Effect of water treatment residuals on soil phosphorus, copper and aluminium availability and toxicity

Water treatment residuals (WTRs) are produced by the treatment of potable water with coagulating agents. Beneficial recycling in agriculture is hampered by the fact that WTRs contain potentially toxic contaminants (e.g. copper and aluminium) and they bind phosphorus strongly. These issues were investigated using a plant bioassay (Lactuca sativa), chemical extractions and an isotopic dilution technique. Two WTRs were applied to an acidic and a neutral pH soil at six rates. Reductions in plant growth in amended soils were due to WTR-induced P deficiency, rather than Al or Cu toxicity. The release of potentially toxic Al from WTRs was found to be mitigated by their alkaline nature and pH buffering capacity. However, acidification of WTRs was shown to release more soluble Al than soil naturally high in Al. Copper availability was relatively low in all treatments. However, the lability of WTR-Cu increased when the WTR was applied to the soil.     

降雨主导型库岸滑坡变形时空分布特征

根据某大型水库近坝库岸滑坡8年的监测资料,对该滑坡变形的时空分布特征进行了分析。该滑坡变形的空间分布特征主要表现为3个方面的差异,即区域差异、高程差异和深度差异。而滑坡变形的时间分布特征主要体现在库水作用和降雨两个方面:在重点监测的Ⅱ区,库水作用只影响到其前端部分,对中、后部影响很小;该区的整体变形与降雨关系密切,响应明显。这些特征表明该滑坡为降雨主导型库岸滑坡,并有向稳定方向发展的趋势;但Ⅱ区特有的"后坐式"变形特征又存在一定的安全隐患,因此,该滑坡的监测还应长期进行。     

西南山区某气井井场地基稳定性模拟分析

中国西南山区蕴藏着丰富的天然气资源,但随着开发规模的日益扩大,天然气井逐步转向山区这类地质环境恶劣的地区。本文以西南山区某气井为原型,在详细阐明井场区地质环境背景特征的基础上,首先对井场出现的典型地质问题——地下采空区进行定性判断和分析;之后选用F lac-2D有限差分软件,对井场加载前/后地下采空区可能造成的井场地基应力和变形特征,采用双洞和采空区这2种计算模型,进行数值模拟分析。模拟结果表明,井场加载前/后地基最大位移量为2 mm,地基局部地段出现拉应力区,但总体上地基稳定。研究结论将为后期建设中井场建筑物的优化布局及基础的选型提供依据。     

Novel mesoporous microspheres of Al and Ni doped LMO spinels and their performance as cathodes in secondary lithium ion batteries

A facile, scalable, and solution-based technique is used to fabricate Al and Ni-doped (LiAl_0.1Mn_1.9O₄ and LiAl_0.1Ni_0.1Mn_1.8O₄) microspheres of lithium manganese oxide (LMO) spinels for use as reversible cathode materials for lithium ion batteries (LIBs). The spheres of the two samples exhibit different porosities. Cells with these LMO-based cathodes are then cycled between 4.5 V and 2 V to study their stabilities while simultaneously being subjected to the undesirable Jahn-Teller distortion that occurs around the ~3 V regime. The LiAl_0.1Mn_1.9O₄ (LAMO) and the LiAl_0.1Ni_0.1Mn_1.8O₄ (LANMO) cells exhibit comparable open circuit voltages (OCV) of 2.94 V and 2.97 V, respectively. During cell cycling, the LAMO cell exhibits a maximum specific capacity of 122.51 mAh g^?1 with a capacity fade of 65.35% after 75 cycles. The LiAl_0.1Ni_0.1Mn_1.8O₄ (LAMO) sample fares better and exhibits a maximum of 140.49 mAh g^?1 and a capacity drop of 52.59%. Detailed structural studies indicate that Ni doping and the greater degree of porosity of the LANMO sample to be a stabilizing factor. This is further confirmed by cyclic voltammetry (CV) and AC impedance spectra analysis.     

Characterization of aluminium-based water treatment residual for potential phosphorus removal in engineered wetlands

Aluminium-based water treatment residual (Al-WTR) is the most widely generated residual from water treatment facilities worldwide. It is regarded as a by-product of no reuse potential and landfilled. This study assessed Al-WTR as potential phosphate-removing substrate in engineered wetlands. Results indicate specific surface area ranged from 28.0 m² g⁻¹ to 41.4 m² g⁻¹. X-ray Diffraction, Fourier transform infrared and energy-dispersive X-ray spectroscopes all indicate Al-WTR is mainly composed of amorphous aluminium which influences its phosphorus (P) adsorption capacity. The pH and electrical conductivity ranged from 5.9 to 6.0 and 0.104 dS m⁻¹ to 0.140 dS m⁻¹ respectively, showing that it should support plant growth. Batch tests showed adsorption maxima of 31.9 mg P g⁻¹ and significant P removal was achieved in column tests. Overall, results showed that Al-WTR can be used for P removal in engineered wetlands and it carries the benefits of reuse of a by-product that promotes sustainability.     

