基于复杂网络的燃气管线破裂灾害链风险分析*

为提高燃气管线突发事件应急处置决策水平和应急响应能力及效率,采用复杂网络理论和灾害链演化机理对燃气管线破裂灾害事件影响进行耦合分析,构建燃气管线破裂灾害链网络和风险评估模型,并计算得出燃气管线破裂灾害链风险度。为更准确地表达无传播路径的灾害事件之间的关系,将灾害网络中所有最短路径长度的最大值作为其最短路径长度,计算表明这种算法更符合灾害传播实际情况。结果表明:通过燃气管线破裂灾害链风险分析,能够为燃气管线灾害风险控制措施和方案制定提供参考,有利于提高燃气管线破裂灾害事件的应急处置能力和决策水平。     

非金属管道微小泄漏动力学数值模拟和试验对比

为了探索非金属输送管道泄漏规律,从数值模拟和试验两个角度,对液体PE管道发生泄漏前后管道内流体与泄漏口的流动状态进行了对比分析,为判定管道泄漏提供了依据。运用FLUENT软件针对PE液体管道泄漏,在不同孔径、不同压力下,构建管道泄漏模型分别进行仿真,分析不同泄漏情景下压力梯度的分布规律。同时在近似相同条件下进行PE管道两点泄漏模拟试验。结果显示:数值模拟与试验结果基本一致,泄漏孔处压力、流速均与管内初始压力成正相关;初始压力和孔径的增大,会导致管内压力下降速度上升,但最终会趋于稳定值。     

多点泄漏对天然气管道沿线压力的影响研究

为研究不同的多点泄漏工况对管道流动参数的影响,基于流动方程建立数学模型,讨论泄漏后压力下降幅值与泄漏位置、泄漏点数的关系,在室内输气环道采集多点泄漏工况下的压力信号并对理论分析结果进行验证。结果表明:泄漏点的上游和下游压力均减小,越靠近泄漏点压力降越大;2个泄漏点之间压力也下降,越靠近上游泄漏点,压力下降幅度越大;泄漏点距起点越近,泄漏引起的压力降低幅值越大。压力下降的幅值受距离起点最近的泄漏点位置影响最大,且随着泄漏点数的增多而增大。     

基于事故逆向再现的车辆追尾事故仿真分析研究

为认定车辆碰撞事故的性质及责任,动态还原事故发生过程。提出1种逆向事故分析再现方法,经过坐标系旋转后构建确定方程组的车辆碰撞瞬间解析计算模型,并经过实车碰撞实验数据验证其计算精度与三维再现的准确性。利用Crashview软件对1起车辆追尾事故进行仿真分析,解析计算得出车辆碰撞瞬间车速和碰撞前行驶车速,实现事故二维过程重构和三维模拟再现。结果表明:计算分析车速与VDR记录车速误差在5%以内,模拟再现轨迹与事故现场实测痕迹基本吻合,所构建的方法可有效用于车辆追尾碰撞事故辅助分析鉴定,为事故过程分析提供理论依据。     

基于蒙特卡洛模拟的多米诺事故风险量化管理*

为降低危化品相关的化工事故造成的人员伤亡和财产损失,以化工多米诺事故为研究对象,探讨由初始事故引发1个或多个次生事故的连锁反应机理与风险评估方法。提出应用蒙特卡洛模拟对多米诺事故风险进行动态量化的方法,梳理化工多米诺事故风险的识别、分析、评定、处理全周期管理流程,并以1个天然气压气站为案例,验证基于蒙卡模拟的化工多米诺事故风险量化方法的有效性。结果表明:该方法可以更准确地对化工多米诺事故风险进行定量评估。多米诺事故风险全周期管理流程的梳理能够有效指导化工企业开展安全管理、事故预防等工作。     

A Bayesian network-based approach for the assessment and management of ageing in major hazard establishments

Currently, there is an increasing attention towards ageing of industrial equipment, as the phenomenon has been recognised as a cause of severe accidents, recorded in the last years in many process establishments. Recent studies described ageing through a number of key-factors affecting the phenomenon by accelerating or slowing it down. The Italian Competent Authority for the prevention of chemical accidents (Seveso III Directive) adopted a short-cut method, accounting for the assessment of these factors, to evaluate the adequateness of ageing management during inspections at Seveso sites. In this paper, a Bayesian Network was developed, by using the data gathered during the first application of the short-cut method, with the aim to verify the robustness of the approach for ageing assessment and the validity of the a priori assumptions used in assessing the key-factors. The structure of the Bayesian network was established by using experts’ knowledge, whereas the Counting Learning algorithm was adopted to execute the parameter learning by means of the software Netica. The results showed that this network could effectively explore the complex logical and uncertain relationships amongst factors affecting equipment ageing. Results of the present study were exploited to improve the short-cut method.     

