污染场地地下水中汞污染反应运移模拟

汞（Hg）是人们持续关注的全球环境污染物之一,其对地下水的污染严重威胁着与地下水相关的生态环境系统.汞在地下水系统中的物理与地球化学反应过程的准确刻画是研究汞迁移转化规律的重点和难点.基于某工业场地汞污染数据,首先采用PHREEQC研究地下水中无机二价汞的存在形态,然后利用PHT3D程序建立汞污染物反应性溶质运移二维剖面模型.该模型考虑了汞污染物在地下水系统中的对流、弥散过程及地球化学反应过程（包括水相络合作用、表面络合吸附作用及受动力学控制的氧化还原作用）.结果表明,无机二价汞的存在形态以HgCl₂和Hg（OH）Cl占主导地位,氧化还原作用是影响地下水中汞污染反应性运移的主要控制因素;另一方面,水合氧化铁HFO对汞迁移的阻滞影响较小,而溶解性有机质对汞较强的络合作用不能忽视.本文研究成果可为预测与评估特定污染场地地下水汞污染的变化趋势及制定相应的修复策略提供科学依据.     

微波辐射处理活性艳蓝KN-R染料溶液的研究

在活性炭存在下微波照射能使活性艳蓝KN－R溶液迅速脱色，每g活性炭处理浓度为300mg／L的活性艳蓝KN－R溶液50mL，微波辐射4min脱色率达97．1％。     

非饱和带强化反应层脱氮的试验研究

自然堆肥过程中,畜禽养殖产生的粪污渗滤液入渗土壤非饱和带.高浓度有机氮在微生物作用下经由复杂的地球化学过程转化为各种含氮物质,其中硝酸盐迁移能力较强,在降雨条件下入渗地下水,造成区域性地下水硝酸盐污染.在非饱和带中构建由木屑和壤土组成的强化反应层,通过间歇性的原位淋溶脱氮试验,系统地研究了非饱和带含水量及COD、硝态氮、亚硝态氮和氨氮的浓度变化规律,评价了强化反应层的脱氮能力.研究结果表明:①反应层中木屑材料的强吸水特性使得灌水后短时间内反应层含水量大幅提升,形成有利于反硝化进行的厌氧环境.木屑通过水解作用释放大量溶解性有机碳,供给反硝化微生物进行脱氮.②在入渗硝态氮浓度为170.00 mg·L~(-1)条件下,反应层对硝态氮去除率最高可达97.63%.反应层脱氮量随处理水量增加而提升,当上层为砂土时脱氮量最高,可达24.61 g·m~(-3).③反应层中的NO~-_3-N发生了完全反硝化,出水中NO~-_2-N浓度低于0.5 mg·L~(-1),几乎不发生积累.同时,反应层中发生的DNRA过程使氨氮浓度小幅升高.强化脱氮反应层可阻控硝酸盐污染地下水.     

伯胺N1923反应萃取含Cr~(6+)废水的研究

考察了伯胺N 1 92 3 煤油从硫酸介质中对Cr6 + 的萃取 ,萃取属络合反应机理 ,有机相中主要生成伯胺N1 92 3∶Cr =2∶1的萃合物。探讨了初始水相酸度 ,萃取剂含量 ,温度等对萃取平衡分配系数的影响。对萃取反应中出现的“第三相”问题进行了研究 ,并提出了消除的方法。     

污泥活性炭对染料的吸附动力学研究

以城市污水处理厂脱水污泥作为原料,采用化学活化法(ZnCl2作为活化剂)制得污泥活性炭,全面研究了污泥活性炭对活性艳红K-2BP、酸性大红GR和直接紫N这3种染料的吸附动力学行为.结果表明,污泥活性炭可以有效地吸附染料,实现污泥的资源化;3种染料的平衡吸附量qe均随着染料初始浓度和温度的增大而增大,相同条件下平衡吸附量qe的大小顺序为:酸性大红GR＞活性艳红K-2BP＞直接紫N;伪二级动力学模型能够很好地描述3种染料在污泥活性炭上的吸附动力学行为;对于活性艳红K-2BP和直接紫N,颗粒内扩散过程是该吸附速率的控制步骤,但不是唯一的速率控制步骤,吸附速率同时还受颗粒外扩散过程的控制,而对于酸性大红GR,颗粒内扩散过程不是吸附速率的控制步骤;污泥活性炭对3种染料的吸附是一个吸热过程,吸附活化能较小,主要为物理吸附过程.     