高碱度水库水混凝过程中残留铝控制

针对高碱度水库水源的某水厂残留铝超标问题,选取碱化度(B)与Alb含量不同的3种铝盐絮凝剂,研究不同投量与pH值下混凝效果与残留铝浓度水平。结果表明,碱化度和Alb含量显著影响混凝效果。DOC和浊度的去除率随着3种絮凝剂AlCl3(B=0)、PACl-1(B=1.2)、PACl-2(B=2.2)投量增大而升高。3种絮凝剂投量在1.5～2.0 mg/L(以铝计)范围内,总铝和溶解铝含量最低。对于该水厂自制的絮凝剂PACl-2,可通过降低絮凝剂碱化度,或将水的pH值降低至7～7.5之间,以此可以提高PACl-2混凝效果,而且可以降低出厂水残留铝浓度。考虑工程应用可行性,可优先考虑调整絮凝剂生产工艺。     

生物通风技术修复柴油污染土壤的土柱模拟实验

生物通风技术是将土壤气相抽提和生物降解结合起来的原位强迫氧化降解方法,对于修复因地下储油罐泄漏引起的土壤污染具有广阔的应用前景。通过室内土柱模拟柴油泄漏污染土壤,分析了不同历时残余总石油烃(total pe-troleum hydrocarbon,TPH)的平衡分布规律以及土壤中不同深度柴油量、总柴油量的变化。结果表明:(1)各柱残余TPH剖面分布差异的原因受土柱的初始装填情况的影响较大;(2)残余TPH平衡分布曲线呈双峰型的土柱,柴油的去除主要以挥发作用及生物降解作用为主;(3)挥发作用主要是由通风孔隙体积数及土壤含水率来影响的;重力作用则主要是由初始油浓度、土壤含水率、C∶N∶P影响的;除通风方式外,其余4个因素都对生物降解作用有影响;(4)初始油浓度较大,土壤含水率较小的柱8和柱11,生物降解作用最明显,柴油去除效果最好。该成果可为生物通风过程的强化提供理论依据。     

对地观测技术在重大自然灾害监测与评估中的应用实例分析

对地观测技术可提供大范围、多时相、高分辨率的海量数据,用于自然灾害的监测与评估有其极大的优越性。本文叙述了对地观测技术在洪涝灾害、沙尘天气、森林火灾的监测与评估和地震形变场研究中的应用,并指出对地观测技术是建立数字减灾系统不可或缺的强大信息源。     

滑坡动态变形过程的综合研究方法

影响滑坡变形破坏过程的因素具有复杂性和多变性,要合理评价和预测滑坡的动态发展过程,深入的地质原型调查是基础,地质分析不仅能为其它分析方法的正确使用提供资料,而且能直接对滑坡的变形破坏发展过程作出定性的判断。在此基础上建立力学模型,采用数学力学理论进行定量计算和反演分析,可进一步从本质上去把握滑坡变形破坏的发展规律。本文通过介绍李家峡水电站Ⅱ号滑坡的研究实践,说明了采用定性地质分析与定量力学计算相结合的研究方法揭示滑坡变形破坏动态过程的有效性。     

用固体力学化学理论研究岩土的力学化学行为——以成都龙泉紫色土为例

根据固体力学化学理论 ,提出用化学动力学方法研究岩土破坏及滑坡形成的机理 ,并以成都龙泉紫色土为例研究了在力与水协同作用下易滑土层的力学化学行为。实验表明 ,土长期抗剪强度降低的幅度与溶液的pH值有关 ,土的溶解速度与易溶盐含量有关 ,且溶解曲线略呈“S”型。这初步证明了龙泉紫色土破坏的力学 化学效应及其可能存在的自催化趋势。通过实验了解了力与水协同作用导致土破坏的力学化学规律 ,并将定量求解滑面长期抗剪强度与反应机理研究结合起来 ,为定量评价地下水和应力对岩土破坏机理这一滑坡学关键问题打下基础。