正交试验-硝酸微波消解-冷原子吸收法测定土壤中汞

应用硝酸微波消解土壤样品-冷原子吸收法测定土壤中的汞。通过正交试验,优化了土壤中汞的微波消解条件。并对干扰消除、方法精密度、加标回收、检出限进行了试验研究。在0～10μg／L范围内线性关系良好,方法测定下限为0．20μg／L,土壤中汞的检出限为0．005μg／g。该优化条件对汞含量为0．02—0．46μg／g的土壤样品,汞提取完全。建立了一种简便、成本低、干扰少、灵敏度高的方法。     

对普光气田油菜的二氧化硫熏气实验

为探讨普光气田废气对周围农作物的影响和生物监测方法,选择气田周边油菜作为受试样本,对其进行二氧化硫现场熏气实验。结果表明,油菜在受到1.43 mg/m3浓度、3小时二氧化硫熏气后,植株耐受,不产生明显受害症状;叶片含硫量、MDA含量、可溶性蛋白含量等指标的测定结果与二氧化硫熏气浓度、熏气时间存在显著的相关关系。     

铬渣秸秆共热解产物铬稳定性研究

生物质铬渣共热解工艺是新型的铬渣处理工艺,该工艺能有效地将铬渣中的Cr(Ⅵ)还原为Cr(Ⅲ).而由于共热解产物总铬含量较高,因此考察了铬渣与秸秆共热解过程中铬稳定性.通过考察共热解产物成分及形态分析、pH影响实验、淋洗实验及长期稳定性实验,对共热解铬渣的铬环境安全性进行评估.结果表明:(1)共热解温度对铬渣形态有较大影响,可交换态及碳酸盐结合态铬含量随共热解温度升高而逐渐降低,800℃时候可交换态铬降至＜0.1％(质量分数,下同),碳酸盐结合态铬为1.2％;共热解后最稳定的残渣态铬含量随共热解温度升高而逐渐升高.(2)当pH＞7时,两种共热解产物总铬溶出量极低,基本都小于6mg/kg;当pH≤7时,总铬的溶出量显著增加,最高超过500 mg/kg.但由于解毒铬渣的酸中和能力极强,因此铬释放风险较低.(3)共热解产物的总铬累积溶出量极低,根据拟合结果计算出其100年填埋时间的总铬溶出量不超过1.3 mg/kg.长期稳定性实验表明,自然堆置过程中共热解产物的Cr(Ⅵ)含量逐渐降低.     

木屑处置漏油事故的室内模拟

用锯木屑作为吸附材料,0#柴油为吸附对象进行室内模拟实验,研究了木屑对纯油、水中浮油的吸附以及吸油后的木屑在水中的漂浮性能;并以木屑粒径、木屑投加量、振荡频率、油膜厚度为研究指标,设计了5因素4水平的正交实验,考察了各因素对0#柴油的吸附量、去除率以及木屑漂浮率的影响并对优化条件进行了讨论。结果表明,在实验研究范围内,木屑对水中柴油的吸附速度极快,1min即可达到饱和,饱和吸附量为8．08g／g;木屑在水中漂浮性能良好,静态时经72h漂浮,漂浮率维持在92％左右;振荡频率为150r／min时,72h内漂浮率维持在68％以上;最佳吸油条件组合为吸附剂粒径10～20目,振荡频率120r／min,木屑投加量0．7g,油膜厚度1．65mm。     

煤与瓦斯突出的物理模拟和数值模拟研究

利用自行设计的实验装置,通过现场采集具有突出倾向的煤样,分别向实验装置煤样中充入吸附能力较大的CO2和吸附能力较小的N2来模拟不同级别的煤与瓦斯突出现象,物理试验结果表明:瓦斯压力越大,突出强度越大;当瓦斯压力相近时,吸附和解吸能力大的瓦斯突出强度大。通过数值模拟对煤与瓦斯突出进行研究,数值模拟再现了煤矿开采过程中诱发的煤与瓦斯突出全过程,同时验证了煤与瓦斯突出是瓦斯压力、地应力及煤岩体的力学性质综合作用的结果,该验证对进一步深入理解认识煤与瓦斯突出的机理具有重要的理论和实践意义。     

TEOM法与实验室称重法监测大气中TSP的对比研究

用数理统计的方法计算出TEOM法与称重法监测结果的偏差,用F检验法检验TEOM法与称重法监测结果之间的致性,用r检测法检验TEOM法与称重法监测结果之间的相关性,用t检验法检验TEOM法与称重法监测结果之间的差异,通过对比研究,找出TEOM法与称重法之间的相互关系和规律。     

中华鳖出血性肠炎的药物防治研究

对由实验定筛选的中华鳖出血肠炎病病原菌的最佳防治药物为本正交试验的第6组,即A2B3C1,其抑菌圈达21.5mm.临床应用中采用中西结合复方制剂,即用第6组试验药物再加上中药白头翁汤(加减),其疗效更佳.     

Experimental Study of the Criteria of Flow Laminarization in Two-Dimensional Dense Gas Plumes

Laminarization of flow in a two-dimensional dense gas plume was experimentally investigated in this study. The plume was created by releasing CO₂ through a ground-level line source into a simulated turbulent boundary layer over an aerodynamically rough surface in a meteorological wind tunnel. The bulk Richardson number (Ri_*), based on negative plume buoyancy, plume thickness, and friction velocity, was varied over a wide range so that the effects of stable stratification on plume laminarization could be observed. A variety of ambient wind speeds as well as three different sizes of roughness arrays were used so that possible effects of roughness Reynolds number (Re_*) on plume laminarization could also be identified. Both flow visualization methods and quantitative measurements of velocity and intermittency of turbulence were used to provide quantitative assessments of plume laminarization.Flow visualization provided an overall picture of how the plume was affected by the negative buoyancy. With increasing Ri_*, both the plume depth and the vertical mixing were significantly suppressed, while upstream propagation of the plume from the source was enhanced. The most important feature of the flow revealed by visualization was the laminarization of flow in the lower part of the plume, which appeared to be closely related to both Ri_* and Re_*.Measurements within the simulated dense gas plumes revealed the influence of the stable stratification on mean velocity and turbulence intensity profiles. Both the mean velocity and turbulence intensity were significantly reduced near the surface; and these reductions systematically depended on Ri_*. The roughness Reynolds number also had considerable influence on the mean flow and turbulence structure of the dense gas plumes.An intermittency analysis technique was developed and applied to the digitized instantaneous velocity signals. It not only confirmed the general flow picture within the dense plume indicated by the flow visualization, but also clearly demonstrated the changes of flow regime with variations in Ri_* and Re_*. Most importantly, based on this intermittency analysis, simple criteria for characterizing different flow regimes are formulated; these may be useful in predicting when plume laminarization might occur.     

正交法优化顶空—毛细管气相色谱法测定水中甲醇的实验条件

用顶空进样-毛细管气相色谱法测定水中甲醇,实验结果受到顶空条件影响因素较多。本文使用正交试验方法对顶空进样的加盐量、炉温、恒温时间等5个因素进行了优化,确定了顶空进样气相色谱法测定水中甲醇的最佳操作条件,配合DB-624石英毛细管柱和氢火焰离子化检测器,检出限可达到0．33mg/L。用本方法选择实验条件更加科学合理,测定结果更加可靠。     

精密度--偏性分析质控试验数据处理系统

结合环境监测实验实质量控制数据处理的实际要求,用计算机高级语言,设计开发成功了《精密度－偏性分析质控试验数据处理系统》,该系统具有数据输入,查询,修改,统计分析和打印报告等功能,在实际应用中,取得良好效果。