不同生长期的Pseudomonas putida 5-x细胞对工业废水中Cu~(2+)的吸附

研究了不同生长阶段的Cu2 + 吸附细菌Pseudomonasputida 5 x对Cu2 + 的吸附容量 .结果表明在低硫培养基中 ,当P putida 5 x细胞生长刚进入对数生长期时 ,单位细胞对Cu2 + 的吸附溶量最低 .而当生长进入稳定生长期的后期或死亡期的早期时 ,单位细胞对Cu2 + 的吸附量最大 .实验结果还表明 ,高浓度的Cu2 + 对对数期细胞的吸附能力有一定的抑制 ,而对死亡期的细胞影响较小 .早期研究已证明细胞对重金属离子的吸附和细胞表面某些对重金属离子具有亲和性的功能基团 (如某些膜蛋白及羰基化合物 )有关 .利用透视电子显微镜观察了不同生长阶段的细胞表面结构及对铜离子的吸附效果 ,发现生长后期细胞表面吸附有较多的Cu2 + ,这表明生长后期的细胞表面可能含有较多的这类功能基团     

重庆近11年大气混合层厚度研究

根据新闻颁国家标准ＧＢ／Ｔ１３２０１－９１的规定，计算了重庆地区近１１年大气混合厚度，分析结果表明，重庆地区大气混合层厚度有明显日变化和季节变化，大气稳定度是混合层厚度的主要决定因子。     

Determination of polychlorinated biphenyl congeners in environmental samples

Ｄｅｔｅｒｍｉｎａｔｉｏｎｏｆｐｏｌｙｃｈｌｏｒｉｎａｔｅｄｂｉｐｈｅｎｙｌｃｏｎｇｅｎｅｒｓｉｎｅｎｖｉｒｏｎｍｅｎｔａｌｓａｍｐｌｅｓ￥ＣｈｕＳｈａｏｇａｎｇ；ＹａｎｇＣｈｕｎ；ＸｕＸｉａｏｂａｉ（ＲｅｓｅａｒｃｈＣｅｎｔｅｒｆｏｒＥｃｏ－Ｅｎｖ...     

气相色谱法测定二硫化碳和甲硫醚

利用气相色谱(配火焰光度检测器,采用3mxφ2mm玻璃填充柱分离)对CS2和甲硫醚(DMS)两种含硫化合物进行了分离检测。该方法具有较高的灵敏度和良好的线性关系。结果表明:该分析对含硫气体的最小检测浓度在mg/m3级,在柱温为70℃,检测器温度为180℃,气化室温度为150℃,氮气流速为50mL/min时,CS2的回收率为98.66%,变异系数为2.12%;甲硫醚的回收率为98.66%,变异系数为1.56%。     

脉冲电晕等离子体脱硫脱氮与除尘技术

脉冲电晕放电是产生等离子体的方法之一，目前已达到工业性试验阶段，该文对脉冲电晕等离子脱硫脱氮与除尘技术的形成过程进行了回顾，对其理论作了分析，并简介了工艺流程，还指出了目前存在的主要问题和需研究的关键技术。     

Developing Canada's National Forest Carbon Monitoring, Accounting and Reporting System to Meet the Reporting Requirements of the Kyoto Protocol

The rate of carbon accumulation in the atmosphere can be reduced by decreasing emissions from the burning of fossil fuels and by increasing the net uptake (or reducing the net loss) of carbon in terrestrial (and aquatic) ecosystems. The Kyoto Protocol addresses both the release and uptake of carbon. Canada is developing a National Forest Carbon Monitoring, Accounting and Reporting System in support of its international obligations to report greenhouse gas sources and sinks. This system employs forest-inventory data, growth and yield information, and statistics on natural disturbances, management actions and land-use change to estimate forest carbon stocks, changes in carbon stocks, and emissions of non-CO₂ greenhouse gases. A key component of the system is the Carbon Budget Model of the Canadian Forest Sector (CBM-CFS). The model is undergoing extensive revisions to enable analyses at four spatial scales (national, provincial, forest management unit and stand) and in annual time steps. The model and the supporting databases can be used to assess carbon-stock changes between 1990 and the present, and to predict future carbon-stock changes based on scenarios of future disturbance rates and management actions.     

Carbon Dioxide Balance of Wood Substitution: Comparing Concrete- and Wood-Framed Buildings

In this study a method is suggested to compare the net carbon dioxide (CO₂) emission from the construction of concrete- and wood-framed buildings. The method is then applied to two buildings in Sweden and Finland constructed with wood frames, compared with functionally equivalent buildings constructed with concrete frames. Carbon accounting includes: emissions due to fossil fuel use in the production of building materials; the replacement of fossil fuels by biomass residues from logging, wood processing, construction and demolition; carbon stock changes in forests and buildings; and cement process reactions. The results show that wood-framed construction requires less energy, and emits less CO₂ to the atmosphere, than concrete-framed construction. The lifecycle emission difference between the wood- and concrete-framed buildings ranges from 30 to 130 kg C per m² of floor area. Hence, a net reduction of CO₂ emission can be obtained by increasing the proportion of wood-based building materials, relative to concrete materials. The benefits would be greatest if the biomass residues resulting from the production of the wood building materials were fully used in energy supply systems. The carbon mitigation efficiency, expressed in terms of biomass used per unit of reduced carbon emission, is considerably better if the wood is used to replace concrete building material than if the wood is used directly as biofuel.     

氨法烟气脱硫脱硝的技术特征

氨法烟气脱硫脱硝具有显著的技术优势:脱硫效率高,脱硫脱硝一举两得,不耗费热量不产生废渣,脱硫剂利用充分用量小,不损害设备有节能功效。脱硫剂利用率可达90%以上,脱硫效率可达90%以上、脱硝效率可达80%以上;脱硫剂用量是钙法工艺的十到二十分之一;副产物为可以直接利用的化学肥料,而非难于处置的废渣。     

埋地钢质输水管道的内外防腐选择

本文通过目前比较常见的几种内外防腐方式及材料的性能和优缺点 ,对埋地钢质输水管道的防腐选择提供了参考意见     

复合催化氧化技术对油气田压裂返排液的处理研究

酸化压裂作业废水是石油天然气生产过程中的主要污染源,它的污染成份复杂,有害物质浓度高,特别是含有胍胶和表面活性剂等高分子物质,具有高COD、高稳定度、高粘度的特点.本文通过对压裂液的来源、水质特征、治理现状等常用方法的分析,确定了物理化学脱稳,过滤、O3/H2O2复合催化氧化、深度氧化的达标治理工艺路线.经过处理后的压裂液澄清透明,达到国家二级排放标准(GB8978-96).