斜管沉淀池应用中存在问题的探讨

斜管沉淀池是目前广泛使用的污水物化处理工艺。针对实际应用所遇到的问题，如沉淀池进口布水不均匀，致使出水水质下降，从沉淀的基础理论，通过水力学的分析，较深入地说明了斜管沉淀池矾花泛起，水质恶化的原因。并提出了应用斜管沉淀池应注意的事项。     

嘉陵江重庆磁器口段藻类生长模拟研究

藻类生长有一个适合的流速,即临界流速,在其他条件相同的情况下,处于临界流速状态的藻类生长更快.在藻类生长模型中,引人流速影响函数,数值模拟嘉陵江重庆城区磁器口河段2007年2月-7月的藻类生长情况,模拟结果与实测结果吻合较好.研究结果表明.流速在0.03-0.05 m/s比较适合研究河段的藻类生长.     

A~2/O工艺中好氧污泥絮体的分形结构与理化特征分析

采用图像法和沉降柱法分别研究了A2/O工艺中好氧污泥絮体的形貌、粒度分布、低维分形维数和沉降速率、有效密度、空隙率以及质量分形维数,并尝试探讨了上述相关性质与这些污泥宏观操作性质(沉降、压缩、脱水和稳定性)相关的各种理化指标以及胞外高分子物质(EPS)的含量之间的变化关系.结果表明,污泥絮体呈现不规则的形貌,表面具有空隙.其有效密度一般随着其粒径的增加而降低,而空隙率和沉降速率却呈现与有效密度相反的变化趋势,这些均表明了污泥絮体的分形结构的存在.2次所采集的污泥絮体的中位直径分别为248.81、332.86μm,有效密度的平均值分别为0.0040、0.0072g·cm-3,自由沉降速率的平均值分别为2.67、4.79mm·s-1,空隙率的平均值分别为0.94、0.89,一维分形维数分别为1.03、1.19,二维分形维数分别为1.64、1.84,采用基于Logan经验公式的有效密度-最大直径的双对数关系确定的质量分形维数分别为1.74、2.29.尽管第2次所采集的污泥絮体较为密实,但其表面粗糙程度却比第1次的低.此外,研究中发现絮凝能力较高或负电荷较高的A2/O好氧污泥絮体具有高的SVI和ZSV值;分形维数较低...     

蜂窝断面内循环三相生物流化床内流动状况的数值模拟

根据蜂窝断面内循环三相生物流化床内混合液的连续性方程、动量方程和能量方程,利用Fluent软件对反应器内的流动状况进行了数值模拟.采用Fluent的前处理软件Gambit完成流化床的三维模型,利用Fluent主程序解析计算,并利用后处理软件实现计算结果的显示.模拟计算结果获得了反应器内静压力、静压差的变化规律,得到了液体循环速度、气含率沿纵向及横断面的分布.     

偏心双轴搅拌用于污泥搅拌混合的数值模拟

在大型污泥搅拌机中探索采用偏心双轴搅拌,使用Fluent软件对偏心双轴搅拌槽内污泥流体的流场变化进行数值模拟,并与中心双层搅拌进行比较,分析2种结构搅拌槽内宏观流场结构、速度分布及功耗特性,通过实验测量不同转速下偏心双轴的功耗,仿真计算结果和实验值吻合较好。结果表明：偏心双轴搅拌形成的流场结构打破了中心搅拌的流场对称性,有效的消除了隔离区。偏心双轴搅拌槽内流场各方向的速度分量均比中心双层搅拌有明显的提高,速度梯度较大,能够增大搅拌混合区,有利于污泥固液两相的混合。在N=5 r·s-1时偏心双轴搅拌的功耗约为中心双层搅拌的90.4%,具有明显的节能效果。     

Numerical simulation of far-field blast loads arising from large TNT equivalent explosives

