基于生态足迹改进模型的生态安全及其预测研究

由William Rees提出的生态足迹模型已经成为近年来生态可持续发展的重要的度量工具,但是该模型仅考虑了土地的基本生产功能,忽视了土地生态系统的服务功能。文章借鉴生态系统服务功能理论改进了传统的生态足迹模型,将生态系统服务功能价值当量因子引入生态足迹模型均衡因子和产量因子的计算中,改进后的模型体现了生态系统功能的完整性;同时,文章以江苏省2010年的统计数据为基础,应用改进模型计算了其2010年生态压力指数,结果表明,江苏省生态压力指数达到1.495,其安全状况已经超过了极不安全边界,处于极不安全状态;最后利用灰色理论GM(1,1)模型对其2011-2015年的生态安全状况进行了预测,发现江苏省未来5年生态压力指数快速增大,年平均增长速度为6.89%,表明江苏省未来5年生态安全状况将继续恶化,这将严重影响其生态可持续发展和经济可持续发展。     

选矿废水污染的土壤铜量与生物累积的研究

通过对花石头河沿岸研究区植物的根部、茎叶进行采样分析,探讨了土壤铜含量和铜在植物体内的累积状况。结果表明,光叶蕨、三叶鬼针草、野牡丹、紫茎泽兰4种植物体内铜含量随着土壤铜含量的增加而增加,光叶蕨增量最大。植物根部铜生物累积系数(BF)与茎叶铜生物累积系数(BF)之间相关性不显著,但根部BF为1.311,茎叶BF为0.159,前者是后者的8.2倍。光叶蕨铜的累积能力最强,其次是紫茎泽兰,植物间铜生物累积系数没有显著性差异。各采样区土壤铜含量差异大,它们之间的差异达到显著性水平。无论是全株植物、根部,还是茎叶,BF值:公路边>山坡上>河边。青蒿铜的迁移系数(TF)最大,与其余植物的迁移系数存在显著性差异,而这4种植物之间铜的迁移系数没有显著性差异,不同采样区TF均值以公路边TF值最高,其次是河边,最后才是山坡上。     

厌氧氨氧化工艺脱氮及其污泥形态的研究

为研究厌氧氨氧化工艺对高浓度含氮废水的脱氮性能,在以聚乙烯海绵作为填料的上流式厌氧固定床反应器中利用人工配置高浓度含氮废水进行了实验研究.实验中通过添加充足无机碳源,实现了厌氧氨氧化反应器在总氮浓度900～1 210 mg/L长期稳定的运行,脱氮效率在80％以上,最高氮负荷为5.9 kg/m3·d.结果表明:充足的无机碳源在一定程度上可有效地降低高浓度亚硝氮对厌氧氨氧化菌的抑制作用.通过对污泥性状的研究,明确寻找出污泥上浮的原因所在.通过Stover-Kincannon模型确定系统动力学参数KB和Umax分别为30.2 g/L·d和2L2g/L·d,这将有助于对该厌氧氨氧化系统各控制条件的有效调节和准确设定,也为日后应用于实际工程中提供重要的理论依据.     

Application of CGP-cross route process for microstructure refinement and mechanical properties improvement in steel sheets

A modified method of severe plastic deformation (SPD) entitled constrained groove pressing-cross route (CGP-CR) was introduced for imposing a high magnitude of equivalent strain of about 2.32 per pass on the sheet form samples. The major benefit of this improved route compared to previous common route was the more homogeneity of strain in the rolling (RD) and transverse (TD) directions of sheets. In this study, low carbon steel samples were used for examination of evolutions in microstructure and mechanical properties during SPD via CGP-CR process. Mechanical properties improvement were measured by tensile and macro hardness tests. The results indicate that CGP-CR process can effectively improve tensile strength; and also, yield stress and hardness of as-received low carbon steel samples were improved up to about 100% after two deformation passes. Also, high magnitude of inhomogeneity can be observed in hardness distribution through first pass of the process which diminishes in the subsequent passes. Microstructural evolutions during process were monitored by optical microscopy observations and X-ray diffraction analysis. The results demonstrate that initial ferritic microstructure with grain size of about 30 μm was refined to a 225 nm cell structure after two passes of CGP-CR process.     

Modulation-assisted high speed machining of compacted graphite iron (CGI)

The application of controlled, low-frequency modulation (～100 Hz) superimposed onto the cutting process in the feed-direction – modulation-assisted machining (MAM) – is shown to be quite effective in reducing the wear of cubic boron nitride (CBN) tools when machining compacted graphite iron (CGI) at high machining speeds (>500 m/min). The tool life is at least 20 times greater than in conventional machining. This significant reduction in wear is a consequence of the multiple effects realized by MAM, including periodic disruption of the tool–workpiece contact, formation of discrete chips, enhanced fluid action and lower cutting temperatures. The propensity for thermochemical wear of CBN, the principal wear mode at high speeds in CGI machining, is thus reduced. The tool wear in MAM is also found to be smaller at the higher cutting speeds (730 m/min) tested. The feed-direction MAM appears feasible for implementation in industrial machining applications involving high speeds.     

双台子河流域综合水质评价方法的对比研究

本研究利用双台子河2011年枯、丰、平水期的22个水文监测断面数据,并借助主成份分析法,确定主要污染因子和超标断面。分别采用综合标识指数、单因子、模糊评判、灰色关联四种评价法,选取DO、COD、NH3-N、TP、TN、BOD 6个评价因子,对河流水污染特性进行综合评价与分析。结果表明:以Bartlett球度检验,主成份因子负荷值较高的NH3-N、TP、BOD因子,累积方差贡献率91.97%,主要污染因子;超标断面的污染因子判别应考虑周边污染源的类型和河流上游的排放物浓度。模糊评判、灰色关联评价结果中均没有劣V类,两者的水质类别累积频率均在V类到达100%;考虑到单因子法在同一水质类别中不能判定多项因子共同对水体的综合影响,本文采用标识指数法为最佳评价方法。从枯、丰、平水期的劣V类和V类断面比重分析,枯水期>平水期>丰水期。从劣V类和V类数量与分布来看,盘锦市辖区控制单元的污染程度,比大洼县和盘山县污染较重。     

海水中亚硝化细菌的分离鉴定研究

从海水样品中分离到1株严格自养的氨氧化细菌GW201210,对该株茵的形态特征、培养特性、生理生化特性等生物学特性进行了初步研究。结果表明,它为革兰氏染色阴性,无鞭毛,不产芽孢,细胞短杆状,呈单个排列或排列成直线。该菌株能将氨氮氧化成亚硝酸盐,不能还原硝酸盐,能利用CO2,在7％NaCl条件下生长,在肉汤培养基中不生长,其特性均符合亚硝酸菌的特征,并用PCR方法扩增该菌株的16SrDNA基因,进行16SrDNA序列比较、同源性分析并构建系统发育树,将菌株GW201210初步鉴定为亚硝化单胞菌属（Nitro．somonascommunis）o