A2/O工艺中好氧污泥絮体的分形结构与理化特征分析

采用图像法和沉降柱法分别研究了A²/O工艺中好氧污泥絮体的形貌、粒度分布、低维分形维数和沉降速率、有效密度、空隙率以及质量分形维数,并尝试探讨了上述相关性质与这些污泥宏观操作性质(沉降、压缩、脱水和稳定性)相关的各种理化指标以及胞外高分子物质(EPS)的含量之间的变化关系.结果表明,污泥絮体呈现不规则的形貌,表面具有空隙.其有效密度一般随着其粒径的增加而降低,而空隙率和沉降速率却呈现与有效密度相反的变化趋势,这些均表明了污泥絮体的分形结构的存在.2次所采集的污泥絮体的中位直径分别为248.81、 332.86 μm,有效密度的平均值分别为0.004 0、 0.007 2 g·cm^-3,自由沉降速率的平均值分别为2.67、 4.79　mm·s^-1,空隙率的平均值分别为0.94、 0.89,一维分形维数分别为1.03、 1.19,二维分形维数分别为1.64、 1.84,采用基于Logan经验公式的有效密度-最大直径的双对数关系确定的质量分形维数分别为1.74、 2.29.尽管第2次所采集的污泥絮体较为密实,但其表面粗糙程度却比第1次的低.此外,研究中发现絮凝能力较高或负电荷较高的A²/O好氧污泥絮体具有高的SVI和ZSV值;分形维数较低的污泥具有高的剪切敏感性和低絮体强度,相应的污泥稳定性低;EPS总量高的污泥脱水性能差,EPS中蛋白质含量高的污泥其表面电荷也较高.     

Experimental study on the competing effect of ceramic pellets on premixed methane-air flame propagation in a duct

It is urgent to explore effective suppression methods for gas fires and explosions to ensure the safe utilizations of combustible gases in industrial processes. In this work, experiments are performed to study the effect of spherical ceramic pellets on premixed methane-air flame propagation in a closed duct. High-speed schlieren photography and pressure transducers are used to record the flame propagation and pressure transient, respectively. Behaviors of the flame propagating through a section of the duct filled with ceramic pellets in mixtures at different equivalence ratios are scrutinized. Three different diameters of pellets are considered in the experiments. The result shows that the flame can be quenched in the case with a smaller pellet diameter (3 mm) for a wide range of equivalence ratios from fuel-lean to fuel-rich mixture. For larger pellet diameter (5 or 10 mm), flame extinction occurs in fuel-rich mixtures (e.g. Φ = 1.1, 1.2). For the cases of flame surviving through the pellets bed, the pellets show a significant influence on the flame structure and behavior. The flame propagation depends on the porosity and the mean void diameter of the porous media in the pellets bed. Small void diameter is beneficial to flame quenching, while large porosity can accelerate the flame propagation. The pressure dynamics evolution is closely related to the interaction of flame with the pellets, and it depends on whether the flame quenches in the pellets bed. Overall, d = 3 mm ceramic pellets display the best suppression effect on flame propagation and pressure buildup in this study. The results of this study are of great significance to guide the safety design of spherical suppression materials in engineering applications for process safety researchers and engineers.     

PAN dust explosion inhibition mechanisms of NaHCO3 and Al(OH)3

We investigate the PAN dust explosion inhibition behaviors of NaHCO₃ and Al(OH)₃ in a 20 L spherical explosion system and a transparent pipe explosion propagation test system. The results show that, in the standard 20 L spherical explosion system, the highest PAN dust explosion concentration is 500 g/m³, the maximum explosion pressure is 0.661 MPa, and the maximum explosion pressure increase rate is 31.64 MPa/s; adding 50% NaHCO₃ and 60% Al(OH)₃ can totally inhibit PAN dust explosion. In the DN0.15 m transparent pipe explosion propagation test system, for 500 g/m³ PAN dust, the initial explosion flame velocity is 102 m/s, the initial pressure is 0.46 MPa, and the initial temperature is 967 °C; adding 60% NaHCO₃ and 70% Al(OH)₃ can totally inhibit PAN dust explosion flames. Through FTIR and TG analyses, we obtain the explosion products and pyrolysis patterns of the explosion products of PAN dust, NaHCO₃, and Al(OH)₃. On this basis, we also summarize the PAN dust explosion inhibition mechanisms of NaHCO₃ and Al(OH)₃.     

Effect of the vent burst pressure on explosion venting of rich methane-air mixtures in a cylindrical vessel

The effect of the vent burst pressure on explosion venting of a rich methane-air mixture was experimentally investigated in a small cylindrical vessel. The experimental results show that Helmholtz oscillation of the internal flame bubble of the methane-air mixture can occur in a vessel with a vent area much smaller than that reported by previous researchers, and the period of Helmholtz oscillation decreases slightly when the vent burst pressure increases. The maximum overpressure in the vessel increases approximately linearly with the increase in the vent burst pressure; however, the pressure peaks induced by Helmholtz oscillation always remain approximately several kilopascals. The external flame reaches its maximum length in a few milliseconds after vent failure and then oscillates in accordance with the pressure oscillation in the vessel. The maximum length of the external flame increases, but its duration time decreases with the increase in the vent burst pressure.     

