂排放进行核算。结果表明:物料衡算法能很好地反映不同类型焦化企业的排放特征;排放因子法对我国独立焦化企业存在碳排放量系统性高估的可能。为此,建议我国焦化企业可借鉴德国焦化企业的碳核算经验,采用碳平衡法对不同类型的焦化企业(单元)的碳排放量进行核算,并完善相关的统计和监测技术。     

多种复合材料固定化反应器的对比研究

选用活性炭、海砺壳2种材料作为固定化载体,对改良型UASB系统去除COD的性能进行研究,结果表明选择既高柱又循环且增加载体填充体积的系统,可有效去除高浓度有机废水的COD,但当填充载体过高时,循环系统难以实现,并存在憋气的可能。     

城市废物的回收处理与利用

当前世界各国均面临着“废弃物”所造成的环境污染问题。本文列举了一些国家“废弃物”的排放以及回收利用情况,并举例说明对变废为宝的技术路线和应该采取的措施。     

上海市经济-环境系统的物质输入分析

对区域或城市经济-环境系统的物质输入分析。可以判断可持续发展所处的状态。进而为区域或城市制定循环经济发展战略提供依据。利用物质流的理论和方法．依据欧盟指导原则，分析了1990—2003年间上海市经济-环境系统的物质总需求和资源生产率等主要指标。研究结果表明：①上海市巨大的物质总需求和直接物质消耗给上海市的生态环境带来了巨大的压力；②1996年上海市的资源生产率是全国的1．22倍．但2000年日本的资源生产率是上海市的36倍；③影响上海市的物质总需求或者环境质量的关键因素是技术和制度能力。在上述的分析基础上。提出在2020年之前上海市发展循环经济要注重于输入端的减物质化和加强循环绍济的技术支撑研究与开发以及制度能力建设。     

粉煤灰基质滤料生物过滤处理生活污水研究

将粉煤灰基质滤料用于曝气生物滤池,该滤料具有较高的比表面积和孔隙率,吸附性能良好,挂膜后生物相丰富。对于中等浓度的生活污水,当水力负荷和COD有机物负荷分别控制在1.53 m3/(m2.h)、3.68 kg/(m3.d)以下时,该曝气生物滤池COD和NH3-N去除率能稳定在85%以上,出水COD和NH3-N达到排放标准要求。该曝气生物滤池对进水水质水量的变动具有较强的抗冲击负荷能力。