基于模糊推理的FRAM事故定量分析方法研究

为有效克服FRAM事故分析中无法进行定量分析的缺陷,提出结合模糊推理技术的Fuzzy FRAM模型。此改进模型基于FRAM识别系统运行状态;依据功能输出要素的时间/精度属性利用Matlab构建2阶模糊推理系统量化功能输出质量;根据通用性能条件(CPC)及功能输入耦合端口构建功能评价体系,针对评价体系中存在的不确定性信息融合及建模问题,采用模糊证据推理技术,通过模糊信度结构建立、数据处理、信息融合测度后获得功能的风险指数;以既有铁路危险品运输事故为例,验证方法的可行性。结果表明:Fuzzy FRAM模型的评估结果较为精确,是FRAM分析方法的有效补充。     

Prevalence of alcohol among nonfatally injured road accident casualties in two level III trauma centers in northern Ghana

Background: Alcohol use is pervasive among motorists on the road in Ghana; however, we do not know the extent to which this behavior is implicated in road accidents in this country.

Objectives: The main objective of this research was to establish the prevalence of alcohol in the blood of nonfatally injured casualties in the emergency departments (EDs) in northern Ghana.

Method: Participants were injured road traffic crash victims, namely, pedestrians, cyclists, motorcyclists, and drivers seeking treatment at an ED. The study sites were 2 level III trauma centers located in Wa and Bolgatanga. Participants were screened for alcohol followed by breath tests for positive participants using breathalyzers.

Results: Two hundred and sixty-two accident victims visited EDs, 58% of whom were in Wa. Among the victims, 41% were hospitalized and 57% experienced slight injuries. The vast majority (76%) of the casualties were motorcyclists, 13% were pedestrians, 8% were cyclists, and 2% were drivers. Casualties who had detectable alcohol in their blood were predominantly vulnerable road users. In all, 34% of participants had detectable blood alcohol concentrations (BACs) and the mean BAC for all casualties who tested positive and could give definitive BACs was 0.2265 (226 mg/dl). The prevalence of alcohol use was 53% among cyclists, 34% among motorcyclists, 21% among pedestrians, and 17% among drivers. Male casualties were more likely to test positive for alcohol than females. In addition, the prevalence of alcohol was significantly higher among injured casualties in Bolgatanga compared to Wa.

Conclusion: There was a high prevalence of alcohol use among nonfatally injured casualties in northern Ghana and injury severity increased with BAC. AUDIT screening in the hospital, alcohol consumption guideline, road safety education with an emphasis on minimizing or eliminating alcohol consumption, and enhanced enforcement of the BAC limit among motorists are recommended.     

Features of fatal injuries in older cyclists in vehicle–bicycle accidents in Japan

Objective: The purpose of this study was to identify and better understand the features of fatal injuries in cyclists aged 75 years and over involved in collisions with either hood- or van-type vehicles.

Methods: This study investigated the fatal injuries of cyclists aged 75 years old and over by analyzing accident data. We focused on the body regions to which the fatal injury occurred using vehicle–bicycle accident data from the Institute for Traffic Accident Research and Data Analysis (ITARDA) in Japan. Using data from 2009 to 2013, we examined the frequency of fatally injured body region by gender, age, and actual vehicle travel speed. We investigated any significant differences in distributions of fatal injuries by body region for cyclists aged 75 years and over using chi-square tests to compare with cyclists in other age groups. We also investigated the cause of fatal head injuries, such as impact with a road surface or vehicle.

Results: The results indicated that head injuries were the most common cause of fatalities among the study group. At low vehicle travel speeds for both hood- and van-type vehicles, fatalities were most likely to be the result of head impacts against the road surface.

The percentage of fatalities following hip injuries was significantly higher for cyclists aged 75 years and over than for those aged 65–74 or 13–59 in impacts with hood-type vehicles. It was also higher for women than men in the over-75 age group in impacts with these vehicles.

Conclusions: For cyclists aged 75 years and over, wearing a helmet may be helpful to prevent head injuries in vehicle-to-cyclist accidents. It may also be helpful to introduce some safety measures to prevent hip injuries, given the higher level of fatalities following hip injury among all cyclists aged 75 and over, particularly women.     

A path analysis model for explaining unsafe behavior in workplaces: the effect of perceived work pressure

Background. Unsafe behavior is closely related to occupational accidents. Work pressure is one the main factors affecting employees’ behavior. The aim of the present study was to provide a path analysis model for explaining how work pressure affects safety behavior. Methods. Using a self-administered questionnaire, six variables supposed to affect safety employees’ behavior were measured. The path analysis model was constructed based on several hypotheses. The goodness of fit of the model was assessed using both absolute and comparative fit indices. Results. Work pressure was determined not to influence safety behavior directly. However, it negatively influenced other variables. Group attitude and personal attitude toward safety were the main factors mediating the effect of work pressure on safety behavior. Among the variables investigated in the present study, group attitude, personal attitude and work pressure had the strongest effects on safety behavior. Conclusion. Managers should consider that in order to improve employees’ safety behavior, work pressure should be reduced to a reasonable level, and concurrently a supportive environment, which ensures a positive group attitude toward safety, should be provided. Replication of the study is recommended.