高盐条件下染料酸性橙7的生物降解特性

对偶氮染料废水厌氧-好氧生物处理中的高盐度抑制生物活性和芳香胺自氧化问题,通过多种强化策略,考察了NaCl为100g/L时酸性橙7(AO7)的生物降解特性.结果表明,加入葡萄糖(0.5g/L)、蛋白胨(1g/L)和酵母粉(0.5g/L)有利于高盐条件下AO7的生物降解.进水中加入酸性红B对AO7的脱色有加速作用.耐盐污泥中加入蒽醌形成的蒽醌-污泥自固定化体系可以促进AO7脱色,当蒽醌浓度为100mg/L时,AO7最大脱色率约为92%.以活性炭毡作为生物载体,厌氧和好氧体系均可实现稳定运行,且体系污泥沉降性良好,脱色速率达26.67mg/(L×h),且可有效抑制脱色中间产物1-氨基-2-萘酚的好氧自氧化,使COD去除率始终保持在90%以上.     

反硝化菌的偶氮染料脱色研究

从活性污泥中分离到几株反硝化能力的偶氮染料脱色菌。它们在合成培养基吧有使大多数所试偶氮染料脱色,而在反硝化条件下很难使偶氮染料脱色,只有菌株１７在培养２０ｄ后才有较好的脱色效果。酵母粉等有机物作为生长因子时,对菌株１７反硝化条件下的偶氮染料脱色有非常明显的促进作用;     

Arsenic and chromate removal from water by iron chips-Effects of anions

The purpose of this study is to estimate the removal efficiency of As and Cr (VI) by one kind of industrial waste — iron chips, as well as to estimate the effects of typical inorganic anions (sulfate, phosphate, and nitrate), and typical organic anions (citrate, oxalate, and humate) on As or Cr (VI) removal. The results showed that 98% of As (V) and 92% of As (III) could be removed from aqueous phase by the iron chips within 60 min. Compared with As species, Cr (VI) was removed much more rapidly and efficiently with 97% of Cr (VI) being removed within 25 min. The removal efficiency for arsenic was in the order: As (III) (sulfate), As (III) (nitrate) or As (III), As (III) (humate), As (III) (oxalate), As (III) (citrate), As (III) (phosphate), and for chromate was in the order: Cr (VI) (sulfate), Cr (VI) (phosphate) or Cr (VI) (nitrate) or Cr (VI) (oxalate), Cr (VI), Cr (VI) (citrate), Cr (VI) (humate). In all the treatments, pH level increased with time except for As (III), the removal of which was either without anions or in the presence of humate or nitrate.     

Quinone-mediated decolorization of sulfonated azo dyes by cells and cell extracts from Sphingomonas xenophaga

The effects of various quinone compounds on the decolorization rates of sulfonated azo dyes by Sphingomonas xenophaga QYY were investigated. The results showed that anthraquinone-2-sulfonate (AQS) was the most effective redox mediator and AQS reduction was the rate-limited step of AQS-mediated decolorization of sulfonated azo dyes. Based on AQS biological toxicity tests, it was assumed that AQS might enter the cells to kill them. In the cytoplasmic extracts from strain QYY, AQS effectively increased decolorization rates of sulfonated azo dyes than other quinone compounds. In addition, we found a NADH/FMN-dependent AQS reductase using nondenaturing polyacrylamide gel electrophoresis (Native-PAGE).     

Photocatalytic degradation of dye effluent by titanium dioxide pillar pellets in aqueous solution

Photocatalytic oxidation (PCO) process is an effective way to deal with organic pollutants in wastewater which could be difficult to be degraded by conventional biological treatment methods. Normally the TiO2 powder in nanometre size range was directly used as photocatalyst for dye degradation in wastewater. However the titanium dioxide powder was arduous to be recovered from the solution after treatment. In this application, a new form of TiO2(i. e. pillar pellets ranging from 2.5 to 5.3 mm long and with a diameter of 3.7 mm) was used and investigated for photocatalytic degradation of textile dye effluent. A test system was built with a flat plate reactor(FPR) and UV light source(blacklight and solar simulator as light source respectively) for investigating the effectiveness of the new form of TiO2. It was found that the photocatalytic process under this configuration could efficiently remove colours from textile dyeing effluent. Comparing with the TiO2 powder, the pellet was very easy to recovered from the treated solution and can be reused in multiple times without the significant change on the photocatalytic property. The results also showed that to achieve the same photocatalytic performance, the FPR area by pellets was about 91% smaller than required by TiO2 powder. At least TiO2 pellet could be used as an alternative form of photocatalyst in applications for textile effluent treatment process, also other wastewater treatment processes.