Experimental evaluation of the possibility of ignition and flame propagation in accumulated difluoromethane (R32) from a kerosene cigarette lighter

The possibility of ignition and flame propagation in accumulated difluoromethane (CH₂F₂, R32) was examined experimentally, simulating a situation in which a service operative uses a kerosene lighter for smoking. To simulate the situation where a kerosene cigarette lighter is used in accumulated R32, electrodes fixed in the windbreak of the lighter were remotely supplied with electricity to generate sparks of various durations but of similar energies to those of actual sparks generated by rubbing a flint to ignite the fuel in the lighter. We identified several cases of ignition and formation of an open flame in the windbreak of the lighter, and the flame propagated to the accumulated R32 when it was supplied with sufficient energy from the spark. Gas chromatographic analyses confirmed that the mixture in the windbreak of the kerosene lighter consisted mainly of vaporized fuel and air, with no R32. Therefore, even if the lighter is located in accumulated R32, an open flame can be generated in the windbreak of the kerosene cigarette lighter through ignition by the spark energy generated by friction between the flint and the flint wheel. Our results confirmed that there is a real possibility of ignition and flame propagation when a kerosene cigarette lighter is used in accumulated R32 under the leak rate conditions of the present experiment.     

A Power Law Model for River Flow Velocity in Iowa Basins

This study explores power law relationships to estimate water flow velocity as a function of discharge and drainage area across river networks. We test the model using empirical data from 214 United States (U.S.) Geological Survey gauging stations distributed over the state of Iowa in the U.S. The empirical data are the measurements of the mean cross‐sectional velocity and concurrent discharge. The data are used to estimate parameters for a state‐wide model and to test for spatial variability for 15 large river basins contained within the state. Spatial differences among the basins are small but some parameters significantly differ from the state‐wide model. Using individual station data, the authors also explore a simpler power law model that disregards dependence on the drainage area. Overall, the study shows that including drainage area improves the model. Our study provides parameter values that can be directly incorporated into a regional scale routing model, and provides a framework for developing flow velocity models for hydraulically similar rivers in the U.S. and the world.     

空气提升内循环生物流化床反应器动力学研究

进行了空气提升内循环生物流化床反应液体内循环速度,有机的降解动力学,载体表面生物膜脱落与增工动力学的研究,结果表明,内循环生物硫化内不速度分别与反应器高度及升流区表观气速ｕｇ０．５次方成正比,当内循环流量很大时,反应器可视为ＣＳＴＲ;生物膜的脱降率分别与ｕｇ及膜厚δ的次方,载体数量的２／３次方成正比。     

现行的UASB反应器的设计问题及改良的可行性

探讨了UASB反应器的设计问题和改良的可行性。重点介绍并评价了UASB反应器的器内流速关系以及对应的问题。对比第 3代厌氧反应器的特点 ,提出了UASB反应器可行的改良方法。作为改良可行性证据 ,提供了改良后的实验数据     

水体突发性重金属污染胁迫下斑马鱼的行为反应分析

研究了斑马鱼在不同程度突发性的Zn2＋和Cr6＋胁迫下的行为反应,采用计算机视觉技术量化研究斑马鱼游动行为数据。结果表明,在Zn2＋和Cr6＋的突发性胁迫中,斑马鱼的行为反应快速且敏感,游动行为与污染物种类、质量浓度和暴露时间直接相关,并表现出比较相似的行为变化规律;随着胁迫程度的增加,斑马鱼游动速度的变化幅度增大,反应时间缩短,且其变化曲线符合生物行为的环境压力模型。斑马鱼的行为变化远远提前于生物的病理损伤或死亡,可利用斑马鱼暴露于污染物时的行为变化实现在线水体突发性重金属污染事故的监测预警。     

水平燃料填充床反向阴燃传播及其熄灭分析

根据单步反应机理(仅包括燃料的氧化),建立了一维非稳态燃料填充床反向阴燃的数学模型。通过简化模型参数及大活化能渐近分析,得出了定性描述燃料反向阴燃传播的两个方程。结果表明:随着空气流量的增大,阴燃温度是不断上升的,但由于受到反向空气风流的影响,阴燃温度的增长幅度是逐渐变小的;阴燃传播速度却呈现出先增大后减小直至熄灭的变化趋势。这种变化趋势与前人的实验结果相一致。通过定性分析得出:在气体流量为零的情况下,燃料仍然可以发生阴燃,而维持阴燃不断传播所需要的氧气量源于反应区域周围气体的扩散。此外,也分析了燃料特性参数(如密度、孔隙率、比热、导热系数及活化能)对燃料阴燃温度和阴燃速度传播的影响。