Large TNT equivalent explosions usually arise from accidents occurring during the transportation, storage, and manufacturing of chemicals relevant to process industries. The blast wave generated by the explosion will spread and interact with the surrounding factories and storehouses, damaging the building structures within several kilometers and causing significant casualties and property losses. This study aims to develop an efficient numerical simulation method to predict blast loads to estimate the consequences of accidents involving far-field free air bursts or surface burst explosions. Before its interaction with the interested target, a blast wave is generated in the numerical model by specifying the initial and boundary conditions of the disturbed air. Based on empirical data of incident overpressure, an explicit formula to calculate the air particle velocity is derived from the governing equations of a perfect inviscid gas. A simplified path line method is proposed to calculate the air density. The proposed method is applied to the LS-DYNA CESE solver to simulate the blast loads on building structures in the far field. Validations against empirical data and experiments indicate that the proposed method is sufficiently accurate for engineering applications and, through a case study, presents a more efficient performance than the LOAD_BLAST_ENHANCED (LBE) and mapping methods.     

Experimental study on explosion inhibition by heptafluoropropane and its synergy with inert gas

The inhibition effect of heptafluoropropane (CF₃CHFCF₃) on methane explosions under different inhibitor concentrations in a closed vessel was studied. A high-speed camera and a pressure sensor were adopted respectively to record flame propagation characteristics and pressure data. Results indicate that the relationship between flame propagation and pressure rising was correlated. As the equivalent ratio (ϕ)≤1, the pressure presented a trend of rising firstly and then decreasing with increasing CF₃CHFCF₃ concentration, and it was found that there existed a critical concentration for pressure decrease. As ϕ > 1, the pressure exhibited a decreasing trend. Although the pressure appeared to seemingly increase, the moment that the pressure began to rise (t_rise) and the moment that the maximum explosion overpressure appeared (t_Pmax) were obviously delayed. The average rate of pressure rise ((dP/dt)_ave) was decreased as the concentration of CF3CHFCF3 increased. It indicates that CF₃CHFCF₃ can effectively reduce the explosion reaction rate. The critical concentration of CF₃CHFCF₃ for complete inhibition was determined. Meanwhile, the synergy of CF₃CHFCF₃-inert gas can improve the inhibition effect. Compared with CF₃CHFCF₃–N₂, the synergy of CF₃CHFCF₃–CO₂ presented a better inhibition effect, and the inhibition effect was increased with increasing inert gas concentration. And the mechanisms of physical and chemical effects on explosion inhibition were analyzed.     

电极配置和操作条件对静电油烟净化效率的影响

以有机气溶胶发生器产生的0.02～2.02μm癸二酸二辛酯颗粒模拟餐饮业排出的油烟PM2 5组分,利用静电低压撞击器颗粒物检测仪测定各粒径范围的颗粒个数和质量浓度,并系统研究了电极配置、电场风速和供电电压等因素对静电油烟净化效率的影响.结果表明:油烟荷电量以及荷电颗粒迁移距离是影响净化效率的关键因素,优化电极配置的增效...     

横通道通风对隧道火灾烟气蔓延影响的数值模拟研究

为探究隧道横通道通风对隧道火灾烟气蔓延的影响规律,使用火灾动力学模拟软件FDS,对不同火源位置的横通道临界风速、主隧道温度分布以及烟气层高度进行研究。研究结果表明：在一定火源功率范围内,隧道横通道临界风速与火源功率的1/3次方成正比且火源距横通道越远,临界风速越小;当火源位于交叉口,横通道使用临界风速通风时,隧道内烟气温度明显降低,烟气迅速沉降到2 m以下;当火源距离交叉口10,20 m,横通道通风会加快火源下游烟气沉降,烟气沉降速度随横通道通风速率的增大而增大;当火源位于交叉口时,烟气沉降由横通道通风对烟气的降温作用和涡旋作用共同主导,当火源位于距离交叉口10,20 m时,烟气沉降主要由涡旋作用主导。     

卧式电除尘器电晕极优化实验研究

运用粉尘粒子荷电原理,对四种电晕极的主要技术性能进行了试验研究,探讨了卧式电除尘器的最佳极配形式。