重型柴油车实际道路排放与行驶工况的相关性研究

采用SEMTECH-D车载排放测试仪测量了东风柴油卡车在城市实际道路工况以及等速和加速工况下的油耗及污染物排放状况.测试结果显示,测试卡车实际道路综合百公里油耗为17.8 L,NOx、CO和HC排放因子分别为3.96、8.86和2.15g·km-1.其中主干道路况相对较差,油耗与排放因子较高,是所有测试道路平均水平的1.3～1.8倍左右.研究结果表明,重型车油耗及污染物排放与各行驶工况下的速度、加速度均密切相关,车辆在高速加速行驶状态下易产生高排放.车辆在30～50 km·h-1速度区间内等速行驶时,油耗与排放因子最为经济且环境友好.车辆在加速行驶时,油耗与NOx、CO排放因子可达到城市实际道路平均水平的2.0、2.2、1.4倍,急加速时达到2.8、2.1、14倍.应用比功率概念可准确描述车辆在各运行工况下的排放水平,但在重型车上缺乏实验依据,有待进一步研究.     

Carbonyl emissions from heavy-duty diesel vehicle exhaust in China and the contribution to ozone formation potential

Fifteen heavy-duty diesel vehicles were tested on chassis dynamometer by using typical heavy duty driving cycle and fuel economy cycle. The air from the exhaust was sampled by 2,4- dinitrophenyhydrazine cartridge and 23 carbonyl compounds were analyzed by high performance liquid chromatography. The average emission factor of carbonyls was 97.2 mg/km, higher than that of light-duty diesel vehicles and gasoline-powered vehicles. Formaldehyde, acetaldehyde, acetone and propionaidehyde were the species with the highest emission factors. Main influencing factors for carbonyl emissions were vehicle type, average speed and regulated emission standard, and the impact of vehicle loading was not evident in this study. National emission of carbonyls from diesel vehicles exhaust was calculated for China, 2011, based on both vehicle miles traveled and fuel consumption. Carbonyl emission of diesel vehicle was estimated to be 45.8 Gg, and was comparable to gasolinepowered vehicles （58.4 Gg）. The emissions of formaldehyde, acetaldehyde and acetone were 12.6, 6.9, 3.8 Gg, respectively. The ozone formation potential of carbonyls from diesel vehicles exhaust was 537 mg O3/km, higher than 497 mg O3/km of none-methane hydrocarbons emitted from diesel vehicles.     

基于全生命周期法的矿用柴油重卡碳核算

矿用柴油重卡因工作任务量大和工作环境恶劣,导致其碳排放量巨大。从使用矿用柴油重卡的企业角度出发,采用全生命周期法,理清了矿用柴油重卡全生命周期各个阶段的碳排放量及影响碳排放的因素,建立了矿用柴油重卡碳核算模型。以内蒙古某煤矿4种柴油重卡为案例,对矿用柴油重卡全生命周期碳排放量进行了核算,分析了核算结果,并从车辆重量与经济性角度,分析比较了几种车辆的单位重量排放量和单位价格排放量。结果表明：矿用柴油重卡全生命周期碳排放量由车辆重量和燃料消耗量共同作用,其中燃料消耗量占绝大比重。综合考虑节能减排和经济性,重量为156 t和85 t的车辆是最佳选择,煤矿企业可适当提高该类车辆的占比。在保证工作量的情况下,将138 t和65 t车辆代替为156 t和85 t的车辆,全生命周期内可减少1.275×10⁵ t 的碳排放量,节省9 936.704 万元的花费。本研究结果可为重卡企业开展节能减排工作提供参考。     

可旋转径向式微粒捕集器消声特性影响因素灰色关联分析

为降低可旋转径向式微粒捕集器中的排气噪声,采用有限元法建立可旋转径向式微粒捕集器声学特性模型,分析得到了其消声特性和传递损失曲线,并采用灰色关联分析方法研究可旋转径向式微粒捕集器结构参数对消声特性的影响程度。结果表明,可旋转径向式微粒捕集器具有降噪能力,且对高频噪声消声效果明显好于低频噪声,平均消声量为20 dB左右;直径比和扩张管锥角是影响可旋转径向式微粒捕集器消声特性的2个主要因素,适当选用小的直径比和扩张管锥角,有利于提高可旋转径向式微粒捕集器的消声性能。     

重型柴油车车载排放实测与加载影响研究

采用车载排放测试仪,对2辆重型柴油卡车在空载和加载条件下进行实际道路车载排放测试.通过分析获得了油耗与排放速率的速度-加速度及其工况点的分布,发现高油耗与高排放工况点主要集中在高速加速区域,加载时油耗与排放高值随工况点分布更广;车辆在(30±2.5)km·h^-1等速及加速行驶时受加载影响最大,此时加载油耗与排放约是空载的1.6～3.2倍左右;由实测结果发现,卡车Ⅰ和卡车Ⅱ加载时油耗及CO、HC、NO_x排放因子分别是空载的1.6倍、3.5倍、1.1倍、1.5倍以及1.2倍、1.0倍、0.9倍和1.5倍,加载对油耗与NO_x排放影响最为明显,对HC影响最小,CO影响取决于车辆保养水平;卡车Ⅱ较卡车Ⅰ车型更大,发动机功率更高,相同荷载时受加载影响较小,说明重型车在发动机负荷可承受的范围内合理装载,有助于避免油耗与排放恶化,提高燃油经济性和排放水平.     

Mutagenicity of diesel engine exhaust in the Ames / Salmonella assay using a direct exposure method

The aim of this study was to investigate the potential mutagenic activity of diesel engine exhaust in the Ames/Salmonella assay using a direct aerosol exposure system. So, TA 98 and TA 100 strains, with or without added S9 mix, were exposed to diesel emissions after varying degrees of filtration. Variants of these two strains, deficient in nitroreductase (TA 98NR and TA 100NR) or over-expressing O-Acetyl Transferase (YG 1024 and YG 1029), were also exposed to total (unfiltered) diesel exhaust to highlight the putative mutagenicity of any nitro-PAHs present in these emissions. Mutagenic activity of the diesel exhaust was demonstrated on Salmonella typhimurium, strains TA 100 and variants TA 100 NR and YG1029. The use of a particle filter did not modify the genotoxicity of the diesel emissions, indicating a major contribution of the gas phase to the mutagenicity of these diesel emissions. The prominent role of the particulate-associated nitro-polycyclic aromatic hydrocarbons (nitro-PAHs) claimed by some authors working on diesel exhaust organic extracts was not confirmed by our results with native diesel exhaust exposure. Our results show that the gas phase is potentially more mutagenic than the particles alone.     

公交柴油车道路排放特征的实测研究初探

利用GPS和SEMTECH-D车载排放测试仪测量了上海市公交车行驶工况和公交柴油车在市区道路上的排放状况.该研究共获得193400组公交车行驶工况数据,累计测量里程820 km,排放数据75420个.测量结果显示,上海市公交车平均车行速度14 km·h-1,最高车速为60 km·h-1;市区公交车平均车行速度14 km·h-1,最高车速小于60 km·h-1,市区公交车的怠速时间比在25%以上.被测公交柴油车的CO、THC和NOx平均里程排放因子为(3.41±0.86)、(1.95±0.47)和(4.56±0.99) g·km-1,与陈长虹等人2005年提供的卡车3和卡车5的排放状况相近.测量结果还显示,被测车辆进出站时单位里程排放量是正常行驶条件下的10倍.此外,在交通高峰期或拥堵期,车行速度降低至0～5 km·h-1时,被测公交柴油车的CO、THC和NOx平均里程排放因子升高至17.49、6.68和15.85 g·km-1,是平均车速时候的5.13倍、3.4倍和3.48倍,车辆排放污染将明显加剧.测量结果说明,加强城市交通管理,减少车辆拥堵,不仅可以提高公交车运行效率,而且也是降低公交车污染的有效措施.     

Feasibility analysis of renewable hybrid energy supply options for Masirah Island

In this paper, the assessment and modelling of alternative renewable energy systems for Masirah Island is considered. The hybrid system that is simulated comprises various combinations of wind turbines and/or photovoltaic (PV) supplemented with diesel generators and short-term battery storage. It was found from the analysis that the PV–wind–diesel hybrid system, with battery unit, has the lowest cost values as compared to solar-only or wind–diesel hybrid systems. Furthermore, the study illustrates that for a given hybrid system the presence of battery storage will reduce diesel consumption. The decrease in carbon emission, the percentage of fuel savings, the cost of energy production and the effect of wind and PV penetration are also addressed in this paper. The PV–wind–diesel hybrid option is techno-economically viable for the electrification of the Masirah Island.     

Effects of EGR,swirl augmentation techniques on combustion of biodiesel/ethanol and their blends in a diesel engine

The diminishing resources and continuously increasing cost of petroleum in association with their alarming pollution levels from diesel engines have caused an interest in finding alternative fuels to diesel which are renewable and sustainable. Emission control and engine efficiency are two most important parameters in current engine design. The impending introduction of emission standards such as Euro IV and Euro V is forcing the research towards developing new technologies for combating engine emissions. The classification of Euro IV and V norms is applicable to heavy-duty engines in Europe, where as Euro 5 is applicable to light-duty engines. This paper presents the effects of exhaust gas recirculation (EGR), swirl augmentation techniques and ethanol addition on the combustion of Honge oil methyl ester (HOME) and its blends with ethanol in a diesel engine. From the experimental work conducted, it is found that the combustion of HOME plus up to 15% ethanol blend in a diesel engine operated with optimised parameters of injection timing 23° Before Top Dead Centre and compression ratio 17.5 results in acceptable combustion emissions and improved brake thermal efficiency (BTE). The addition of ethanol increased BTE with reduced hydrocarbons (HCs), CO and smoke emissions. However, NO _x emissions increased dramatically. Use of appropriate EGR reduces NO _x to acceptable levels. The implementation of swirl augmentation techniques further resulted in increased BTE and considerable reduction in tail pipe emissions such as smoke, HCs, CO and NO _x . The effect of swirl by providing grooves on the piston was taken into consideration to find the overall biodiesel engine performance, which gives scope for further studies.     

Intelligent power supply management of an autonomous hybrid energy generator

ABSTRACT

This work deals with the optimization of an hybrid energy system used to supply an isolated site. The proposed system combines a wind turbine, a photovoltaic panel, a diesel generator and a battery bank to electrify atypical home. An energy cost-effectiveness approach is adopted in accordance with meteorological data, time profile of energy consumption, and the cost of different alternative systems. A variety of performances is obtained through simulations within the Homer Pro environment. The selection of an optimal combination is based on the maximum integration of renewable energy in the suggested system with a minimum of gas emission. According to the obtained results, the overall cost of the selected installation is about 72,900 €, with 0.415€ the unit cost of a kWh electric energy provided with a contribution of renewable energy of around 86%. Simulations show a technical and financial benefits of the different configurations obtained to supply the target site. To control the proposed hybrid energy system, a supervision algorithm is developed and implemented on TMS320F28027 DSP platform. The proposed energy system aims to take advantages of renewable energy sources and shift to conventional sources only when necessary in order to ensure source autonomy and service continuity.